⭕ Circle theorems practice

Answer key

1. (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
2. (d) The angle between a tangent and a radius is 90° — OP is the radius drawn to the point of contact P, and a circle theorem states that a tangent always meets that radius at a right angle, so angle OPQ = 90°. A tangent is not parallel to the radius it touches — at the point of contact it is perpendicular to that radius, not parallel to it. A tangent does not pass through the centre — a straight line through the centre that also touches the circle at one point would have to be a diameter, which is a different line entirely. The angle-in-a-semicircle theorem needs a triangle drawn inside the circle with a diameter as its longest side; there is no such triangle here, just a tangent and a radius.
3. (b) 62 — Method: co-interior (allied) angles between parallel lines add up to 180°. Working: 180 − 118 = 62. Answer: 62°. A candidate who treats co-interior angles as equal, like corresponding angles, gives 118. A candidate who uses 360° instead of 180°, working out 360 − 118, gets 242. A candidate who subtracts as if the angles were complementary, working out 118 − 90, gets 28.
4. (c) chord — A diameter is a straight line joining two points on the circle that happens to pass through the centre. The general term for any straight line joining two points on a circle is a chord — every diameter is a chord, but not every chord is a diameter. Calling it a radius is wrong because a radius runs from the centre to just ONE point on the circle, not between two points on the circle. A tangent touches the circle at only one point, so it cannot be a diameter at all. An arc is a curved part of the circle's edge, not a straight line.
5. (b) Minor segment — Method: compare the sizes of the two regions cut off by the chord, and recall the term used for the smaller one. Working: the chord creates two segments; the smaller region is called the minor segment and the larger one the major segment. A student who answers major segment has picked the larger region by mistake instead of the smaller one. A student who answers minor arc has named the curved boundary rather than the two-dimensional region it encloses. A student who answers semicircle has wrongly assumed the chord must pass through the centre. Answer: minor segment.
6. (d) 13 — Method: OP and PQ meet at a right angle because of the tangent–radius fact, so triangle OPQ is right-angled at P; use Pythagoras' theorem. Working: OQ² = OP² + PQ² = 5² + 12² = 25 + 144 = 169; OQ = √169 = 13. A student who answers 17 has simply added the two given lengths (5 + 12) instead of using Pythagoras' theorem. A student who answers 7 has subtracted the two given lengths (12 − 5) instead of using Pythagoras' theorem. A student who answers 144 has correctly squared 12 but stopped there, forgetting to add 5² and take the square root. Answer: 13 cm.
7. (b) 2x + 2y = 180° — Method: use the fact that OA, OB and OC are all radii, so triangles OAC and OBC are each isosceles, and set up the angle sum of triangle ABC as a whole. Working: since OA = OC, triangle OAC is isosceles, so angle OAC = angle OCA = x. Since OB = OC, triangle OBC is isosceles, so angle OBC = angle OCB = y. The angle at A in triangle ABC is x, the angle at B is y, and the angle at C is angle OCA plus angle OCB, which is x + y. The three angles of triangle ABC sum to 180°, giving x + y + (x + y) = 180°, which is 2x + 2y = 180°. Answer: 2x + 2y = 180°. Dividing this by 2 gives x + y = 90°, and since angle ACB = x + y, this proves angle ACB = 90°: the point C was never restricted to any particular position on the circle, so the proof holds for every choice of C. Include ALL THREE angles of the triangle in the sum, do not use a quadrilateral's 360° total, and remember angle ACB is the SUM x + y, not x alone.
8. (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
9. (b) Statement 3 — a triangle's angles are said to sum to 360° — The angles of any triangle sum to 180°, not 360° — Statement 3 uses the wrong total, and that error is what sends its final line to the impossible claim that angle ACB = 180°. The correct working is angle OAC + angle OBC + angle ACB = 180°, and since angle ACB = angle OCA + angle OCB, this gives 2 × angle ACB = 180°, so angle ACB = 90°, which is the actual theorem. Statement 1 correctly identifies OA and OC as equal radii, making triangle OAC isosceles — nothing wrong there. Statement 2 correctly does the same for triangle OBC. Statement 4 correctly states that A, O and B are collinear, since a diameter passes through the centre — also nothing wrong there. Statement 3 is the one to flag: it is the angle sum it quotes that is wrong, not the diagram or the radii.
10. (c) 1/4 — A full turn at the centre of a circle is 360°, so a sector's fraction of the circle is its angle divided by 360°: 90 ÷ 360 = 1/4. 1/2 would be the fraction for a sector with an angle of 180°, not 90°. 3/4 is the fraction of the rest of the circle, the major sector left over from the 270° that is not part of this sector. 1/8 would be the fraction for a sector with an angle of 45°, half of 90°.
11. (b) 58° — Method: the angle at the centre is TWICE the angle at the circumference when both stand on the same arc. Working: angle AOC is the angle at the centre standing on arc AC, and angle ABC is the angle at the circumference standing on the same arc AC, with B on the major arc, so angle AOC = 2 × angle ABC. Rearranging, angle ABC = 116 ÷ 2 = 58 degrees. Answer: 58°. Halve the centre angle, do not double it, and use the angle AOC exactly as given, 116°: you do not need its reflex angle here, because B sits on the major arc, which is precisely the arrangement the theorem is stated for.
12. (a) 67° — PA and PB are tangents from the same point, so OAPB is a kite with right angles at A and B, by the tangent–radius theorem. The kite's angles sum to 360°, so angle AOB = 360° − 90° − 90° − 46° = 134°. C is on the major arc AB, so by the angle at the centre theorem, angle ACB = 134° ÷ 2 = 67°. Doubling angle APB instead of first finding angle AOB from the kite gives 46° + 46° = 92°. Using angle APB directly as if it were the centre angle, then halving it, gives 46° ÷ 2 = 23°. Finding angle AOB = 134° correctly but forgetting to halve it for the angle at the circumference gives 134°. Halve angle AOB, once you've found it properly, and you get 67°.
13. (c) 72° — Method: opposite angles in a cyclic quadrilateral always sum to 180°. Working: angle DAB and angle BCD are opposite angles of the cyclic quadrilateral ABCD, so angle BCD = 180 − 108 = 72 degrees. Answer: 72°. Opposite angles in a cyclic quadrilateral are SUPPLEMENTARY, not equal, so do not simply copy the given angle; and do not subtract from 360°, which is the rule for angles round a point, or confuse this with the angle-in-a-semicircle theorem, which gives a fixed 90° that has nothing to do with this quadrilateral.
14. (b) 31.4 cm — Circumference = π × diameter, so 3.14 × 10 = 31.4 cm. 15.7 cm comes from using the radius, 5 cm, in place of the diameter: 3.14 × 5 = 15.7, which is only half the circumference. 78.5 cm comes from using the area formula π × radius² instead of the circumference formula: 3.14 × 5² = 3.14 × 25 = 78.5. 62.8 cm comes from keeping the 2 from the radius form of the formula, C = 2 × π × radius, but putting the full diameter into it: 2 × 3.14 × 10 = 62.8.
15. (d) 60° — Method: the six angles at the centre together make one complete turn of 360°, and because the hexagon is regular they are all equal, so divide 360° by 6. Working: 360 ÷ 6 = 60. Answer: 60°. The distractors: 120° is the interior angle of a regular hexagon, 720 ÷ 6, which is the angle at a vertex and not the angle at the centre; 45° comes from dividing 360 by 8, treating the hexagon as though it had eight sides; 30° comes from halving the angle at the centre, as though each of the six triangles were split again by a line of symmetry.
16. (a) Reflex + non-reflex angle BOD = 360°, so 2a + 2c = 360°. — A correct proof must build in a strictly logical order: the reflex and non-reflex angles at O, which together make a complete turn about the centre, must be added to 360° before 2a and 2c can be combined and divided. The statement 'Reflex + non-reflex angle BOD = 360°, so 2a + 2c = 360°' is the only one that follows directly from having 2a and 2c already established, and it is exactly what is needed before the final division step. Jumping straight to 'Divide by 2 throughout to get a + c = 180°' skips the step that justifies why 2a + 2c equals 360° in the first place — there is nothing yet to divide. Repeating 'Angle BOD is 2a and 2c, by the centre theorem' does not move the proof forward at all, since that fact has already been established in the sentence given. Introducing 'OB = OD are radii, so triangle OBD is isosceles' brings in an unrelated triangle and an unrelated method that plays no part in this particular proof.
17. (a) 25° — PA and PB are tangents from the same external point, so PA = PB and OAPB is a kite with right angles at A and B, by the tangent–radius theorem: angle OAP = angle OBP = 90°. The four angles of the kite sum to 360°, so angle AOB = 360° − 90° − 90° − 50° = 130°. Triangle OAB is isosceles because OA = OB, both radii, so its base angles are equal: angle OAB = (180° − 130°) ÷ 2 = 25°. Using angle APB itself as the apex angle of triangle OAB instead of angle AOB gives (180° − 50°) ÷ 2 = 65°. Using a triangle's angle sum on the four-sided kite, and so counting only one of its two right angles, treats angle AOB as 180° − 90° − 50° = 40°, and halving what is then left of triangle OAB gives (180° − 40°) ÷ 2 = 70°. Finding angle AOB = 130° correctly but forgetting to halve for the isosceles base angle gives 180° − 130° = 50°. Halve that remaining angle, and 25° is what's left for angle OAB.
18. (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.