⭕ Circle theorems practice

Answer key

1. (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
2. (a) 25° — PA and PB are tangents from the same external point, so PA = PB and OAPB is a kite with right angles at A and B, by the tangent–radius theorem: angle OAP = angle OBP = 90°. The four angles of the kite sum to 360°, so angle AOB = 360° − 90° − 90° − 50° = 130°. Triangle OAB is isosceles because OA = OB, both radii, so its base angles are equal: angle OAB = (180° − 130°) ÷ 2 = 25°. Using angle APB itself as the apex angle of triangle OAB instead of angle AOB gives (180° − 50°) ÷ 2 = 65°. Using a triangle's angle sum on the four-sided kite, and so counting only one of its two right angles, treats angle AOB as 180° − 90° − 50° = 40°, and halving what is then left of triangle OAB gives (180° − 40°) ÷ 2 = 70°. Finding angle AOB = 130° correctly but forgetting to halve for the isosceles base angle gives 180° − 130° = 50°. Halve that remaining angle, and 25° is what's left for angle OAB.
3. (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
4. (d) tangent — A line that touches a circle at exactly one point, without crossing into the circle, is called a tangent. A chord is a straight line joining two points ON the circle, so it touches at two points, not one. A radius runs from the centre to the circle's edge, not along the outside of it. A diameter is a chord that passes through the centre, also touching the circle at two points.
5. (c) 32 — Method: alternate angles between parallel lines are equal, so 2x + 10 = 74. Working: subtracting 10 from both sides gives 2x = 64; dividing by 2 gives x = 32. Answer: x = 32. A candidate who forgets to subtract 10 first and divides 74 by 2 directly gets 37. A candidate who treats the angles as co-interior instead of alternate, so that the two expressions add to 180° rather than being equal, gets 48 after solving. A candidate who makes a sign error and treats the equation as 2x equalling 10 minus 74 instead of 74 minus 10 gets −32.
6. (a) 1260° — The sum of the interior angles of a polygon with n sides is (n − 2) × 180°. For a nonagon, n = 9, so the sum is (9 − 2) × 180° = 7 × 180° = 1260°. 1620° uses 9 × 180° without subtracting 2 from n first. 140° is the size of a single interior angle of a regular nonagon (1260° ÷ 9), not the sum of all nine. 1440° uses (n − 1) × 180° = 8 × 180° instead of (n − 2) × 180°.
7. (b) 58° — Method: the angle at the centre is TWICE the angle at the circumference when both stand on the same arc. Working: angle AOC is the angle at the centre standing on arc AC, and angle ABC is the angle at the circumference standing on the same arc AC, with B on the major arc, so angle AOC = 2 × angle ABC. Rearranging, angle ABC = 116 ÷ 2 = 58 degrees. Answer: 58°. Halve the centre angle, do not double it, and use the angle AOC exactly as given, 116°: you do not need its reflex angle here, because B sits on the major arc, which is precisely the arrangement the theorem is stated for.
8. (a) 46° — Method: use the angle at the centre, then the cyclic quadrilateral, then the angle sum of a triangle. Working: angle ABC = 152° ÷ 2 = 76° (angle at the centre is twice the angle at the circumference); angle ADC = 180° − 76° = 104° (opposite angles of a cyclic quadrilateral sum to 180°); angle DAC = 180° − 104° − 30° = 46° (angle sum of triangle ACD). Skipping the halving step and taking angle ABC = 152° gives angle ADC = 180° − 152° = 28° and then angle DAC = 122°; using angle ABC = 76° directly as angle ADC, skipping the cyclic quadrilateral step, gives 74°; and finding angle DAC as 180° − 104° without subtracting the given 30° gives 76°. Each of the three steps must be carried through in order — halve, then subtract from 180°, then subtract from 180° again with the extra angle.
9. (a) 80° — In triangle ABD, the three angles sum to 180°: angle BAD = 180° − 35° − 65° = 80°. ABCD is a cyclic quadrilateral, so the exterior angle at C, angle BCE, is equal to the interior angle at the opposite vertex, angle BAD: angle BCE = 80°. Adding the two given angles in triangle ABD instead of subtracting them from 180°, 35° + 65° = 100°, and then applying the exterior-angle rule correctly still gives the wrong angle BAD and so the wrong exterior angle, 100°. Halving the correct angle BAD, 80° ÷ 2 = 40°, confuses the exterior-angle rule with a different circle theorem in which one angle is half of another. Doubling it instead, 80° × 2 = 160°, makes the same kind of confusion in the other direction.
10. (b) segment — The region enclosed between a chord and the arc it cuts off is called a segment. A sector is the different region already named in the question, enclosed by the two radii and the arc, not by the chord. A tangent is a straight line that touches the circle at one point, not an enclosed region at all. The circumference is the total distance around the whole circle, a length, not a region.
11. (b) 160° — B is on the minor arc AC, so the angle at the centre theorem applies to the reflex angle AOC: reflex angle AOC = 2 × 100° = 200°. The non-reflex angle AOC is the rest of the full turn: 360° − 200° = 160°. Reporting the reflex angle itself, without subtracting it from 360°, gives 200°. Subtracting angle ABC from 180° instead, as if this were a cyclic quadrilateral, gives 80°. Halving angle ABC instead of doubling it gives 50°. Double first, then take the angle away from a full turn, and 160° is what's left.
12. (c) chord — A diameter is a straight line joining two points on the circle that happens to pass through the centre. The general term for any straight line joining two points on a circle is a chord — every diameter is a chord, but not every chord is a diameter. Calling it a radius is wrong because a radius runs from the centre to just ONE point on the circle, not between two points on the circle. A tangent touches the circle at only one point, so it cannot be a diameter at all. An arc is a curved part of the circle's edge, not a straight line.
13. (c) VW — Method: within one circle a chord's distance from the centre is fixed by its length, because a chord passing nearer the centre cuts further across the circle; so the chord that lies closest to the centre is simply the longest one listed. Working: the four lengths are 6 cm, 10 cm, 14 cm and 15 cm. Placing them in order, the greatest is 15 cm, and that length belongs to VW, so VW lies closest to the centre. Answer: VW. The distractors: PQ comes from reversing the rule and taking the shortest chord to be the one tucked nearest the centre; TU comes from knowing that the very longest chord is a diameter, deciding that such a chord passes through the centre rather than lying close to it, ruling the 15 cm chord out on that ground and taking the next longest; RS comes from reading 'closest to the centre' as 'nearest the middle of the list of lengths' and picking a middling value.
14. (c) 90° — A tangent to a circle always meets the radius drawn to the point of contact at a right angle, so the angle between the tangent and the radius at P is 90°. 180° confuses the tangent with the diameter through P, as if the radius continued in a straight line into the tangent. 45° halves the true angle by mistake. 60° comes from confusing this fact with the angle of an equilateral triangle.
15. (b) 35° — Method: angle CBE and angle ABC lie on a straight line at B, so they are supplementary; angle ABC then equals angle ADC because B and D are both on the major arc AC (angles in the same segment). Working: angle ABC = 180 − 145 = 35 degrees, using angles on a straight line. Since B and D are both on the major arc AC, angle ADC = angle ABC = 35°. Answer: 35°. Find angle ABC FIRST from the straight line at B before applying the circle theorem: using the given 145° directly, doubling or halving it, or subtracting it from 180° a second time all give the wrong angle.
16. (b) 80° — Method: opposite angles of a cyclic quadrilateral sum to 180°, so form and solve an equation for x, then substitute back to find angle DAB. Working: (2x + 10) + (3x − 5) = 180, so 5x + 5 = 180, x = 35, and angle DAB = 2(35) + 10 = 80°. Using 360° instead of 180° as the total (as if the two angles were the whole circle rather than a pair of opposite angles) gives x = 71 and angle DAB = 152°; solving correctly for x but reporting x itself instead of substituting it back into 2x + 10 gives 35°; and mishandling the signs when combining the two expressions, using (2x + 10) + (3x + 5) = 180 instead of (2x + 10) + (3x − 5) = 180, gives x = 33 and angle DAB = 76°. Opposite angles of a cyclic quadrilateral — not adjacent ones — are the pair that sums to 180°.
17. (b) (2x + 10)° — By the angle at the centre theorem, angle ABC is half of angle AOC, because both stand on the same arc AC: angle ABC = (4x + 20)° ÷ 2 = (2x + 10)°. Writing down the centre angle itself, without halving at all, gives (4x + 20)°. Halving only the constant term and leaving the x-term unchanged gives (4x + 10)°. Doubling the centre angle instead of halving it gives (8x + 40)°. Halve every term in the expression, and (2x + 10)° is what you get.
18. (d) The angle between a tangent and a radius is 90° — OP is the radius drawn to the point of contact P, and a circle theorem states that a tangent always meets that radius at a right angle, so angle OPQ = 90°. A tangent is not parallel to the radius it touches — at the point of contact it is perpendicular to that radius, not parallel to it. A tangent does not pass through the centre — a straight line through the centre that also touches the circle at one point would have to be a diameter, which is a different line entirely. The angle-in-a-semicircle theorem needs a triangle drawn inside the circle with a diameter as its longest side; there is no such triangle here, just a tangent and a radius.