✏️ Paper 1 non-calculator warm-up — Foundation

Answer key

1. (c) 18 — 45 ÷ 5 = 9, and 2 × 9 = 18. A candidate who stops after finding one fifth gets 9. A candidate who uses 3/5 instead of 2/5 gets 27. A candidate who uses 4/5 instead of 2/5 gets 36.
2. (b) 14 — Method: the greatest number of identical rows is the highest common factor of the two bulb totals, found by taking every prime factor the two totals share. Working: 42 = 2 × 3 × 7 and 56 = 2 × 2 × 2 × 7, so the prime factors common to both are 2 and 7, giving a highest common factor of 2 × 7 = 14. 2 comes from taking only the common factor 2 and forgetting the common factor 7. 7 comes from taking only the common factor 7 and forgetting the common factor 2. 168 is the lowest common multiple of 42 and 56, not their highest common factor. Answer: 14.
3. (b) £45 — Since 2/3 of the amount is £30, one third is £30 ÷ 2 = £15, and the whole amount is three thirds: £15 × 3 = £45. Applying the fraction forwards to £30 instead of reversing it, £30 × 2/3 = £20, treats the given amount as the whole rather than as two thirds of it. Finding one third correctly as £15 but forgetting to multiply by 3 to get the whole amount leaves £15 as the final answer. Reading £30 as one third of the amount rather than as two thirds, and so multiplying straight by 3, gives £30 × 3 = £90.
4. (c) 0.024 — Multiply the digits ignoring the decimal points: 6 × 4 = 24. Count the total number of decimal places in the two numbers being multiplied: 0.6 has 1 decimal place and 0.04 has 2, giving 3 in total. Place the decimal point in 24 so that there are 3 digits after it: 0.024. Counting only 2 decimal places instead of 3 gives 0.24. Counting 4 decimal places instead of 3 gives 0.0024. Counting only 1 decimal place instead of 3 — in effect moving the point in just one of the two numbers, as if the calculation were 6 × 0.4 — gives 2.4. So 0.6 × 0.04 = 0.024.
5. (a) 2 × 3² × 5 — Method: divide repeatedly by the smallest prime number until only prime factors remain. Working: 90 ÷ 2 = 45, 45 ÷ 3 = 15, 15 ÷ 3 = 5, and 5 is prime, so 90 = 2 × 3 × 3 × 5, written as 2 × 3² × 5. 2 × 3 × 15 stops before the 15 is broken down into 3 × 5, so it is not fully factorised. 3 × 3 × 10 stops before the 10 is broken down into 2 × 5. 2 × 45 stops after only one division. Answer: 2 × 3² × 5.
6. (a) 0 — Method: BIDMAS works through the index first, then the multiplication, then the subtraction. Working: 5² = 25, then 4 × 25 = 100, and finally 100 − 100 = 0. Answer: 0. The distractors: 2400 comes from working from left to right and subtracting first, giving (100 − 4) × 25 = 96 × 25 = 2400; −300 comes from multiplying before applying the index, giving (4 × 5)² = 20² = 400 and then 100 − 400 = −300; 60 comes from reading 5² as 5 × 2 = 10, so that 4 × 10 = 40 and 100 − 40 = 60.
7. (c) 600 — Method: round each number to the nearest 100, then add the rounded values. Working: 113 is nearer to 100 than to 200, so it rounds to 100; 491 is nearer to 500 than to 400, so it rounds to 500; adding those gives the estimate. Answer: 600. The distractors: 500 comes from rounding each number down to the hundred below instead of to the nearest hundred, giving 100 + 400; 700 comes from rounding each number up to the hundred above, giving 200 + 500; 604 is the exact total, worked out in full when the question asks for an estimate.
8. (b) −5 — Using the order of operations, work out the multiplication first: 4 × (−2) = −8. Then 3 + (−8) = −5. A candidate who adds before multiplying gets (3 + 4) × (−2) = −14. A candidate who drops the negative sign on the multiplication gets 3 + 4 × 2 = 11. A candidate who works out the multiplication correctly but gives that as the final answer, forgetting to combine it with the 3, gets −8.
9. (a) 4 : 15 — Convert to the same unit first: 1.5 kg = 1500 g, since 1 kg = 1000 g. This gives the ratio 400 : 1500. Divide both parts by their highest common factor, 100, to get 4 : 15. Giving 40 : 150 divides by 10 only, which is not the highest common factor, so it is not fully simplified. Giving 15 : 4 swaps the order. Giving 4 : 1.5 has not converted 1.5 kg into grams, so the two parts are not measured in the same unit.
10. (d) 51 is not prime, because 51 = 3 × 17. — Check 51 for small prime factors: 51 ÷ 3 = 17, and both 3 and 17 are themselves prime, so 51 = 3 × 17 and 51 is not a prime number — it has factors other than 1 and itself. Checking only 2, 3 and 5 and concluding wrongly that none of them divide 51 misses that 3 does divide it exactly, so the claim that 51 is prime because it avoids 2, 3 and 5 is false. Assuming any odd number must be prime ignores that 51 = 3 × 17 is a counterexample — plenty of odd numbers are not prime. Misreading 51 as the even number 52 leads to the false claim that it is divisible by 2; 51 itself is odd, and 2 is not one of its factors. So 51 is not prime, because 51 = 3 × 17.
11. (c) 2/3 — Method: fractions with the same denominator are added by adding the numerators and leaving the denominator alone, because the parts are already the same size. Working: 1/3 + 1/3 has numerators 1 + 1 = 2 and the denominator stays as 3, giving 2/3. Answer: 2/3. The distractors: 2/6 comes from adding the denominators as well as the numerators, 1 + 1 over 3 + 3; 2/9 comes from adding the numerators but multiplying the denominators, 1 + 1 over 3 × 3; 1/9 comes from multiplying throughout instead of adding, 1 × 1 over 3 × 3.
12. (a) 1/4 — The empty part of the tank is 80 − 60 = 20 litres. As a fraction of the full capacity, this is 20/80, which simplifies to 1/4. Finding the fraction of the tank that is FULL instead of empty, 60/80, simplifies to 3/4 — the wrong quantity for the question asked. Writing the empty amount over the amount remaining instead of over the full capacity, 20/60, simplifies to 1/3. Comparing the empty amount to 100 instead of to the tank's actual capacity of 80, 20/100, gives 1/5.
13. (a) 25 — Reverse the operations in reverse order: undo the subtraction by adding 6, then undo the division by multiplying by 5. −1 + 6 = 5, so the number divided by 5 equals 5, and 5 × 5 = 25 — checking, 25 ÷ 5 − 6 = 5 − 6 = −1. A candidate who subtracted 6 again instead of adding worked out −1 − 6 = −7, then −7 × 5 = −35. A candidate who multiplied by 5 before undoing the subtraction, doing the inverse operations in the wrong order, worked out −1 × 5 = −5, then −5 + 6 = 1. A candidate who multiplied by 5 but forgot to undo the subtraction at all worked out −1 × 5 = −5 and stopped there.
14. (a) 36 — Method: find the lowest common multiple of 6 and 9, then move up the list of common multiples until one is greater than 20. Working: the common multiples of 6 and 9 are 18, 36, 54 …. 18 is not greater than 20, so the next one, 36, is the smallest value of n that is greater than 20. 18 is the lowest common multiple itself, but it fails the 'greater than 20' condition. 54 is the common multiple after 36, one step too far. 27 is a multiple of 9 but not of 6, since 27 ÷ 6 is not a whole number. Answer: 36.
15. (b) 5:8 — The mix has 5 parts sand and 3 parts cement, so 5 + 3 = 8 parts in total. Sand to total is 5 : 8, and since the highest common factor of 5 and 8 is 1, this is already in its simplest form. Giving 5 : 3 answers sand to cement, not sand to the total mix. Giving 3 : 8 is cement to total, the wrong part of the mix. Giving 8 : 5 has the total and the sand swapped round.
16. (b) 7 — Method: trap the number between the two square numbers on either side of it, then decide which of them it is nearer to. Working: 6² = 36 and 7² = 49, so √45 lies between 6 and 7; 49 − 45 = 4 while 45 − 36 = 9, so 45 is nearer to 49. Answer: 7. The distractors: 6 comes from taking the square number below 45 and stopping there, without checking which of 36 and 49 is nearer; 22.5 comes from halving 45 instead of looking for the number that multiplies by itself to give 45; 2,025 comes from squaring 45 instead of taking its square root.
17. (c) 9/5 — Method: the area of a rectangle is its length multiplied by its width; the decimal product is then written over a power of ten and cancelled. Working: 24 × 75 = 1800, and 2.4 and 0.75 have three decimal places between them, so 2.4 × 0.75 = 1.8; the area of the panel is 1.8 square metres, which is eighteen tenths, so it can be written as 18/10, and dividing the numerator and the denominator by 2 gives 9 over 5. Answer: 9/5. The distractors: 4/5 comes from converting only the digits after the decimal point and losing the whole one, turning 1.8 into eight tenths; 63/20 comes from adding the two sides instead of multiplying them, giving 3.15; 9/50 comes from misplacing the decimal point in the product and writing 0.18, which cancels to 9 over 50.
18. (c) 1,000 m² — Method: round each length to 1 significant figure, then use area of a rectangle = length × width on the rounded lengths. Working: 19.6 m rounds to 20 m and 48.3 m rounds to 50 m, so the estimate is 20 × 50 = 1,000 and the area is about 1,000 m². Answer: 1,000 m². The distractors: 800 m² comes from rounding 48.3 down to 40 when the digit after its first significant figure is 8 and sends it up to 50, giving 20 × 40 = 800; 140 m² is the perimeter of the rounded rectangle, 2 × 20 + 2 × 50 = 140, not its area; 70 m² comes from adding the rounded lengths, 20 + 50 = 70, instead of multiplying them.
19. (a) 9:11 — Method: divide both parts of the ratio by their highest common factor. Working: the factors of 18 are 1, 2, 3, 6, 9 and 18, and the factors of 22 are 1, 2, 11 and 22, so the highest common factor is 2; 18 ÷ 2 = 9 and 22 ÷ 2 = 11. Answer: 9:11. The distractors: 11:9 comes from dividing both parts correctly but writing them the wrong way round, so it describes 22 to 18 rather than 18 to 22; 9:22 comes from dividing only the first part by 2 and leaving the second part untouched; 9:13 comes from subtracting 9 from each part instead of dividing, since 18 − 9 = 9 and 22 − 9 = 13, and subtracting the same amount from both parts does not give an equivalent ratio.
20. (c) 9/10 — Method: write the decimal over 10 using its one decimal place. Working: 0.9 = 9/10, which is already in its simplest form since 9 and 10 share no common factor. Answer: 9/10. The student's fraction, 9/100, comes from always writing the denominator as 100, regardless of how many decimal places the number actually has. 9 comes from dropping the decimal point altogether and treating 0.9 as the whole number 9. 1/9 comes from flipping the correct fraction upside down.