🔺 Higher stretch — grade 8 and 9 topics

Answer key

1. (a) (0, 7) and (0, −7) — A tangent is horizontal where the radius to that point is vertical, i.e. where the point lies on the y-axis. On x² + y² = 49, setting x = 0 gives y² = 49, so y = 7 or y = −7. The points are (0, 7) and (0, −7). (7, 0) and (−7, 0) comes from swapping the condition — these are the points where the tangent is VERTICAL, not horizontal (the radius there is horizontal). (0, 7) only comes from finding one valid point but forgetting that y² = 49 also gives the negative root, y = −7. (7, 0) only combines both mistakes: the wrong axis, and only one of the two roots.
2. (b) (x + 2)/3 — Start with y = 3x − 2 and swap x and y: x = 3y − 2. Add 2 to both sides: x + 2 = 3y. Divide both sides by 3: y = (x + 2)/3, so f⁻¹(x) = (x + 2)/3. Writing x/3 + 2 comes from dividing only the 3y term by 3 and leaving the +2 outside the division — the 2 must be added before you divide, not after. Writing (x − 2)/3 comes from keeping the subtraction sign instead of flipping it to addition when the −2 is moved across the equals sign. Writing 3x + 2 comes from swapping x and y but never actually solving for y — just changing the sign of the constant term.
3. (b) 8/35 — Method: the pupil picked is known to play at least one of the two sports, so first count how many pupils that is, then divide the number who play both by it. Working: 25 play football and 18 play tennis, but the 8 who play both have been counted in each figure, so the number who play at least one sport is 25 + 18 minus 8, which is 35. The pupils who play both give 8/35, which will not cancel. Answer: the probability is 8/35. The distractors: 2/15 is 8/60, dividing by the whole year group instead of by the 35 pupils who play at least one sport; 8/43 uses 25 + 18 as the denominator, forgetting that the 8 pupils who play both have been counted twice; 8/25 conditions on the footballers alone, answering the probability that a footballer also plays tennis rather than using every pupil who plays a sport.
4. (b) 8 — Method: a circle centred on the origin has equation x² + y² = r², where r is the radius, so the number on the right-hand side is the square of the radius and not the radius itself. Working: comparing x² + y² = 64 with x² + y² = r² gives r² = 64, so r = √64 = 8. Answer: the radius is 8. The distractors: 64 is r² read straight off the equation as though the right-hand side were the radius, which is the commonest error on this form; 32 comes from halving 64, treating the right-hand side as a diameter that has to be halved; 16 is the diameter, 2 × 8, quoted in place of the radius.
5. (b) 25 — The tangent at (9, 12) is 9x + 12y = 225. Setting y = 0 (the x-axis): 9x = 225, so x = 25. Choosing 18.75 comes from swapping the coefficients in the tangent equation (using 12x + 9y = 225) before setting y = 0. Choosing 15 is where the circle itself meets the x-axis (from x² = 225), not where the tangent does. Choosing 9 is just the x-coordinate of the original point (9, 12), not the point P.
6. (b) 5 ≤ m < 10 — Method: with 60 values the median is the 60 ÷ 2 = 30th value in order, so build a running total until it first reaches 30. Working: the running totals are 22 after the first class, 22 + 20 = 42 after the second, 51 after the third, 56 after the fourth and 60 after the fifth; the 30th parcel is past 22 but not past 42, so it lies in the second class. Answer: the median lies in the class 5 ≤ m < 10. The distractors: 0 ≤ m < 5 comes from giving the class with the greatest frequency, 22, which is the modal class and not the median class; 10 ≤ m < 20 comes from choosing the middle class in the list of five instead of counting to the middle value; 20 ≤ m < 30 comes from halving the range of the data, 50 ÷ 2 = 25, and giving the class that contains 25 kg rather than the class that contains the 30th parcel.
7. (c) 72 — Method: on a histogram the frequency of a class is the area of its bar, so frequency = frequency density × class width. Working: the class 50 ≤ m < 80 has width 80 − 50 = 30 grams and a frequency density of 2.4 per gram, so the frequency is 2.4 × 30 = 72. Answer: 72 pebbles. The distractors: 192 comes from using the upper class boundary, 80, as the width, giving 2.4 × 80; 12.5 comes from dividing the width by the density, 30 ÷ 2.4, which reverses the area rule; 2.4 comes from reading the height of the bar as the frequency itself, the commonest mistake on histograms, where a height is a density and only an area is a count.
8. (a) 7/16 — Method: the adult picked is known to have a driving licence, so the sample space is everyone with a licence; divide the number of men with a licence by that total. Working: 45 women and 35 men have a licence, so 80 adults have one. The men with a licence give 35/80, and dividing the numerator and the denominator by 5 gives 7/16. Answer: the probability is 7/16. The distractors: 7/10 is 35/50, the probability that an adult has a licence given that he is a man, which is the condition and the event the wrong way round; 7/24 is 35/120, dividing by all 120 adults surveyed instead of by the 80 who have a licence; 5/12 is 50/120, the probability that an adult picked from the whole survey is a man, which uses none of the licence information the question supplies.
9. (c) Statement (ii) — Statement (ii) opens with 'Since n(n + 1) is even', treating the very fact the proof is meant to establish as if it were already known — that is circular reasoning, assuming the conclusion to help derive itself. Statement (i) only names the two consecutive integers as n and n + 1; it makes no claim about whether their product is even, so it introduces nothing circular. Statement (iii) states the conclusion, and would be a valid final step if statement (ii) had reached 'one of n and n + 1 is even' by a genuine argument, such as considering the cases where n is even or odd separately. Saying the proof assumes nothing circular is wrong, because statement (ii)'s opening clause is exactly that assumption.
10. (b) (1/2)b − (1/2)a — Method: MN runs from M to N, so MN = ON − OM, with OM = (1/2)a and ON = (1/2)b. Working: MN = (1/2)b − (1/2)a. Answer: MN = (1/2)b − (1/2)a. Subtracting the other way round gives (1/2)a − (1/2)b, the reverse vector from N to M; subtracting the wrong way round AND forgetting to halve gives a − b, which is BA, not MN; and adding the two halved vectors instead of subtracting them gives (1/2)a + (1/2)b, which is the position vector of the midpoint of AB. Always subtract the START point's vector from the END point's vector, and halve OA and OB before you combine them, not after.
11. (c) (1/3)b − (1/3)a — Method: PQ runs from P to Q, so PQ = OQ − OP. Working: PQ = (1/3)b − (1/3)a. Answer: PQ = (1/3)b − (1/3)a. Subtracting the other way round gives (1/3)a − (1/3)b, the same vector pointing back from Q to P instead of P to Q; using 2/3 instead of the 1/3 that OP and OQ were actually given as gives (2/3)b − (2/3)a; and using the full vectors a and b with no scaling at all gives b − a, which is AB, not PQ. Always subtract START from END, OQ − OP, and carry the fraction given in the question through to your final vector.
12. (b) £105 — The hourly charge is 25 × 3 = £75. Adding the call-out fee: £75 + £30 = £105. A candidate who forgets the call-out fee gives just the hourly charge, £75. A candidate who adds the call-out fee to the hourly rate before multiplying by the hours, (30 + 25) × 3, gets £165. A candidate who multiplies the call-out fee by the number of hours instead of the hourly rate, 30 × 3, gets £90.
13. (c) 15/23 — Method: find P(rough and delayed) and the overall P(delayed) using the tree, then divide. Working: P(rough and delayed) = 0.2 × 0.75 = 0.15. P(calm and delayed) = 0.8 × 0.1 = 0.08. P(delayed) = 0.15 + 0.08 = 0.23. P(rough | delayed) = 0.15 ÷ 0.23 = 15/23. Answer: 15/23. Watch out: leaving the answer as 0.15 (3/20) gives P(rough and delayed) itself, without dividing by the overall probability that a crossing is delayed. Giving 0.75 (3/4) is the probability you were told to start with — that a crossing is delayed GIVEN the sea is rough — which is the reverse of what's being asked. And 0.2 (1/5) is just the original probability that the sea is rough, before you take the fact that the crossing was delayed into account.
14. (a) 16 — A and B share the same y-coordinate, so the distance between them is the horizontal difference between their x-coordinates: 8 − (−8) = 16, giving a chord of length 16. Choosing 8 gives only the x-coordinate of one point, not the full distance between the two points. Choosing 34 is the diameter of the circle (2 × 17), not the length of this particular chord. Choosing 17 is the radius — the distance from the centre to A or to B, not from A to B.
15. (b) Q was faster on average and more consistent — Method: compare the medians for the average and the interquartile ranges for the spread, remembering that a shorter time is faster and a smaller interquartile range means more consistent. Working: the median for class Q is 35 seconds against 38 seconds for class P, so class Q was faster on average; the interquartile range for class P is 46 − 24 = 22 seconds and for class Q it is 44 − 30 = 14 seconds, so class Q's times are more tightly grouped. Answer: class Q was faster on average and more consistent. The distractors: calling Q slower comes from comparing the lower quartiles, 30 against 24, as though a quartile were the average; calling Q less consistent comes from using the gap between the median and the upper quartile as the spread, 44 − 35 = 9 against 46 − 38 = 8, instead of the full interquartile range; the statement that Q was both slower and less consistent comes from making both of those mistakes together.
16. (c) 42 — Method: find the target cumulative frequency, 90% of the total, locate the class it falls in from the plotted points, then interpolate: lower boundary, plus the extra distance needed into the class divided by the class's frequency, times its width. Working: 90% of 320 is 0.9 × 320 = 288. The plotted points show a cumulative frequency of 280 at d = 40 and 320 at d = 50, so the class 40 ≤ d < 50 has frequency 320 − 280 = 40 and width 50 − 40 = 10, and 288 falls inside it. The extra distance needed into the class is 288 − 280 = 8, and 8 ÷ 40 × 10 = 2, so the diameter is 40 + 2 = 42. Answer: the estimated diameter is 42 mm. Watch which point and which class the interpolation actually uses: reading off d = 40, the plotted point just below the target, instead of interpolating the extra 8 ball bearings into the next 10 mm, stops one step short of the true answer; finding the diameter below which only 10% lie instead of 90% gives a target of 0.1 × 320 = 32, which falls in the class 10 ≤ d < 20 — the extra distance into that class is 32 − 30 = 2, and 2 ÷ 60 × 10 = 0.3, so this route gives 10 + 0.3 = 10.3, the bottom decile rather than the top 90%; and interpolating within the class 30 ≤ d < 40 instead of 40 ≤ d < 50, as though 288 had not yet reached a cumulative frequency of 280, treats the extra distance as 288 − 190 = 98, and 98 ÷ 90 × 10 = 10.9, giving 30 + 10.9 = 40.9, one class too early.
17. (b) x² + y² = 625 — Since (7, 24) lies on the circle, x² + y² = 7² + 24² = 49 + 576 = 625, so the equation is x² + y² = 625. Choosing x² + y² = 31 adds the coordinates 7 and 24 directly instead of squaring them first. Choosing x² + y² = 576 uses only 24² and forgets to add 7². Choosing x² + y² = 49 uses only 7² and forgets to add 24².
18. (a) x + 14 — Expand each bracket separately: 3(x + 4) = 3x + 12, and −2(x − 1) = −2x + 2 (multiply −2 by both x and −1). Combine: 3x + 12 − 2x + 2 = x + 14. Writing x + 10 comes from taking −2(x − 1) as −2x − 2, not flipping the sign of the −1 inside the bracket. Writing 5x + 10 comes from treating the second bracket as +2(x − 1) instead of subtracting it, so the x-terms are added rather than subtracted. Writing x + 13 comes from only multiplying the 2 by the x, and carrying the −1 across unmultiplied.