✏️ Paper 1 non-calculator warm-up — Foundation

Answer key

1. (c) 0.36 — Method: convert the fraction to an equivalent fraction with denominator 100, then read off the decimal. Working: 9/25 = 36/100 (multiplying numerator and denominator by 4) = 0.36. Answer: 0.36. 2.8 comes from flipping the fraction and dividing the denominator by the numerator instead: 25 ÷ 9 = 2.77…, rounded to 2.8. 0.925 comes from writing the digits of the numerator and denominator directly after the decimal point without scaling the fraction. 0.9 comes from writing the numerator straight after the decimal point, as if the denominator were 10 rather than 25.
2. (c) 9/5 — Method: the area of a rectangle is its length multiplied by its width; the decimal product is then written over a power of ten and cancelled. Working: 24 × 75 = 1800, and 2.4 and 0.75 have three decimal places between them, so 2.4 × 0.75 = 1.8; the area of the panel is 1.8 square metres, which is eighteen tenths, so it can be written as 18/10, and dividing the numerator and the denominator by 2 gives 9 over 5. Answer: 9/5. The distractors: 4/5 comes from converting only the digits after the decimal point and losing the whole one, turning 1.8 into eight tenths; 63/20 comes from adding the two sides instead of multiplying them, giving 3.15; 9/50 comes from misplacing the decimal point in the product and writing 0.18, which cancels to 9 over 50.
3. (c) 20% — Method: percentage increase = (increase ÷ original) × 100. Working: the increase is 54 − 45 = 9, and 9 ÷ 45 = 0.2, so the percentage increase is 0.2 × 100 = 20. Answer: 20%. The distractors: 9% comes from writing the actual increase as a percentage; 16.7% comes from dividing by the new value 54 instead of the original 45; 120% is the multiplier 1.2 written as a change rather than the change itself.
4. (a) 200 g — One quarter of 160 g is 40 g. Increasing the amount means adding this on: 160 + 40 = 200 g. Finding the increase, 1/4 of 160 = 40 g, but stopping there without adding it to the original amount leaves just 40 g. Using 4/5 instead of 5/4 as the scaling fraction, 160 × 4/5 = 128 g, actually decreases the amount rather than increasing it. Increasing by a half instead of a quarter, 160 + 80 = 240 g, uses the wrong fraction of 160.
5. (d) 3/5 — Method: a decimal with one digit after the point is a number of tenths, so it is written over 10 and then cancelled. Working: 0.6 is six tenths, so 0.6 = 6/10; the highest common factor of 6 and 10 is 2, and 6 ÷ 2 = 3 with 10 ÷ 2 = 5. Answer: 3/5. The distractors: 2/3 comes from confusing 0.6 with the recurring decimal 0.666..., which is the one that equals 2/3; 1/6 comes from putting 1 over the single digit after the point; 3/50 comes from using hundredths for a one-place decimal, giving 6/100, which then cancels by 2 to 3/50.
6. (b) 3:2 — Write both fractions over a common denominator of 4: 3/4 stays as 3/4, and 1/2 = 2/4. Comparing the numerators gives the ratio 3 : 2. Getting 2 : 3 swaps the two parts round. Getting 3 : 1 comes from using the numerator of the first fraction and the original numerator of the second fraction (1) without converting to a common denominator. Getting 2 : 1 comes from using only the denominators, 4 and 2, and simplifying those instead of the numerators.
7. (d) 7:15 — Method: write the two parts in the order asked for, red first, then divide both parts by their highest common factor. Working: the factors of 7 are 1 and 7, and the factors of 15 are 1, 3, 5 and 15, so the only common factor is 1; dividing both parts by 1 leaves both counts unchanged. Answer: 7:15, which is already in its simplest form. The distractors: 15:7 is the ratio of blue to red, the reverse of the order the question asks for; 7:5 comes from cancelling the digit 1 out of 15, which is not a division by a common factor; 1:2 comes from dividing 15 by 7, rounding the result to 2 and writing the ratio as 1 to 2, but 7 is not a factor of 15 so that division is not exact.
8. (b) −2 — Method: the multiplication is carried out before the addition, and a negative multiplied by a positive is negative. Working: (−3) × 4 = −12, so the calculation becomes −12 + 10 = −2. Answer: −2. The distractors: 22 comes from ignoring the minus sign and working out 3 × 4 + 10 = 22; −42 comes from adding before multiplying, giving (4 + 10) × (−3) = 14 × (−3) = −42; −22 comes from adding 12 and 10 and then writing a minus sign in front of the total, instead of moving 10 places up from −12.
9. (c) 2:3 — Divide both parts of the ratio by their highest common factor, 2x: 4x ÷ 2x = 2 and 6x ÷ 2x = 3, giving 2 : 3. Writing 4 : 6 has not been simplified at all. Writing 2x : 3x has cancelled the common factor of 2 but left the x in, so it is not written as a ratio of whole numbers. Writing 3 : 2 has the two parts the wrong way round.
10. (b) £72 — One fifth of £60 = £12. New price = £60 + £12 = £72. A candidate who gives the increase instead of the new price gets £12. A candidate who subtracts the increase instead of adding it gets £60 − £12 = £48. A candidate who uses 1/4 instead of 1/5 gets £60 + £15 = £75.
11. (d) 12 — Method: if the bracelets are identical and no beads are left over, the number of bracelets must divide exactly into both totals, so it is the highest common factor of 24 and 36. Working: 24 = 2³ × 3 and 36 = 2² × 3²; taking the lower index of each shared prime gives 2² × 3 = 4 × 3 = 12. Each bracelet then has 2 red beads and 3 blue beads. Answer: 12. The distractors: 6 comes from taking each shared prime once rather than at its lower index, giving 2 × 3, which is a common factor but not the highest; 72 is the lowest common multiple of 24 and 36, from taking the higher index of each prime instead of the lower; 60 comes from adding the two bead totals instead of looking for a common factor.
12. (a) Yes, because 120 ends in 0 — Method: a whole number divides exactly by 5 when its last digit is 5 or 0, so look at the final digit. Working: the final digit of 120 is 0, so 120 is a multiple of 5; the division confirms it, since 5 × 24 = 120 with nothing left over. Answer: Yes, because 120 ends in 0. The distractors: the option that says yes because 120 is even reaches the right conclusion from the wrong test, since being even is the test for divisibility by 2, and 14 is even but is not a multiple of 5; saying no because 5 does not divide into 12 comes from ignoring the final digit and testing only the leading digits; saying no because the digits add to 3 applies the digit-sum test, which works for 3 and for 9 but not for 5.
13. (b) 1 — Method: BIDMAS deals with the index before the subtraction, and a negative number multiplied by itself gives a positive result. Working: (−2)² = (−2) × (−2) = 4, so the calculation becomes 4 − 3 = 1. Answer: 1. The distractors: −7 comes from squaring only the 2 and leaving the minus sign outside the index, giving −(2²) − 3 = −4 − 3 = −7; −1 comes from subtracting the square from 3 instead of 3 from the square, giving 3 − 4 = −1; 25 comes from carrying out the subtraction before the index, giving (−2 − 3)² = (−5)² = 25.
14. (a) 6 — Method: list the factors of each number and compare them. Working: the factors of 18 are 1, 2, 3, 6, 9, 18; the factors of 24 are 1, 2, 3, 4, 6, 8, 12, 24. The only option that appears in both lists is 6. 8 is a factor of 24 but not of 18. 9 is a factor of 18 but not of 24. 12 is a factor of 24 but not of 18. Answer: 6.
15. (c) 12 m — Method: the perimeter of a rectangle is twice the sum of the length and the width, so half the perimeter is one length plus one width; split that half using the ratio. Working: half of 64 is 64 ÷ 2 = 32 m, the ratio 5:3 has 5 + 3 = 8 parts, so one part is 32 ÷ 8 = 4 m, and the width is 3 × 4 = 12 m. So the width is 12 m. Distractor 20 m is the length, 5 parts, not the width. Distractor 24 m comes from splitting the whole perimeter, 64 m, into 8 parts and multiplying by 3, forgetting to halve the perimeter first. Distractor 8 m comes from the same slip stopped one step earlier: splitting the whole perimeter into 8 parts, 64 ÷ 8 = 8, and giving that instead of the width.
16. (b) 18 — Method: multiply the two numbers ignoring their signs, then apply the rule that a negative number multiplied by a negative number gives a positive answer. Working: 6 × 3 = 18; since both −6 and −3 are negative, the product is positive. Answer: 18. −18 comes from keeping the answer negative, as if only one of the two negative signs affects the sign of the product. −9 comes from adding the two numbers instead of multiplying them, −6 + (−3) = −9. 9 comes from adding 6 and 3 as if both numbers were positive, ignoring the negative signs entirely.
17. (c) 9:15:21 — 6 : 10 : 14 simplifies to 3 : 5 : 7 (divide every part by 2). Multiplying every part of 3 : 5 : 7 by 3 gives 9 : 15 : 21, so 9 : 15 : 21 is equivalent to 6 : 10 : 14. Adding 2 to every part of 6 : 10 : 14 gives 8 : 12 : 16, which is not equivalent — ratios are equivalent when every part is multiplied by the same number, not when the same number is added to every part. Doubling only the first two parts, 6 × 2 = 12 and 10 × 2 = 20, but leaving the third part unchanged at 14, gives 12 : 20 : 14 — a scaling applied to two parts and not the third. Cancelling the first two parts correctly, 6 ÷ 2 = 3 and 10 ÷ 2 = 5, then treating the three numbers as a sequence and making the third part the sum of the first two, 3 + 5 = 8, gives 3 : 5 : 8 — the third part was never divided by 2 at all.
18. (a) 9/20 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.45 = 45/100 = 9/20 (dividing both numerator and denominator by 5). Answer: 9/20. 9/100 comes from dividing only the numerator by 5 and leaving the denominator as 100. 9/2 comes from writing the decimal over 10 instead of 100, as if there were only one decimal place, then simplifying 45/10. 9/200 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places, then simplifying 45/1000.
19. (d) 1:4 — Convert 1.4 l to millilitres: 1.4 l = 1400 ml. The ratio is 350 : 1400. Divide both parts by 350: 350 ÷ 350 = 1 and 1400 ÷ 350 = 4, giving 1 : 4. Misreading 1.4 l as 14 (moving the decimal point) gives 350 : 14, which simplifies to 25 : 1 — a very different, implausible ratio. Dividing by 175 instead of 350 gives 2 : 8, which still shares a common factor of 2, so it is not fully simplified. Swapping the order gives 4 : 1, litres to millilitres the wrong way round.
20. (d) 3 : 2 — Convert both amounts to pence: £3.60 = 360p and £2.40 = 240p, giving the ratio 360 : 240. Divide both parts by their highest common factor, 120, to get 3 : 2. Giving 360 : 240 has not been simplified at all. Giving 2 : 3 swaps the order. Giving 36 : 24 has been divided by 10, which is a common factor but not the highest one, so it is not yet in simplest form.