🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (a) 1/3 — To subtract these fractions, first write 3/4 with a denominator of 12: 3/4 = 9/12. Then 9/12 − 5/12 = 4/12, which simplifies to 1/3. Subtracting the numerators and the denominators separately, (3 − 5)/(4 − 12), gives −2/−8, which simplifies to 1/4. Changing 3/4 to twelfths by only changing the denominator, without scaling the numerator to match, gives 3/12 − 5/12 = −2/12, which simplifies to −1/6. Adding the fractions instead of subtracting them, 9/12 + 5/12, gives 14/12, which simplifies to 7/6.
2. (c) It has two different real solutions — Method: the discriminant is the quantity under the square root sign in the quadratic formula, so its sign decides how many real values the formula produces. Working: when the discriminant is positive its square root is a real number that is not zero, and the formula adds that root and subtracts it in turn, so the two results are different; a positive discriminant that is not a perfect square still gives two solutions, but they are not whole numbers. Answer: it has two different real solutions. The distractors: one repeated real solution is what a discriminant of zero gives, because adding and subtracting zero changes nothing; no real solutions is what a negative discriminant gives, because a negative number has no real square root; two whole-number solutions happens only when the discriminant is a perfect square and the division works out exactly, which a positive discriminant does not guarantee.
3. (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.
4. (d) 3√5 — Split 45 into a perfect square times a factor: 45 = 9 × 5. Take the square root of each part separately: √45 = √9 × √5 = 3√5, since √9 = 3. Writing the perfect-square factor itself (9) as the coefficient instead of its root would give 9√5 — that trap comes from forgetting the last step, rooting 9. Multiplying 3 and 5 together instead of keeping them as coefficient and radicand gives 15, which throws away the surd entirely. Doubling the correct coefficient by mistake gives 6√5.
5. (d) 2⁷ — When multiplying powers of the same base, the indices add: 3 + 4 = 7, so 2³ × 2⁴ = 2⁷. Multiplying the indices instead of adding them gives 3 × 4 = 12, so 2¹². Subtracting the indices instead of adding them gives 4 − 3 = 1, so 2¹. Multiplying the bases together as well as adding the indices gives 2 × 2 = 4, so 4⁷.
6. (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
7. (d) 2x/(x − 2) — Factorise x² − 4 as (x − 2)(x + 2) first — it's a difference of two squares. The (x + 2) in the numerator then cancels with the (x + 2) in the factorised denominator, and 6x² ÷ 3x simplifies to 2x, leaving 2x/(x − 2). Writing 2/(x − 2) comes from over-cancelling 6x² ÷ 3x as 2 instead of 2x, dropping the x that should remain. Writing 2x/(x + 2) comes from factorising x² − 4 as (x + 2)² instead of (x − 2)(x + 2), a difference of two squares always has one plus and one minus bracket. Writing 2x²/(x − 2) comes from simplifying 6x² ÷ 3x as 2x² instead of 2x, dividing the coefficients but not reducing the power of x.
8. (d) x² − 6x + 9 — Method: squaring a bracket means multiplying that bracket by itself, so expand (x − 3)(x − 3) term by term and then collect like terms. Working: x × x = x², x × (−3) = −3x, (−3) × x = −3x and (−3) × (−3) = 9, giving x² − 3x − 3x + 9, and the two middle terms collect to −6x. Answer: x² − 6x + 9. The distractors: x² − 3x + 9 comes from writing down only one of the two middle products instead of both; x² + 6x + 9 comes from treating (−3) × x as +3x, so the middle terms are added rather than subtracted; x² − 9 comes from treating the square as the difference of two squares (x − 3)(x + 3).
9. (c) 1/2 — sin 45° = √2/2 and cos 45° = √2/2, so sin 45° × cos 45° = √2/2 × √2/2 = 2/4 = 1/2. √2/2 comes from writing down only one of the two factors and forgetting to multiply by the other. √2 comes from adding the two exact values instead of multiplying them: √2/2 + √2/2 = √2. 1 comes from wrongly treating sin 45° × cos 45° as sin(45° + 45°) = sin 90° = 1 — multiplying two ratios is not the same as adding their angles.
10. (c) 9π cm² — The area of a circle is π × r². With a radius of 3 cm this is π × 3² = 9π cm², and this is exact because π has not been replaced by any approximation. Writing 28.3 cm² replaces π with a rounded decimal value, 3.14, and then rounds the result again, so it is only an approximation. Writing 28.26 cm² uses π ≈ 3.14 without a final rounding step, but this is still only an approximation of 9π, not the exact value. Writing 27 cm² comes from replacing π with the rough approximation 3, which is even further from the true value.
11. (c) x = −2 or x = 4 — The solutions of x² − 2x − 8 = 0 are the x-values where y = 0. From the table, y = 0 when x = −2 and when x = 4, so those are the two solutions. Distractor origins: x = −1 or x = 3 picks the pair of x-values that give equal (but non-zero) y-values instead of y = 0; x = 0 or x = −8 mixes up an x-value with its corresponding y-value; x = −2 only reads off one of the two roots and misses the other.
12. (d) x = 0 or x = 6 — Method: factorise by taking out the common factor x: x(x − 6) = 0, so x = 0 or x − 6 = 0, giving x = 0 or x = 6. Distractor origins: x = 6 comes from dividing both sides by x, which loses the solution x = 0; x = 0 stops after finding only one factor; x = 3 comes from halving the coefficient of x instead of factorising.
13. (a) 17 — Method: work out each power separately, then combine them as the question asks. Working: $2^3 = 8$ and $3^2 = 9$, and 8 + 9 = 17. 72 comes from working out 8 × 9 = 72, multiplying the two powers instead of adding them. 12 comes from misreading the powers as repeated multiplication of the base by the index, 2 × 3 + 3 × 2 = 6 + 6 = 12. −1 comes from working out 8 − 9 = −1, subtracting the powers instead of adding them. Answer: 17.
14. (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
15. (a) x = 6 or x = −4 — We need two numbers that multiply to −24 and add to −2: these are −6 and 4, since −6 × 4 = −24 and −6 + 4 = −2. So x² − 2x − 24 = (x − 6)(x + 4) = 0, giving x = 6 or x = −4. A candidate who swaps the signs, using 6 and −4 the wrong way round in the brackets, gets x = −6 or x = 4. A candidate who picks the wrong factor pair, 8 and −3 (which multiply to −24 but add to +5, not −2), gets (x + 8)(x − 3) = 0 and answers x = −8 or x = 3. A candidate who makes both factors negative gets x = −6 or x = −4, which would require the constant term to be +24, not −24.
16. (a) 1/2 — cos 0° = 1 and sin 30° = 1/2, so cos 0° − sin 30° = 1 − 1/2 = 1/2. 1 comes from writing down cos 0° alone and forgetting to subtract sin 30°. 3/2 comes from adding the two values instead of subtracting. −1/2 comes from working out sin 30° − cos 0°, the two terms the wrong way round.
17. (d) 6 m — The horizontal distance is adjacent to the 60° angle and the zip-wire is the hypotenuse, so horizontal distance = 12 × cos 60° = 12 × 1/2 = 6 m. 6√3 m comes from using sin 60° = √3/2 instead of cos 60°, which would give the vertical drop, not the horizontal distance. 4√3 m comes from treating 12 as the side adjacent to a tangent ratio and dividing by tan 60° = √3. 24 m comes from dividing 12 by cos 60° instead of multiplying by it.
18. (c) 3/11 — Method: let a letter stand for the recurring decimal, multiply by the power of ten that shifts exactly one repeating block past the point, subtract the original equation so that the recurring tail cancels, then solve and cancel. Working: let x = 0.272727...; the repeating block is two digits long, so multiply by 100 to give 100x = 27.272727...; subtracting gives 99x = 27, so x = 27/99; the highest common factor of 27 and 99 is 9, and 27 ÷ 9 = 3 with 99 ÷ 9 = 11. Answer: 3/11. The distractors: 27/100 comes from writing the repeating block over 100 instead of over 99, forgetting that subtracting x leaves 99x rather than 100x; 3/10 comes from rounding the decimal to one place and converting 0.3; 2/9 comes from treating only the 2 as recurring and converting 0.222... instead.
19. (d) (3x − 2)(x + 4) — For 3x² + 10x − 8, find two numbers multiplying to 3 × (−8) = −24 and adding to 10: these are 12 and −2. Rewrite: 3x² + 12x − 2x − 8 = 3x(x + 4) − 2(x + 4) = (3x − 2)(x + 4). Choosing (3x + 2)(x − 4) expands to 3x² − 10x − 8 — the correct factor pair but the wrong signs, giving the middle term the wrong sign. Choosing (x − 2)(3x + 4) expands to 3x² − 2x − 8 — the 3 is attached to the wrong bracket, changing which terms combine for the x-coefficient. Choosing (3x − 4)(x + 2) expands to 3x² + 2x − 8 — this uses 4 and 2 instead of the correct pair 12 and 2, so the middle term does not come to 10x.
20. (d) 16π cm² — Method: for a circle, area = π × radius². Working: area = π × 4² = π × 16 = 16π cm². Answer: 16π cm². The student squared the radius but left out the π, which is why 16 cm² is not the exact area. 4π cm² comes from multiplying by the radius once instead of squaring it: π × 4 = 4π. 8π cm² comes from using the circumference formula 2 × π × radius instead of the area formula: 2 × π × 4 = 8π. 64π cm² comes from using the diameter (8 cm) as the radius in the area formula: π × 8² = 64π.