🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (a) x = 10 or x = −10 — Rearranging, x² = 100. Taking the square root of both sides gives x = ±10, i.e. x = 10 or x = −10. A candidate who forgets the negative root gives only x = 10. A candidate who halves 100 instead of taking its square root gets x = 50. A candidate who applies the ± sign to 100 itself instead of to its square root gets x = 100 or x = −100.
2. (c) 6x(2x + 3) — The highest common factor of 12x² and 18x is 6x. Dividing each term by 6x gives 12x² ÷ 6x = 2x and 18x ÷ 6x = 3, so 12x² + 18x = 6x(2x + 3). A candidate who only takes out the number 6 (missing the x) gets 6(2x² + 3x), which is not fully factorised. A candidate who only takes out 2x (missing the extra factor of 3 in 6) gets 2x(6x + 9), also not fully factorised — the bracket still shares a common factor. A candidate who takes out 3x instead of the full 6x gets 3x(4x + 6), which again is not fully factorised since 4x + 6 shares a common factor of 2.
3. (d) 6 + 2√3 — Multiply √3 by each term in the bracket separately. First term: √3 × 2 = 2√3. Second term: √3 × √12 = √(3 × 12) = √36 = 6. Adding the two results in the order they were found, and writing the whole-number term first, gives 6 + 2√3. Adding the numbers under the root for the second term instead of multiplying them (3 + 12 = 15) gives √15 in place of 6, leading to √15 + 2√3. Multiplying √3 by the 2 but never distributing to the √12 term at all leaves just 2√3. Treating √3 × 2 as if the 3 were multiplied by the 2 inside the root, √3 × 2 → √6, while still getting the second term correct, gives 6 + √6.
4. (b) (x − 5)(x + 2) — We need two numbers that multiply to −10 and add to −3: these are −5 and 2, since −5 × 2 = −10 and −5 + 2 = −3. So x² − 3x − 10 = (x − 5)(x + 2). A candidate who swaps the signs, using +5 and −2, gets (x + 5)(x − 2), which expands to x² + 3x − 10 — the wrong middle term. A candidate who picks the factor pair 1 and 10 instead of 2 and 5 gets (x − 10)(x + 1), which expands to x² − 9x − 10. A candidate who makes both factors negative gets (x − 5)(x − 2), which expands to x² − 7x + 10 — the wrong sign on the constant term.
5. (d) x = 0 or x = 6 — Method: factorise by taking out the common factor x: x(x − 6) = 0, so x = 0 or x − 6 = 0, giving x = 0 or x = 6. Distractor origins: x = 6 comes from dividing both sides by x, which loses the solution x = 0; x = 0 stops after finding only one factor; x = 3 comes from halving the coefficient of x instead of factorising.
6. (a) 5√2 cm — Method: the angles of a triangle add to 180°, so the third angle is 45° as well and the two shorter sides are equal. Take one of them as the side opposite a 45° angle and use sin 45° = opposite ÷ hypotenuse. Working: the exact value of sin 45° is √2/2, so the shorter side = 10 × √2 ÷ 2, and half of 10 is 5. Answer: 5√2 cm, which is about 7.07 cm. Remembering sin 45° as √2 rather than as √2 halved gives 10√2 cm, which is longer than the hypotenuse. Halving the hypotenuse because 45° is half of 90° gives 5 cm. Taking the value from the other special triangle, sin 60° = √3/2, gives 5√3 cm.
7. (c) 9π cm² — The area of a circle is π × r². With a radius of 3 cm this is π × 3² = 9π cm², and this is exact because π has not been replaced by any approximation. Writing 28.3 cm² replaces π with a rounded decimal value, 3.14, and then rounds the result again, so it is only an approximation. Writing 28.26 cm² uses π ≈ 3.14 without a final rounding step, but this is still only an approximation of 9π, not the exact value. Writing 27 cm² comes from replacing π with the rough approximation 3, which is even further from the true value.
8. (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
9. (a) 2√3/3 — tan 30° = √3/3, so tan 30° + tan 30° = 2 × √3/3 = 2√3/3. √3 comes from wrongly treating tan 30° + tan 30° as tan(30° + 30°) = tan 60° = √3 — adding angles is not the same as adding ratios. √3/3 comes from forgetting to double the value and just writing down tan 30° on its own. 2√3 comes from doubling the numerator of √3/3 but forgetting to keep the denominator of 3.
10. (b) k = 9 — Method: complete the square, because a squared bracket is equal to zero for exactly one value of x. Working: x² − 6x = (x − 3)² − 9, so the equation becomes (x − 3)² − 9 + k = 0, that is (x − 3)² = 9 − k; there is exactly one solution when 9 − k = 0, so k = 9 and the equation reads x² − 6x + 9 = 0 with the repeated solution x = 3. Answer: k = 9. The distractors: k = 3 comes from halving the 6 and not squaring the result; k = 36 comes from squaring the whole of 6 instead of half of it; k = −9 comes from solving 9 − k = 0 with the sign of k the wrong way round.
11. (b) 8π cm² — A diameter of 8 cm gives a radius of 4 cm. The area of a full circle would be π × r² = π × 4² = 16π cm², and a semicircle is exactly half of this, giving 16π ÷ 2 = 8π cm². Forgetting to halve the area for the semicircle gives 16π cm², the area of the whole circle. Halving the diameter twice, using a radius of 2 instead of 4, gives π × 2² = 4π cm². Using the diameter itself as the radius, so π × 8² = 64π, and then halving that for the semicircle gives 32π cm².
12. (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.
13. (a) 6 — Use √a × √b = √(ab): √3 × √12 = √(3 × 12) = √36 = 6. Adding the numbers under the roots instead of multiplying them, 3 + 12 = 15, gives √15 — that comes from applying the rule for adding surds to a multiplication question. Multiplying the two numbers under the roots but then forgetting to take the square root at the end leaves 36. Simplifying only √12 to 2√3 and then dropping the other √3 factor entirely gives 2√3.
14. (a) 4 + √6 — Multiply top and bottom by the conjugate, 4 + √6. The denominator becomes (4 − √6)(4 + √6) = 4² − (√6)² = 16 − 6 = 10. The numerator becomes 10 × (4 + √6) = 40 + 10√6. So the fraction is (40 + 10√6)/10 = 4 + √6, since both terms in the numerator divide by 10. Distributing the conjugate to only the whole-number term of the numerator, and forgetting the surd term entirely, leaves just 4. Rationalising by multiplying the numerator by the conjugate but leaving the ORIGINAL denominator's sign unchanged instead of squaring it lands on 4 − √6, with the surd's sign never actually flipping to positive. Dividing only the whole-number part of the numerator by 10 and forgetting to divide the surd term too leaves 4 + 10√6.
15. (d) 1/16 — Method: a negative index means the reciprocal of the power, so 2⁻⁴ is 1 divided by 2⁴. Working: 2⁴ = 2 × 2 × 2 × 2 = 16, so the value is 1/16. Answer: 1/16. The distractors: −16 comes from reading the negative index as a minus sign on the result; 16 comes from ignoring the minus sign and working out 2⁴; 1/8 comes from multiplying the base by the index, 2 × 4, and writing 1 over that product.
16. (d) x² − 6x + 9 — Method: squaring a bracket means multiplying that bracket by itself, so expand (x − 3)(x − 3) term by term and then collect like terms. Working: x × x = x², x × (−3) = −3x, (−3) × x = −3x and (−3) × (−3) = 9, giving x² − 3x − 3x + 9, and the two middle terms collect to −6x. Answer: x² − 6x + 9. The distractors: x² − 3x + 9 comes from writing down only one of the two middle products instead of both; x² + 6x + 9 comes from treating (−3) × x as +3x, so the middle terms are added rather than subtracted; x² − 9 comes from treating the square as the difference of two squares (x − 3)(x + 3).
17. (b) 9/25 — Method: write the decimal over the matching power of ten, then divide the numerator and the denominator by their highest common factor. Working: 0.36 has two digits after the point, so 0.36 = 36/100; the highest common factor of 36 and 100 is 4, and 36 ÷ 4 = 9 with 100 ÷ 4 = 25; since 9 and 25 share no factor greater than 1, the fraction is fully cancelled. Answer: 9/25. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 9/50 comes from dividing the numerator by 4 but the denominator by only 2; 36/10 comes from counting one decimal place instead of two and writing the digits over 10.
18. (b) (2x + 14)/((x − 1)(x + 3)) — To subtract these fractions, write them over the common denominator (x − 1)(x + 3): the numerator becomes 4(x + 3) − 2(x − 1). Expanding gives 4x + 12 − 2x + 2, which simplifies to 2x + 14, so the answer is (2x + 14)/((x − 1)(x + 3)). Writing (2x + 11)/((x − 1)(x + 3)) comes from not distributing the minus sign fully across the second bracket, treating −2(x − 1) as −2x − 1 instead of −2x + 2. Writing 2/((x − 1)(x + 3)) comes from subtracting the two original numerators directly, 4 − 2 = 2, the same mistake as subtracting fractions without a common denominator. Writing (2x − 10)/((x − 1)(x + 3)) comes from swapping which numerator multiplies which bracket, forming 4(x − 1) − 2(x + 3) instead of 4(x + 3) − 2(x − 1).
19. (a) 13/40 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.325 = 325/1000 = 13/40 (dividing both numerator and denominator by 25). Answer: 13/40. 13/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 8/25 comes from rounding 0.325 down to 0.32 before converting. 3/8 comes from recalling the learned conversion 3/8 = 0.375 and matching it to 0.325 because both are three-place decimals beginning with 3, instead of converting the decimal given.
20. (a) 1/2 — cos 0° = 1 and sin 30° = 1/2, so cos 0° − sin 30° = 1 − 1/2 = 1/2. 1 comes from writing down cos 0° alone and forgetting to subtract sin 30°. 3/2 comes from adding the two values instead of subtracting. −1/2 comes from working out sin 30° − cos 0°, the two terms the wrong way round.