⚖️ Foundation to Higher crossover check

Answer key

1. (b) 75 g — Method: split the total mass into the number of parts shown by the ratio, then find the mass of tin. Working: the ratio 7:3 has 7 + 3 = 10 parts, so one part is 250 ÷ 10 = 25 g, and the mass of tin is 3 × 25 = 75 g. So the alloy contains 75 g of tin. Distractor 175 g is the mass of copper, not tin. Distractor 125 g comes from splitting the alloy into two equal halves, ignoring the ratio. Distractor 25 g is the value of one part, found correctly but never multiplied by 3.
2. (d) 2x = 10 — Method: collect the x-terms on one side and the constants on the other, keeping the equals sign balanced. Working: 5x − 3x = 8 + 2, giving 2x = 10. Answer: 2x = 10. 2x = 6 comes from a sign error moving the constant, subtracting instead of adding: 8 − 2 = 6. 8x = 6 comes from adding the x-terms instead of subtracting them (5x + 3x = 8x), alongside the constant sign error. 2x = −10 comes from a sign error moving the constant the other way: −2 − 8 = −10.
3. (c) £672 — Simple interest per year = 3% of £600 = £18. Over 4 years the interest is 18 × 4 = £72. Total in the account = £600 + £72 = £672. A student who gives just the interest, without adding it to the principal, writes £72. A student who adds only one year's interest instead of four gets £600 + £18 = £618. A student who wrongly compounds the interest each year gets 600 × 1.03⁴ = £675.31.
4. (c) y = −x + 30 — Method: in a linear model the value at the start is the constant term and the steady rate of change is the gradient, which is negative when the quantity is falling. Working: at x = 0 the candle is 30 cm tall, so the constant term is 30; it loses 1 cm every hour, so the gradient is −1 and the height after x hours is y = −x + 30. Answer: y = −x + 30. The distractors: y = x + 30 comes from taking the rate as +1 and making the candle grow rather than shrink; y = 30x − 1 comes from building the model correctly as 30 − 1x and then copying it into the form y = mx + c with the two numbers left where they stood, so the starting height 30 ends up multiplying x and the hourly 1 is left behind as the constant being taken away; y = −30x + 1 comes from reading the two numbers the other way round, taking 30 cm per hour as the rate and 1 cm as the starting height, which burns 30 cm an hour from a candle only 1 cm tall.
5. (d) x² − 49 — Area = length × width = (x + 7)(x − 7). Expanding: x × x = x², x × (−7) = −7x, 7 × x = 7x, 7 × (−7) = −49. The two middle terms −7x and 7x cancel, leaving x² − 49. A candidate who misremembers the difference-of-two-squares result as a sum gets x² + 49. A candidate who makes a sign error and treats both middle terms as −7x instead of cancelling gets x² − 14x − 49. A candidate who confuses area with perimeter and simply adds the length and width gets 2x.
6. (c) 12 m — Method: the perimeter of a rectangle is twice the sum of the length and the width, so half the perimeter is one length plus one width; split that half using the ratio. Working: half of 64 is 64 ÷ 2 = 32 m, the ratio 5:3 has 5 + 3 = 8 parts, so one part is 32 ÷ 8 = 4 m, and the width is 3 × 4 = 12 m. So the width is 12 m. Distractor 20 m is the length, 5 parts, not the width. Distractor 24 m comes from splitting the whole perimeter, 64 m, into 8 parts and multiplying by 3, forgetting to halve the perimeter first. Distractor 8 m comes from the same slip stopped one step earlier: splitting the whole perimeter into 8 parts, 64 ÷ 8 = 8, and giving that instead of the width.
7. (c) tan θ = opposite/adjacent — The tangent ratio is defined as tan θ = opposite/adjacent, so this is the ratio that connects the opposite and adjacent sides. "sin θ = opposite/adjacent" wrongly labels this ratio as sine, when sine actually connects the opposite side and the hypotenuse. "cos θ = opposite/adjacent" wrongly labels it as cosine, when cosine connects the adjacent side and the hypotenuse. "tan θ = adjacent/opposite" uses the correct ratio name but has the opposite and adjacent sides the wrong way round.
8. (d) Line 3 — Method: check each line of Chloe's working against the correct algebraic step. Working: Line 1 to Line 2 is correct, subtracting 2x from both sides gives 3x − 4 = 8. But Line 2 to Line 3 should add 4 to both sides, giving 3x = 12, not 3x = 4 — the constant −4 has been dropped rather than removed correctly. Line 4 follows correctly from Chloe's own, incorrect, Line 3. Answer: Line 3. Line 1 is simply the original equation, copied out correctly. Line 2 correctly subtracts 2x from both sides of Line 1. Line 4 divides Chloe's own Line 3 by 3 correctly — the arithmetic there is fine, the mistake happened one line earlier.
9. (a) 6b − 5 — Method: sort the expression into terms in b and number terms, then collect each kind, keeping the sign in front of every term. Working: the b terms give 2b + 2b + 2b = 6b; the number terms are −1 and −4, and −1 − 4 = −5. Answer: 6b − 5. The distractors: 6b − 3 comes from working out the difference 4 − 1 instead of adding two negative numbers; 6b + 5 comes from adding 1 and 4 while ignoring both minus signs; 8b − 5 comes from multiplying the coefficients 2, 2 and 2 instead of adding them.
10. (c) y = 200 − 8x — Method: in a linear model the amount present at the start is the constant term and the steady rate of change is the gradient, which is negative because the amount is falling. Working: at x = 0 minutes there are 200 litres, so the constant term is 200; 8 litres are lost every minute, so after x minutes 8x litres have gone and the amount left is y = 200 − 8x. Answer: y = 200 − 8x. The distractors: y = 8x + 200 treats the draining as filling, so the butt would gain 8 litres a minute; y = 200x − 8 swaps the two numbers over, using the starting 200 litres as the rate per minute and the 8 litres per minute as the starting amount; y = −8x − 200 makes the starting amount negative as well as the rate, so the butt would begin 200 litres in deficit.
11. (a) 30 — Method: an outlier is a value that lies far away from the pattern set by the rest of the data, so compare each value with the group the others form. Working: five of the counts, 5, 7, 8, 9 and 11, lie within 6 of one another and the steps between them are 2, 1, 1 and 2; the remaining count of 30 is 19 above the nearest of them, so it is the value that does not belong to the pattern. Answer: 30. The distractors: 5 comes from picking the smallest value, on the idea that the odd one out must be at the bottom of the list; 11 comes from ordering the data and stopping one value short, taking the largest of the counts that sit close together; 8.5 comes from working out the median, (8 + 9) ÷ 2, and giving a measure of centre where a value standing apart was asked for.
12. (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
13. (a) 20% — Method: a percentage is a number of parts per hundred, so divide the numerator by the denominator and multiply by 100. Working: 1 ÷ 5 = 0.2, and 0.2 × 100 = 20; the same result comes from scaling 1/5 to 20/100. Answer: 20%. The distractors: 5% comes from reading the denominator 5 straight off as the percentage; 25% comes from confusing 1/5 with 1/4, the fraction met most often in percentage work; 50% comes from a place value slip in the division, writing 1 ÷ 5 as 0.5 instead of 0.2.
14. (b) 12 — The difference between the parts of the ratio is 5 − 2 = 3 parts, and this is worth 18. Divide to find one part: 18 ÷ 3 = 6. Cats have 2 parts: 2 × 6 = 12. (30 is the number of dogs, using 5 parts instead of 2. 6 is the value of one part — the number of cats is 2 lots of this, not just one. 9 comes from dividing 18 by 2 and stopping there, instead of dividing by the difference in parts, 3, and then multiplying by 2.)
15. (c) The mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3. — Method: work each measure out before the extra value is added and again afterwards, then compare the size of the two changes. Working: before, the six values total 42, so the mean is 42 ÷ 6 = 7, and the middle pair 6 and 8 give a median of (6 + 8) ÷ 2 = 7; after, the seven values total 142, so the mean is 142 ÷ 7 = 20.29 to 2 decimal places, while the median is now the 4th of the seven ordered values, which is 8; the mean has moved by about 13.3 and the median by 1. Answer: the mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3 — this is why the median is often preferred when a data set contains an outlier. The distractors: the reply that the mean rises by 100 adds the extra value to the mean instead of adding it to the total; the reply that the median moves to 12 takes the largest of the original values as the new middle instead of counting to the 4th of the seven values; the reply about even and odd counts quotes a rule that does not exist, since the median moved because a very large value was added, not because the count of values changed.
16. (a) 3/8, 41%, 0.43 — Method: convert every value to a decimal so they can be compared on the same scale, then order them. Working: 3/8 = 0.375, 41% = 0.41, and 0.43 stays as 0.43, so from smallest to largest the decimals are 0.375, 0.41, 0.43, giving the order 3/8, 41%, 0.43. Answer: 3/8, 41%, 0.43. The order 3/8, 0.43, 41% comes from comparing 0.43 and 41% as raw digits (43 versus 41) without converting 41% into the decimal 0.41 first, wrongly placing 0.43 before 41%. The order 0.43, 41%, 3/8 comes from placing the values in completely reversed order, from largest to smallest instead of smallest to largest. The order 41%, 0.43, 3/8 comes from ordering the values by their TYPE (percentage, then decimal, then fraction) rather than by their actual size.
17. (b) −5 — Method: a point whose x-coordinate is 0 lies on the y-axis, so its y-coordinate is the constant c; once m and c are both known the equation can be written down and x substituted into it. Working: the line passes through (0, 1), so c = 1 and the equation is y = −3x + 1; substituting x = 2 gives y = −3 × 2 + 1 = −6 + 1 = −5. Answer: −5. The distractors: 7 comes from ignoring the minus sign on the gradient and working out 3 × 2 + 1; 5 comes from working out 3 × 2 = 6 and then using the minus sign to take the constant off the product, 6 − 1 = 5; −7 comes from subtracting the constant instead of adding it, −6 − 1 = −7.
18. (d) a² + b² = c² — Pythagoras' theorem states that the square of the hypotenuse equals the sum of the squares of the other two sides, so a² + b² = c². "a + b = c" adds the sides directly without squaring them at all. "a² − b² = c²" subtracts the squares instead of adding them. "a² + b² = c" adds the squares correctly but forgets to square the hypotenuse on the other side of the equation.
19. (b) 24 — Method: let one part of the ratio be worth x, write both groups in terms of x, and use the fact that the two groups end up equal. Working: the boys are 3x and the girls are 4x; after the 6 boys join, 3x + 6 = 4x, so x = 6; the girls are 4 parts, so 4 × 6 = 24. Answer: 24 girls. The distractors: 18 is the number of boys before the 6 join, which is 3 × 6; 30 comes from adding the 6 new members to the girls as well as to the boys; 42 is the total number of members in the choir before the 6 boys join, the 18 boys and the girls together.
20. (c) 150% — Percentage = (180,000 ÷ 120,000) × 100 = 150%.