🔺 Higher stretch — grade 8 and 9 topics

Answer key

1. (a) y = −x³ + 5x — Reflecting a graph in the y-axis replaces every x in the equation with −x: y = (−x)³ − 5(−x) = −x³ + 5x. Writing y = −x³ − 5x comes from substituting −x into the x³ term only and leaving the −5x term as it was. Writing y = x³ + 5x comes from substituting −x into the −5x term only and leaving the x³ term as it was. Writing y = x³ − 5x is the original equation with no reflection applied at all — every term needs the substitution, not just one of them.
2. (b) (x + 2)/3 — Start with y = 3x − 2 and swap x and y: x = 3y − 2. Add 2 to both sides: x + 2 = 3y. Divide both sides by 3: y = (x + 2)/3, so f⁻¹(x) = (x + 2)/3. Writing x/3 + 2 comes from dividing only the 3y term by 3 and leaving the +2 outside the division — the 2 must be added before you divide, not after. Writing (x − 2)/3 comes from keeping the subtraction sign instead of flipping it to addition when the −2 is moved across the equals sign. Writing 3x + 2 comes from swapping x and y but never actually solving for y — just changing the sign of the constant term.
3. (c) 72 — Method: on a histogram the frequency of a class is the area of its bar, so frequency = frequency density × class width. Working: the class 50 ≤ m < 80 has width 80 − 50 = 30 grams and a frequency density of 2.4 per gram, so the frequency is 2.4 × 30 = 72. Answer: 72 pebbles. The distractors: 192 comes from using the upper class boundary, 80, as the width, giving 2.4 × 80; 12.5 comes from dividing the width by the density, 30 ÷ 2.4, which reverses the area rule; 2.4 comes from reading the height of the bar as the frequency itself, the commonest mistake on histograms, where a height is a density and only an area is a count.
4. (a) x = 2, x = 7; y-intercept cannot be found here — Translating y = f(x) to y = f(x − 3) shifts the graph 3 units to the right, so each root increases by 3: x = −1 becomes x = 2, and x = 4 becomes x = 7. The y-intercept is the value at x = 0, which for this new graph is f(0 − 3) = f(−3) — and f(−3) is not one of the values given, so the new y-intercept cannot be worked out from the information given. Writing 'y-intercept stays at (0, −8)' wrongly assumes a horizontal translation leaves the y-intercept unchanged — it generally does not, since it moves the whole graph sideways, including the point that used to sit on the y-axis. Writing roots at x = −4 and x = 1 comes from translating 3 units to the LEFT instead of to the right — f(x − 3) shifts the graph in the positive x-direction, not the negative direction.
5. (a) −8 — −f(x) means take the output value from the table and change its sign, without changing which x-value is looked up. From the table, f(1) = 8, so −f(1) = −8. Reading f(1) = 8 from the table but forgetting to apply the negative sign gives 8. Misreading the row and using f(0) = 5 instead of f(1) = 8, then negating it, gives −5. Confusing −f(x) with f(x) − 1 — taking f(1) = 8 and subtracting 1 instead of negating — gives 7.
6. (c) 76 — Method: the frequency of each class is the area of its bar, frequency density × class width, so work out all three frequencies and add them. Working: the widths are 5, 10 and 25 kg, so the frequencies are 4 × 5 = 20, 2.6 × 10 = 26 and 1.2 × 25 = 30; the total is 20 + 26 + 30 = 76. Answer: 76 dogs. The distractors: 7.8 comes from adding the three frequency densities, 4 + 2.6 + 1.2, treating each height as though it were a count; 107 comes from using each upper class boundary as the width, giving 4 × 5, 2.6 × 15 and 1.2 × 40; 39 comes from using the first class width, 5, for every bar, which ignores the unequal intervals and gives 20 + 13 + 6.
7. (a) 0.45, different from 0.4 for all the households — Method: work out the probability inside the restricted group of garden owners, then work out the probability across the whole survey, and compare the two. Working: 54 of the 120 households with a garden own a dog, so the conditional probability is 54 divided by 120, which is 0.45. Across the whole survey 80 of the 200 households own a dog, which is 0.4. Since 0.45 is not 0.4, having a garden changes the chance of owning a dog and the two events are not independent. Answer: 0.45, different from 0.4 for all the households. The distractors: 0.27 is 54/200, dividing the households with both by the whole survey instead of by the 120 with a garden; 0.675 is 54/80, the probability that a household has a garden given that it owns a dog, which is the condition and the event the wrong way round; 0.4 is 80/200, the probability of owning a dog with the garden information never used, which is why that route also reports no difference.
8. (a) 7 — Multiply the input by 2: 6 × 2 = 12. Then subtract 5: 12 − 5 = 7. A candidate who does the operations in the wrong order, subtracting 5 first and then multiplying by 2, gets (6 − 5) × 2 = 2. A candidate who only carries out the multiplication and forgets to subtract gets 12. A candidate who adds 5 instead of subtracting gets 6 × 2 + 5 = 17.
9. (a) 2(3x + 1) = 6x + 2 — Expanding 2(3x + 1) = 6x + 2 gives an expression that matches the right-hand side exactly for every value of x — it is an identity. 4x − 3 = 3x + 5 is an ordinary equation with one solution, x = 8. 7 − x = x − 7 is also an ordinary equation with one solution, x = 7. 5x + 1 = 5(x + 1) never holds for any value of x at all, since expanding the right-hand side gives 5x + 5, and 5x + 1 = 5x + 5 would require 1 = 5, which is impossible.
10. (b) Q was faster on average and more consistent — Method: compare the medians for the average and the interquartile ranges for the spread, remembering that a shorter time is faster and a smaller interquartile range means more consistent. Working: the median for class Q is 35 seconds against 38 seconds for class P, so class Q was faster on average; the interquartile range for class P is 46 − 24 = 22 seconds and for class Q it is 44 − 30 = 14 seconds, so class Q's times are more tightly grouped. Answer: class Q was faster on average and more consistent. The distractors: calling Q slower comes from comparing the lower quartiles, 30 against 24, as though a quartile were the average; calling Q less consistent comes from using the gap between the median and the upper quartile as the spread, 44 − 35 = 9 against 46 − 38 = 8, instead of the full interquartile range; the statement that Q was both slower and less consistent comes from making both of those mistakes together.
11. (c) 10x − 15 — Expand the bracket first: 3(2x − 5) = 6x − 15. Then add the 4x: 6x − 15 + 4x = 10x − 15. The option 10x − 5 comes from forgetting to multiply the 5 inside the bracket by 3 (treating it as 6x − 5), then adding 4x. The option 10x + 15 comes from a sign error when expanding, treating 3 × (−5) as +15 instead of −15, then adding 4x. The option 6x − 15 comes from expanding the bracket correctly but forgetting to add the 4x term at all.
12. (a) (2n + 1) + (2n + 3) = 4n + 4 = 4(n + 1) — Two consecutive odd numbers can be written as 2n + 1 and 2n + 3, for a whole number n. Adding them: (2n + 1) + (2n + 3) = 4n + 4 = 4(n + 1), which is a multiple of 4 for every whole number n, proving the general result. Using 2n + 1 twice does not represent two different numbers, so it proves nothing about a sum of two numbers; writing n + (n + 2) drops the +1 that makes the numbers odd in the first place, and only shows a multiple of 2; and check every constant term is added correctly — 1 + 3 is 4, not 3.
13. (b) Translate −90° in x, then translate −2 in y. — cos(x + 90°) translates the graph 90° in the NEGATIVE x-direction, since a positive shift inside the bracket moves a graph left, not right, and subtracting 2 afterwards translates it 2 units in the negative y-direction (down). So the sequence is: translate −90° in x, then translate −2 in y. Using +90° in x reverses the direction of the horizontal shift — the sign inside the bracket moves the graph the opposite way to what it looks like. Using +2 in y reverses the direction of the vertical shift; subtracting 2 outside the function moves the graph down, not up. Describing the −2 as a reflection in the x-axis is wrong because a reflection turns positive y-values negative and vice versa, whereas here every y-value is simply reduced by the fixed amount 2, which is what a translation does, not a reflection.
14. (b) 2x + 3 — fg(x) means f(g(x)): apply g first, then apply f to the result. g(x) = 2x, so f(g(x)) = f(2x) = 2x + 3. Writing 2x + 6 comes from working out gf(x) instead — g(f(x)) = g(x + 3) = 2(x + 3) = 2x + 6 — which applies the functions in the wrong order. Writing 3x + 3 comes from adding f(x) and g(x) together, (x + 3) + 2x = 3x + 3, instead of composing them. Writing 2x² + 6x comes from multiplying f(x) and g(x) together, (x + 3)(2x) = 2x² + 6x, instead of substituting one into the other.
15. (b) 60 — Method: independence means the proportion of part timers among the cyclists is the same as the proportion among all the employees, so find that proportion and apply it to the cyclists. Working: 150 of the 400 employees work part time, which is a proportion of 0.375. Applying it to the 160 cyclists gives 0.375 × 160 = 60 employees. Answer: you would expect 60 employees. The distractors: 310 adds 150 and 160, treating the group who do both as everyone who does one thing or the other; 10 subtracts 150 from 160, reading 'both' as the difference between the two counts; 75 halves the 150 part timers, assuming that independence means they split evenly between cyclists and non cyclists, which would need exactly half the workforce to cycle.
16. (b) 6 — Reflecting y = f(x) in the x-axis turns the minimum point (2, −3) into a maximum point at (2, 3), since −f(x) negates every y-value: −(−3) = 3. Adding a then gives 3 + a = 9, so a = 9 − 3 = 6. Forgetting the reflection and using the original y-value of −3 gives −3 + a = 9, so a = 12 — this ignores that −f(x) changes the sign of the y-coordinate before a is added. Writing a = −12 comes from subtracting in the wrong order, working out 9 − (−3) as −3 − 9 instead. Writing a = −6 comes from taking the negative of the correct answer, as if the final value of a needed to be reflected too, on top of the turning point.
17. (c) 20 ≤ h < 40 — Method: with 80 values the lower quartile is the 80 ÷ 4 = 20th value in order, so build a running total until it first reaches 20. Working: the running totals are 14, then 14 + 22 = 36, then 52, then 80; the 20th plant is past 14 but not past 36, so it lies in the second class. Answer: the lower quartile lies in the class 20 ≤ h < 40. The distractors: 0 ≤ h < 20 comes from believing that the bottom quarter of the data must all sit in the first class, when that class holds only 14 of the 80 plants; 40 ≤ h < 50 comes from using the position 80 ÷ 2 = 40 and so locating the median rather than the lower quartile; 50 ≤ h < 80 comes from counting 20 plants down from the tallest instead of up from the shortest, which locates the upper quartile at the 60th plant.
18. (b) (1/2)b − (1/2)a — Method: MN runs from M to N, so MN = ON − OM, with OM = (1/2)a and ON = (1/2)b. Working: MN = (1/2)b − (1/2)a. Answer: MN = (1/2)b − (1/2)a. Subtracting the other way round gives (1/2)a − (1/2)b, the reverse vector from N to M; subtracting the wrong way round AND forgetting to halve gives a − b, which is BA, not MN; and adding the two halved vectors instead of subtracting them gives (1/2)a + (1/2)b, which is the position vector of the midpoint of AB. Always subtract the START point's vector from the END point's vector, and halve OA and OB before you combine them, not after.