🔺 Higher stretch — grade 8 and 9 topics

Answer key

1. (a) 1.36 — Method: put the starting value into the right-hand side to get x₁, feed that value back in to get x₂, and round only once the second value has been found. Working: x₁ = 5 ÷ (1 + 2) = 5 ÷ 3 = 1.66666…; x₂ = 5 ÷ (1.66666… + 2) = 5 ÷ 3.66666… = 1.36363…. The digit in the third decimal place is 3, so x₂ = 1.36 correct to 2 decimal places. Answer: 1.36. The distractors: 1.67 is x₁, the value after a single use of the formula, given by a candidate who counts the starting value itself as x₁; 1.49 is x₃ = 1.48648…, one use of the formula too many; 1.37 comes from writing x₁ down as 1.66, truncating the display instead of keeping it in full, and then working out 5 ÷ 3.66 = 1.36612…, which rounds up to 1.37.
2. (d) −2 — Method: run the machine backwards, undoing the operations in the opposite order and swapping each one for its inverse. Working: the machine added 7 last, so take 7 off the output: 1 − 7 = −6; before that the machine had multiplied by 3, so divide: −6 ÷ 3, and a negative divided by a positive stays negative. Answer: −2, which checks because 3 × (−2) + 7 = −6 + 7 = 1. The distractors: 2 comes from dividing 6 by 3 and losing the minus sign; −6 comes from taking the 7 off and stopping there, never undoing the multiplication; −18 comes from multiplying −6 by 3 instead of dividing by 3.
3. (d) (1/2)a + (1/2)c — Method: X is the midpoint of AC, so OX = OA + (1/2)AC, with AC = c − a. Working: OX = a + 1/2(c − a) = a − (1/2)a + (1/2)c = (1/2)a + (1/2)c. Answer: OX = (1/2)a + (1/2)c. Since OB = a + c, this is exactly half of OB, so OX = (1/2)OB, meaning X lies on OB at its midpoint too — the two diagonals bisect each other. Forgetting to halve AC at all gives a + c, which is OB itself, not its midpoint; halving only the c-term gives (1/2)a + c; and a sign error on the c-term gives (1/2)a − (1/2)c. Halve the whole of AC, both terms together, and add it to OA rather than to a alone.
4. (a) 1.6 — Method: on a histogram the height of a bar is the frequency density, and frequency density = frequency ÷ class width. Working: the class 15 ≤ t < 30 runs from 15 to 30, so its width is 30 − 15 = 15 minutes; the frequency is 24, so the frequency density is 24 ÷ 15 = 1.6. Answer: 1.6 people per minute. The distractors: 360 comes from multiplying the frequency by the class width, 24 × 15, which uses the area rule backwards — area gives the frequency, so the frequency must be divided by the width to give the height; 0.625 comes from dividing the class width by the frequency, 15 ÷ 24, reversing the formula; 0.8 comes from dividing by the upper class boundary, 24 ÷ 30, instead of by the width of the class.
5. (d) (−4, −3) — The combined translation is the sum of the two column vectors, added component by component: top numbers 3 + (−7) = −4, bottom numbers −5 + 2 = −3, giving (−4, −3). (10, −7) subtracts the second vector from the first instead of adding them. (−4, 3) gets the top number right but makes a sign error on the bottom, treating −5 + 2 as +3. (4, −3) gets the bottom number right but makes a sign error on the top, treating 3 + (−7) as +4.
6. (c) 75 — Method: the number in a class is the area of its bar, frequency density × class width, so work out the frequency of each class that lies at or above 10 minutes and add them. Working: the class 10 ≤ t < 25 is 15 minutes wide with a frequency density of 3.2, giving 3.2 × 15 = 48 members; the class 25 ≤ t < 55 is 30 minutes wide with a frequency density of 0.9, giving 0.9 × 30 = 27 members; the total charged is 48 + 27 = 75. Answer: 75 members pay the extra charge. The distractors: 4.1 comes from adding the two frequency densities, 3.2 + 0.9, as though each height were a count; 93 comes from including the class 0 ≤ t < 10 as well, 1.8 × 10 = 18 added to 48 and 27, which charges every member; 27 comes from using only the class 25 ≤ t < 55 and forgetting that 10 ≤ t < 25 is also at or above 10 minutes.
7. (b) (2, 6) — y = f(x − 3) translates y = f(x) horizontally by 3 units to the RIGHT — inside the brackets, subtracting moves the graph in the positive x-direction. Turning point (−1, 6) → (−1 + 3, 6) = (2, 6). The common slip is to move LEFT instead, since the sign inside the bracket is negative — that gives (−4, 6). Changing the y-coordinate instead of the x-coordinate, as in (−1, 3) or (−1, 9), treats this as a vertical shift, which y = f(x − 3) is not.
8. (c) 1 — At x = 0, f(0) = 4. Applying the transformations in order — reflect in the x-axis first, then translate up by 5 — gives −f(0) + 5 = −4 + 5 = 1. Applying the translation but forgetting the reflection gives f(0) + 5 = 9. Applying the reflection to the whole expression, including the +5, gives −f(0) − 5 = −9. Applying the reflection but forgetting the translation gives −f(0) = −4.
9. (b) (5, 1) — First scale a by 2: 2a = (2×3, 2×(−2)) = (6, −4). Then add b component by component: (6+(−1), −4+5) = (5, 1). (2, 3) is a + b without doubling a first. (4, 6) doubles both a and b instead of only a. (7, −9) subtracts b from 2a instead of adding it.
10. (c) (1/3)b − (1/3)a — Method: PQ runs from P to Q, so PQ = OQ − OP. Working: PQ = (1/3)b − (1/3)a. Answer: PQ = (1/3)b − (1/3)a. Subtracting the other way round gives (1/3)a − (1/3)b, the same vector pointing back from Q to P instead of P to Q; using 2/3 instead of the 1/3 that OP and OQ were actually given as gives (2/3)b − (2/3)a; and using the full vectors a and b with no scaling at all gives b − a, which is AB, not PQ. Always subtract START from END, OQ − OP, and carry the fraction given in the question through to your final vector.
11. (d) 1.2 pupils per mark — Method: on a histogram whose class intervals are not all the same width the height of a bar is not the frequency but the frequency density, found by dividing the frequency of the class by the width of that class, so that the area of the bar represents the frequency. Working: the class 40 ≤ m < 60 holds 24 pupils, and its width is 60 − 40 = 20 marks, so the frequency density is 24 ÷ 20 = 1.2. Answer: 1.2 pupils per mark. The distractors: 24 pupils per mark comes from plotting the frequency itself as the height, which is only correct when every class has the same width; 2.4 pupils per mark comes from dividing by 10, the width of the narrowest class, instead of by the width of this class; 0.2 pupils per mark comes from dividing by the 120 pupils in the year group, which gives the proportion of pupils in the class and not a frequency density.
12. (d) It has a solution between x = 2.2 and x = 2.3 — Since f(2.2) is negative and f(2.3) is positive, the graph of f crosses the x-axis somewhere between x = 2.2 and x = 2.3, so the equation has a solution in that interval. Choosing 'between x = −2.2 and x = −2.3' confuses the negative f-VALUE at 2.2 with a negative x-value. Choosing 'no solution' misreads a change of sign as meaning the opposite of what it shows. Choosing 'exactly two solutions' assumes a single change of sign must give two roots, which is not what the rule guarantees.
13. (a) −1 — Reflecting y = sin x in the x-axis gives y = −sin x, so g(x) = −sin x. Since sin 90° = 1, g(90) = −1. Reading sin 90° = 1 and forgetting to apply the reflection gives 1. Misreading the angle as 0° instead of 90° gives sin 0° = 0, so 0. Confusing sin 90° with sin 30° = 0.5, then reflecting it, gives −0.5.
14. (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
15. (c) n = 4 — Testing n = 4: 4² = 16, and 16 + 4 + 1 = 21, and 21 = 3 × 7 is not a prime number, so this value disproves the claim. Testing n = 1: 1² = 1, and 1 + 1 + 1 = 3, which is prime, so it does not disprove the claim. Testing n = 2: 2² = 4, and 4 + 2 + 1 = 7, which is prime. Testing n = 3: 3² = 9, and 9 + 3 + 1 = 13, which is also prime — a counterexample has to give a result that isn't prime, and only n = 4 does that.
16. (b) 0.458 — x₁ = (0.4² + 3) ÷ 7 = 3.16 ÷ 7 = 0.4514 (unrounded, 0.451428...). x₂ = (x₁² + 3) ÷ 7 = (0.2038 + 3) ÷ 7 = 3.2038 ÷ 7 = 0.458 (3 d.p.). Choosing 0.632 divides only the 3 by 7 instead of dividing the whole sum x₁² + 3 by 7. Choosing 0.451 repeats the calculation for x₁ instead of moving on to x₂. Choosing 0.493 uses x₁ itself instead of x₁² inside the formula.
17. (d) −2 — y = f(x) − 6 is f(x) shifted down by 6, so every y-value on the graph decreases by 6. At x = 0, f(0) = 4, so the new y-value is 4 − 6 = −2. Adding 6 instead of subtracting gives 10; writing down the shift itself, −6, or leaving the original value 4 unchanged both skip the translation altogether.
18. (c) Statement (ii) — Statement (ii) opens with 'Since n(n + 1) is even', treating the very fact the proof is meant to establish as if it were already known — that is circular reasoning, assuming the conclusion to help derive itself. Statement (i) only names the two consecutive integers as n and n + 1; it makes no claim about whether their product is even, so it introduces nothing circular. Statement (iii) states the conclusion, and would be a valid final step if statement (ii) had reached 'one of n and n + 1 is even' by a genuine argument, such as considering the cases where n is even or odd separately. Saying the proof assumes nothing circular is wrong, because statement (ii)'s opening clause is exactly that assumption.