🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (a) x¹¹ — Method: when multiplying powers of the same base, add the indices. Working: 7 + 4 = 11, so x⁷ × x⁴ = x¹¹. x²⁸ comes from multiplying the indices, 7 × 4 = 28, instead of adding them. x³ comes from working out 7 − 4 = 3, which is the rule for dividing powers, not multiplying them. 11x comes from adding the indices to make 11 but then treating x as a coefficient instead of a power. Answer: x¹¹.
2. (c) x = 0 or x = −7 — Factorising: x² + 7x = x(x + 7) = 0, so x = 0 or x + 7 = 0, giving x = 0 or x = −7. A candidate who divides both sides of the original equation by x, which loses the solution x = 0, gets only x = −7. A candidate who makes a sign error solving x + 7 = 0 gets x = 0 or x = 7. A candidate who misreads the coefficient and doubles it gets x = 0 or x = −14.
3. (d) x = 0 or x = 6 — Method: factorise by taking out the common factor x: x(x − 6) = 0, so x = 0 or x − 6 = 0, giving x = 0 or x = 6. Distractor origins: x = 6 comes from dividing both sides by x, which loses the solution x = 0; x = 0 stops after finding only one factor; x = 3 comes from halving the coefficient of x instead of factorising.
4. (d) a/2 — Method: write both terms over the same denominator, subtract the numerators, then cancel the fraction down. Working: 6 is a multiple of 3, so a/3 is rewritten as 2a/6; the calculation becomes 5a/6 − 2a/6 = 3a/6, and dividing numerator and denominator by 3 gives a/2. Answer: a/2. The distractors: 4a/3 comes from subtracting the denominators as well as the numerators, giving (5 − 1)a over (6 − 3); 2a/3 comes from subtracting 1 from 5 without first rewriting a/3 as 2a/6, giving 4a/6; 7a/6 comes from adding the two fractions instead of subtracting them, giving 5a/6 + 2a/6.
5. (d) 12 m — Method: give the width a letter, write the length in terms of it and use length × width = area to form a quadratic. Working: with a width of x metres the length is x + 4, so x(x + 4) = 96, which rearranges to x² + 4x − 96 = 0; factorising gives (x + 12)(x − 8) = 0, and a width must be positive, so x = 8 and the length is 8 + 4 = 12. Answer: 12 m, and 12 × 8 = 96 as the area requires. The distractors: 8 m is the width rather than the length asked for; 16 m comes from taking the other root as 12 and adding 4 to it, ignoring that the root −12 cannot be a width; 24 m comes from dividing the area by the 4 in the question instead of forming an equation.
6. (c) cos 45° — cos 45° = √2/2, and √2 cannot be written as an exact fraction, so this value is irrational. tan 0° = 0, sin 90° = 1 and sin 30° = 1/2 are all rational, since each can be written as an exact whole number or fraction.
7. (c) 25 — Method: read off a, b and c with their signs and substitute them into b² − 4ac. Working: for 2x² + 3x − 2 = 0, a = 2, b = 3 and c = −2, so b² − 4ac = 3² − 4 × 2 × (−2) = 9 − (−16) = 9 + 16 = 25. Answer: 25. The distractors: −7 comes from taking c as +2, which gives 9 − 16; 22 comes from working b² as 2 × 3 = 6 and then 6 + 16; 13 comes from leaving the 4 out of 4ac and working 9 − 2 × (−2).
8. (b) 5/27 — Method: multiply the numerators together and the denominators together, then simplify. Working: (5 × 2)/(6 × 9) = 10/54 = 5/27. Answer: 5/27. 7/15 comes from adding the fractions instead of multiplying: (5+2)/(6+9) = 7/15. 15/4 comes from flipping the second fraction, as if dividing: (5 × 9)/(6 × 2) = 45/12 = 15/4. 5/3 comes from cancelling the two denominators against each other, dividing both 6 and 9 by 3 to leave 5/2 × 2/3 = 10/6 = 5/3; cancelling is only valid between a numerator and a denominator, never between two denominators.
9. (c) tan 45° — Method: replace each ratio by its exact value, then compare. Working: a right-angled triangle with a 45° angle is isosceles, so its opposite and adjacent sides are equal and the tangent of 45° is exactly 1. The others are cos 30° = √3/2, about 0.87; sin 45° = √2/2, about 0.71; and cos 60° = 1/2. Answer: tan 45°, the only one of the four that reaches 1. Reading √3/2 as though it were √3, about 1.73, makes cos 30° look the largest, but the division by 2 is part of the value. Ranking by the size of the angle also fails here, because the cosine of an angle falls as the angle grows.
10. (c) 5/11 — Let x = 0.45 recurring, so x = 0.454545... . Since two digits repeat, multiply by 100: 100x = 45.454545... . Subtracting the original x removes the recurring part exactly, because it lines up digit for digit: 100x − x = 45.454545... − 0.454545... = 45, so 99x = 45, giving x = 45/99 = 5/11. Treating the decimal as if it terminated at two places gives 45/100 = 9/20, which is only 0.45 and drops the repeating part entirely. Subtracting 10x instead of x — using 100x − 10x = 90x = 45 — is the wrong power of ten for a two-digit repeating block, and gives x = 45/90 = 1/2. Making an arithmetic slip in the numerator, 45 − 1 = 44 instead of 45, gives 44/99 = 4/9.
11. (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
12. (d) 6 m — The horizontal distance is adjacent to the 60° angle and the zip-wire is the hypotenuse, so horizontal distance = 12 × cos 60° = 12 × 1/2 = 6 m. 6√3 m comes from using sin 60° = √3/2 instead of cos 60°, which would give the vertical drop, not the horizontal distance. 4√3 m comes from treating 12 as the side adjacent to a tangent ratio and dividing by tan 60° = √3. 24 m comes from dividing 12 by cos 60° instead of multiplying by it.
13. (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
14. (a) 5√2 — Simplify each surd first: √8 = √4 × √2 = 2√2, and √18 = √9 × √2 = 3√2. Both terms are now multiples of √2, so they are like terms: 2√2 + 3√2 = 5√2. Adding the numbers under the two roots first, 8 + 18 = 26, and writing √26 treats unlike surds as if they combine under one root — they only combine once they share the same radicand, which is not how addition of surds works. Writing 9√2 for √18 instead of 3√2 (forgetting to root the 9) and then adding gives 2√2 + 9√2 = 11√2. Writing 4√2 for √8 instead of 2√2 (forgetting to root the 4) and adding gives 4√2 + 3√2 = 7√2.
15. (d) x² − 6x + 9 — Method: squaring a bracket means multiplying that bracket by itself, so expand (x − 3)(x − 3) term by term and then collect like terms. Working: x × x = x², x × (−3) = −3x, (−3) × x = −3x and (−3) × (−3) = 9, giving x² − 3x − 3x + 9, and the two middle terms collect to −6x. Answer: x² − 6x + 9. The distractors: x² − 3x + 9 comes from writing down only one of the two middle products instead of both; x² + 6x + 9 comes from treating (−3) × x as +3x, so the middle terms are added rather than subtracted; x² − 9 comes from treating the square as the difference of two squares (x − 3)(x + 3).
16. (c) x = −2 or x = 4 — The solutions of x² − 2x − 8 = 0 are the x-values where y = 0. From the table, y = 0 when x = −2 and when x = 4, so those are the two solutions. Distractor origins: x = −1 or x = 3 picks the pair of x-values that give equal (but non-zero) y-values instead of y = 0; x = 0 or x = −8 mixes up an x-value with its corresponding y-value; x = −2 only reads off one of the two roots and misses the other.
17. (d) 2x/(x − 2) — Factorise x² − 4 as (x − 2)(x + 2) first — it's a difference of two squares. The (x + 2) in the numerator then cancels with the (x + 2) in the factorised denominator, and 6x² ÷ 3x simplifies to 2x, leaving 2x/(x − 2). Writing 2/(x − 2) comes from over-cancelling 6x² ÷ 3x as 2 instead of 2x, dropping the x that should remain. Writing 2x/(x + 2) comes from factorising x² − 4 as (x + 2)² instead of (x − 2)(x + 2), a difference of two squares always has one plus and one minus bracket. Writing 2x²/(x − 2) comes from simplifying 6x² ÷ 3x as 2x² instead of 2x, dividing the coefficients but not reducing the power of x.
18. (c) x⁽²⁄³⁾ — Method: a root can be written as a fractional index, with the root's index as the denominator and the power inside the root as the numerator. Working: the cube root gives a denominator of 3 and the square inside gives a numerator of 2, so ∛(x²) = x⁽²⁄³⁾. Answer: x⁽²⁄³⁾. The distractors: x⁽³⁄²⁾ comes from writing the fraction upside down, with the root's index on top; x⁽¹⁄⁶⁾ comes from treating the square as a second root and multiplying 1/3 by 1/2; x⁶ comes from multiplying the root's index by the power, 3 × 2, and keeping the result as a whole-number index.
19. (b) 0.58333... — Divide 7 by 12 using long division. 70 ÷ 12 = 5 remainder 10, so the first decimal digit is 5. Bring down a 0 to make 100: 100 ÷ 12 = 8 remainder 4, so the second digit is 8. Bring down a 0 to make 40: 40 ÷ 12 = 3 remainder 4, so the third digit is 3. Bring down a 0 to make 40 again — the remainder 4 has reappeared, so the digit 3 repeats forever from here. This gives 7/12 = 0.58333... . Stopping the division after two digits and writing 0.58 treats it as if it terminated, when the remainder is not yet zero. Misreading the pattern as a two-digit repeating block, '58', gives 0.585858..., which wrongly makes the 5 recur as well as the 3. A slip in the long division that carries the wrong remainder forward can make the second digit itself appear to repeat instead of the third, giving 0.588888... .
20. (b) (x − 5)(x + 2) — We need two numbers that multiply to −10 and add to −3: these are −5 and 2, since −5 × 2 = −10 and −5 + 2 = −3. So x² − 3x − 10 = (x − 5)(x + 2). A candidate who swaps the signs, using +5 and −2, gets (x + 5)(x − 2), which expands to x² + 3x − 10 — the wrong middle term. A candidate who picks the factor pair 1 and 10 instead of 2 and 5 gets (x − 10)(x + 1), which expands to x² − 9x − 10. A candidate who makes both factors negative gets (x − 5)(x − 2), which expands to x² − 7x + 10 — the wrong sign on the constant term.