🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (c) cos 45° — cos 45° = √2/2, and √2 cannot be written as an exact fraction, so this value is irrational. tan 0° = 0, sin 90° = 1 and sin 30° = 1/2 are all rational, since each can be written as an exact whole number or fraction.
2. (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
3. (d) 3/8 — Method: making half the recipe means dividing the quantity of sugar by 2. Working: 3/4 ÷ 2 = 3/8. Answer: 3/8. 3/2 comes from multiplying by 2 instead of dividing, as if doubling the recipe. 5/4 comes from adding 1/2 to 3/4 instead of halving it, confusing "half of" with "plus a half". 3/4 comes from leaving the amount unchanged, forgetting to halve it for the smaller recipe.
4. (a) 4 + √6 — Multiply top and bottom by the conjugate, 4 + √6. The denominator becomes (4 − √6)(4 + √6) = 4² − (√6)² = 16 − 6 = 10. The numerator becomes 10 × (4 + √6) = 40 + 10√6. So the fraction is (40 + 10√6)/10 = 4 + √6, since both terms in the numerator divide by 10. Distributing the conjugate to only the whole-number term of the numerator, and forgetting the surd term entirely, leaves just 4. Rationalising by multiplying the numerator by the conjugate but leaving the ORIGINAL denominator's sign unchanged instead of squaring it lands on 4 − √6, with the surd's sign never actually flipping to positive. Dividing only the whole-number part of the numerator by 10 and forgetting to divide the surd term too leaves 4 + 10√6.
5. (a) x⁶ — Method: work through the powers in order — multiplying powers of the same base means adding indices, and dividing powers of the same base means subtracting indices. Working: first, x⁵ × x³ = x⁸ (adding 5 and 3); then x⁸ ÷ x² = x⁶ (subtracting 2 from 8). x⁴ comes from swapping the two rules — subtracting for the multiplication, 5 − 3 = 2, and then adding for the division, 2 + 2 = 4. x¹⁰ comes from adding all three indices, 5 + 3 + 2 = 10, treating the division the same as a multiplication. 6x comes from correctly reaching a total index of 6 but then writing it as a coefficient of x instead of as its power. Answer: x⁶.
6. (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.
7. (d) x = 2 or x = −5 — Method: find two numbers that multiply to give −10 and add to give 3 — these are 5 and −2. So x² + 3x − 10 = (x + 5)(x − 2) = 0, giving x = −5 or x = 2. Distractor origins: x = −2 or x = 5 swaps the signs of the two roots; x = 2 or x = 5 makes both roots positive, ignoring the sign of −10; x = −5 or x = −2 makes both roots negative.
8. (c) 9π cm² — The area of a circle is π × r². With a radius of 3 cm this is π × 3² = 9π cm², and this is exact because π has not been replaced by any approximation. Writing 28.3 cm² replaces π with a rounded decimal value, 3.14, and then rounds the result again, so it is only an approximation. Writing 28.26 cm² uses π ≈ 3.14 without a final rounding step, but this is still only an approximation of 9π, not the exact value. Writing 27 cm² comes from replacing π with the rough approximation 3, which is even further from the true value.
9. (b) 0.83333... — Divide 5 by 6 using long division. 5.000... ÷ 6: 50 ÷ 6 = 8 remainder 2, giving the first decimal digit 8. Bring down a 0 to make 20, and 20 ÷ 6 = 3 remainder 2 — the remainder 2 has reappeared, so from here the digit 3 repeats forever. This gives 5/6 = 0.83333... . Stopping after two decimal places and writing 0.83 treats the division as if it terminated, when the remainder never reaches zero. Shifting the decimal point one place too far to the left gives 0.083333..., the same digits divided by an extra power of ten. A slip in the long division itself, misreading a remainder, can produce the wrong repeating digit, 0.85555... .
10. (a) 2√3/3 — tan 30° = √3/3, so tan 30° + tan 30° = 2 × √3/3 = 2√3/3. √3 comes from wrongly treating tan 30° + tan 30° as tan(30° + 30°) = tan 60° = √3 — adding angles is not the same as adding ratios. √3/3 comes from forgetting to double the value and just writing down tan 30° on its own. 2√3 comes from doubling the numerator of √3/3 but forgetting to keep the denominator of 3.
11. (d) 8 — Method: write $16^{3/4}$ as $(\sqrt[4]{16})^3$ — the denominator of the index gives the root, the numerator gives the power. Working: $\sqrt[4]{16} = 2$, so $16^{3/4} = 2^3 = 8$. Answer: 8. A candidate who multiplies 16 by 3/4 is treating the index as an ordinary factor and gets 12 — a fractional index is not a multiplier. A candidate who takes the square root instead of the fourth root and then cubes it works out $(\sqrt{16})^3 = 4^3$ and gets 64; the denominator 4 names a fourth root, not a square root. A candidate who takes the fourth root of 16 correctly but stops there, without cubing it, gets 2.
12. (d) 2⁷ — When multiplying powers of the same base, the indices add: 3 + 4 = 7, so 2³ × 2⁴ = 2⁷. Multiplying the indices instead of adding them gives 3 × 4 = 12, so 2¹². Subtracting the indices instead of adding them gives 4 − 3 = 1, so 2¹. Multiplying the bases together as well as adding the indices gives 2 × 2 = 4, so 4⁷.
13. (c) 1/2 — sin 45° = √2/2 and cos 45° = √2/2, so sin 45° × cos 45° = √2/2 × √2/2 = 2/4 = 1/2. √2/2 comes from writing down only one of the two factors and forgetting to multiply by the other. √2 comes from adding the two exact values instead of multiplying them: √2/2 + √2/2 = √2. 1 comes from wrongly treating sin 45° × cos 45° as sin(45° + 45°) = sin 90° = 1 — multiplying two ratios is not the same as adding their angles.
14. (d) x = 0 or x = 6 — Method: factorise by taking out the common factor x: x(x − 6) = 0, so x = 0 or x − 6 = 0, giving x = 0 or x = 6. Distractor origins: x = 6 comes from dividing both sides by x, which loses the solution x = 0; x = 0 stops after finding only one factor; x = 3 comes from halving the coefficient of x instead of factorising.
15. (a) 3 m — Height = sloping length × sin 45° = 3√2 × √2/2 = (3 × 2)/2 = 3 m, since √2 × √2 = 2. 3√2 m comes from forgetting to multiply by sin 45° at all. 3√2/2 m comes from using sin 30° = 1/2 instead of sin 45° = √2/2. 6 m comes from using √2 instead of √2/2 for sin 45°, dropping the denominator of the exact value: 3√2 × √2 = 6.
16. (a) x = 3 — Method: factorise x² + 2x − 15 as (x + 5)(x − 3), since 5 × (−3) = −15 and 5 + (−3) = 2. Setting each bracket equal to zero gives x + 5 = 0 or x − 3 = 0, so x = −5 or x = 3. Only x = 3 is offered here. Distractor origins: x = −3 reverses the sign of the factor pair, treating the bracket (x − 3) as giving x = −3 instead of x = 3; x = 5 takes the number from the other factor, (x + 5), but with the wrong sign, giving x = 5 instead of x = −5; x = 15 takes the constant term of the original expression as if it were a root, without factorising at all.
17. (c) x = 2 or x = 3 — Method: factorise into two brackets whose numbers multiply to the constant term and add to the coefficient of x, then set each bracket equal to zero. Working: two numbers that multiply to 6 and add to −5 are −2 and −3, so x² − 5x + 6 = (x − 2)(x − 3) = 0; then x − 2 = 0 gives x = 2 and x − 3 = 0 gives x = 3. Answer: x = 2 or x = 3. The distractors: x = −2 or x = −3 comes from reading the numbers inside the brackets as the solutions instead of changing their signs; x = 1 or x = 6 comes from taking the first factor pair of 6 without checking that the pair adds to −5; x = 5 or x = 6 comes from reading the solutions straight off the 5 and the 6 in the equation.
18. (d) x⁴ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided. Working: six factors of x on the top and two on the bottom cancel in pairs, leaving 6 − 2 = 4 factors of x. Answer: x⁴. The distractors: x³ comes from dividing the indices, 6 ÷ 2, instead of subtracting them; x⁸ comes from adding the indices, 6 + 2, as though the powers were being multiplied; x¹² comes from multiplying the indices, 6 × 2, as though a power were being raised to a power.
19. (b) 8π cm² — A diameter of 8 cm gives a radius of 4 cm. The area of a full circle would be π × r² = π × 4² = 16π cm², and a semicircle is exactly half of this, giving 16π ÷ 2 = 8π cm². Forgetting to halve the area for the semicircle gives 16π cm², the area of the whole circle. Halving the diameter twice, using a radius of 2 instead of 4, gives π × 2² = 4π cm². Using the diameter itself as the radius, so π × 8² = 64π, and then halving that for the semicircle gives 32π cm².
20. (d) 12 m — Method: give the width a letter, write the length in terms of it and use length × width = area to form a quadratic. Working: with a width of x metres the length is x + 4, so x(x + 4) = 96, which rearranges to x² + 4x − 96 = 0; factorising gives (x + 12)(x − 8) = 0, and a width must be positive, so x = 8 and the length is 8 + 4 = 12. Answer: 12 m, and 12 × 8 = 96 as the area requires. The distractors: 8 m is the width rather than the length asked for; 16 m comes from taking the other root as 12 and adding 4 to it, ignoring that the root −12 cannot be a width; 24 m comes from dividing the area by the 4 in the question instead of forming an equation.