✏️ Paper 1 non-calculator warm-up — Foundation

Answer key

1. (d) 1/4 — Method: count the digits after the decimal point to choose a denominator that is a power of ten, then cancel the fraction by the highest common factor of the numerator and the denominator. Working: 0.25 has two digits after the point, so 0.25 is 25 hundredths and can be written as 25/100; the highest common factor of 25 and 100 is 25, and 25 ÷ 25 = 1 with 100 ÷ 25 = 4. Answer: 1/4. The distractors: 2/5 comes from reading the two digits after the point as a numerator and a denominator and writing 2 over 5; 1/25 comes from putting 1 over the digits after the point, as though 0.25 meant one twenty-fifth; 1/40 comes from miscounting the decimal places and using a denominator of 1000, giving 25/1000, which cancels by 25 to 1/40.
2. (c) 40 cm — Method: split the total length into the number of parts shown by the ratio, then find the value of the shorter share. Working: the ratio 4:5 has 4 + 5 = 9 parts, so one part is 90 ÷ 9 = 10 cm, and the shorter piece is 4 × 10 = 40 cm. So the shorter piece is 40 cm. Distractor 50 cm is the length of the LONGER piece, not the shorter one. Distractor 45 cm comes from splitting the ribbon into two equal halves, ignoring the ratio. Distractor 10 cm is the value of one part, found correctly but never multiplied by 4.
3. (d) 1 × 10⁷ seconds — Method: the time for a journey is the distance divided by the speed, so round each number to 1 significant figure and then divide; dividing numbers in standard form means dividing the coefficients and subtracting the indices. Working: 3.1 × 10¹⁵ rounds to 3 × 10¹⁵ and 2.998 × 10⁸ rounds to 3 × 10⁸; 3 ÷ 3 = 1 for the coefficients, and 15 − 8 = 7 for the indices. Answer: about 1 × 10⁷ seconds. The distractors: 3 × 10⁷ seconds comes from subtracting the indices correctly but leaving the coefficient as 3 instead of dividing 3 by 3; 1 × 10⁻⁷ seconds comes from dividing the speed by the distance instead of the distance by the speed; 9 × 10²³ seconds comes from multiplying the two quantities instead of dividing them, since 3 × 3 = 9 and 15 + 8 = 23.
4. (b) 0.6 — Method: convert the fraction to an equivalent fraction with denominator 10, then read off the decimal. Working: 3/5 = 6/10 (multiplying numerator and denominator by 2) = 0.6. Answer: 0.6. 0.35 comes from combining the digits 3 and 5 directly after the decimal point instead of converting the fraction. 0.53 comes from writing the numerator and denominator digits in the wrong order. 1.67 comes from flipping the fraction to 5/3 before converting to a decimal.
5. (b) 1 — Method: BIDMAS deals with the index before the subtraction, and a negative number multiplied by itself gives a positive result. Working: (−2)² = (−2) × (−2) = 4, so the calculation becomes 4 − 3 = 1. Answer: 1. The distractors: −7 comes from squaring only the 2 and leaving the minus sign outside the index, giving −(2²) − 3 = −4 − 3 = −7; −1 comes from subtracting the square from 3 instead of 3 from the square, giving 3 − 4 = −1; 25 comes from carrying out the subtraction before the index, giving (−2 − 3)² = (−5)² = 25.
6. (c) 18 — 45 ÷ 5 = 9, and 2 × 9 = 18. A candidate who stops after finding one fifth gets 9. A candidate who uses 3/5 instead of 2/5 gets 27. A candidate who uses 4/5 instead of 2/5 gets 36.
7. (c) 0.7, 0.72, 3/4 — Method: numbers written in different forms cannot be compared as they stand, so every fraction is turned into a decimal by dividing the numerator by the denominator, and the decimals are then compared place by place from the left. Working: 3/4 means 3 ÷ 4 = 0.75, so the three values to compare are 0.7, 0.75 and 0.72; written to two decimal places they are 0.70, 0.75 and 0.72, and the hundredths digits 0, 5 and 2 put 0.70 first, 0.72 next and 0.75 last; written again in the forms the question used, the order from smallest is 0.7, then 0.72, then 3/4. Answer: 0.7, 0.72, 3/4. The distractors: 3/4, 0.7, 0.72 comes from turning 3/4 into 0.34 by writing the numerator and the denominator as the two digits after the point, which makes the fraction the smallest of the three; 0.72, 3/4, 0.7 comes from the belief that the more digits a decimal has the smaller it must be, which puts both 0.72 and 0.75 below 0.7 and 0.72 below 0.75; 3/4, 0.72, 0.7 comes from comparing the three values correctly but listing them largest first, against an instruction to start with the smallest.
8. (a) 45% — Method: percentage increase = increase ÷ original amount × 100. Working: the increase is £116 − £80 = £36, and 36 ÷ 80 = 0.45, so 0.45 × 100 = 45%. Answer: 45%. The distractors: 36% comes from quoting the £36 increase as though pounds and per cent were the same thing; 31% comes from dividing the £36 increase by the new price £116 instead of by the original £80, which gives 31% to the nearest per cent; 145% is the new price written as a percentage of the original price, which is the whole of the new price rather than the increase.
9. (d) 25% — Method: to convert a decimal to a percentage, multiply by 100. Working: 0.25 × 100 = 25. Answer: 25%. The distractors: 0.25% comes from writing a percent sign after the decimal without multiplying; 2.5% comes from multiplying by 10 instead of 100; 250% comes from multiplying by 1000.
10. (d) 600 — Method: the number of seats is the number of rows multiplied by the number of seats in each row, so round each number to 1 significant figure and then multiply the rounded values, which is quick because a product of two multiples of ten is found by multiplying the non-zero digits and attaching the zeros. Working: 21 rounds to 20 and 29 rounds to 30; 2 × 3 = 6, and 20 and 30 carry one zero each, so two zeros follow the 6. Answer: about 600 seats. The distractors: 50 comes from adding the two rounded numbers instead of multiplying them, 20 + 30; 60 comes from multiplying 20 by the 3 of 30 and forgetting the zero in 30; 6,000 comes from attaching three zeros to 2 × 3 when 20 and 30 provide only two between them.
11. (a) 13/40 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.325 = 325/1000 = 13/40 (dividing both numerator and denominator by 25). Answer: 13/40. 13/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 8/25 comes from rounding 0.325 down to 0.32 before converting. 3/8 comes from recalling the learned conversion 3/8 = 0.375 and matching it to 0.325 because both are three-place decimals beginning with 3, instead of converting the decimal given.
12. (b) £45.90 — The cost is 18 × £3.45 = £62.10. Profit = £108 − £62.10 = £45.90. A candidate who does not borrow in the tenths column, doing 1 − 0 = 1 instead of borrowing to make 10 − 1 = 9 and so leaving the units as 8 − 2 = 6, gets £46.10. A candidate who adds the cost to the selling price instead of subtracting gets £108 + £62.10 = £170.10. A candidate who gives the cost instead of the profit gets £62.10.
13. (c) £47.00 — First apply the 20% reduction: £65 × 0.8 = £52.00. Then take off the further £5: £52.00 − £5 = £47.00. Treating the 20% as a flat £20 rather than a percentage of the price, £65 − £20 − £5, gives £40.00. Applying the 20% reduction correctly but forgetting to take off the extra £5 leaves £52.00. Taking off the £5 first and then applying the 20% reduction to the smaller amount, (£65 − £5) × 0.8, gives £48.00.
14. (d) 25% — Method: percentage decrease = decrease ÷ original amount × 100. Working: the reduction is £60 − £45 = £15, and 15 ÷ 60 = 0.25, so 0.25 × 100 = 25%. Answer: 25%. The distractors: 15% comes from quoting the £15 reduction as though pounds and per cent were the same thing; 33% comes from dividing the £15 by the new price £45 instead of by the original £60, which gives 33% to the nearest per cent; 75% is the new price written as a percentage of the old one, which is what is still paid rather than what has been taken off.
15. (c) 25/36 — Method: square a fraction by squaring its numerator and its denominator separately, then add the two results over a common denominator. Working: (2/3)² = 4/9 and (1/2)² = 1/4; the lowest common denominator of 9 and 4 is 36, so 4/9 = 16/36 and 1/4 = 9/36, and 16 + 9 = 25. Answer: 25/36. The distractors: 49/36 comes from adding the two fractions first and squaring the total, giving (7/6)²; 5/13 comes from squaring correctly but then adding the numerators and the denominators, as (4 + 1)/(9 + 4); 7/3 comes from doubling each fraction instead of squaring it, giving 4/3 + 1.
16. (d) 17 — 8 ÷ 2 = 4, then 20 − 4 = 16, then 16 + 1 = 17. Stopping after the subtraction and forgetting to add the final 1 leaves 16. Adding the 4 and the 1 together before subtracting gives 4 + 1 = 5, then 20 − 5 = 15 — the subtraction should use the 4 from the division, not a combined total. Working strictly left to right without giving division priority gives 20 − 8 = 12, then 12 ÷ 2 = 6, then 6 + 1 = 7.
17. (c) 9/10 — Method: write the decimal over 10 using its one decimal place. Working: 0.9 = 9/10, which is already in its simplest form since 9 and 10 share no common factor. Answer: 9/10. The student's fraction, 9/100, comes from always writing the denominator as 100, regardless of how many decimal places the number actually has. 9 comes from dropping the decimal point altogether and treating 0.9 as the whole number 9. 1/9 comes from flipping the correct fraction upside down.
18. (a) 120 — For the lowest common multiple, take each prime that appears in either factorisation, raised to the higher power. In 2³ × 3 and 2² × 3 × 5, the prime 2 appears with power 3 in one and power 2 in the other — take the higher, 2³; the prime 3 appears with the same power in both, 3¹; and the prime 5 appears only in the second factorisation, so use 5¹. Multiplying these, 2³ × 3 × 5, gives 120. Taking the lower power of 2 instead of the higher, and leaving out 5 altogether, gives the highest common factor, 12, instead. Multiplying the two original numbers together, 24 × 60, gives 1440, which double-counts every shared prime factor. Assuming the lowest common multiple is simply the larger of the two numbers gives 60, but 60 is not a multiple of 24 — 60 ÷ 24 does not divide exactly. So the lowest common multiple of 24 and 60 is 120.
19. (a) 30 cm — The tile's side length must be a common factor of 90 and 120. The factors of 90 include 1, 2, 3, 5, 6, 9, 10, 15, 18, 30, 45, 90; the factors of 120 include 1, 2, 3, 4, 5, 6, 8, 10, 12, 15, 20, 24, 30, 40, 60, 120. The highest number common to both lists is 30, so the largest square tile has a side length of 30 cm. Picking 15 cm, a common factor but not the largest, gives tiles that are smaller than necessary. Picking 10 cm, also a common factor but smaller still, wastes even more of the possible tile size. Working out the lowest common multiple instead of the highest common factor gives 360 cm, a length far bigger than either side of the patio. So the largest square tile Ben can use has a side length of 30 cm.
20. (c) 9 — Method: factors come in pairs that multiply to give the number, so work through the pairs in order; a factor paired with itself is counted only once. Working: the pairs are 1 × 100, 2 × 50, 4 × 25, 5 × 20 and 10 × 10. The first four pairs give eight different factors, and the last pair adds only one more, so the factors are 1, 2, 4, 5, 10, 20, 25, 50 and 100. Answer: 9. The distractors: 10 comes from counting the pair 10 × 10 as two separate factors; 8 comes from leaving 1 out of the list, on the view that 1 is not a proper factor; 4 comes from writing 100 = 2² × 5² and multiplying the two indices together instead of adding 1 to each index first.