🔺 Higher stretch — grade 8 and 9 topics

Answer key

1. (a) 4/9 — Method: two steps. Find how many cars failed altogether, because the car picked is known to be one of them, then divide the diesel failures by that total. Working: 30 petrol cars and 24 diesel cars failed, so 54 cars failed. The diesel failures give 24/54, and dividing the numerator and the denominator by 6 gives 4/9. Answer: the probability is 4/9. The distractors: 3/10 is 24/80, the probability that a car fails given that it is a diesel car, which is the condition and the event swapped; 3/25 is 24/200, dividing by every car serviced that week rather than by the 54 that failed; 2/5 is 80/200, the probability that a car chosen from the whole week is a diesel car, which ignores the fact that the car picked failed.
2. (d) 3 and 4 — f(3) = 3³ − 3 × 3² − 4 = 27 − 27 − 4 = −4, and f(4) = 4³ − 3 × 4² − 4 = 64 − 48 − 4 = 12. Since f(3) is negative and f(4) is positive, there is a change of sign, so the solution lies between 3 and 4. A sign slip when expanding −3x², treating it as +3x², gives f(3) = 27 + 27 − 4 = 50, a positive value; taken with the correctly negative f(2) = 8 − 12 − 4 = −8, this reads as a change of sign between 2 and 3. The same sign slip applied at x = 1 gives f(1) = 1 + 3 − 4 = 0, read as the point the sign changes, against f(0) = 0 + 0 − 4 = −4, giving 0 and 1. Shifting the correctly found interval up by one integer, an indexing slip, reports the change as lying between 4 and 5 instead of 3 and 4.
3. (d) Yes, because 3² + 4² = 25. — A point lies on the circle x² + y² = 25 exactly when substituting its coordinates makes the equation true. Squaring each coordinate separately and adding: 3² + 4² = 9 + 16 = 25, which matches the right-hand side, so (3, 4) does lie on the circle. Adding the coordinates without squaring them, 3 + 4 = 7, and then reasoning that 7 is less than 25 happens to reach the same verdict, but it is not testing the equation of the circle at all — the circle equation depends on x² + y², not x + y. Squaring the sum instead of summing the squares, (3 + 4)² = 49, not 25, wrongly rules the point out. Doubling each coordinate instead of squaring it, so that 4² is taken as 8, gives 9 + 8 = 17, not 25, which also wrongly rules the point out.
4. (a) 7.9 m — Method: the iteration converges on the width of the plot, so run the formula three times from the starting value and then add 4 m, because the length is 4 m greater than the width. Working: x₁ = √(30 − 4 × 3) = √18 = 4.24264…; x₂ = √(30 − 4 × 4.24264…) = √13.02943… = 3.60963…; x₃ = √(30 − 4 × 3.60963…) = √15.56147… = 3.94480…. The estimate for the length is 3.94480… + 4 = 7.94480…, which is 7.9 m correct to 1 decimal place. Answer: 7.9 m. The iteration is still oscillating at x₃, so this is the estimate that three uses of the formula give, not a settled value. The distractors: 3.9 m is x₃ itself, the width, given by a candidate who runs the iteration correctly and then stops before the step the question actually asks for; 7.6 m uses x₂ in place of x₃, one use of the formula short, and then adds the 4 m correctly; 15.8 m multiplies the width by 4 instead of adding 4 m to it, reading greater than as a multiplier.
5. (c) 37.5 — The tangent at (18, 24) is 18x + 24y = 900 (using ax + by = r² with a = 18, b = 24, r² = 900). Setting x = 0 to find the y-intercept: 24y = 900, so y = 37.5. Choosing 900 skips the division by 24 and just repeats the constant. Choosing 50 divides the constant by the x-coefficient 18 instead of the y-coefficient 24. Choosing 1.25 uses the radius 30 instead of r² = 900 as the constant before dividing.
6. (b) 6 — Reflecting y = f(x) in the x-axis turns the minimum point (2, −3) into a maximum point at (2, 3), since −f(x) negates every y-value: −(−3) = 3. Adding a then gives 3 + a = 9, so a = 9 − 3 = 6. Forgetting the reflection and using the original y-value of −3 gives −3 + a = 9, so a = 12 — this ignores that −f(x) changes the sign of the y-coordinate before a is added. Writing a = −12 comes from subtracting in the wrong order, working out 9 − (−3) as −3 − 9 instead. Writing a = −6 comes from taking the negative of the correct answer, as if the final value of a needed to be reflected too, on top of the turning point.
7. (d) 11 — f⁻¹(x) = 5 means x = f(5), since applying f to both sides undoes the inverse. f(5) = 2 × 5 + 1 = 11. Writing 2 comes from confusing f⁻¹(x) = 5 with f(x) = 5, and solving 2x + 1 = 5 instead: 2x = 4, x = 2. Writing 9 comes from finding f⁻¹(x) with a sign error, f⁻¹(x) = (x + 1)/2 instead of (x − 1)/2, then setting this equal to 5: x + 1 = 10, x = 9. Writing 6 comes from finding f⁻¹(x) without dividing by 2 at all, f⁻¹(x) = x − 1, then setting this equal to 5: x = 6.
8. (c) Correct: 3y = 4 − x gives f⁻¹(x) = (4 − x)/3 — Swap x and y: x = 4 − 3y. Add 3y to both sides and subtract x from both sides: 3y = 4 − x. Divide by 3: y = (4 − x)/3, which is exactly what Ben wrote — his rearrangement is correct. Check with a value: f(1) = 4 − 3 = 1, and Ben's formula gives (4 − 1)/3 = 1, which matches. 'Correct, but only because f is its own inverse' gives the right verdict for a false reason — f(f(x)) = 4 − 3(4 − 3x) = 9x − 8, which is not x, so f is not self-inverse; Ben's rearrangement is correct for the ordinary algebraic reason above, not because of any special property of f. 'Wrong: sign kept, giving (−4 − x)/3' comes from not carrying the swap through consistently — testing x = 1 gives (−4 − 1)/3 = −5/3, which does not equal 1, so it is wrong. 'Wrong: correct inverse is (x − 4)/3' comes from writing 3y = x − 4 instead of 3y = 4 − x, a sign slip when isolating y — testing x = 1 gives (1 − 4)/3 = −1, which again does not equal 1.
9. (b) (5, 1) — First scale a by 2: 2a = (2×3, 2×(−2)) = (6, −4). Then add b component by component: (6+(−1), −4+5) = (5, 1). (2, 3) is a + b without doubling a first. (4, 6) doubles both a and b instead of only a. (7, −9) subtracts b from 2a instead of adding it.
10. (b) 25 — The tangent at (9, 12) is 9x + 12y = 225. Setting y = 0 (the x-axis): 9x = 225, so x = 25. Choosing 18.75 comes from swapping the coefficients in the tangent equation (using 12x + 9y = 225) before setting y = 0. Choosing 15 is where the circle itself meets the x-axis (from x² = 225), not where the tangent does. Choosing 9 is just the x-coordinate of the original point (9, 12), not the point P.
11. (d) 2√2 — The radius satisfies r² = 8, so r = √8 = √(4 × 2) = √4 × √2 = 2√2. Choosing 8 forgets to take the square root of r² at all. Choosing 4 comes from halving 8 instead of finding its square root. Choosing √2 splits off the factor of 4 correctly but forgets to multiply the 2 back in front of the root.
12. (c) 9/16 — Method: two steps. Total the patients who had a flu jab, since the patient picked is known to be one of them, then divide the over 65s who had a jab by that total. Working: 90 patients over 65 and 70 patients aged 65 or under had a jab, so 160 patients had one. The over 65s give 90/160, and dividing the numerator and the denominator by 10 gives 9/16. Answer: the probability is 9/16. The distractors: 7/16 is 70/160, the probability that the patient picked is aged 65 or under, which is the other part of the same restricted group; 3/4 is 90/120, the probability that a patient had a jab given that they are over 65, which is the condition and the event the wrong way round and needs the 120 patients over 65; 9/40 is 90/400, dividing by every patient on the list instead of by the 160 who had a jab.
13. (a) xₙ₊₁ = ∛(5xₙ + 3) — Starting from x³ − 5x − 3 = 0, add 5x and 3 to both sides to get x³ = 5x + 3, then take the cube root of both sides: x = ∛(5x + 3), giving the iterative formula xₙ₊₁ = ∛(5xₙ + 3). A sign error when moving the constant term across, treating x³ − 5x − 3 = 0 as x³ = 5x − 3, gives xₙ₊₁ = ∛(5xₙ − 3). Swapping the coefficient of x with the constant term gives xₙ₊₁ = ∛(3xₙ + 5), which does not come from x³ = 5x + 3 at all. Treating cubing as meaning multiply by 3 rather than raise to the power 3, and so undoing it by dividing by 3 instead of taking a cube root, gives xₙ₊₁ = (5xₙ + 3) ÷ 3.
14. (b) £105 — The hourly charge is 25 × 3 = £75. Adding the call-out fee: £75 + £30 = £105. A candidate who forgets the call-out fee gives just the hourly charge, £75. A candidate who adds the call-out fee to the hourly rate before multiplying by the hours, (30 + 25) × 3, gets £165. A candidate who multiplies the call-out fee by the number of hours instead of the hourly rate, 30 × 3, gets £90.
15. (c) x + 3 — Expand the bracket: 0.5(4x + 6) = 2x + 3. Then subtract the x: 2x + 3 − x = x + 3. The option 2x + 3 comes from expanding the bracket correctly but then forgetting to subtract the x at all. The option x + 6 comes from forgetting to multiply the 6 inside the bracket by 0.5 (treating it as 2x + 6), then subtracting x. The option 3x + 3 comes from adding the x instead of subtracting it: 2x + 3 + x = 3x + 3.
16. (a) (8, 2) — Method: translating a point by a column vector means adding the vector's top number to the x-coordinate and its bottom number to the y-coordinate. Working: x-coordinate 2 + 6 = 8; y-coordinate 5 + (−3) = 2. Answer: B = (8, 2). A candidate who ignores the negative sign and adds 3 instead of −3 gets (8, 8). A candidate who translates in the reverse direction, subtracting the vector from A instead of adding it, gets (−4, 8). A candidate who swaps the vector's top and bottom numbers before adding gets (−1, 11).
17. (b) 1/4 — Method: the person picked is known to be aged 30 or over, so the sample space is those 140 people; divide the number of them who had been to the cinema by 140. Working: 35 of the 140 people aged 30 or over had been to the cinema, giving 35/140. Dividing the numerator and the denominator by 35 gives 1/4. Answer: the probability is 1/4. The distractors: 7/20 is 35/100, taking the count from the older group but the total from the under 30s, which is reading across the wrong row; 7/48 is 35/240, dividing by everyone surveyed instead of by the age group named; 3/4 is 105/140, the probability that someone aged 30 or over had NOT been to the cinema, the opposite event inside the correct group.
18. (c) A histogram, with frequency density up the vertical axis — Method: decide which diagram makes area stand for frequency, which is the property the question asks for. Working: on a histogram the vertical axis is frequency density, so the area of a bar is frequency density × class width, and that product is the frequency; this is exactly what is wanted, and it is what allows classes of unequal width to be shown fairly. Answer: a histogram, with frequency density up the vertical axis. The distractors: a bar chart plots frequency as the height, so with unequal widths a wide class would cover far more area than a narrow class holding the same number of batteries, and area would measure nothing; a cumulative frequency diagram plots running totals against upper class boundaries, so a point on it gives how many lie below a value rather than how many lie in a class; a pie chart shows each class as a share of the whole 300 and loses the class widths entirely, so no area on it is tied to a scale of hours.