🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (c) 0.001 — Method: a negative index means 'one over' the positive power, so $10^{-3}$ means one over $10^{3}$. Working: ten cubed is 1000, and one over 1000 is 0.001. 1000 comes from ignoring the negative sign and working out ten cubed instead of its reciprocal. −1000 comes from ignoring what the negative index does to the size, while still writing a negative sign on the large value. −0.001 comes from correctly finding the size, 0.001, but wrongly keeping a negative sign because the index was negative. Answer: 0.001.
2. (c) Exactly 1: the subtraction has no rounding at any step. — 10x − x removes the recurring part completely, because the digits after the decimal point in 10x and in x are identical from the tenths place onward, so they cancel exactly: 9.999... − 0.999... = 9.000... = 9. Nothing was rounded to reach 9x = 9, so x = 1 is an exact equality, not an approximation, and the statement that the value is exactly 1, with no rounding at any step, is the correct one. Calling it only approximately 1, on the ground that a recurring decimal can never reach a whole number, misunderstands what the subtraction has just shown: the recurring tail cancels completely, leaving no gap to approximate away. Claiming the method only works because the recurring digit is 9 is also wrong — the same subtraction cancels the recurring part for any repeating digit, not just 9; it is the choice of multiplier (10, matching the one-digit repeat) that makes the cancellation exact, not the digit itself. Saying 10x minus x gives 8.999... rather than 9 misreads the subtraction: 9.999... − 0.999... has no digit to borrow from, since every decimal digit in the two numbers matches, so the result is exactly 9, not 8.999... .
3. (c) 9/5 — Method: the area of a rectangle is its length multiplied by its width; the decimal product is then written over a power of ten and cancelled. Working: 24 × 75 = 1800, and 2.4 and 0.75 have three decimal places between them, so 2.4 × 0.75 = 1.8; the area of the panel is 1.8 square metres, which is eighteen tenths, so it can be written as 18/10, and dividing the numerator and the denominator by 2 gives 9 over 5. Answer: 9/5. The distractors: 4/5 comes from converting only the digits after the decimal point and losing the whole one, turning 1.8 into eight tenths; 63/20 comes from adding the two sides instead of multiplying them, giving 3.15; 9/50 comes from misplacing the decimal point in the product and writing 0.18, which cancels to 9 over 50.
4. (b) 9/25 — Method: write the decimal over the matching power of ten, then divide the numerator and the denominator by their highest common factor. Working: 0.36 has two digits after the point, so 0.36 = 36/100; the highest common factor of 36 and 100 is 4, and 36 ÷ 4 = 9 with 100 ÷ 4 = 25; since 9 and 25 share no factor greater than 1, the fraction is fully cancelled. Answer: 9/25. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 9/50 comes from dividing the numerator by 4 but the denominator by only 2; 36/10 comes from counting one decimal place instead of two and writing the digits over 10.
5. (c) 5√3 m — The cable, the pole and the ground form a right-angled triangle: the ground distance (5 m) is adjacent to the 60° angle, and the height of the pole is opposite it, so height = 5 × tan 60° = 5 × √3 = 5√3 m. 5√3/2 m comes from using sin 60° = √3/2 instead of tan 60°. 5/√3 m comes from using tan 30° = 1/√3, the reciprocal-angle value, instead of tan 60°. 10√3 m comes from doubling the correct height by mistake.
6. (d) 6 m — The horizontal distance is adjacent to the 60° angle and the zip-wire is the hypotenuse, so horizontal distance = 12 × cos 60° = 12 × 1/2 = 6 m. 6√3 m comes from using sin 60° = √3/2 instead of cos 60°, which would give the vertical drop, not the horizontal distance. 4√3 m comes from treating 12 as the side adjacent to a tangent ratio and dividing by tan 60° = √3. 24 m comes from dividing 12 by cos 60° instead of multiplying by it.
7. (d) 27/80 — Method: write the total as a fraction of a litre, then divide by the number of glasses. Working: 1.35 = 27/20, so each glass holds 27/20 ÷ 4 = 27/80 of a litre. Answer: 27/80. 27/20 comes from converting the total correctly to a fraction but forgetting to divide by the number of glasses. 27/5 comes from multiplying the total by 4 instead of dividing. 17/50 comes from rounding 1.35 ÷ 4 to 0.34 before converting to a fraction.
8. (a) x = 4 or x = −3 — Method: find two numbers that multiply to give −12 and add to give −1 — these are −4 and 3. So x² − x − 12 = (x − 4)(x + 3) = 0, giving x = 4 or x = −3. Distractor origins: x = −4 or x = 3 has the signs the wrong way round; x = 4 or x = 3 makes both roots positive, ignoring the sign of −12; x = 12 or x = −1 comes from reading off the coefficient and the constant directly instead of factorising.
9. (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
10. (c) 3/11 — Method: let a letter stand for the recurring decimal, multiply by the power of ten that shifts exactly one repeating block past the point, subtract the original equation so that the recurring tail cancels, then solve and cancel. Working: let x = 0.272727...; the repeating block is two digits long, so multiply by 100 to give 100x = 27.272727...; subtracting gives 99x = 27, so x = 27/99; the highest common factor of 27 and 99 is 9, and 27 ÷ 9 = 3 with 99 ÷ 9 = 11. Answer: 3/11. The distractors: 27/100 comes from writing the repeating block over 100 instead of over 99, forgetting that subtracting x leaves 99x rather than 100x; 3/10 comes from rounding the decimal to one place and converting 0.3; 2/9 comes from treating only the 2 as recurring and converting 0.222... instead.
11. (d) 9√3 cm — DE is opposite the 60° angle at F, and EF is adjacent to it, so DE = EF × tan 60° = 9 × √3 = 9√3 cm. 9√3/2 cm comes from using sin 60° = √3/2 instead of tan 60°. 3√3 cm comes from using tan 30° = 1/√3 instead of tan 60° (9 × 1/√3 = 9/√3 = 3√3). 18 cm is the hypotenuse DF, not DE: it comes from using cos 60° = 1/2 and working out 9 ÷ 1/2 = 18, which finds the wrong side of the triangle.
12. (c) 1 — cos 45° = √2/2 and sin 45° = √2/2. Squaring each gives (√2/2)² = 2/4 = 1/2, so (cos 45°)² + (sin 45°)² = 1/2 + 1/2 = 1. The distractor √2 comes from adding cos 45° + sin 45° directly without squaring first (√2/2 + √2/2 = √2). The distractor 2 comes from squaring the top of the fraction, (√2)² = 2, but then dividing by 2 instead of 4 for each term, giving 1 + 1 = 2. The distractor 1/2 comes from squaring only cos 45° and forgetting to add the sin 45° term.
13. (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
14. (c) 6x(2x + 3) — The highest common factor of 12x² and 18x is 6x. Dividing each term by 6x gives 12x² ÷ 6x = 2x and 18x ÷ 6x = 3, so 12x² + 18x = 6x(2x + 3). A candidate who only takes out the number 6 (missing the x) gets 6(2x² + 3x), which is not fully factorised. A candidate who only takes out 2x (missing the extra factor of 3 in 6) gets 2x(6x + 9), also not fully factorised — the bracket still shares a common factor. A candidate who takes out 3x instead of the full 6x gets 3x(4x + 6), which again is not fully factorised since 4x + 6 shares a common factor of 2.
15. (b) k = 9 — Method: complete the square, because a squared bracket is equal to zero for exactly one value of x. Working: x² − 6x = (x − 3)² − 9, so the equation becomes (x − 3)² − 9 + k = 0, that is (x − 3)² = 9 − k; there is exactly one solution when 9 − k = 0, so k = 9 and the equation reads x² − 6x + 9 = 0 with the repeated solution x = 3. Answer: k = 9. The distractors: k = 3 comes from halving the 6 and not squaring the result; k = 36 comes from squaring the whole of 6 instead of half of it; k = −9 comes from solving 9 − k = 0 with the sign of k the wrong way round.
16. (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
17. (d) 3√5 — Split 45 into a perfect square times a factor: 45 = 9 × 5. Take the square root of each part separately: √45 = √9 × √5 = 3√5, since √9 = 3. Writing the perfect-square factor itself (9) as the coefficient instead of its root would give 9√5 — that trap comes from forgetting the last step, rooting 9. Multiplying 3 and 5 together instead of keeping them as coefficient and radicand gives 15, which throws away the surd entirely. Doubling the correct coefficient by mistake gives 6√5.
18. (a) 13/40 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.325 = 325/1000 = 13/40 (dividing both numerator and denominator by 25). Answer: 13/40. 13/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 8/25 comes from rounding 0.325 down to 0.32 before converting. 3/8 comes from recalling the learned conversion 3/8 = 0.375 and matching it to 0.325 because both are three-place decimals beginning with 3, instead of converting the decimal given.
19. (c) cos 45° — cos 45° = √2/2, and √2 cannot be written as an exact fraction, so this value is irrational. tan 0° = 0, sin 90° = 1 and sin 30° = 1/2 are all rational, since each can be written as an exact whole number or fraction.
20. (d) (3x − 2)(x + 4) — For 3x² + 10x − 8, find two numbers multiplying to 3 × (−8) = −24 and adding to 10: these are 12 and −2. Rewrite: 3x² + 12x − 2x − 8 = 3x(x + 4) − 2(x + 4) = (3x − 2)(x + 4). Choosing (3x + 2)(x − 4) expands to 3x² − 10x − 8 — the correct factor pair but the wrong signs, giving the middle term the wrong sign. Choosing (x − 2)(3x + 4) expands to 3x² − 2x − 8 — the 3 is attached to the wrong bracket, changing which terms combine for the x-coefficient. Choosing (3x − 4)(x + 2) expands to 3x² + 2x − 8 — this uses 4 and 2 instead of the correct pair 12 and 2, so the middle term does not come to 10x.