🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (a) 0.625 — Method: convert the fraction to a decimal so it can be compared properly with 0.6. Working: 5/8 = 0.625, and since 0.625 > 0.6, the larger value is 0.625. Answer: 0.625. 0.6 repeats Sam's incorrect claim, made by comparing single digits rather than full place value. 0.58 comes from converting 5/8 incorrectly, treating it as if it read 5 tenths and 8 hundredths. 0.85 comes from turning the fraction upside down and writing its digits straight after the decimal point, 8 then 5, instead of dividing.
2. (c) 6x(2x + 3) — The highest common factor of 12x² and 18x is 6x. Dividing each term by 6x gives 12x² ÷ 6x = 2x and 18x ÷ 6x = 3, so 12x² + 18x = 6x(2x + 3). A candidate who only takes out the number 6 (missing the x) gets 6(2x² + 3x), which is not fully factorised. A candidate who only takes out 2x (missing the extra factor of 3 in 6) gets 2x(6x + 9), also not fully factorised — the bracket still shares a common factor. A candidate who takes out 3x instead of the full 6x gets 3x(4x + 6), which again is not fully factorised since 4x + 6 shares a common factor of 2.
3. (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
4. (c) 100√3 cm — The height is opposite the 60° angle, so height = 2 × sin 60° = 2 × √3/2 = √3 m. Converting to centimetres: √3 m = 100√3 cm. '√3 cm' forgets to convert the answer from metres to centimetres. '200√3 cm' comes from mis-recalling sin 60° as √3 instead of √3/2, dropping the denominator of the exact value: 2 × √3 = 2√3 m = 200√3 cm. '50√3 cm' comes from halving the ladder's length before multiplying by sin 60°, instead of using the full 2 m.
5. (d) 6 m — The horizontal distance is adjacent to the 60° angle and the zip-wire is the hypotenuse, so horizontal distance = 12 × cos 60° = 12 × 1/2 = 6 m. 6√3 m comes from using sin 60° = √3/2 instead of cos 60°, which would give the vertical drop, not the horizontal distance. 4√3 m comes from treating 12 as the side adjacent to a tangent ratio and dividing by tan 60° = √3. 24 m comes from dividing 12 by cos 60° instead of multiplying by it.
6. (c) 2 — First write 1 1/2 as an improper fraction, 3/2. To divide by 3/4, multiply by its reciprocal, 4/3: 3/2 × 4/3 = 12/6 = 2. Dropping the whole number and dividing only the fractional part, 1/2 ÷ 3/4 = 1/2 × 4/3, gives 2/3. Multiplying by 3/4 directly instead of using its reciprocal, 3/2 × 3/4, gives 9/8. Using the reciprocal of the first fraction instead of the second, 2/3 × 3/4, gives 1/2.
7. (a) 17 — Method: work out each power separately, then combine them as the question asks. Working: $2^3 = 8$ and $3^2 = 9$, and 8 + 9 = 17. 72 comes from working out 8 × 9 = 72, multiplying the two powers instead of adding them. 12 comes from misreading the powers as repeated multiplication of the base by the index, 2 × 3 + 3 × 2 = 6 + 6 = 12. −1 comes from working out 8 − 9 = −1, subtracting the powers instead of adding them. Answer: 17.
8. (c) 7/30 — Let x = 0.2333... . Because only the 3 recurs, use two multiples of x that line up the recurring part exactly: 10x = 2.333... and 100x = 23.333... . Subtracting removes the recurring tail completely: 100x − 10x = 23.333... − 2.333... = 21, so 90x = 21, giving x = 21/90 = 7/30. Treating the decimal as if it terminated after two places, writing 0.23 as 23/100, ignores that the 3 carries on forever. Misreading which digits recur — treating 0.2333... as if the block '23' repeated, giving 0.232323... — leads to x = 23/99, which is a different, larger recurring decimal from the one given. A numerator slip in the subtraction, computing 22 instead of 21, gives x = 22/90 = 11/45.
9. (a) x = 4 or x = −3 — Method: find two numbers that multiply to give −12 and add to give −1 — these are −4 and 3. So x² − x − 12 = (x − 4)(x + 3) = 0, giving x = 4 or x = −3. Distractor origins: x = −4 or x = 3 has the signs the wrong way round; x = 4 or x = 3 makes both roots positive, ignoring the sign of −12; x = 12 or x = −1 comes from reading off the coefficient and the constant directly instead of factorising.
10. (b) 5² — Method: multiplying two powers of the same base adds their indices, and a negative index is added as a negative number. Working: −2 + 4 = 2, so 5⁻² × 5⁴ = 5². Answer: 5². The distractors: 5⁶ comes from adding the sizes of the indices, 2 + 4, and ignoring the minus sign; 5⁻⁸ comes from multiplying the indices, −2 × 4, instead of adding them; 5⁻⁶ comes from subtracting the indices, −2 − 4, as though the powers were being divided.
11. (b) 16π — Use the circumference formula C = 2πr to find the radius: 8π = 2πr, so r = 8π ÷ 2π = 4 cm. Then use the area formula A = πr²: A = π × 4² = 16π cm². Using C = πr instead of C = 2πr gives r = 8, and squaring that gives 64π. Finding r = 4 correctly but then substituting it back into the circumference formula instead of the area formula gives 2π × 4 = 8π. Finding r = 4 correctly but forgetting to square it in the area formula, using A = πr instead of A = πr², gives 4π.
12. (c) 0.001 — Method: a negative index means 'one over' the positive power, so $10^{-3}$ means one over $10^{3}$. Working: ten cubed is 1000, and one over 1000 is 0.001. 1000 comes from ignoring the negative sign and working out ten cubed instead of its reciprocal. −1000 comes from ignoring what the negative index does to the size, while still writing a negative sign on the large value. −0.001 comes from correctly finding the size, 0.001, but wrongly keeping a negative sign because the index was negative. Answer: 0.001.
13. (c) 3⁻³ — Method: when dividing powers of the same base, subtract the index of the number you are dividing by from the index of the number being divided, keeping them in the order the question writes them. Working: 2 − 5 = −3, so 3² ÷ 3⁵ = 3⁻³. It is worth checking this against the numbers: 3² = 9 and 3⁵ = 243, and 9 ÷ 243 = 1/27, which is 3⁻³. 3³ comes from subtracting the other way round, 5 − 2 = 3, which reverses the sign of the index and gives 27 instead of 1/27. 3⁷ comes from working out 2 + 5 = 7, which is the rule for multiplying powers, not dividing them. 3¹⁰ comes from multiplying the indices, 2 × 5 = 10, instead of subtracting them. Answer: 3⁻³.
14. (c) 1/2 — sin 45° = √2/2 and cos 45° = √2/2, so sin 45° × cos 45° = √2/2 × √2/2 = 2/4 = 1/2. √2/2 comes from writing down only one of the two factors and forgetting to multiply by the other. √2 comes from adding the two exact values instead of multiplying them: √2/2 + √2/2 = √2. 1 comes from wrongly treating sin 45° × cos 45° as sin(45° + 45°) = sin 90° = 1 — multiplying two ratios is not the same as adding their angles.
15. (b) 9 — Method: a negative index means take the reciprocal of the base first and then apply the positive power. Working: the reciprocal of 1/3 is 3, so (1/3)⁻² = 3² = 3 × 3 = 9. Answer: 9. The distractors: 1/9 comes from ignoring the minus sign and squaring 1/3 as it stands; −9 comes from reading the negative index as a minus sign on the result; 6 comes from multiplying the denominator by the index, 3 × 2, instead of squaring the reciprocal.
16. (b) (x − 3)/(x + 2) — Factorise both: x² − 9 = (x − 3)(x + 3) (difference of two squares), and x² + 5x + 6 = (x + 2)(x + 3) (two numbers multiplying to 6 and adding to 5, namely 2 and 3). The factor (x + 3) is common to both, so it cancels, leaving (x − 3)/(x + 2). Choosing −9/(5x + 6) comes from cancelling the x² terms directly without factorising first — x² is not a common factor of the whole numerator or denominator. Choosing (x + 3)/(x + 2) cancels the (x − 3) factor instead of the shared (x + 3) factor, and (x − 3) does not appear in the denominator to cancel with. Choosing x − 3 cancels the whole denominator (x + 2) as though it were equal to 1.
17. (b) 1/9 — Method: let x stand for the recurring decimal, multiply by the power of ten that moves exactly one repeating block past the decimal point, subtract the original equation so that the recurring tail cancels, and solve the equation that is left. Working: let x = 0.111...; the repeating block is one digit long, so multiply by 10 to give 10x = 1.111...; subtracting the first equation from the second gives 10x − x = 1.111... − 0.111..., that is 9x = 1; dividing both sides by 9 gives x = 1/9. Answer: 1/9. The distractors: 1/10 comes from dividing by the multiplier 10 at the last step instead of by the 9 that is left in front of x; 1/11 comes from recalling the elevenths family instead of the ninths, although 1/11 = 0.0909... has a two-digit repeating block rather than a one-digit one; 11/100 comes from stopping the decimal after two digits and converting 0.11 into hundredths.
18. (c) 1 — cos 45° = √2/2 and sin 45° = √2/2. Squaring each gives (√2/2)² = 2/4 = 1/2, so (cos 45°)² + (sin 45°)² = 1/2 + 1/2 = 1. The distractor √2 comes from adding cos 45° + sin 45° directly without squaring first (√2/2 + √2/2 = √2). The distractor 2 comes from squaring the top of the fraction, (√2)² = 2, but then dividing by 2 instead of 4 for each term, giving 1 + 1 = 2. The distractor 1/2 comes from squaring only cos 45° and forgetting to add the sin 45° term.
19. (c) x = 3 or x = 1/2 — Method: factorise into two brackets whose x terms multiply to 2x² and whose numbers multiply to 3, checking that they produce the middle term −7x, then set each bracket equal to zero. Working: (2x − 1)(x − 3) expands to 2x² − 6x − x + 3 = 2x² − 7x + 3, so (2x − 1)(x − 3) = 0; then 2x − 1 = 0 gives x = 1/2 and x − 3 = 0 gives x = 3. Answer: x = 3 or x = 1/2. The distractors: x = 3/2 or x = 1 comes from factorising as (2x − 3)(x − 1), whose middle term is −5x and not −7x; x = −3 or x = −1/2 comes from reading the roots straight out of (2x − 1)(x − 3) without changing the signs; x = 6 or x = 1 comes from using the quadratic formula with the denominator written as a instead of 2a, dividing 7 ± 5 by 2.
20. (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.