🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (d) x = 2 or x = −5 — Method: find two numbers that multiply to give −10 and add to give 3 — these are 5 and −2. So x² + 3x − 10 = (x + 5)(x − 2) = 0, giving x = −5 or x = 2. Distractor origins: x = −2 or x = 5 swaps the signs of the two roots; x = 2 or x = 5 makes both roots positive, ignoring the sign of −10; x = −5 or x = −2 makes both roots negative.
2. (b) 8π cm² — A diameter of 8 cm gives a radius of 4 cm. The area of a full circle would be π × r² = π × 4² = 16π cm², and a semicircle is exactly half of this, giving 16π ÷ 2 = 8π cm². Forgetting to halve the area for the semicircle gives 16π cm², the area of the whole circle. Halving the diameter twice, using a radius of 2 instead of 4, gives π × 2² = 4π cm². Using the diameter itself as the radius, so π × 8² = 64π, and then halving that for the semicircle gives 32π cm².
3. (c) 1/x⁶ — Method: raising a power to another power multiplies the two indices, and a negative index means one over the matching positive power. Working: −2 × 3 = −6, so (x⁻²)³ = x⁻⁶, and x⁻⁶ written as a fraction is 1/x⁶. Answer: 1/x⁶. The distractors: x⁶ comes from multiplying the indices correctly but dropping the minus sign; 1/x⁵ comes from adding the sizes of the indices, 2 + 3, instead of multiplying them; −x⁶ comes from reading the negative index as a minus sign in front of the whole term.
4. (c) 9π cm² — The area of a circle is π × r². With a radius of 3 cm this is π × 3² = 9π cm², and this is exact because π has not been replaced by any approximation. Writing 28.3 cm² replaces π with a rounded decimal value, 3.14, and then rounds the result again, so it is only an approximation. Writing 28.26 cm² uses π ≈ 3.14 without a final rounding step, but this is still only an approximation of 9π, not the exact value. Writing 27 cm² comes from replacing π with the rough approximation 3, which is even further from the true value.
5. (a) 0.1666... — Method: a fraction bar means divide, so the decimal is found by dividing the numerator by the denominator; when a remainder comes back unchanged the division never ends, the digit it produces repeats for ever, and the exact value has to be written with that recurring digit rather than a rounded one. Working: 1 ÷ 6 is set out as 1.000 ÷ 6; six does not go into 1, and six goes into 10 tenths once with 4 left over, so the first decimal digit is 1; the 4 left over makes 40 hundredths, and six goes into 40 six times with 4 left over again; that same remainder of 4 returns at every step, so the digit 6 repeats without end. Answer: 0.1666... The distractors: 0.16 comes from carrying the division out to two decimal places and stopping there, as though the decimal terminated; 0.17 comes from rounding the division to two decimal places, which gives a value close to one sixth but not equal to it; 0.6 comes from writing the digit of the denominator straight after the decimal point, as though 1/6 meant six tenths.
6. (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
7. (d) x⁽¹⁄²⁾ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided, and fractional indices are subtracted like any other fractions. Working: 3/4 − 1/4 = 2/4, which simplifies to 1/2, so the result is x⁽¹⁄²⁾. Answer: x⁽¹⁄²⁾. The distractors: x comes from adding the indices, 3/4 + 1/4 = 1, as though the powers were being multiplied; x³ comes from dividing the indices, so that 3/4 divided by 1/4 gives 3; x⁽³⁄¹⁶⁾ comes from multiplying the indices, 3/4 × 1/4.
8. (d) 2⁷ — When multiplying powers of the same base, the indices add: 3 + 4 = 7, so 2³ × 2⁴ = 2⁷. Multiplying the indices instead of adding them gives 3 × 4 = 12, so 2¹². Subtracting the indices instead of adding them gives 4 − 3 = 1, so 2¹. Multiplying the bases together as well as adding the indices gives 2 × 2 = 4, so 4⁷.
9. (b) 24√2 — The side length of the tile is √72. Since 72 = 36 × 2, √72 = √36 × √2 = 6√2 cm. A square has four equal sides, so the perimeter is 4 × 6√2 = 24√2 cm. Simplifying √72 by writing the perfect-square factor itself as the coefficient instead of its root, 36√2 instead of 6√2, and then multiplying by 4 lands on 144√2. Working out the correct side length, 6√2 cm, but then giving that as the final answer without multiplying by 4 for the perimeter gives 6√2. Doubling the side length instead of quadrupling it, as if the perimeter were 2 × 6√2 rather than 4 × 6√2, gives 12√2.
10. (b) 6x + 6 — Perimeter = 2[(2x + 5) + (x − 2)] = 2(3x + 3) = 6x + 6. A candidate who adds the length and width but forgets to double for the perimeter gets 3x + 3. A candidate who makes a sign error and adds 2 instead of subtracting it before doubling gets 2[(2x + 5) + (x + 2)] = 6x + 14. A candidate who multiplies the length and width instead of adding them, confusing the perimeter formula with the area formula, and then doubles that product, gets 2(2x + 5)(x − 2) = 4x² + 2x − 20.
11. (b) 2⁵ — Method: a power outside brackets multiplies the index of every factor inside them, and dividing powers of the same base subtracts their indices. Working: (5² × 2³)³ = 5⁶ × 2⁹ and (5³ × 2²)² = 5⁶ × 2⁴. Dividing gives 5⁶⁻⁶ × 2⁹⁻⁴, and since 5⁰ = 1 the whole expression reduces to 2⁵. Answer: 2⁵. The distractors: 2² comes from adding the outside index to each inside index instead of multiplying, which gives 5⁵ × 2⁶ over 5⁵ × 2⁴; 2¹³ comes from adding the indices of 2 when dividing, 9 + 4, instead of subtracting them; 2 comes from applying the outside power to the first factor inside each bracket only, leaving 5⁶ × 2³ over 5⁶ × 2².
12. (c) 7 + 4√3 — Expand the brackets fully: (2 + √3)² = 2² + 2 × 2 × √3 + (√3)² = 4 + 4√3 + 3. Adding the two whole-number terms, 4 + 3 = 7, gives 7 + 4√3. Using (a + b)² = a² + b² and skipping the middle cross term entirely gives just 4 + 3 = 7, with no surd term at all. Treating (√3)² as if it stayed √3 rather than becoming 3, then merging it with the existing surd term, gives 4 + 5√3. Squaring only the surd term correctly but carrying the whole-number term as 2 instead of squaring it to 4 gives 2 + 3 + 4√3 = 5 + 4√3.
13. (c) cos 45° — cos 45° = √2/2, and √2 cannot be written as an exact fraction, so this value is irrational. tan 0° = 0, sin 90° = 1 and sin 30° = 1/2 are all rational, since each can be written as an exact whole number or fraction.
14. (c) 1/4 — A negative index means the reciprocal of the positive power, so 2⁻² = 1 ÷ 2² = 1/4. Treating the negative sign as making the answer negative instead gives −(2²) = −4. Ignoring the negative sign altogether gives just 2² = 4. Finding the reciprocal correctly but then also applying a negative sign gives −1/4.
15. (a) 10 — √49 = 7 and ∛27 = 3, so √49 + ∛27 = 7 + 3 = 10. Treating the cube root as dividing by 3 instead of finding the cube root gives 27 ÷ 3 = 9, then 7 + 9 = 16. Multiplying the two roots instead of adding them gives 7 × 3 = 21. Ignoring the cube root symbol and using 27 as it stands gives 7 + 27 = 34.
16. (a) x = 4 ± √13 — Method: halve the coefficient of x to form the bracket, subtract the square of that number to keep the expression equal to the original, then rearrange and take the square root of both sides. Working: half of −8 is −4, so x² − 8x + 3 = (x − 4)² − 16 + 3 = (x − 4)² − 13; setting this equal to zero gives (x − 4)² = 13, so x − 4 = ±√13 and x = 4 ± √13. Answer: x = 4 ± √13. The distractors: x = 8 ± √13 comes from putting the whole coefficient 8 inside the bracket instead of half of it; x = 4 ± √19 comes from adding 16 and 3 rather than subtracting 3 from 16; x = −4 ± √13 comes from writing the bracket as (x + 4)², which reverses the sign of the number that comes out of it.
17. (d) 27/80 — Method: write the total as a fraction of a litre, then divide by the number of glasses. Working: 1.35 = 27/20, so each glass holds 27/20 ÷ 4 = 27/80 of a litre. Answer: 27/80. 27/20 comes from converting the total correctly to a fraction but forgetting to divide by the number of glasses. 27/5 comes from multiplying the total by 4 instead of dividing. 17/50 comes from rounding 1.35 ÷ 4 to 0.34 before converting to a fraction.
18. (b) (x − 5)(x + 2) — We need two numbers that multiply to −10 and add to −3: these are −5 and 2, since −5 × 2 = −10 and −5 + 2 = −3. So x² − 3x − 10 = (x − 5)(x + 2). A candidate who swaps the signs, using +5 and −2, gets (x + 5)(x − 2), which expands to x² + 3x − 10 — the wrong middle term. A candidate who picks the factor pair 1 and 10 instead of 2 and 5 gets (x − 10)(x + 1), which expands to x² − 9x − 10. A candidate who makes both factors negative gets (x − 5)(x − 2), which expands to x² − 7x + 10 — the wrong sign on the constant term.
19. (a) 5√2 cm — Method: the angles of a triangle add to 180°, so the third angle is 45° as well and the two shorter sides are equal. Take one of them as the side opposite a 45° angle and use sin 45° = opposite ÷ hypotenuse. Working: the exact value of sin 45° is √2/2, so the shorter side = 10 × √2 ÷ 2, and half of 10 is 5. Answer: 5√2 cm, which is about 7.07 cm. Remembering sin 45° as √2 rather than as √2 halved gives 10√2 cm, which is longer than the hypotenuse. Halving the hypotenuse because 45° is half of 90° gives 5 cm. Taking the value from the other special triangle, sin 60° = √3/2, gives 5√3 cm.
20. (a) 3 m — Height = sloping length × sin 45° = 3√2 × √2/2 = (3 × 2)/2 = 3 m, since √2 × √2 = 2. 3√2 m comes from forgetting to multiply by sin 45° at all. 3√2/2 m comes from using sin 30° = 1/2 instead of sin 45° = √2/2. 6 m comes from using √2 instead of √2/2 for sin 45°, dropping the denominator of the exact value: 3√2 × √2 = 6.