🔺 Higher stretch — grade 8 and 9 topics

Answer key

1. (b) 1/3 — Method: the first sweet has already been taken and it was red, so work out the second probability from what is actually left in the bag. Working: one red sweet has gone, so 3 red sweets remain out of 9 sweets altogether, giving 3/9. Dividing the numerator and the denominator by 3 gives 1/3. Answer: the probability is 1/3. The distractors: 2/5 is 4/10, the probability for the first draw used again, which is only right if the first sweet is put back; 3/10 takes one off the red count but leaves the total at 10, updating half of the fraction; 4/9 takes one off the total but leaves the red count at 4, updating the other half of the fraction.
2. (a) A translation by vector (0, 3) — y = x² + 3 adds a constant outside the squaring, so it is a vertical translation of y = x² — every point moves the same distance parallel to the y-axis, with no change in x. The vector is (0, 3), matching the +3. A vector of (3, 0) confuses this with a horizontal shift; (0, −3) has the right axis but the wrong sign, since the graph moves up, not down; a stretch changes the shape of the curve, which adding a constant term never does.
3. (c) (1/3)b − (1/3)a — Method: PQ runs from P to Q, so PQ = OQ − OP. Working: PQ = (1/3)b − (1/3)a. Answer: PQ = (1/3)b − (1/3)a. Subtracting the other way round gives (1/3)a − (1/3)b, the same vector pointing back from Q to P instead of P to Q; using 2/3 instead of the 1/3 that OP and OQ were actually given as gives (2/3)b − (2/3)a; and using the full vectors a and b with no scaling at all gives b − a, which is AB, not PQ. Always subtract START from END, OQ − OP, and carry the fraction given in the question through to your final vector.
4. (c) Translate +1 in y; new range 0 ≤ y ≤ 2 — Adding 1 to sin x translates the graph 1 unit in the positive y-direction, and every y-value on the range increases by 1: −1 + 1 = 0 and 1 + 1 = 2, giving a new range of 0 ≤ y ≤ 2. A translation in the x-direction would not add anything to the y-values, so 'Translate +1 in x; range unchanged' correctly leaves the range at −1 ≤ y ≤ 1 for that (wrong) transformation, but the transformation itself is not what y = sin x + 1 shows. 'Translate +1 in y; new range −2 ≤ y ≤ 0' correctly spots the translation but subtracts 1 from each bound instead of adding it. 'Reflect in the x-axis' mistakes the transformation for a reflection rather than a translation; reflecting sin x in the x-axis does leave the range at −1 ≤ y ≤ 1 unchanged in size, but that is not the transformation y = sin x + 1 actually applies.
5. (b) f(1) = −3 and f(2) = 3 — f(1) = 1³ − 1 − 3 = 1 − 1 − 3 = −3. f(2) = 2³ − 2 − 3 = 8 − 2 − 3 = 3. Since f(1) is negative and f(2) is positive, there is a change of sign, so a solution lies between x = 1 and x = 2. Dropping the −x term entirely gives f(1) = 1 − 3 = −2 and f(2) = 8 − 3 = 5. Using x² instead of x³ throughout gives f(1) = 1 − 1 − 3 = −3, which happens to coincide with the correct value at x = 1, but f(2) = 4 − 2 − 3 = −1, which does not show a change of sign at all. Working out −f(x) instead of f(x), a sign-flip error, gives f(1) = 3 and f(2) = −3, the correct sizes but with both signs reversed.
6. (b) (2, 6) — y = f(x − 3) translates y = f(x) horizontally by 3 units to the RIGHT — inside the brackets, subtracting moves the graph in the positive x-direction. Turning point (−1, 6) → (−1 + 3, 6) = (2, 6). The common slip is to move LEFT instead, since the sign inside the bracket is negative — that gives (−4, 6). Changing the y-coordinate instead of the x-coordinate, as in (−1, 3) or (−1, 9), treats this as a vertical shift, which y = f(x − 3) is not.
7. (d) £16.70 — The mileage charge is 2.20 × 6 = £13.20. Adding the fixed fee: £13.20 + £3.50 = £16.70. A candidate who forgets the fixed fee gives just the mileage charge, £13.20. A candidate who adds the fixed fee to the per-mile rate before multiplying by the number of miles, (3.50 + 2.20) × 6, gets £34.20. A candidate who rounds £2.20 down to £2 gets 2 × 6 + 3.50 = £15.50.
8. (a) 1/3 — Method: since OABC is a parallelogram, B = OA + OC = a + c. M = (1/2)c, since M is the midpoint of OC. Since AN is twice NC, N is 2/3 of the way along AC from A, so N = a + 2/3(c − a) = (1/3)a + (2/3)c. Working: MN = N − M = (1/3)a + (1/6)c, and MB = B − M = a + (1/2)c. Comparing term by term, 1/3 × (a + (1/2)c) = (1/3)a + (1/6)c, which matches MN exactly. Answer: k = 1/3, so M, N and B lie on a straight line. Giving 2/3 instead is the scalar linking N to B (NB = (2/3)MB), not M to N; giving 1/6 is just MN's c-coefficient read off on its own, without comparing it to MB's c-coefficient at all; and giving 3 is the scalar the wrong way up — it is MB that equals 3 × MN, not the other way round, since MN = k × MB was what was asked for. Always match the direction of the scalar to the vectors exactly as the question states them.
9. (c) 37.5 — The tangent at (18, 24) is 18x + 24y = 900 (using ax + by = r² with a = 18, b = 24, r² = 900). Setting x = 0 to find the y-intercept: 24y = 900, so y = 37.5. Choosing 900 skips the division by 24 and just repeats the constant. Choosing 50 divides the constant by the x-coefficient 18 instead of the y-coefficient 24. Choosing 1.25 uses the radius 30 instead of r² = 900 as the constant before dividing.
10. (a) y = 2ˣ + 3 — A translation of 3 units in the positive y-direction shifts the whole graph up, which means adding to the output: y = f(x) + k with k = 3, so the image is y = 2ˣ + 3. Adding the 3 inside the power instead of outside it, which translates the graph horizontally instead of vertically, gives y = 2ˣ⁺³. Using a negative 3, which moves the graph down instead of up, gives y = 2ˣ − 3. Mistaking 2ˣ for the linear expression 2x and adding 3 inside brackets gives y = 2(x + 3).
11. (b) (6, −8) — Method: a scalar multiple of m has the same ratio between its top and bottom numbers as m does. Working: m = (3, −4); multiplying both parts by 2 gives 2 × 3 = 6 and 2 × (−4) = −8, so (6, −8) is a scalar multiple of m. Answer: (6, −8). The vector (6, −4) needs a multiplier of 2 for the top number but only 1 for the bottom number, so it is not a multiple. The vector (−6, −8) needs a multiplier of −2 for the top number but 2 for the bottom number, so it is not a multiple. The vector (9, −8) needs a multiplier of 3 for the top number but 2 for the bottom number, so it is not a multiple.
12. (c) 5/18 — Method: knowing the total is even cuts the 36 equally likely outcomes down to the even ones, so count those first and then count how many of them give 8. Working: the even totals occur as 2 once, 4 three times, 6 five times, 8 five times, 10 three times and 12 once, which is 18 outcomes. The total is 8 for 2 and 6, 3 and 5, 4 and 4, 5 and 3, and 6 and 2, which is 5 outcomes. The probability is 5/18, which will not cancel. Answer: the probability is 5/18. The distractors: 5/36 keeps the right count of ways to make 8 but divides by all 36 outcomes, ignoring the fact that the odd totals have already been ruled out; 1/6 treats the six even totals 2, 4, 6, 8, 10 and 12 as equally likely and picks one of them, which they are not; 1/11 treats the eleven possible totals from 2 to 12 as equally likely and uses neither the counting nor the condition.
13. (b) (n + 1)² − n² = 2n + 1 — (n + 1)² = n² + 2n + 1, so (n + 1)² − n² = n² + 2n + 1 − n² = 2n + 1, which is odd because it is one more than the even number 2n. Expanding (n + 1)² as n² + 1 uses the false rule (a + b)² = a² + b², and subtracting n² from that leaves just 1 — always expand (a + b)² as a² + 2ab + b². Writing n² + 2n + 1 expands correctly but never carries out the subtraction of n². Writing 2n forgets the constant term left after subtracting.
14. (c) A histogram, with frequency density up the vertical axis — Method: decide which diagram makes area stand for frequency, which is the property the question asks for. Working: on a histogram the vertical axis is frequency density, so the area of a bar is frequency density × class width, and that product is the frequency; this is exactly what is wanted, and it is what allows classes of unequal width to be shown fairly. Answer: a histogram, with frequency density up the vertical axis. The distractors: a bar chart plots frequency as the height, so with unequal widths a wide class would cover far more area than a narrow class holding the same number of batteries, and area would measure nothing; a cumulative frequency diagram plots running totals against upper class boundaries, so a point on it gives how many lie below a value rather than how many lie in a class; a pie chart shows each class as a share of the whole 300 and loses the class widths entirely, so no area on it is tied to a scale of hours.
15. (a) (6, 8) — Method: a point lies on the circle x² + y² = 100 exactly when the squares of its two coordinates add to 100, so square both coordinates of each point and add them. Working: for (6, 8), 6² + 8² = 36 + 64 = 100, which matches the right-hand side of the equation. Answer: (6, 8) lies on the circle. The distractors: (3, 4) is the 3, 4, 5 right-angled triangle recalled but never scaled up to a radius of 10, and 3² + 4² = 25, so it lies on the far smaller circle x² + y² = 25; (5, 5) has coordinates adding to 10, which compares the sum of the coordinates with the radius instead of the sum of their squares with r², and 5² + 5² = 50; (10, 10) takes each coordinate separately to equal the radius, and 10² + 10² = 200, which is twice too big.
16. (a) 7.9 m — Method: the iteration converges on the width of the plot, so run the formula three times from the starting value and then add 4 m, because the length is 4 m greater than the width. Working: x₁ = √(30 − 4 × 3) = √18 = 4.24264…; x₂ = √(30 − 4 × 4.24264…) = √13.02943… = 3.60963…; x₃ = √(30 − 4 × 3.60963…) = √15.56147… = 3.94480…. The estimate for the length is 3.94480… + 4 = 7.94480…, which is 7.9 m correct to 1 decimal place. Answer: 7.9 m. The iteration is still oscillating at x₃, so this is the estimate that three uses of the formula give, not a settled value. The distractors: 3.9 m is x₃ itself, the width, given by a candidate who runs the iteration correctly and then stops before the step the question actually asks for; 7.6 m uses x₂ in place of x₃, one use of the formula short, and then adds the 4 m correctly; 15.8 m multiplies the width by 4 instead of adding 4 m to it, reading greater than as a multiplier.
17. (b) (5, 1) — First scale a by 2: 2a = (2×3, 2×(−2)) = (6, −4). Then add b component by component: (6+(−1), −4+5) = (5, 1). (2, 3) is a + b without doubling a first. (4, 6) doubles both a and b instead of only a. (7, −9) subtracts b from 2a instead of adding it.
18. (c) 1/56 — Method: for draws without replacement, multiply a chain of three fractions where both the numerator (reds remaining) and the denominator (counters remaining) fall by one after each draw. Working: P(all three red) = 3/8 × 2/7 × 1/6 = 6/336 = 1/56. Answer: 1/56. Watch out: using 3/8 for all three draws (27/512) treats the counters as if they were replaced each time. Reducing only the numerator each draw (3/8 × 2/8 × 1/8) forgets that the total number of counters left in the bag also falls. And reducing only the denominator while keeping the numerator at 3 each time (3/8 × 3/7 × 3/6) forgets that a red counter has actually left the bag.