🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (d) k < 4 — Method: the number of real solutions of ax² + bx + c = 0 is decided by the discriminant b² − 4ac, and two different real solutions need it to be greater than zero. Working: here a = 1, b = −4 and c = k, so b² − 4ac = 16 − 4k; the condition is 16 − 4k > 0, which gives 16 > 4k and then k < 4. Answer: k < 4; for example k = 3 gives x² − 4x + 3 = 0, whose solutions are 1 and 3. The distractors: k ≤ 4 comes from using b² − 4ac ≥ 0, which also allows the single repeated solution at k = 4; k > 4 comes from dividing −4k > −16 by −4 without reversing the inequality sign; k < 16 comes from leaving the factor 4 out of 4ac and solving 16 − k > 0.
2. (d) x = 3 or x = −3 — Method: get x² on its own with a coefficient of 1, then take the square root of both sides and keep both the positive and the negative root. Working: dividing 2x² = 18 by 2 gives x² = 9, and the square root of 9 is 3, so x = 3 or x = −3; both check, because 2 × 9 = 18 either way. Answer: x = 3 or x = −3. The distractors: x = 9 or x = −9 comes from dividing by 2 and then forgetting to take the square root; x = 4 or x = −4 comes from subtracting 2 from 18 instead of dividing by it, giving x² = 16; x = 6 or x = −6 comes from multiplying by 2 instead of dividing, giving x² = 36.
3. (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
4. (c) x = −2 or x = 4 — The solutions of x² − 2x − 8 = 0 are the x-values where y = 0. From the table, y = 0 when x = −2 and when x = 4, so those are the two solutions. Distractor origins: x = −1 or x = 3 picks the pair of x-values that give equal (but non-zero) y-values instead of y = 0; x = 0 or x = −8 mixes up an x-value with its corresponding y-value; x = −2 only reads off one of the two roots and misses the other.
5. (a) t = 0 or t = 4 — The ball is at ground level exactly when h = 0. From the table, h = 0 at t = 0 and at t = 4, so those are the two times. Distractor origins: t = 1 or t = 3 picks the times with equal (but non-zero) height instead of ground level; t = 2 picks the time of maximum height instead of ground level; t = 0 finds only the starting time and misses the second one.
6. (d) 16π cm² — Method: for a circle, area = π × radius². Working: area = π × 4² = π × 16 = 16π cm². Answer: 16π cm². The student squared the radius but left out the π, which is why 16 cm² is not the exact area. 4π cm² comes from multiplying by the radius once instead of squaring it: π × 4 = 4π. 8π cm² comes from using the circumference formula 2 × π × radius instead of the area formula: 2 × π × 4 = 8π. 64π cm² comes from using the diameter (8 cm) as the radius in the area formula: π × 8² = 64π.
7. (b) 0.83333... — Divide 5 by 6 using long division. 5.000... ÷ 6: 50 ÷ 6 = 8 remainder 2, giving the first decimal digit 8. Bring down a 0 to make 20, and 20 ÷ 6 = 3 remainder 2 — the remainder 2 has reappeared, so from here the digit 3 repeats forever. This gives 5/6 = 0.83333... . Stopping after two decimal places and writing 0.83 treats the division as if it terminated, when the remainder never reaches zero. Shifting the decimal point one place too far to the left gives 0.083333..., the same digits divided by an extra power of ten. A slip in the long division itself, misreading a remainder, can produce the wrong repeating digit, 0.85555... .
8. (c) x = 0 or x = 3 — Method: take out the common factor 5x: 5x(x − 3) = 0, so 5x = 0 or x − 3 = 0, giving x = 0 or x = 3. Distractor origins: x = 0 or x = 15 comes from forgetting to divide the second term by the common factor 5x correctly, leaving 15 instead of 3; x = 3 loses the solution x = 0 by dividing both sides by x; x = 5 or x = 3 mistakes the coefficient 5 itself for one of the solutions.
9. (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
10. (d) x⁽¹⁄²⁾ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided, and fractional indices are subtracted like any other fractions. Working: 3/4 − 1/4 = 2/4, which simplifies to 1/2, so the result is x⁽¹⁄²⁾. Answer: x⁽¹⁄²⁾. The distractors: x comes from adding the indices, 3/4 + 1/4 = 1, as though the powers were being multiplied; x³ comes from dividing the indices, so that 3/4 divided by 1/4 gives 3; x⁽³⁄¹⁶⁾ comes from multiplying the indices, 3/4 × 1/4.
11. (c) 9/5 — Method: the area of a rectangle is its length multiplied by its width; the decimal product is then written over a power of ten and cancelled. Working: 24 × 75 = 1800, and 2.4 and 0.75 have three decimal places between them, so 2.4 × 0.75 = 1.8; the area of the panel is 1.8 square metres, which is eighteen tenths, so it can be written as 18/10, and dividing the numerator and the denominator by 2 gives 9 over 5. Answer: 9/5. The distractors: 4/5 comes from converting only the digits after the decimal point and losing the whole one, turning 1.8 into eight tenths; 63/20 comes from adding the two sides instead of multiplying them, giving 3.15; 9/50 comes from misplacing the decimal point in the product and writing 0.18, which cancels to 9 over 50.
12. (c) x = 0 or x = −7 — Factorising: x² + 7x = x(x + 7) = 0, so x = 0 or x + 7 = 0, giving x = 0 or x = −7. A candidate who divides both sides of the original equation by x, which loses the solution x = 0, gets only x = −7. A candidate who makes a sign error solving x + 7 = 0 gets x = 0 or x = 7. A candidate who misreads the coefficient and doubles it gets x = 0 or x = −14.
13. (b) 5/27 — Method: multiply the numerators together and the denominators together, then simplify. Working: (5 × 2)/(6 × 9) = 10/54 = 5/27. Answer: 5/27. 7/15 comes from adding the fractions instead of multiplying: (5+2)/(6+9) = 7/15. 15/4 comes from flipping the second fraction, as if dividing: (5 × 9)/(6 × 2) = 45/12 = 15/4. 5/3 comes from cancelling the two denominators against each other, dividing both 6 and 9 by 3 to leave 5/2 × 2/3 = 10/6 = 5/3; cancelling is only valid between a numerator and a denominator, never between two denominators.
14. (c) 3⁻³ — Method: when dividing powers of the same base, subtract the index of the number you are dividing by from the index of the number being divided, keeping them in the order the question writes them. Working: 2 − 5 = −3, so 3² ÷ 3⁵ = 3⁻³. It is worth checking this against the numbers: 3² = 9 and 3⁵ = 243, and 9 ÷ 243 = 1/27, which is 3⁻³. 3³ comes from subtracting the other way round, 5 − 2 = 3, which reverses the sign of the index and gives 27 instead of 1/27. 3⁷ comes from working out 2 + 5 = 7, which is the rule for multiplying powers, not dividing them. 3¹⁰ comes from multiplying the indices, 2 × 5 = 10, instead of subtracting them. Answer: 3⁻³.
15. (c) cos 45° — cos 45° = √2/2, and √2 cannot be written as an exact fraction, so this value is irrational. tan 0° = 0, sin 90° = 1 and sin 30° = 1/2 are all rational, since each can be written as an exact whole number or fraction.
16. (c) 25 cm — Method: for a cube, the edge length is the cube root of the volume. Working: 25 × 25 × 25 = 15,625, so the edge length is 25 cm. 5 cm comes from cube-rooting 125 instead of 15,625, misreading the number of digits. 50 cm comes from working out 25 × 2 = 50, doubling the correct edge length. 125 cm comes from taking the square root of the volume instead of the cube root, since 125 × 125 = 15,625 — that would be the side of a SQUARE of area 15,625, not the edge of a cube of that volume. Answer: 25 cm.
17. (c) 6x(2x + 3) — The highest common factor of 12x² and 18x is 6x. Dividing each term by 6x gives 12x² ÷ 6x = 2x and 18x ÷ 6x = 3, so 12x² + 18x = 6x(2x + 3). A candidate who only takes out the number 6 (missing the x) gets 6(2x² + 3x), which is not fully factorised. A candidate who only takes out 2x (missing the extra factor of 3 in 6) gets 2x(6x + 9), also not fully factorised — the bracket still shares a common factor. A candidate who takes out 3x instead of the full 6x gets 3x(4x + 6), which again is not fully factorised since 4x + 6 shares a common factor of 2.
18. (b) 1/9 — Method: let x stand for the recurring decimal, multiply by the power of ten that moves exactly one repeating block past the decimal point, subtract the original equation so that the recurring tail cancels, and solve the equation that is left. Working: let x = 0.111...; the repeating block is one digit long, so multiply by 10 to give 10x = 1.111...; subtracting the first equation from the second gives 10x − x = 1.111... − 0.111..., that is 9x = 1; dividing both sides by 9 gives x = 1/9. Answer: 1/9. The distractors: 1/10 comes from dividing by the multiplier 10 at the last step instead of by the 9 that is left in front of x; 1/11 comes from recalling the elevenths family instead of the ninths, although 1/11 = 0.0909... has a two-digit repeating block rather than a one-digit one; 11/100 comes from stopping the decimal after two digits and converting 0.11 into hundredths.
19. (d) x = 4 or x = −4 — Method: divide both sides by 2 to get x² = 16, then take the square root of both sides: x = 4 or x = −4. Distractor origins: x = 4 forgets the negative root; x = 8 comes from halving 16 instead of taking its square root; x = 16 stops at x² = 16 without ever taking the square root.
20. (d) 72a⁷ — Method: a power outside brackets applies to every factor inside them, and multiplying two powers of the same letter adds their indices. Working: (3a²)² = 3² × a⁴ = 9a⁴, and (2a)³ = 2³ × a³ = 8a³. Multiplying the two results gives 9 × 8 = 72 for the number and 4 + 3 = 7 for the index of a. Answer: 72a⁷. The distractors: 36a⁷ comes from squaring the 2 in (2a)³ instead of cubing it, giving 4a³ and then 9 × 4; 72a¹² comes from multiplying the indices 4 and 3 when the two terms are multiplied, instead of adding them; 17a⁷ comes from adding the coefficients 9 and 8 rather than multiplying them.