⭕ Circle theorems practice

Answer key

1. (b) 128° — Angle AOC and angle ABC stand on the same arc AC (the minor arc, which does not contain B), so by the angle at the centre theorem angle ABC = 104° ÷ 2 = 52°. ABCD is a cyclic quadrilateral, so its opposite angles ABC and ADC sum to 180°: angle ADC = 180° − 52° = 128°. A candidate who finds angle ABC = 52° correctly but then treats opposite angles as equal, as in a parallelogram, instead of supplementary, writes down 52° and stops there. Skipping the halving step and using 104° as angle ABC gives 180° − 104° = 76°. Reading off the given centre angle itself as the final answer, without applying either theorem, gives 104°. Work through both theorems in order and you land on 128°.
2. (b) 63° — Method: a tangent meets the radius drawn to the point of contact at a right angle, so triangle OPT has a 90° angle at T; the three angles of the triangle then sum to 180°. Working: angle OTP = 90°, angle OPT = 27°, so angle POT = 180 − 90 − 27 = 63 degrees. Answer: 63°. The tangent-radius angle is a fixed 90°, not something to assume equal to another angle in the triangle, and the three angles of ANY triangle sum to 180°, never 360°: that total belongs to a quadrilateral, not a triangle.
3. (c) 1/4 — A full turn at the centre of a circle is 360°, so a sector's fraction of the circle is its angle divided by 360°: 90 ÷ 360 = 1/4. 1/2 would be the fraction for a sector with an angle of 180°, not 90°. 3/4 is the fraction of the rest of the circle, the major sector left over from the 270° that is not part of this sector. 1/8 would be the fraction for a sector with an angle of 45°, half of 90°.
4. (c) chord — A diameter is a straight line joining two points on the circle that happens to pass through the centre. The general term for any straight line joining two points on a circle is a chord — every diameter is a chord, but not every chord is a diameter. Calling it a radius is wrong because a radius runs from the centre to just ONE point on the circle, not between two points on the circle. A tangent touches the circle at only one point, so it cannot be a diameter at all. An arc is a curved part of the circle's edge, not a straight line.
5. (b) (2x + 10)° — By the angle at the centre theorem, angle ABC is half of angle AOC, because both stand on the same arc AC: angle ABC = (4x + 20)° ÷ 2 = (2x + 10)°. Writing down the centre angle itself, without halving at all, gives (4x + 20)°. Halving only the constant term and leaving the x-term unchanged gives (4x + 10)°. Doubling the centre angle instead of halving it gives (8x + 40)°. Halve every term in the expression, and (2x + 10)° is what you get.
6. (b) 160° — B is on the minor arc AC, so the angle at the centre theorem applies to the reflex angle AOC: reflex angle AOC = 2 × 100° = 200°. The non-reflex angle AOC is the rest of the full turn: 360° − 200° = 160°. Reporting the reflex angle itself, without subtracting it from 360°, gives 200°. Subtracting angle ABC from 180° instead, as if this were a cyclic quadrilateral, gives 80°. Halving angle ABC instead of doubling it gives 50°. Double first, then take the angle away from a full turn, and 160° is what's left.
7. (c) 68° — Since PA and PB are both tangents from the external point P, PA = PB, so triangle PAB is isosceles with equal base angles at A and B. The angles of triangle PAB sum to 180°, so angle PAB + angle PBA = 180° − 44° = 136°, and since the two base angles are equal, angle PAB = 136° ÷ 2 = 68°. Angle PAB is the angle between the tangent at A and the chord AB, so by the alternate segment theorem it equals the angle in the alternate segment, angle ACB = 68°. Using angle APB directly as angle ACB, without using the isosceles triangle to find angle PAB first, gives 44°. Halving angle APB directly, rather than subtracting it from 180° before halving, gives 22°. Finding 180° − 44° = 136° correctly but forgetting to divide by 2 for one base angle leaves 136°.
8. (d) Concentric circles — Method: focus on what the two circles have in common — their centre, not their size. Working: both circles share exactly the same centre point but have different radii, which is the defining feature of this pair of circles. A student who answers congruent circles has confused 'same centre' with 'same size', but congruent circles simply have equal radii and need not share a centre. A student who answers tangential circles has confused circles that touch each other at one point with ones that share a centre. A student who answers similar circles has used the general term for the same shape at different sizes, missing the specific 'same centre' fact. Answer: concentric circles.
9. (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
10. (a) 80° — In triangle ABD, the three angles sum to 180°: angle BAD = 180° − 35° − 65° = 80°. ABCD is a cyclic quadrilateral, so the exterior angle at C, angle BCE, is equal to the interior angle at the opposite vertex, angle BAD: angle BCE = 80°. Adding the two given angles in triangle ABD instead of subtracting them from 180°, 35° + 65° = 100°, and then applying the exterior-angle rule correctly still gives the wrong angle BAD and so the wrong exterior angle, 100°. Halving the correct angle BAD, 80° ÷ 2 = 40°, confuses the exterior-angle rule with a different circle theorem in which one angle is half of another. Doubling it instead, 80° × 2 = 160°, makes the same kind of confusion in the other direction.
11. (b) 35° — Method: angle CBE and angle ABC lie on a straight line at B, so they are supplementary; angle ABC then equals angle ADC because B and D are both on the major arc AC (angles in the same segment). Working: angle ABC = 180 − 145 = 35 degrees, using angles on a straight line. Since B and D are both on the major arc AC, angle ADC = angle ABC = 35°. Answer: 35°. Find angle ABC FIRST from the straight line at B before applying the circle theorem: using the given 145° directly, doubling or halving it, or subtracting it from 180° a second time all give the wrong angle.
12. (c) 32 — Method: alternate angles between parallel lines are equal, so 2x + 10 = 74. Working: subtracting 10 from both sides gives 2x = 64; dividing by 2 gives x = 32. Answer: x = 32. A candidate who forgets to subtract 10 first and divides 74 by 2 directly gets 37. A candidate who treats the angles as co-interior instead of alternate, so that the two expressions add to 180° rather than being equal, gets 48 after solving. A candidate who makes a sign error and treats the equation as 2x equalling 10 minus 74 instead of 74 minus 10 gets −32.
13. (b) 31.4 cm — Circumference = π × diameter, so 3.14 × 10 = 31.4 cm. 15.7 cm comes from using the radius, 5 cm, in place of the diameter: 3.14 × 5 = 15.7, which is only half the circumference. 78.5 cm comes from using the area formula π × radius² instead of the circumference formula: 3.14 × 5² = 3.14 × 25 = 78.5. 62.8 cm comes from keeping the 2 from the radius form of the formula, C = 2 × π × radius, but putting the full diameter into it: 2 × 3.14 × 10 = 62.8.
14. (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
15. (a) 46° — Method: use the angle at the centre, then the cyclic quadrilateral, then the angle sum of a triangle. Working: angle ABC = 152° ÷ 2 = 76° (angle at the centre is twice the angle at the circumference); angle ADC = 180° − 76° = 104° (opposite angles of a cyclic quadrilateral sum to 180°); angle DAC = 180° − 104° − 30° = 46° (angle sum of triangle ACD). Skipping the halving step and taking angle ABC = 152° gives angle ADC = 180° − 152° = 28° and then angle DAC = 122°; using angle ABC = 76° directly as angle ADC, skipping the cyclic quadrilateral step, gives 74°; and finding angle DAC as 180° − 104° without subtracting the given 30° gives 76°. Each of the three steps must be carried through in order — halve, then subtract from 180°, then subtract from 180° again with the extra angle.
16. (a) 49° — Method: an exterior angle of a triangle equals the sum of the two interior angles that are not next to it, which here are the angles at A and at C; since those two are equal, the exterior angle is twice the angle at A. Working: 2 × angle A = 98, so angle A = 98 ÷ 2 = 49. Answer: 49°. The distractors: 82° is the interior angle at B, 180 − 98, given in place of the angle at A; 41° comes from finding that interior angle of 82° and halving it, 82 ÷ 2, instead of halving the exterior angle; 98° comes from taking the exterior angle to be equal to the angle at A on its own, with no halving at all.
17. (c) Tangent-chord angle = angle in the alternate segment. — This diagram has a diameter AC, a centre O, and a cyclic quadrilateral ABCD, but no tangent anywhere in it. 'Angle in a semicircle = 90°' applies directly, because AC is a diameter. 'Opposite angles of a cyclic quadrilateral sum to 180°' applies directly, because ABCD is a cyclic quadrilateral. 'Angle at the centre = twice angle at circumference' applies directly, because O is given as the centre of the circle. The tangent-chord fact relates the angle between a tangent and a chord to an angle elsewhere in the circle, and since this diagram has no tangent, there is nothing in it for that fact to describe — so it is the one theorem that does not apply here.
18. (b) Minor segment — Method: compare the sizes of the two regions cut off by the chord, and recall the term used for the smaller one. Working: the chord creates two segments; the smaller region is called the minor segment and the larger one the major segment. A student who answers major segment has picked the larger region by mistake instead of the smaller one. A student who answers minor arc has named the curved boundary rather than the two-dimensional region it encloses. A student who answers semicircle has wrongly assumed the chord must pass through the centre. Answer: minor segment.