🔺 Higher stretch — grade 8 and 9 topics

Answer key

1. (a) 1.36 — Method: put the starting value into the right-hand side to get x₁, feed that value back in to get x₂, and round only once the second value has been found. Working: x₁ = 5 ÷ (1 + 2) = 5 ÷ 3 = 1.66666…; x₂ = 5 ÷ (1.66666… + 2) = 5 ÷ 3.66666… = 1.36363…. The digit in the third decimal place is 3, so x₂ = 1.36 correct to 2 decimal places. Answer: 1.36. The distractors: 1.67 is x₁, the value after a single use of the formula, given by a candidate who counts the starting value itself as x₁; 1.49 is x₃ = 1.48648…, one use of the formula too many; 1.37 comes from writing x₁ down as 1.66, truncating the display instead of keeping it in full, and then working out 5 ÷ 3.66 = 1.36612…, which rounds up to 1.37.
2. (b) Translate −90° in x, then translate −2 in y. — cos(x + 90°) translates the graph 90° in the NEGATIVE x-direction, since a positive shift inside the bracket moves a graph left, not right, and subtracting 2 afterwards translates it 2 units in the negative y-direction (down). So the sequence is: translate −90° in x, then translate −2 in y. Using +90° in x reverses the direction of the horizontal shift — the sign inside the bracket moves the graph the opposite way to what it looks like. Using +2 in y reverses the direction of the vertical shift; subtracting 2 outside the function moves the graph down, not up. Describing the −2 as a reflection in the x-axis is wrong because a reflection turns positive y-values negative and vice versa, whereas here every y-value is simply reduced by the fixed amount 2, which is what a translation does, not a reflection.
3. (c) 1/56 — Method: for draws without replacement, multiply a chain of three fractions where both the numerator (reds remaining) and the denominator (counters remaining) fall by one after each draw. Working: P(all three red) = 3/8 × 2/7 × 1/6 = 6/336 = 1/56. Answer: 1/56. Watch out: using 3/8 for all three draws (27/512) treats the counters as if they were replaced each time. Reducing only the numerator each draw (3/8 × 2/8 × 1/8) forgets that the total number of counters left in the bag also falls. And reducing only the denominator while keeping the numerator at 3 each time (3/8 × 3/7 × 3/6) forgets that a red counter has actually left the bag.
4. (d) 36/91 — Method: P(both red | same colour) = P(both red) ÷ P(same colour), where P(same colour) = P(both red) + P(both green). Working: P(both red) = 9/20 × 8/19 = 72/380 = 18/95. P(both green) = 11/20 × 10/19 = 110/380 = 11/38. P(same colour) = 18/95 + 11/38 = 36/190 + 55/190 = 91/190. P(both red | same colour) = (36/190) ÷ (91/190) = 36/91. Answer: 36/91. Watch out: stopping at 18/95 gives P(both red) itself, without dividing by the probability that the colours matched at all. Working out 55/91 finds the same-colour probability for green instead of red — check which colour's count you are putting on top. And 9/20 is just the chance the first ball drawn is red, which ignores the second draw and the without-replacement condition completely.
5. (b) x² + y² = 625 — Since (7, 24) lies on the circle, x² + y² = 7² + 24² = 49 + 576 = 625, so the equation is x² + y² = 625. Choosing x² + y² = 31 adds the coordinates 7 and 24 directly instead of squaring them first. Choosing x² + y² = 576 uses only 24² and forgets to add 7². Choosing x² + y² = 49 uses only 7² and forgets to add 24².
6. (a) Outside: OQ² = 221 > r² = 169 — OQ² = 10² + 11² = 100 + 121 = 221. Comparing this with r² = 169: since 221 > 169, OQ > r, so Q lies outside the circle — this is the correct verdict AND the correct working. 'Outside: OQ = 21 (10 + 11) > r = 13' reaches the same Outside verdict, but by invalid working: it adds the coordinates instead of squaring them (10 + 11 = 21, rather than 10² + 11² = 221), so the stated 'OQ' of 21 is not a distance at all — the verdict happens to match, but the method is wrong. 'Inside: OQ ≈ 14.87 < r² = 169' correctly finds the distance OQ = √221 ≈ 14.87, but then compares that DISTANCE with r² = 169 instead of with r = 13 — comparing two different kinds of quantity gives a meaningless, and here wrong, verdict. 'Inside: OQ² = 221 < (2r)² = 676' confuses the radius with the diameter: it compares OQ² with the diameter squared, (2 × 13)² = 676, instead of with r² = 169.
7. (b) (0, 6) and (0, −6) — Method: every point on the y-axis has x-coordinate 0, so substitute x = 0 into the equation of the circle and solve for y, remembering that a square root has a negative value as well as a positive one. Working: putting x = 0 into x² + y² = 36 leaves y² = 36, so y = 6 or y = −6, and the two crossings are (0, 6) and (0, −6). Answer: (0, 6) and (0, −6). The distractors: (0, 36) and (0, −36) use 36 itself as the distance from the centre, which reads r² as r; (6, 0) and (−6, 0) are the right distance from the centre but are the crossings of the x-axis, found by setting y = 0 instead of x = 0; (0, 18) and (0, −18) halve 36, treating the right-hand side of the equation as a diameter.
8. (c) 76 — Method: the frequency of each class is the area of its bar, frequency density × class width, so work out all three frequencies and add them. Working: the widths are 5, 10 and 25 kg, so the frequencies are 4 × 5 = 20, 2.6 × 10 = 26 and 1.2 × 25 = 30; the total is 20 + 26 + 30 = 76. Answer: 76 dogs. The distractors: 7.8 comes from adding the three frequency densities, 4 + 2.6 + 1.2, treating each height as though it were a count; 107 comes from using each upper class boundary as the width, giving 4 × 5, 2.6 × 15 and 1.2 × 40; 39 comes from using the first class width, 5, for every bar, which ignores the unequal intervals and gives 20 + 13 + 6.
9. (a) (8, 2) — Method: translating a point by a column vector means adding the vector's top number to the x-coordinate and its bottom number to the y-coordinate. Working: x-coordinate 2 + 6 = 8; y-coordinate 5 + (−3) = 2. Answer: B = (8, 2). A candidate who ignores the negative sign and adds 3 instead of −3 gets (8, 8). A candidate who translates in the reverse direction, subtracting the vector from A instead of adding it, gets (−4, 8). A candidate who swaps the vector's top and bottom numbers before adding gets (−1, 11).
10. (d) −11/60 — The radius from the origin to (11, 60) has gradient 60/11. The tangent is perpendicular to this radius, so its gradient is the negative reciprocal: −1 ÷ (60/11) = −11/60. Choosing 60/11 uses the radius's gradient unchanged, without applying perpendicularity. Choosing −60/11 negates the radius's gradient but forgets to take its reciprocal. Choosing 11/60 takes the reciprocal correctly but keeps the gradient positive instead of negative.
11. (b) 1/3 — Method: the first sweet has already been taken and it was red, so work out the second probability from what is actually left in the bag. Working: one red sweet has gone, so 3 red sweets remain out of 9 sweets altogether, giving 3/9. Dividing the numerator and the denominator by 3 gives 1/3. Answer: the probability is 1/3. The distractors: 2/5 is 4/10, the probability for the first draw used again, which is only right if the first sweet is put back; 3/10 takes one off the red count but leaves the total at 10, updating half of the fraction; 4/9 takes one off the total but leaves the red count at 4, updating the other half of the fraction.
12. (a) y = 2ˣ + 3 — A translation of 3 units in the positive y-direction shifts the whole graph up, which means adding to the output: y = f(x) + k with k = 3, so the image is y = 2ˣ + 3. Adding the 3 inside the power instead of outside it, which translates the graph horizontally instead of vertically, gives y = 2ˣ⁺³. Using a negative 3, which moves the graph down instead of up, gives y = 2ˣ − 3. Mistaking 2ˣ for the linear expression 2x and adding 3 inside brackets gives y = 2(x + 3).
13. (b) (2, 6) — y = f(x − 3) translates y = f(x) horizontally by 3 units to the RIGHT — inside the brackets, subtracting moves the graph in the positive x-direction. Turning point (−1, 6) → (−1 + 3, 6) = (2, 6). The common slip is to move LEFT instead, since the sign inside the bracket is negative — that gives (−4, 6). Changing the y-coordinate instead of the x-coordinate, as in (−1, 3) or (−1, 9), treats this as a vertical shift, which y = f(x − 3) is not.
14. (c) 145 g — Method: find the position of the median from the total frequency, locate the class that contains it, then use linear interpolation inside that class, assuming the apples in it are spread evenly. Working: the median is the 100 ÷ 2 = 50th apple; the running totals are 10, then 10 + 30 = 40, then 40 + 40 = 80, so the 50th apple lies in the class 140 ≤ m < 160; it is the 50 − 40 = 10th of the 40 apples in that class, and the class is 20 g wide, so the median is 140 + (10 ÷ 40) × 20 = 140 + 5 = 145. Answer: an estimated median of 145 g. The distractors: 150 g comes from giving the midpoint of the class that contains the median instead of interpolating inside it; 140 g comes from stopping at the lower boundary of that class, which locates the class but not the value; 155 g comes from measuring the 5 g step down from the upper boundary, 160 − 5, instead of up from the lower boundary.
15. (b) 6 — Method: frequency density = frequency ÷ class width. Working: the class 12 ≤ h < 18 has width 18 − 12 = 6, so frequency density = 36 ÷ 6 = 6. Answer: the frequency density is 6 seedlings per cm. Watch which numbers you use: taking the lower bound, 12, as the width instead of 18 − 12 = 6 gives 36 ÷ 12 = 3; dividing the total number of seedlings, 90, rather than this class's frequency, 36, by the width gives 90 ÷ 6 = 15, a density that belongs to no single class; and multiplying instead of dividing gives 36 × 6 = 216, far too large a density for so narrow a class.
16. (a) 70 — Method: two linked steps. Find the expected number of billing calls first, then take the 35% of those, because the 35% is quoted for billing calls only. Working: 40% of 500 is 200 billing calls. 35% of 200 is 70 calls. Answer: you would expect 70 calls. The distractors: 200 stops after the first step and gives the billing calls, forgetting that only some of them are dealt with quickly; 175 is 35% of 500, applying the quick response rate to every call the centre takes rather than to the billing calls only; 375 comes from adding 40% and 35% to get 75% and taking 75% of 500, which treats two stages of one journey as separate outcomes to be added.
17. (d) line 2 — Line 1 correctly represents three consecutive integers using n. Line 2 adds them: n + (n + 1) + (n + 2). Collecting terms: the n-terms give 3n, and the constants give 1 + 2 = 3, so the correct sum is 3n + 3, not 3n + 2 as Line 2 states — this is the first error, an arithmetic slip in collecting the constant terms. Lines 3 and 4 both follow correctly from Line 2's incorrect result, but that result itself is wrong: the true sum, 3n + 3 = 3(n + 1), is a multiple of 3 for every whole number n. Check the working of each line against what came before it, in order, rather than judging whether the final conclusion feels right — an error that flips the conclusion can sit several lines before the line that states it.
18. (c) (−35, −55) — Add the three stages component by component to find the drone's position relative to base: (30+(−10)+15, 40+20+(−5)) = (35, 55). The flight back to base is the negative of this vector, reversing both numbers: (−35, −55). (35, 55) is the vector from base to the drone's position — it forgets to reverse direction for the return flight. (−35, 55) only reverses the top number. (35, −55) only reverses the bottom number.