⭕ Circle theorems practice

Answer key

1. (c) VW — Method: within one circle a chord's distance from the centre is fixed by its length, because a chord passing nearer the centre cuts further across the circle; so the chord that lies closest to the centre is simply the longest one listed. Working: the four lengths are 6 cm, 10 cm, 14 cm and 15 cm. Placing them in order, the greatest is 15 cm, and that length belongs to VW, so VW lies closest to the centre. Answer: VW. The distractors: PQ comes from reversing the rule and taking the shortest chord to be the one tucked nearest the centre; TU comes from knowing that the very longest chord is a diameter, deciding that such a chord passes through the centre rather than lying close to it, ruling the 15 cm chord out on that ground and taking the next longest; RS comes from reading 'closest to the centre' as 'nearest the middle of the list of lengths' and picking a middling value.
2. (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
3. (c) chord — A diameter is a straight line joining two points on the circle that happens to pass through the centre. The general term for any straight line joining two points on a circle is a chord — every diameter is a chord, but not every chord is a diameter. Calling it a radius is wrong because a radius runs from the centre to just ONE point on the circle, not between two points on the circle. A tangent touches the circle at only one point, so it cannot be a diameter at all. An arc is a curved part of the circle's edge, not a straight line.
4. (a) 49° — Method: an exterior angle of a triangle equals the sum of the two interior angles that are not next to it, which here are the angles at A and at C; since those two are equal, the exterior angle is twice the angle at A. Working: 2 × angle A = 98, so angle A = 98 ÷ 2 = 49. Answer: 49°. The distractors: 82° is the interior angle at B, 180 − 98, given in place of the angle at A; 41° comes from finding that interior angle of 82° and halving it, 82 ÷ 2, instead of halving the exterior angle; 98° comes from taking the exterior angle to be equal to the angle at A on its own, with no halving at all.
5. (a) 65° — OT and OC are both radii, so triangle OTC is isosceles with OT = OC, and its base angles are equal: angle OTC = angle OCT = (180° − 130°) ÷ 2 = 25°. A tangent is perpendicular to the radius at the point of contact, so angle OTP = 90°. Since C lies inside angle OTP, the chord TC splits this right angle into angle OTC and angle PTC, so angle PTC = angle OTP − angle OTC = 90° − 25° = 65°. Stopping after finding the base angle of the isosceles triangle, without subtracting it from the right angle at T, leaves 25° instead of the angle actually asked for. Adding the base angle to the right angle instead of subtracting it, 90° + 25° = 115°, reverses the direction the two angles combine in. Finding the sum of the two base angles of the isosceles triangle, 180° − 130° = 50°, and stopping there, gives another wrong value entirely.
6. (d) 13 — Method: OP and PQ meet at a right angle because of the tangent–radius fact, so triangle OPQ is right-angled at P; use Pythagoras' theorem. Working: OQ² = OP² + PQ² = 5² + 12² = 25 + 144 = 169; OQ = √169 = 13. A student who answers 17 has simply added the two given lengths (5 + 12) instead of using Pythagoras' theorem. A student who answers 7 has subtracted the two given lengths (12 − 5) instead of using Pythagoras' theorem. A student who answers 144 has correctly squared 12 but stopped there, forgetting to add 5² and take the square root. Answer: 13 cm.
7. (d) 63.6 — Method: the three angles inside the triangle formed by the two ladders and the ground add up to 180°. Working: 180 − 58.2 − 58.2 = 63.6. Answer: 63.6°. A candidate who assumes the top angle equals the base angles gives 58.2. A candidate who subtracts only one base angle from 180°, working out 180 − 58.2, gets 121.8. A candidate who doubles the base angle instead of subtracting it twice from 180°, working out 2 × 58.2, gets 116.4.
8. (b) 80° — Method: opposite angles of a cyclic quadrilateral sum to 180°, so form and solve an equation for x, then substitute back to find angle DAB. Working: (2x + 10) + (3x − 5) = 180, so 5x + 5 = 180, x = 35, and angle DAB = 2(35) + 10 = 80°. Using 360° instead of 180° as the total (as if the two angles were the whole circle rather than a pair of opposite angles) gives x = 71 and angle DAB = 152°; solving correctly for x but reporting x itself instead of substituting it back into 2x + 10 gives 35°; and mishandling the signs when combining the two expressions, using (2x + 10) + (3x + 5) = 180 instead of (2x + 10) + (3x − 5) = 180, gives x = 33 and angle DAB = 76°. Opposite angles of a cyclic quadrilateral — not adjacent ones — are the pair that sums to 180°.
9. (b) 62° — Because AT is a diameter, the radius OT lies along AT, and the tangent PT meets every radius at 90°, by the tangent–radius theorem. So PT meets AT at T at a right angle: angle ATP = 90°. The angles of triangle APT sum to 180°, so angle APT = 180° − 90° − 28° = 62°. Copying the given angle PAT straight across, as though the triangle were isosceles, gives 28°. Adding the two known angles instead of subtracting them from 180° gives 90° + 28° = 118°. Naming the right angle itself, angle ATP, instead of the angle that was actually asked for gives 90°. Subtract both known angles from 180°, and 62° is angle APT.
10. (a) 80° — In triangle ABD, the three angles sum to 180°: angle BAD = 180° − 35° − 65° = 80°. ABCD is a cyclic quadrilateral, so the exterior angle at C, angle BCE, is equal to the interior angle at the opposite vertex, angle BAD: angle BCE = 80°. Adding the two given angles in triangle ABD instead of subtracting them from 180°, 35° + 65° = 100°, and then applying the exterior-angle rule correctly still gives the wrong angle BAD and so the wrong exterior angle, 100°. Halving the correct angle BAD, 80° ÷ 2 = 40°, confuses the exterior-angle rule with a different circle theorem in which one angle is half of another. Doubling it instead, 80° × 2 = 160°, makes the same kind of confusion in the other direction.
11. (b) 31.4 cm — Circumference = π × diameter, so 3.14 × 10 = 31.4 cm. 15.7 cm comes from using the radius, 5 cm, in place of the diameter: 3.14 × 5 = 15.7, which is only half the circumference. 78.5 cm comes from using the area formula π × radius² instead of the circumference formula: 3.14 × 5² = 3.14 × 25 = 78.5. 62.8 cm comes from keeping the 2 from the radius form of the formula, C = 2 × π × radius, but putting the full diameter into it: 2 × 3.14 × 10 = 62.8.
12. (a) Reflex + non-reflex angle BOD = 360°, so 2a + 2c = 360°. — A correct proof must build in a strictly logical order: the reflex and non-reflex angles at O, which together make a complete turn about the centre, must be added to 360° before 2a and 2c can be combined and divided. The statement 'Reflex + non-reflex angle BOD = 360°, so 2a + 2c = 360°' is the only one that follows directly from having 2a and 2c already established, and it is exactly what is needed before the final division step. Jumping straight to 'Divide by 2 throughout to get a + c = 180°' skips the step that justifies why 2a + 2c equals 360° in the first place — there is nothing yet to divide. Repeating 'Angle BOD is 2a and 2c, by the centre theorem' does not move the proof forward at all, since that fact has already been established in the sentence given. Introducing 'OB = OD are radii, so triangle OBD is isosceles' brings in an unrelated triangle and an unrelated method that plays no part in this particular proof.
13. (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
14. (a) 25° — PA and PB are tangents from the same external point, so PA = PB and OAPB is a kite with right angles at A and B, by the tangent–radius theorem: angle OAP = angle OBP = 90°. The four angles of the kite sum to 360°, so angle AOB = 360° − 90° − 90° − 50° = 130°. Triangle OAB is isosceles because OA = OB, both radii, so its base angles are equal: angle OAB = (180° − 130°) ÷ 2 = 25°. Using angle APB itself as the apex angle of triangle OAB instead of angle AOB gives (180° − 50°) ÷ 2 = 65°. Using a triangle's angle sum on the four-sided kite, and so counting only one of its two right angles, treats angle AOB as 180° − 90° − 50° = 40°, and halving what is then left of triangle OAB gives (180° − 40°) ÷ 2 = 70°. Finding angle AOB = 130° correctly but forgetting to halve for the isosceles base angle gives 180° − 130° = 50°. Halve that remaining angle, and 25° is what's left for angle OAB.
15. (a) 90° — Method: the angle in a semicircle theorem states that the angle subtended at the circumference by a diameter is always a right angle, whatever the circle's size. Working: since AC is a diameter, the angle ABC subtended at the circumference by AC is 90 degrees, regardless of the circle's radius. Answer: 90°. This result holds for every position of B on the circle and for every size of circle, so no length or radius is ever needed: do not confuse angle ABC with the straight angle along the diameter itself, which is 180°, and do not halve the right angle again.
16. (c) 90° — A tangent to a circle always meets the radius drawn to the point of contact at a right angle, so the angle between the tangent and the radius at P is 90°. 180° confuses the tangent with the diameter through P, as if the radius continued in a straight line into the tangent. 45° halves the true angle by mistake. 60° comes from confusing this fact with the angle of an equilateral triangle.
17. (b) segment — The region enclosed between a chord and the arc it cuts off is called a segment. A sector is the different region already named in the question, enclosed by the two radii and the arc, not by the chord. A tangent is a straight line that touches the circle at one point, not an enclosed region at all. The circumference is the total distance around the whole circle, a length, not a region.
18. (b) 160° — B is on the minor arc AC, so the angle at the centre theorem applies to the reflex angle AOC: reflex angle AOC = 2 × 100° = 200°. The non-reflex angle AOC is the rest of the full turn: 360° − 200° = 160°. Reporting the reflex angle itself, without subtracting it from 360°, gives 200°. Subtracting angle ABC from 180° instead, as if this were a cyclic quadrilateral, gives 80°. Halving angle ABC instead of doubling it gives 50°. Double first, then take the angle away from a full turn, and 160° is what's left.