✏️ Paper 1 non-calculator warm-up — Foundation

Answer key

1. (d) 3:8 — Convert 2 hours to minutes: 2 hours = 120 minutes. The ratio is 45 : 120. The highest common factor of 45 and 120 is 15. Divide both parts by 15: 45 ÷ 15 = 3 and 120 ÷ 15 = 8, giving 3 : 8. Leaving the hours unconverted gives 45 : 2 — the units on each side are different, so this does not compare like with like. Dividing by 5 instead of 15 gives 9 : 24, which still shares a common factor of 3, so it is not fully simplified. Swapping the order gives 8 : 3, hours to minutes instead of minutes to hours.
2. (a) 3:2 — There are 24 green sweets and 16 orange sweets. The highest common factor of 24 and 16 is 8. Divide both numbers by 8: 24 ÷ 8 = 3 and 16 ÷ 8 = 2, so the ratio is 3 : 2. Dividing by 4 instead of 8 gives 6 : 4, which still has a common factor of 2, so it is not fully simplified. Writing green sweets to the total number of sweets, 24 : 40, simplifies to 3 : 5 — that compares green to everything, not green to orange, so it answers a different question. Swapping the order gives 2 : 3, green and orange the wrong way round.
3. (b) 5 — Method: divide the total amount of sugar by the amount needed for one cake, then round down because a part-used amount of sugar cannot make an extra whole cake. Working: 3 1/2 ÷ 2/3 = 7/2 × 3/2 = 21/4 = 5.25; only 5 complete cakes can be made, since the leftover 0.25 of a portion is not enough for a 6th cake. Answer: 5. 5.25 gives the exact result of the division without rounding down to a whole number of cakes. 7 comes from multiplying 3.5 by 2 and ignoring the need to also divide by 3 as part of dividing by the fraction 2/3. 6 comes from rounding 5.25 up to the nearest whole number instead of down, wrongly assuming a 6th cake could be made from the leftover sugar.
4. (d) 2:3 — The highest common factor of 20 and 30 is 10. Divide both parts of the ratio by 10: 20 ÷ 10 = 2 and 30 ÷ 10 = 3, so 20 : 30 = 2 : 3. Dividing by 5 instead of the highest common factor gives 4 : 6, which still shares a common factor of 2, so it is not fully simplified. Dividing only the first part by 10 and leaving the second part unchanged gives 2 : 30, which is not equivalent to the original ratio. Swapping the order of the two parts gives 3 : 2, the ratio the wrong way round.
5. (a) 15 : 12 — Multiply both parts of the ratio 5 : 4 by the same number, 3, to get an equivalent ratio: 5 × 3 = 15 and 4 × 3 = 12, giving 15 : 12. Giving 15 : 16 multiplies the two parts by different scale factors (×3 and ×4), which changes the ratio. Giving 9 : 8 adds 4 to each part instead of multiplying, which also changes the ratio. Giving 4 : 5 swaps the order of the two parts.
6. (c) 12 m — Method: the perimeter of a rectangle is twice the sum of the length and the width, so half the perimeter is one length plus one width; split that half using the ratio. Working: half of 64 is 64 ÷ 2 = 32 m, the ratio 5:3 has 5 + 3 = 8 parts, so one part is 32 ÷ 8 = 4 m, and the width is 3 × 4 = 12 m. So the width is 12 m. Distractor 20 m is the length, 5 parts, not the width. Distractor 24 m comes from splitting the whole perimeter, 64 m, into 8 parts and multiplying by 3, forgetting to halve the perimeter first. Distractor 8 m comes from the same slip stopped one step earlier: splitting the whole perimeter into 8 parts, 64 ÷ 8 = 8, and giving that instead of the width.
7. (a) 3200 — Method: round each number to 1 significant figure, then multiply the rounded numbers. Working: 37 rounds to 40 (the digit after the first, 7, rounds the 3 up to 4), and 84 rounds to 80, so the estimate is 40 × 80 = 3200. 2400 comes from rounding 37 down to 30, keeping the first digit as it is instead of letting the 7 round it up, giving 30 × 80 = 2400. 3108 comes from multiplying the exact numbers, 37 × 84, without rounding either of them first. 120 comes from adding the rounded numbers, 40 + 80 = 120, instead of multiplying them. Answer: 3200.
8. (a) 49 — Method: 7² means 7 multiplied by itself. Working: 7 × 7 = 49. Answer: 49. 14 comes from working out 7 × 2, treating the power 2 as a number to multiply by rather than an instruction to multiply 7 by itself. 77 comes from writing the digit 7 twice side by side, treating the power as an instruction to repeat the digit rather than to multiply. 9 comes from working out 7 + 2, adding the base and the power instead of multiplying the base by itself.
9. (d) 9 — List all the factors of 36 in pairs that multiply to give 36: 1 × 36, 2 × 18, 3 × 12, 4 × 9, and 6 × 6. This gives the factors 1, 2, 3, 4, 6, 9, 12, 18 and 36 — nine factors in total, with 6 counted only once even though it appears in a pair with itself. Forgetting that 36 is itself a factor of 36 and leaving it off the list gives 8. Counting the number of factor pairs, five of them, rather than the number of individual factors gives 5. Treating the repeated pair 6 × 6 as two separate factors, 6 and 6 again, gives 10 instead of 9. So 36 has 9 factors.
10. (c) 87 litres — Work out how much water is drained: 8 × 6 = 48 litres. Subtract this from the starting amount: 120 − 48 = 72 litres. Then add the 15 litres from the hose: 72 + 15 = 87 litres. Subtracting the 15 litres instead of adding it, as though the hose also removed water, gives 120 − 48 − 15 = 57 litres. Stopping after the drain step, without adding the hose water back in, leaves the working at 72 litres. Adding the rate and the time instead of multiplying them, 8 + 6 = 14 litres drained, and then working from there gives 120 − 14 + 15 = 121 litres. So 87 litres of water is left in the tank.
11. (a) £177.60 — Total raised = 240 × £1.85 = £444.00. The hospital receives 40% of this: £444.00 × 0.4 = £177.60. A candidate who works out the remaining 60% instead of the 40% given away gets £266.40. A candidate who forgets to find the percentage and gives the full total gets £444.00. A candidate who halves 40% by mistake and uses 20% gets £88.80.
12. (b) −5 — Using the order of operations, work out the multiplication first: 4 × (−2) = −8. Then 3 + (−8) = −5. A candidate who adds before multiplying gets (3 + 4) × (−2) = −14. A candidate who drops the negative sign on the multiplication gets 3 + 4 × 2 = 11. A candidate who works out the multiplication correctly but gives that as the final answer, forgetting to combine it with the 3, gets −8.
13. (d) £20 — 1% of £250 = £2.50, so 8% = 8 × £2.50 = £20. A candidate who misplaces the decimal point and finds 0.8% instead gets £2. A candidate who confuses 8% with 80% gets £200. A candidate who rounds 8% up to the nearby 10% gets £25.
14. (b) 30 — Method: the smallest matching total is the lowest common multiple of the two pack sizes. Working: multiples of 6 are 6, 12, 18, 24, 30 …; multiples of 10 are 10, 20, 30 …. The lowest common multiple is 30. 60 comes from working out 6 × 10 = 60, the product of the pack sizes rather than their lowest common multiple. 16 comes from working out 6 + 10 = 16, which is not a common multiple at all. 2 is the highest common factor of 6 and 10, not a total of tickets. Answer: 30.
15. (c) 10 — Method: the multiplication is carried out before the subtraction. Working: 4 × 2 = 8, so the calculation becomes 18 − 8 = 10. Answer: 10. The distractors: 28 comes from working from left to right, giving (18 − 4) × 2 = 14 × 2 = 28; −10 comes from subtracting the 18 from the 8 rather than the 8 from the 18, giving 8 − 18 = −10; 12 comes from reading 4 × 2 as 4 + 2 = 6 and then working out 18 − 6 = 12.
16. (c) 693 — Method: multiplying a bracket by a number multiplies every term inside it, so 7 × (100 − 1) = 7 × 100 − 7 × 1. Working: 7 × 100 = 700 and 7 × 1 = 7, so the calculation becomes 700 − 7 = 693. Answer: 693. The distractors: 699 comes from subtracting the 1 itself rather than 7 lots of it, giving 700 − 1 = 699; 707 comes from adding the second product instead of subtracting it, giving 700 + 7 = 707; 700 comes from rounding 99 up to 100 and then offering the estimate 7 × 100 as an exact value.
17. (c) 0.36 — Method: convert the fraction to an equivalent fraction with denominator 100, then read off the decimal. Working: 9/25 = 36/100 (multiplying numerator and denominator by 4) = 0.36. Answer: 0.36. 2.8 comes from flipping the fraction and dividing the denominator by the numerator instead: 25 ÷ 9 = 2.77…, rounded to 2.8. 0.925 comes from writing the digits of the numerator and denominator directly after the decimal point without scaling the fraction. 0.9 comes from writing the numerator straight after the decimal point, as if the denominator were 10 rather than 25.
18. (d) 17 — 8 ÷ 2 = 4, then 20 − 4 = 16, then 16 + 1 = 17. Stopping after the subtraction and forgetting to add the final 1 leaves 16. Adding the 4 and the 1 together before subtracting gives 4 + 1 = 5, then 20 − 5 = 15 — the subtraction should use the 4 from the division, not a combined total. Working strictly left to right without giving division priority gives 20 − 8 = 12, then 12 ÷ 2 = 6, then 6 + 1 = 7.
19. (a) 200 g — One quarter of 160 g is 40 g. Increasing the amount means adding this on: 160 + 40 = 200 g. Finding the increase, 1/4 of 160 = 40 g, but stopping there without adding it to the original amount leaves just 40 g. Using 4/5 instead of 5/4 as the scaling fraction, 160 × 4/5 = 128 g, actually decreases the amount rather than increasing it. Increasing by a half instead of a quarter, 160 + 80 = 240 g, uses the wrong fraction of 160.
20. (c) 0.7, 0.72, 3/4 — Method: numbers written in different forms cannot be compared as they stand, so every fraction is turned into a decimal by dividing the numerator by the denominator, and the decimals are then compared place by place from the left. Working: 3/4 means 3 ÷ 4 = 0.75, so the three values to compare are 0.7, 0.75 and 0.72; written to two decimal places they are 0.70, 0.75 and 0.72, and the hundredths digits 0, 5 and 2 put 0.70 first, 0.72 next and 0.75 last; written again in the forms the question used, the order from smallest is 0.7, then 0.72, then 3/4. Answer: 0.7, 0.72, 3/4. The distractors: 3/4, 0.7, 0.72 comes from turning 3/4 into 0.34 by writing the numerator and the denominator as the two digits after the point, which makes the fraction the smallest of the three; 0.72, 3/4, 0.7 comes from the belief that the more digits a decimal has the smaller it must be, which puts both 0.72 and 0.75 below 0.7 and 0.72 below 0.75; 3/4, 0.72, 0.7 comes from comparing the three values correctly but listing them largest first, against an instruction to start with the smallest.