⭕ Circle theorems practice

Answer key

1. (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
2. (d) The angle between a tangent and a radius is 90° — OP is the radius drawn to the point of contact P, and a circle theorem states that a tangent always meets that radius at a right angle, so angle OPQ = 90°. A tangent is not parallel to the radius it touches — at the point of contact it is perpendicular to that radius, not parallel to it. A tangent does not pass through the centre — a straight line through the centre that also touches the circle at one point would have to be a diameter, which is a different line entirely. The angle-in-a-semicircle theorem needs a triangle drawn inside the circle with a diameter as its longest side; there is no such triangle here, just a tangent and a radius.
3. (b) 30 cm — The perpendicular from the centre of a circle to a chord bisects the chord, so this line, half the chord and the radius form a right-angled triangle. Using Pythagoras' theorem, half the chord = √(17² − 8²) = √(289 − 64) = √225 = 15 cm. The full chord AB is twice this length: AB = 2 × 15 = 30 cm. Stopping after finding the half-chord, without doubling it for the whole chord, gives 15 cm. Adding the radius and the perpendicular distance directly, 17 + 8 = 25 cm, ignores that these two lengths are the two shorter sides of a right-angled triangle, not parts of a straight line. Subtracting instead, 17 − 8 = 9 cm, makes the same mistake in the other direction.
4. (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
5. (c) 90° — A tangent to a circle always meets the radius drawn to the point of contact at a right angle, so the angle between the tangent and the radius at P is 90°. 180° confuses the tangent with the diameter through P, as if the radius continued in a straight line into the tangent. 45° halves the true angle by mistake. 60° comes from confusing this fact with the angle of an equilateral triangle.
6. (d) 60° — Method: the six angles at the centre together make one complete turn of 360°, and because the hexagon is regular they are all equal, so divide 360° by 6. Working: 360 ÷ 6 = 60. Answer: 60°. The distractors: 120° is the interior angle of a regular hexagon, 720 ÷ 6, which is the angle at a vertex and not the angle at the centre; 45° comes from dividing 360 by 8, treating the hexagon as though it had eight sides; 30° comes from halving the angle at the centre, as though each of the six triangles were split again by a line of symmetry.
7. (a) 30° — Method: the exterior angles of any convex polygon add up to 360°, and in a regular polygon they are all equal, so divide 360° by the number of sides. Working: 360 ÷ 12 = 30. Answer: 30°. The distractors: 150° is the interior angle, 180 − 30, which answers for the wrong angle at the vertex; 15° comes from dividing 180 by 12, using the angles on a straight line instead of the full turn; 36° comes from dividing 360 by 12 − 2 = 10, carrying the subtraction of 2 out of the interior angle sum formula into a calculation that does not need it.
8. (a) 46° — Method: use the angle at the centre, then the cyclic quadrilateral, then the angle sum of a triangle. Working: angle ABC = 152° ÷ 2 = 76° (angle at the centre is twice the angle at the circumference); angle ADC = 180° − 76° = 104° (opposite angles of a cyclic quadrilateral sum to 180°); angle DAC = 180° − 104° − 30° = 46° (angle sum of triangle ACD). Skipping the halving step and taking angle ABC = 152° gives angle ADC = 180° − 152° = 28° and then angle DAC = 122°; using angle ABC = 76° directly as angle ADC, skipping the cyclic quadrilateral step, gives 74°; and finding angle DAC as 180° − 104° without subtracting the given 30° gives 76°. Each of the three steps must be carried through in order — halve, then subtract from 180°, then subtract from 180° again with the extra angle.
9. (b) 160° — B is on the minor arc AC, so the angle at the centre theorem applies to the reflex angle AOC: reflex angle AOC = 2 × 100° = 200°. The non-reflex angle AOC is the rest of the full turn: 360° − 200° = 160°. Reporting the reflex angle itself, without subtracting it from 360°, gives 200°. Subtracting angle ABC from 180° instead, as if this were a cyclic quadrilateral, gives 80°. Halving angle ABC instead of doubling it gives 50°. Double first, then take the angle away from a full turn, and 160° is what's left.
10. (b) Statement 3 — a triangle's angles are said to sum to 360° — The angles of any triangle sum to 180°, not 360° — Statement 3 uses the wrong total, and that error is what sends its final line to the impossible claim that angle ACB = 180°. The correct working is angle OAC + angle OBC + angle ACB = 180°, and since angle ACB = angle OCA + angle OCB, this gives 2 × angle ACB = 180°, so angle ACB = 90°, which is the actual theorem. Statement 1 correctly identifies OA and OC as equal radii, making triangle OAC isosceles — nothing wrong there. Statement 2 correctly does the same for triangle OBC. Statement 4 correctly states that A, O and B are collinear, since a diameter passes through the centre — also nothing wrong there. Statement 3 is the one to flag: it is the angle sum it quotes that is wrong, not the diagram or the radii.
11. (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
12. (a) 80° — In triangle ABD, the three angles sum to 180°: angle BAD = 180° − 35° − 65° = 80°. ABCD is a cyclic quadrilateral, so the exterior angle at C, angle BCE, is equal to the interior angle at the opposite vertex, angle BAD: angle BCE = 80°. Adding the two given angles in triangle ABD instead of subtracting them from 180°, 35° + 65° = 100°, and then applying the exterior-angle rule correctly still gives the wrong angle BAD and so the wrong exterior angle, 100°. Halving the correct angle BAD, 80° ÷ 2 = 40°, confuses the exterior-angle rule with a different circle theorem in which one angle is half of another. Doubling it instead, 80° × 2 = 160°, makes the same kind of confusion in the other direction.
13. (b) 62 — Method: co-interior (allied) angles between parallel lines add up to 180°. Working: 180 − 118 = 62. Answer: 62°. A candidate who treats co-interior angles as equal, like corresponding angles, gives 118. A candidate who uses 360° instead of 180°, working out 360 − 118, gets 242. A candidate who subtracts as if the angles were complementary, working out 118 − 90, gets 28.
14. (d) Concentric circles — Method: focus on what the two circles have in common — their centre, not their size. Working: both circles share exactly the same centre point but have different radii, which is the defining feature of this pair of circles. A student who answers congruent circles has confused 'same centre' with 'same size', but congruent circles simply have equal radii and need not share a centre. A student who answers tangential circles has confused circles that touch each other at one point with ones that share a centre. A student who answers similar circles has used the general term for the same shape at different sizes, missing the specific 'same centre' fact. Answer: concentric circles.
15. (c) 15 — The exterior angle is 180° − 156° = 24°, and the number of sides of a regular polygon is 360° divided by the exterior angle, so 360 ÷ 24 = 15. 24° is the exterior angle itself, stopping one step before the final division. 17 comes from finding 15 correctly and then adding 2, muddling the exterior angle rule with the (n − 2) that appears in the interior angle sum formula. 7.5 comes from dividing 180 by the exterior angle instead of 360, using the angles on a straight line rather than the total of the exterior angles of a polygon.
16. (b) 62° — Because AT is a diameter, the radius OT lies along AT, and the tangent PT meets every radius at 90°, by the tangent–radius theorem. So PT meets AT at T at a right angle: angle ATP = 90°. The angles of triangle APT sum to 180°, so angle APT = 180° − 90° − 28° = 62°. Copying the given angle PAT straight across, as though the triangle were isosceles, gives 28°. Adding the two known angles instead of subtracting them from 180° gives 90° + 28° = 118°. Naming the right angle itself, angle ATP, instead of the angle that was actually asked for gives 90°. Subtract both known angles from 180°, and 62° is angle APT.
17. (a) 105° — The interior angles of a pentagon add up to (5 − 2) × 180° = 540°. Subtracting the three known angles, 540 − 100 − 110 − 120 = 210°, and this 210° is shared equally between the two angles marked x°, so each one is 210 ÷ 2 = 105°. 210° stops one step early, giving the total of the two unknown angles instead of one of them. 108° is the interior angle of a regular pentagon, which does not apply here since this pentagon's angles are not all equal. 55° comes from halving one of the given angles, 110°, instead of halving the remaining total.
18. (b) Minor segment — Method: compare the sizes of the two regions cut off by the chord, and recall the term used for the smaller one. Working: the chord creates two segments; the smaller region is called the minor segment and the larger one the major segment. A student who answers major segment has picked the larger region by mistake instead of the smaller one. A student who answers minor arc has named the curved boundary rather than the two-dimensional region it encloses. A student who answers semicircle has wrongly assumed the chord must pass through the centre. Answer: minor segment.