⭕ Circle theorems practice

Answer key

1. (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
2. (b) (2x + 10)° — By the angle at the centre theorem, angle ABC is half of angle AOC, because both stand on the same arc AC: angle ABC = (4x + 20)° ÷ 2 = (2x + 10)°. Writing down the centre angle itself, without halving at all, gives (4x + 20)°. Halving only the constant term and leaving the x-term unchanged gives (4x + 10)°. Doubling the centre angle instead of halving it gives (8x + 40)°. Halve every term in the expression, and (2x + 10)° is what you get.
3. (b) Minor segment — Method: compare the sizes of the two regions cut off by the chord, and recall the term used for the smaller one. Working: the chord creates two segments; the smaller region is called the minor segment and the larger one the major segment. A student who answers major segment has picked the larger region by mistake instead of the smaller one. A student who answers minor arc has named the curved boundary rather than the two-dimensional region it encloses. A student who answers semicircle has wrongly assumed the chord must pass through the centre. Answer: minor segment.
4. (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
5. (d) Concentric circles — Method: focus on what the two circles have in common — their centre, not their size. Working: both circles share exactly the same centre point but have different radii, which is the defining feature of this pair of circles. A student who answers congruent circles has confused 'same centre' with 'same size', but congruent circles simply have equal radii and need not share a centre. A student who answers tangential circles has confused circles that touch each other at one point with ones that share a centre. A student who answers similar circles has used the general term for the same shape at different sizes, missing the specific 'same centre' fact. Answer: concentric circles.
6. (b) 13 — Using the sum of interior angles formula, (n − 2) × 180° = 1980°, so n − 2 = 1980 ÷ 180 = 11, and n = 11 + 2 = 13. 11 stops after the division, forgetting to add 2 back to find n. 15 adds 2 twice by mistake, giving 11 + 2 + 2. 22 divides 1980 by 90 instead of 180.
7. (d) 77 — Method: angles that meet at a point add up to 360°. Working: 82 + 105 + 96 = 283; 360 − 283 = 77. Answer: 77°. A candidate who gives the sum of the three known angles and forgets to subtract it from 360° gets 283. A candidate who leaves out the 105° angle, working out 360 − 82 − 96, gets 182. A candidate who leaves out the 82° angle, working out 360 − 105 − 96, gets 159.
8. (a) 225 — Method: find the interior angle of the regular octagon, then subtract it from 360° to find the reflex angle at the same vertex, since the interior angle and the reflex angle together make a full turn. Working: there are 8 − 2 = 6 triangles' worth of angle in the octagon, so the interior angle = 6 × 180 ÷ 8 = 135; reflex angle = 360 − 135 = 225. Answer: 225°. A candidate who stops after finding the interior angle gives 135. A candidate who works out the exterior angle instead, 360 ÷ 8 = 45, gives 45. A candidate who subtracts the exterior angle from 360° instead of the interior angle, working out 360 − 45, gets 315.
9. (c) 72° — Method: opposite angles in a cyclic quadrilateral always sum to 180°. Working: angle DAB and angle BCD are opposite angles of the cyclic quadrilateral ABCD, so angle BCD = 180 − 108 = 72 degrees. Answer: 72°. Opposite angles in a cyclic quadrilateral are SUPPLEMENTARY, not equal, so do not simply copy the given angle; and do not subtract from 360°, which is the rule for angles round a point, or confuse this with the angle-in-a-semicircle theorem, which gives a fixed 90° that has nothing to do with this quadrilateral.
10. (b) 80° — Method: opposite angles of a cyclic quadrilateral sum to 180°, so form and solve an equation for x, then substitute back to find angle DAB. Working: (2x + 10) + (3x − 5) = 180, so 5x + 5 = 180, x = 35, and angle DAB = 2(35) + 10 = 80°. Using 360° instead of 180° as the total (as if the two angles were the whole circle rather than a pair of opposite angles) gives x = 71 and angle DAB = 152°; solving correctly for x but reporting x itself instead of substituting it back into 2x + 10 gives 35°; and mishandling the signs when combining the two expressions, using (2x + 10) + (3x + 5) = 180 instead of (2x + 10) + (3x − 5) = 180, gives x = 33 and angle DAB = 76°. Opposite angles of a cyclic quadrilateral — not adjacent ones — are the pair that sums to 180°.
11. (a) 1260° — The sum of the interior angles of a polygon with n sides is (n − 2) × 180°. For a nonagon, n = 9, so the sum is (9 − 2) × 180° = 7 × 180° = 1260°. 1620° uses 9 × 180° without subtracting 2 from n first. 140° is the size of a single interior angle of a regular nonagon (1260° ÷ 9), not the sum of all nine. 1440° uses (n − 1) × 180° = 8 × 180° instead of (n − 2) × 180°.
12. (c) chord — A diameter is a straight line joining two points on the circle that happens to pass through the centre. The general term for any straight line joining two points on a circle is a chord — every diameter is a chord, but not every chord is a diameter. Calling it a radius is wrong because a radius runs from the centre to just ONE point on the circle, not between two points on the circle. A tangent touches the circle at only one point, so it cannot be a diameter at all. An arc is a curved part of the circle's edge, not a straight line.
13. (a) 68° — Method: a tangent meets a radius at 90°, so quadrilateral OAPB has two right angles at A and B; its four angles sum to 360°, so angle APB = 360° − 90° − 90° − angle AOB. Working: angle APB = 360° − 90° − 90° − 112° = 68°. Halving angle AOB, confusing this with the angle-at-centre theorem for a chord, gives 56°; assuming the angle between two tangents is always 90° (true only for the angles at A and B, not at P) gives 90°; and assuming angle APB simply equals angle AOB by symmetry gives 112°. The two right angles at A and B, from the tangent-radius property, are what link angle AOB and angle APB.
14. (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
15. (d) tangent — A line that touches a circle at exactly one point, without crossing into the circle, is called a tangent. A chord is a straight line joining two points ON the circle, so it touches at two points, not one. A radius runs from the centre to the circle's edge, not along the outside of it. A diameter is a chord that passes through the centre, also touching the circle at two points.
16. (a) 104° — Method: find each inscribed angle separately using the angle-at-the-centre theorem: for a point on the arc NOT cut off by the given central angle, halve that central angle; for a point on the OTHER arc, halve the REFLEX central angle instead; then subtract the smaller from the larger. Working: for C on the major arc, angle ACB = 76 ÷ 2 = 38 degrees. For D on the minor arc, D sees the reflex angle at the centre, 360 − 76 = 284 degrees, so angle ADB = 284 ÷ 2 = 142 degrees. The difference is 142 − 38 = 104 degrees. Answer: 104°. Both inscribed angles need the theorem applied separately, using the correct arc's central angle each time (the reflex angle for D), and the question asks for the DIFFERENCE between the two, not either angle on its own and not their sum, 180°, which is simply the opposite-angle total for the cyclic quadrilateral ACBD.
17. (d) Opposite angles in a cyclic quadrilateral sum to 180° — ABCD is a cyclic quadrilateral, and angle ABC and angle ADC are a pair of opposite angles in it — they don't sit next to each other around the quadrilateral. The theorem that fixes the sum of a cyclic quadrilateral's opposite angles at 180° is exactly the one needed here. The other three theorems don't apply to this figure at all: the angle-in-a-semicircle theorem gives a 90° angle only when one side is a diameter, and no diameter is mentioned; the angle-at-the-centre theorem needs a centre point and an inscribed angle on the same arc, and no centre is given here; the tangent–radius theorem gives a 90° angle only where a tangent line touches the circle, and there is no tangent in this figure. Only the cyclic-quadrilateral theorem fits what is actually drawn.
18. (c) 140° — Method: OAPB is a quadrilateral whose angles sum to 360°; the tangent-radius angles at A and B are each 90°, and angle APB is given, so angle AOB is whatever is left. Working: angle OAP = angle OBP = 90°, so angle AOB = 360 − 90 − 90 − 40 = 140 degrees. Answer: 140°. Both tangent-radius angles are 90° each and must both be subtracted, not just one, and the quadrilateral's angles sum to 360°, not 180°: do not assume angle AOB simply matches angle APB, which is a different angle in a different part of the figure.