⭕ Circle theorems practice

Answer key

1. (a) 225 — Method: find the interior angle of the regular octagon, then subtract it from 360° to find the reflex angle at the same vertex, since the interior angle and the reflex angle together make a full turn. Working: there are 8 − 2 = 6 triangles' worth of angle in the octagon, so the interior angle = 6 × 180 ÷ 8 = 135; reflex angle = 360 − 135 = 225. Answer: 225°. A candidate who stops after finding the interior angle gives 135. A candidate who works out the exterior angle instead, 360 ÷ 8 = 45, gives 45. A candidate who subtracts the exterior angle from 360° instead of the interior angle, working out 360 − 45, gets 315.
2. (c) 90° — A tangent to a circle always meets the radius drawn to the point of contact at a right angle, so the angle between the tangent and the radius at P is 90°. 180° confuses the tangent with the diameter through P, as if the radius continued in a straight line into the tangent. 45° halves the true angle by mistake. 60° comes from confusing this fact with the angle of an equilateral triangle.
3. (b) Minor segment — Method: compare the sizes of the two regions cut off by the chord, and recall the term used for the smaller one. Working: the chord creates two segments; the smaller region is called the minor segment and the larger one the major segment. A student who answers major segment has picked the larger region by mistake instead of the smaller one. A student who answers minor arc has named the curved boundary rather than the two-dimensional region it encloses. A student who answers semicircle has wrongly assumed the chord must pass through the centre. Answer: minor segment.
4. (b) It is the longest of the three chords — Method: in any circle the length of a chord is decided by how far the chord lies from the centre, because a chord passing nearer the centre cuts further across the circle. Working: the chord through O lies at a distance of zero from the centre, and no chord can lie closer than that, so no chord of the circle can be longer than it; a chord through the centre is a diameter. The other two chords lie at some distance greater than zero, so each of them falls short of that maximum. Answer: It is the longest of the three chords. The distractors: It is the shortest of the three chords comes from reversing the rule and picturing a chord near the centre as a short line tucked inside; It is the same length as the other two chords comes from carrying the fact that all radii of a circle are equal across to chords, which are not all equal; It is half the length of each of the other two chords comes from confusing a chord through the centre with a radius, which really is half a diameter.
5. (b) 61° — Triangle OAT is isosceles because OA = OT, both radii, so its base angles are equal: angle OTA = angle OAT = (180° − 122°) ÷ 2 = 29°. The tangent PT meets the radius OT at 90°, by the tangent–radius theorem, so angle OTP = 90°. Since TA lies between TO and TP, angle OTP splits into angle OTA and angle ATP: angle ATP = 90° − 29° = 61°. Stopping after the isosceles step and reporting the base angle itself gives 29°. Finding the base angles as 180° − 122° without halving, then subtracting from 90°, gives 90° − 58° = 32°. Adding the base angle to 90° instead of subtracting it gives 90° + 29° = 119°. Subtract the base angle from the right angle, and 61° is what's left.
6. (a) 60° — Method: the angles of a triangle add up to 180°, so add the three expressions, solve for x and then substitute back into the expression for angle B. Working: 2x + 3x + 4x = 9x, so 9x = 180 and x = 20. Angle B is 3x, so angle B = 3 × 20 = 60. Answer: 60°. The distractors: 20° is the value of x, from stopping as soon as the equation is solved instead of substituting back; 120° comes from using 360° as the angle sum, which gives x = 40 and 3x = 120; 80° is 4x, the angle at C, from substituting into the wrong expression.
7. (a) 71° — Method: first use the straight line through T to find the tangent-chord angle RTC, then apply the alternate segment theorem, which states that this angle equals the angle subtended by the chord in the alternate segment. Working: the two rails form a straight line through T, so angle RTC = 180 − 109 = 71 degrees. D lies in the alternate segment of the chord TC, so angle TDC = angle RTC = 71°. Answer: 71°. Find angle RTC FIRST from the straight line before applying the theorem: using the given 109° directly, doubling the tangent-chord angle, or taking its complement from 90° all give the wrong angle at D.
8. (b) 13 — Using the sum of interior angles formula, (n − 2) × 180° = 1980°, so n − 2 = 1980 ÷ 180 = 11, and n = 11 + 2 = 13. 11 stops after the division, forgetting to add 2 back to find n. 15 adds 2 twice by mistake, giving 11 + 2 + 2. 22 divides 1980 by 90 instead of 180.
9. (a) 46° — Method: use the angle at the centre, then the cyclic quadrilateral, then the angle sum of a triangle. Working: angle ABC = 152° ÷ 2 = 76° (angle at the centre is twice the angle at the circumference); angle ADC = 180° − 76° = 104° (opposite angles of a cyclic quadrilateral sum to 180°); angle DAC = 180° − 104° − 30° = 46° (angle sum of triangle ACD). Skipping the halving step and taking angle ABC = 152° gives angle ADC = 180° − 152° = 28° and then angle DAC = 122°; using angle ABC = 76° directly as angle ADC, skipping the cyclic quadrilateral step, gives 74°; and finding angle DAC as 180° − 104° without subtracting the given 30° gives 76°. Each of the three steps must be carried through in order — halve, then subtract from 180°, then subtract from 180° again with the extra angle.
10. (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
11. (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
12. (d) 13 — Method: OP and PQ meet at a right angle because of the tangent–radius fact, so triangle OPQ is right-angled at P; use Pythagoras' theorem. Working: OQ² = OP² + PQ² = 5² + 12² = 25 + 144 = 169; OQ = √169 = 13. A student who answers 17 has simply added the two given lengths (5 + 12) instead of using Pythagoras' theorem. A student who answers 7 has subtracted the two given lengths (12 − 5) instead of using Pythagoras' theorem. A student who answers 144 has correctly squared 12 but stopped there, forgetting to add 5² and take the square root. Answer: 13 cm.
13. (b) (2x + 10)° — By the angle at the centre theorem, angle ABC is half of angle AOC, because both stand on the same arc AC: angle ABC = (4x + 20)° ÷ 2 = (2x + 10)°. Writing down the centre angle itself, without halving at all, gives (4x + 20)°. Halving only the constant term and leaving the x-term unchanged gives (4x + 10)°. Doubling the centre angle instead of halving it gives (8x + 40)°. Halve every term in the expression, and (2x + 10)° is what you get.
14. (d) The angle between a tangent and a radius is 90° — OP is the radius drawn to the point of contact P, and a circle theorem states that a tangent always meets that radius at a right angle, so angle OPQ = 90°. A tangent is not parallel to the radius it touches — at the point of contact it is perpendicular to that radius, not parallel to it. A tangent does not pass through the centre — a straight line through the centre that also touches the circle at one point would have to be a diameter, which is a different line entirely. The angle-in-a-semicircle theorem needs a triangle drawn inside the circle with a diameter as its longest side; there is no such triangle here, just a tangent and a radius.
15. (c) VW — Method: within one circle a chord's distance from the centre is fixed by its length, because a chord passing nearer the centre cuts further across the circle; so the chord that lies closest to the centre is simply the longest one listed. Working: the four lengths are 6 cm, 10 cm, 14 cm and 15 cm. Placing them in order, the greatest is 15 cm, and that length belongs to VW, so VW lies closest to the centre. Answer: VW. The distractors: PQ comes from reversing the rule and taking the shortest chord to be the one tucked nearest the centre; TU comes from knowing that the very longest chord is a diameter, deciding that such a chord passes through the centre rather than lying close to it, ruling the 15 cm chord out on that ground and taking the next longest; RS comes from reading 'closest to the centre' as 'nearest the middle of the list of lengths' and picking a middling value.
16. (a) 105° — The interior angles of a pentagon add up to (5 − 2) × 180° = 540°. Subtracting the three known angles, 540 − 100 − 110 − 120 = 210°, and this 210° is shared equally between the two angles marked x°, so each one is 210 ÷ 2 = 105°. 210° stops one step early, giving the total of the two unknown angles instead of one of them. 108° is the interior angle of a regular pentagon, which does not apply here since this pentagon's angles are not all equal. 55° comes from halving one of the given angles, 110°, instead of halving the remaining total.
17. (b) Yes — OA = OC (radii), so the base angles are equal. — Method: check the definition of a radius and the isosceles triangle property the step relies on. Working: every radius of a circle has the same length, so OA = OC regardless of where A and C sit on the circle — this alone makes triangle OAC isosceles, and the base angles opposite the two equal sides, angle OAC and angle OCA, must be equal. The verdict is Yes, for exactly that reason. Claiming OA and OC are only equal if they are drawn to 'the very same point' misunderstands what a radius is — A and C can be any two points on the circle and OA still equals OC. Claiming the triangle is isosceles because angle AOC is 90° reverses the logic: nothing in the step has fixed angle AOC at 90°, and even if it had, that alone would not explain why OA = OC. Claiming the triangle would need to be equilateral confuses isosceles (two equal sides) with equilateral (three equal sides) — only two sides, OA and OC, are being compared here.
18. (a) 68° — Method: a tangent meets a radius at 90°, so quadrilateral OAPB has two right angles at A and B; its four angles sum to 360°, so angle APB = 360° − 90° − 90° − angle AOB. Working: angle APB = 360° − 90° − 90° − 112° = 68°. Halving angle AOB, confusing this with the angle-at-centre theorem for a chord, gives 56°; assuming the angle between two tangents is always 90° (true only for the angles at A and B, not at P) gives 90°; and assuming angle APB simply equals angle AOB by symmetry gives 112°. The two right angles at A and B, from the tangent-radius property, are what link angle AOB and angle APB.