⭕ Circle theorems practice

Answer key

1. (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
2. (a) 30° — Method: the exterior angles of any convex polygon add up to 360°, and in a regular polygon they are all equal, so divide 360° by the number of sides. Working: 360 ÷ 12 = 30. Answer: 30°. The distractors: 150° is the interior angle, 180 − 30, which answers for the wrong angle at the vertex; 15° comes from dividing 180 by 12, using the angles on a straight line instead of the full turn; 36° comes from dividing 360 by 12 − 2 = 10, carrying the subtraction of 2 out of the interior angle sum formula into a calculation that does not need it.
3. (a) 31.4 — Method: first find the circumference of one turn using π × diameter, then multiply by the number of turns. Working: circumference = 3.14 × 0.5 = 1.57 m; total distance = 1.57 × 20 = 31.4 m. A student who answers 15.7 has mistakenly halved the diameter again before multiplying, using 0.25 m instead of 0.5 m. A student who answers 3.14 has simply written down π itself, without completing the circumference or multiplying by the number of turns. A student who answers 62.8 has mistakenly doubled the diameter to 1 m before multiplying, treating the given length as a radius. Answer: 31.4 m.
4. (a) 104° — Method: find each inscribed angle separately using the angle-at-the-centre theorem: for a point on the arc NOT cut off by the given central angle, halve that central angle; for a point on the OTHER arc, halve the REFLEX central angle instead; then subtract the smaller from the larger. Working: for C on the major arc, angle ACB = 76 ÷ 2 = 38 degrees. For D on the minor arc, D sees the reflex angle at the centre, 360 − 76 = 284 degrees, so angle ADB = 284 ÷ 2 = 142 degrees. The difference is 142 − 38 = 104 degrees. Answer: 104°. Both inscribed angles need the theorem applied separately, using the correct arc's central angle each time (the reflex angle for D), and the question asks for the DIFFERENCE between the two, not either angle on its own and not their sum, 180°, which is simply the opposite-angle total for the cyclic quadrilateral ACBD.
5. (b) segment — The region enclosed between a chord and the arc it cuts off is called a segment. A sector is the different region already named in the question, enclosed by the two radii and the arc, not by the chord. A tangent is a straight line that touches the circle at one point, not an enclosed region at all. The circumference is the total distance around the whole circle, a length, not a region.
6. (c) 5 cm — Diameter = circumference ÷ π, so 31.4 ÷ 3.14 = 10 cm, and the radius is half the diameter, so 10 ÷ 2 = 5 cm. 10 cm is the diameter itself, given as the radius by forgetting the final halving step. 15.7 cm comes from halving the circumference, 31.4 ÷ 2 = 15.7, and stopping there, treating half the circumference as the radius without ever dividing by π. 2.5 cm comes from halving the correct radius again, effectively dividing by 2 twice instead of once.
7. (a) 71° — Method: first use the straight line through T to find the tangent-chord angle RTC, then apply the alternate segment theorem, which states that this angle equals the angle subtended by the chord in the alternate segment. Working: the two rails form a straight line through T, so angle RTC = 180 − 109 = 71 degrees. D lies in the alternate segment of the chord TC, so angle TDC = angle RTC = 71°. Answer: 71°. Find angle RTC FIRST from the straight line before applying the theorem: using the given 109° directly, doubling the tangent-chord angle, or taking its complement from 90° all give the wrong angle at D.
8. (b) Statement 3 — a triangle's angles are said to sum to 360° — The angles of any triangle sum to 180°, not 360° — Statement 3 uses the wrong total, and that error is what sends its final line to the impossible claim that angle ACB = 180°. The correct working is angle OAC + angle OBC + angle ACB = 180°, and since angle ACB = angle OCA + angle OCB, this gives 2 × angle ACB = 180°, so angle ACB = 90°, which is the actual theorem. Statement 1 correctly identifies OA and OC as equal radii, making triangle OAC isosceles — nothing wrong there. Statement 2 correctly does the same for triangle OBC. Statement 4 correctly states that A, O and B are collinear, since a diameter passes through the centre — also nothing wrong there. Statement 3 is the one to flag: it is the angle sum it quotes that is wrong, not the diagram or the radii.
9. (c) 72° — Method: opposite angles in a cyclic quadrilateral always sum to 180°. Working: angle DAB and angle BCD are opposite angles of the cyclic quadrilateral ABCD, so angle BCD = 180 − 108 = 72 degrees. Answer: 72°. Opposite angles in a cyclic quadrilateral are SUPPLEMENTARY, not equal, so do not simply copy the given angle; and do not subtract from 360°, which is the rule for angles round a point, or confuse this with the angle-in-a-semicircle theorem, which gives a fixed 90° that has nothing to do with this quadrilateral.
10. (c) 140° — Method: OAPB is a quadrilateral whose angles sum to 360°; the tangent-radius angles at A and B are each 90°, and angle APB is given, so angle AOB is whatever is left. Working: angle OAP = angle OBP = 90°, so angle AOB = 360 − 90 − 90 − 40 = 140 degrees. Answer: 140°. Both tangent-radius angles are 90° each and must both be subtracted, not just one, and the quadrilateral's angles sum to 360°, not 180°: do not assume angle AOB simply matches angle APB, which is a different angle in a different part of the figure.
11. (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
12. (b) 80° — Method: opposite angles of a cyclic quadrilateral sum to 180°, so form and solve an equation for x, then substitute back to find angle DAB. Working: (2x + 10) + (3x − 5) = 180, so 5x + 5 = 180, x = 35, and angle DAB = 2(35) + 10 = 80°. Using 360° instead of 180° as the total (as if the two angles were the whole circle rather than a pair of opposite angles) gives x = 71 and angle DAB = 152°; solving correctly for x but reporting x itself instead of substituting it back into 2x + 10 gives 35°; and mishandling the signs when combining the two expressions, using (2x + 10) + (3x + 5) = 180 instead of (2x + 10) + (3x − 5) = 180, gives x = 33 and angle DAB = 76°. Opposite angles of a cyclic quadrilateral — not adjacent ones — are the pair that sums to 180°.
13. (a) 24 cm — The line from the centre to the midpoint of a chord is perpendicular to the chord, so triangle OMA has a right angle at M. By Pythagoras' theorem, AM² = OA² − OM² = 169 − 25 = 144, so AM = 12 cm. AB is twice AM, since M is the midpoint: AB = 2 × 12 = 24 cm. Finding AM = 12 cm correctly but forgetting to double it for the full chord gives 12 cm. Working out 169 − 25 = 144 and forgetting to take the square root gives 144 cm. Subtracting first and then doubling the wrong way, (13 − 5) × 2, gives 16 cm. Doubling AM after finding it correctly is the step that's missing from all three — do it, and you get 24 cm.
14. (b) It is the longest of the three chords — Method: in any circle the length of a chord is decided by how far the chord lies from the centre, because a chord passing nearer the centre cuts further across the circle. Working: the chord through O lies at a distance of zero from the centre, and no chord can lie closer than that, so no chord of the circle can be longer than it; a chord through the centre is a diameter. The other two chords lie at some distance greater than zero, so each of them falls short of that maximum. Answer: It is the longest of the three chords. The distractors: It is the shortest of the three chords comes from reversing the rule and picturing a chord near the centre as a short line tucked inside; It is the same length as the other two chords comes from carrying the fact that all radii of a circle are equal across to chords, which are not all equal; It is half the length of each of the other two chords comes from confusing a chord through the centre with a radius, which really is half a diameter.
15. (a) 65° — OT and OC are both radii, so triangle OTC is isosceles with OT = OC, and its base angles are equal: angle OTC = angle OCT = (180° − 130°) ÷ 2 = 25°. A tangent is perpendicular to the radius at the point of contact, so angle OTP = 90°. Since C lies inside angle OTP, the chord TC splits this right angle into angle OTC and angle PTC, so angle PTC = angle OTP − angle OTC = 90° − 25° = 65°. Stopping after finding the base angle of the isosceles triangle, without subtracting it from the right angle at T, leaves 25° instead of the angle actually asked for. Adding the base angle to the right angle instead of subtracting it, 90° + 25° = 115°, reverses the direction the two angles combine in. Finding the sum of the two base angles of the isosceles triangle, 180° − 130° = 50°, and stopping there, gives another wrong value entirely.
16. (d) Concentric circles — Method: focus on what the two circles have in common — their centre, not their size. Working: both circles share exactly the same centre point but have different radii, which is the defining feature of this pair of circles. A student who answers congruent circles has confused 'same centre' with 'same size', but congruent circles simply have equal radii and need not share a centre. A student who answers tangential circles has confused circles that touch each other at one point with ones that share a centre. A student who answers similar circles has used the general term for the same shape at different sizes, missing the specific 'same centre' fact. Answer: concentric circles.
17. (d) tangent — A line that touches a circle at exactly one point, without crossing into the circle, is called a tangent. A chord is a straight line joining two points ON the circle, so it touches at two points, not one. A radius runs from the centre to the circle's edge, not along the outside of it. A diameter is a chord that passes through the centre, also touching the circle at two points.
18. (b) 63° — Method: a tangent meets the radius drawn to the point of contact at a right angle, so triangle OPT has a 90° angle at T; the three angles of the triangle then sum to 180°. Working: angle OTP = 90°, angle OPT = 27°, so angle POT = 180 − 90 − 27 = 63 degrees. Answer: 63°. The tangent-radius angle is a fixed 90°, not something to assume equal to another angle in the triangle, and the three angles of ANY triangle sum to 180°, never 360°: that total belongs to a quadrilateral, not a triangle.