🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (c) 0.001 — Method: a negative index means 'one over' the positive power, so $10^{-3}$ means one over $10^{3}$. Working: ten cubed is 1000, and one over 1000 is 0.001. 1000 comes from ignoring the negative sign and working out ten cubed instead of its reciprocal. −1000 comes from ignoring what the negative index does to the size, while still writing a negative sign on the large value. −0.001 comes from correctly finding the size, 0.001, but wrongly keeping a negative sign because the index was negative. Answer: 0.001.
2. (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
3. (d) 6 — By Pythagoras' theorem, the square of the hypotenuse equals the sum of the squares of the other two sides: (√12)² + (√24)² = 12 + 24 = 36. The hypotenuse is √36 = 6 cm. Adding the two side lengths directly instead of squaring them first, treating the theorem as if it were a straight sum of the sides, gives √12 + √24 = 2√3 + 2√6. Multiplying the two squared values, 12 × 24 = 288, instead of adding them, then taking the root, gives √288 = 12√2. Adding the squares correctly to get 36 but forgetting to take the square root at the end leaves 36 as the answer instead of the hypotenuse itself.
4. (b) 9 — Method: a negative index means take the reciprocal of the base first and then apply the positive power. Working: the reciprocal of 1/3 is 3, so (1/3)⁻² = 3² = 3 × 3 = 9. Answer: 9. The distractors: 1/9 comes from ignoring the minus sign and squaring 1/3 as it stands; −9 comes from reading the negative index as a minus sign on the result; 6 comes from multiplying the denominator by the index, 3 × 2, instead of squaring the reciprocal.
5. (c) 3⁻³ — Method: when dividing powers of the same base, subtract the index of the number you are dividing by from the index of the number being divided, keeping them in the order the question writes them. Working: 2 − 5 = −3, so 3² ÷ 3⁵ = 3⁻³. It is worth checking this against the numbers: 3² = 9 and 3⁵ = 243, and 9 ÷ 243 = 1/27, which is 3⁻³. 3³ comes from subtracting the other way round, 5 − 2 = 3, which reverses the sign of the index and gives 27 instead of 1/27. 3⁷ comes from working out 2 + 5 = 7, which is the rule for multiplying powers, not dividing them. 3¹⁰ comes from multiplying the indices, 2 × 5 = 10, instead of subtracting them. Answer: 3⁻³.
6. (d) 6 + 2√3 — Multiply √3 by each term in the bracket separately. First term: √3 × 2 = 2√3. Second term: √3 × √12 = √(3 × 12) = √36 = 6. Adding the two results in the order they were found, and writing the whole-number term first, gives 6 + 2√3. Adding the numbers under the root for the second term instead of multiplying them (3 + 12 = 15) gives √15 in place of 6, leading to √15 + 2√3. Multiplying √3 by the 2 but never distributing to the √12 term at all leaves just 2√3. Treating √3 × 2 as if the 3 were multiplied by the 2 inside the root, √3 × 2 → √6, while still getting the second term correct, gives 6 + √6.
7. (a) 0.625 — Method: convert the fraction to a decimal so it can be compared properly with 0.6. Working: 5/8 = 0.625, and since 0.625 > 0.6, the larger value is 0.625. Answer: 0.625. 0.6 repeats Sam's incorrect claim, made by comparing single digits rather than full place value. 0.58 comes from converting 5/8 incorrectly, treating it as if it read 5 tenths and 8 hundredths. 0.85 comes from turning the fraction upside down and writing its digits straight after the decimal point, 8 then 5, instead of dividing.
8. (b) 5² — Method: multiplying two powers of the same base adds their indices, and a negative index is added as a negative number. Working: −2 + 4 = 2, so 5⁻² × 5⁴ = 5². Answer: 5². The distractors: 5⁶ comes from adding the sizes of the indices, 2 + 4, and ignoring the minus sign; 5⁻⁸ comes from multiplying the indices, −2 × 4, instead of adding them; 5⁻⁶ comes from subtracting the indices, −2 − 4, as though the powers were being divided.
9. (b) 3²⁰ is larger — Method: two powers with different bases and different indices can be compared once they are rewritten with a common index, which is possible whenever the indices share a factor. Working: 30 and 20 have a highest common factor of 10, so 2³⁰ = (2³)¹⁰ = 8¹⁰ and 3²⁰ = (3²)¹⁰ = 9¹⁰. Both are now tenth powers, and since 9 is larger than 8, 9¹⁰ is larger than 8¹⁰. Answer: 3²⁰ is larger. The distractors: 2³⁰ is larger comes from comparing only the indices and choosing the power with the bigger index; They are equal comes from multiplying base by index, 2 × 30 and 3 × 20, and finding 60 each time; They cannot be compared without a calculator comes from assuming that powers this large can only be ranked by evaluating them in full.
10. (c) 2 — First write 1 1/2 as an improper fraction, 3/2. To divide by 3/4, multiply by its reciprocal, 4/3: 3/2 × 4/3 = 12/6 = 2. Dropping the whole number and dividing only the fractional part, 1/2 ÷ 3/4 = 1/2 × 4/3, gives 2/3. Multiplying by 3/4 directly instead of using its reciprocal, 3/2 × 3/4, gives 9/8. Using the reciprocal of the first fraction instead of the second, 2/3 × 3/4, gives 1/2.
11. (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.
12. (d) 3√5 — Split 45 into a perfect square times a factor: 45 = 9 × 5. Take the square root of each part separately: √45 = √9 × √5 = 3√5, since √9 = 3. Writing the perfect-square factor itself (9) as the coefficient instead of its root would give 9√5 — that trap comes from forgetting the last step, rooting 9. Multiplying 3 and 5 together instead of keeping them as coefficient and radicand gives 15, which throws away the surd entirely. Doubling the correct coefficient by mistake gives 6√5.
13. (a) 10 — √49 = 7 and ∛27 = 3, so √49 + ∛27 = 7 + 3 = 10. Treating the cube root as dividing by 3 instead of finding the cube root gives 27 ÷ 3 = 9, then 7 + 9 = 16. Multiplying the two roots instead of adding them gives 7 × 3 = 21. Ignoring the cube root symbol and using 27 as it stands gives 7 + 27 = 34.
14. (d) k < 4 — Method: the number of real solutions of ax² + bx + c = 0 is decided by the discriminant b² − 4ac, and two different real solutions need it to be greater than zero. Working: here a = 1, b = −4 and c = k, so b² − 4ac = 16 − 4k; the condition is 16 − 4k > 0, which gives 16 > 4k and then k < 4. Answer: k < 4; for example k = 3 gives x² − 4x + 3 = 0, whose solutions are 1 and 3. The distractors: k ≤ 4 comes from using b² − 4ac ≥ 0, which also allows the single repeated solution at k = 4; k > 4 comes from dividing −4k > −16 by −4 without reversing the inequality sign; k < 16 comes from leaving the factor 4 out of 4ac and solving 16 − k > 0.
15. (a) x = 4 ± √13 — Method: halve the coefficient of x to form the bracket, subtract the square of that number to keep the expression equal to the original, then rearrange and take the square root of both sides. Working: half of −8 is −4, so x² − 8x + 3 = (x − 4)² − 16 + 3 = (x − 4)² − 13; setting this equal to zero gives (x − 4)² = 13, so x − 4 = ±√13 and x = 4 ± √13. Answer: x = 4 ± √13. The distractors: x = 8 ± √13 comes from putting the whole coefficient 8 inside the bracket instead of half of it; x = 4 ± √19 comes from adding 16 and 3 rather than subtracting 3 from 16; x = −4 ± √13 comes from writing the bracket as (x + 4)², which reverses the sign of the number that comes out of it.
16. (d) x² − 49 — Area = length × width = (x + 7)(x − 7). Expanding: x × x = x², x × (−7) = −7x, 7 × x = 7x, 7 × (−7) = −49. The two middle terms −7x and 7x cancel, leaving x² − 49. A candidate who misremembers the difference-of-two-squares result as a sum gets x² + 49. A candidate who makes a sign error and treats both middle terms as −7x instead of cancelling gets x² − 14x − 49. A candidate who confuses area with perimeter and simply adds the length and width gets 2x.
17. (a) 5√2 cm — Method: the angles of a triangle add to 180°, so the third angle is 45° as well and the two shorter sides are equal. Take one of them as the side opposite a 45° angle and use sin 45° = opposite ÷ hypotenuse. Working: the exact value of sin 45° is √2/2, so the shorter side = 10 × √2 ÷ 2, and half of 10 is 5. Answer: 5√2 cm, which is about 7.07 cm. Remembering sin 45° as √2 rather than as √2 halved gives 10√2 cm, which is longer than the hypotenuse. Halving the hypotenuse because 45° is half of 90° gives 5 cm. Taking the value from the other special triangle, sin 60° = √3/2, gives 5√3 cm.
18. (a) x = 4 or x = −3 — Method: find two numbers that multiply to give −12 and add to give −1 — these are −4 and 3. So x² − x − 12 = (x − 4)(x + 3) = 0, giving x = 4 or x = −3. Distractor origins: x = −4 or x = 3 has the signs the wrong way round; x = 4 or x = 3 makes both roots positive, ignoring the sign of −12; x = 12 or x = −1 comes from reading off the coefficient and the constant directly instead of factorising.
19. (b) (x − 5)(x + 2) — We need two numbers that multiply to −10 and add to −3: these are −5 and 2, since −5 × 2 = −10 and −5 + 2 = −3. So x² − 3x − 10 = (x − 5)(x + 2). A candidate who swaps the signs, using +5 and −2, gets (x + 5)(x − 2), which expands to x² + 3x − 10 — the wrong middle term. A candidate who picks the factor pair 1 and 10 instead of 2 and 5 gets (x − 10)(x + 1), which expands to x² − 9x − 10. A candidate who makes both factors negative gets (x − 5)(x − 2), which expands to x² − 7x + 10 — the wrong sign on the constant term.
20. (a) 0.1666... — Method: a fraction bar means divide, so the decimal is found by dividing the numerator by the denominator; when a remainder comes back unchanged the division never ends, the digit it produces repeats for ever, and the exact value has to be written with that recurring digit rather than a rounded one. Working: 1 ÷ 6 is set out as 1.000 ÷ 6; six does not go into 1, and six goes into 10 tenths once with 4 left over, so the first decimal digit is 1; the 4 left over makes 40 hundredths, and six goes into 40 six times with 4 left over again; that same remainder of 4 returns at every step, so the digit 6 repeats without end. Answer: 0.1666... The distractors: 0.16 comes from carrying the division out to two decimal places and stopping there, as though the decimal terminated; 0.17 comes from rounding the division to two decimal places, which gives a value close to one sixth but not equal to it; 0.6 comes from writing the digit of the denominator straight after the decimal point, as though 1/6 meant six tenths.