🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (a) 13/40 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.325 = 325/1000 = 13/40 (dividing both numerator and denominator by 25). Answer: 13/40. 13/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 8/25 comes from rounding 0.325 down to 0.32 before converting. 3/8 comes from recalling the learned conversion 3/8 = 0.375 and matching it to 0.325 because both are three-place decimals beginning with 3, instead of converting the decimal given.
2. (a) 1/3 — To subtract these fractions, first write 3/4 with a denominator of 12: 3/4 = 9/12. Then 9/12 − 5/12 = 4/12, which simplifies to 1/3. Subtracting the numerators and the denominators separately, (3 − 5)/(4 − 12), gives −2/−8, which simplifies to 1/4. Changing 3/4 to twelfths by only changing the denominator, without scaling the numerator to match, gives 3/12 − 5/12 = −2/12, which simplifies to −1/6. Adding the fractions instead of subtracting them, 9/12 + 5/12, gives 14/12, which simplifies to 7/6.
3. (a) 1/2 — cos 0° = 1 and sin 30° = 1/2, so cos 0° − sin 30° = 1 − 1/2 = 1/2. 1 comes from writing down cos 0° alone and forgetting to subtract sin 30°. 3/2 comes from adding the two values instead of subtracting. −1/2 comes from working out sin 30° − cos 0°, the two terms the wrong way round.
4. (d) x = 0 or x = 6 — Method: factorise by taking out the common factor x: x(x − 6) = 0, so x = 0 or x − 6 = 0, giving x = 0 or x = 6. Distractor origins: x = 6 comes from dividing both sides by x, which loses the solution x = 0; x = 0 stops after finding only one factor; x = 3 comes from halving the coefficient of x instead of factorising.
5. (a) 2√3 — Multiply the top and bottom of the fraction by √3, since √3 × √3 = 3: 6/√3 = (6 × √3)/(√3 × √3) = 6√3/3. Dividing 6 by 3 gives 2, so the fraction simplifies to 2√3. Multiplying only the numerator by √3 and then cancelling the surd in the denominator against it as if they were the same term, without properly squaring the denominator, leads to 6. Dividing 6 by 3 as 3 instead of 2 gives 3√3 — a slip in the final division. Simplifying 6√3/3 by cancelling the whole numerator's 3 with the denominator's 3, including the surd, gives 2, which loses the surd altogether.
6. (d) x⁴ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided. Working: six factors of x on the top and two on the bottom cancel in pairs, leaving 6 − 2 = 4 factors of x. Answer: x⁴. The distractors: x³ comes from dividing the indices, 6 ÷ 2, instead of subtracting them; x⁸ comes from adding the indices, 6 + 2, as though the powers were being multiplied; x¹² comes from multiplying the indices, 6 × 2, as though a power were being raised to a power.
7. (b) 5 and −6 — Method: turn the sentence into an equation in one letter, collect every term on one side so it reads as a quadratic equal to zero, then factorise. Working: if the number is x then x² + x = 30, which rearranges to x² + x − 30 = 0; two numbers that multiply to −30 and add to 1 are 6 and −5, so (x + 6)(x − 5) = 0 and x = −6 or x = 5. Both values work: 5 + 25 = 30 and −6 + 36 = 30. Answer: 5 and −6. The distractors: 6 and −5 comes from reading the numbers inside the brackets as the solutions without changing their signs; 5 only comes from discarding the negative solution, although nothing in the question rules out a negative number; 5 and 6 comes from hunting for a factor pair of 30 instead of forming and solving the quadratic.
8. (a) x⁶ — Method: work through the powers in order — multiplying powers of the same base means adding indices, and dividing powers of the same base means subtracting indices. Working: first, x⁵ × x³ = x⁸ (adding 5 and 3); then x⁸ ÷ x² = x⁶ (subtracting 2 from 8). x⁴ comes from swapping the two rules — subtracting for the multiplication, 5 − 3 = 2, and then adding for the division, 2 + 2 = 4. x¹⁰ comes from adding all three indices, 5 + 3 + 2 = 10, treating the division the same as a multiplication. 6x comes from correctly reaching a total index of 6 but then writing it as a coefficient of x instead of as its power. Answer: x⁶.
9. (b) x = 5 — Area = length × width, so x(x + 3) = 40, which rearranges to x² + 3x − 40 = 0. This factorises as (x + 8)(x − 5) = 0: the two numbers in the brackets must multiply to −40 and add to +3, and the pair 8 and −5 does both. This gives x = −8 or x = 5. Since x is a length, it cannot be negative, so x = 5. A candidate who gives both solutions without rejecting the negative one, which cannot be a length, answers x = 5 or x = −8. A candidate who picks the wrong factor pair of 40, such as 10 and −4 instead of 8 and −5, gets (x + 10)(x − 4) = 0 and answers x = 4. A candidate who rejects the wrong root, keeping the negative solution instead of the positive one, answers x = −8.
10. (b) 9/25 — Method: write the decimal over the matching power of ten, then divide the numerator and the denominator by their highest common factor. Working: 0.36 has two digits after the point, so 0.36 = 36/100; the highest common factor of 36 and 100 is 4, and 36 ÷ 4 = 9 with 100 ÷ 4 = 25; since 9 and 25 share no factor greater than 1, the fraction is fully cancelled. Answer: 9/25. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 9/50 comes from dividing the numerator by 4 but the denominator by only 2; 36/10 comes from counting one decimal place instead of two and writing the digits over 10.
11. (a) 2/11 — Let x = 0.18 recurring, so x = 0.181818... . Since two digits repeat, multiply by 100: 100x = 18.181818... . Subtracting the original x removes the recurring part, because the digits line up exactly: 100x − x = 18.181818... − 0.181818... = 18, so 99x = 18, giving x = 18/99 = 2/11. Treating the decimal as if it terminated at two places gives 18/100 = 9/50, which is only 0.18 and drops the repeating part entirely. Subtracting 10x instead of x — using 100x − 10x = 90x = 18 — is the wrong power of ten for a two-digit repeating block, and gives x = 18/90 = 1/5. Making an arithmetic slip in the numerator, 18 − 1 = 17 instead of 18, gives 17/99.
12. (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
13. (d) k < 4 — Method: the number of real solutions of ax² + bx + c = 0 is decided by the discriminant b² − 4ac, and two different real solutions need it to be greater than zero. Working: here a = 1, b = −4 and c = k, so b² − 4ac = 16 − 4k; the condition is 16 − 4k > 0, which gives 16 > 4k and then k < 4. Answer: k < 4; for example k = 3 gives x² − 4x + 3 = 0, whose solutions are 1 and 3. The distractors: k ≤ 4 comes from using b² − 4ac ≥ 0, which also allows the single repeated solution at k = 4; k > 4 comes from dividing −4k > −16 by −4 without reversing the inequality sign; k < 16 comes from leaving the factor 4 out of 4ac and solving 16 − k > 0.
14. (c) x = 0 or x = −7 — Factorising: x² + 7x = x(x + 7) = 0, so x = 0 or x + 7 = 0, giving x = 0 or x = −7. A candidate who divides both sides of the original equation by x, which loses the solution x = 0, gets only x = −7. A candidate who makes a sign error solving x + 7 = 0 gets x = 0 or x = 7. A candidate who misreads the coefficient and doubles it gets x = 0 or x = −14.
15. (a) 25 — Method: squaring a square root removes the root, so a square root raised to the power 4 can be squared in two stages. Working: (√5)⁴ = ((√5)²)² = 5² = 5 × 5 = 25. Answer: 25. The distractors: 5 comes from squaring once and stopping, treating the fourth power as a square; 625 comes from raising 5 to the power 4 and ignoring the root sign altogether; 20 comes from multiplying 5 by the index 4 instead of raising 5 to that power.
16. (d) 1/16 — Method: a negative index means the reciprocal of the power, so 2⁻⁴ is 1 divided by 2⁴. Working: 2⁴ = 2 × 2 × 2 × 2 = 16, so the value is 1/16. Answer: 1/16. The distractors: −16 comes from reading the negative index as a minus sign on the result; 16 comes from ignoring the minus sign and working out 2⁴; 1/8 comes from multiplying the base by the index, 2 × 4, and writing 1 over that product.
17. (c) 9π cm² — The area of a circle is π × r². With a radius of 3 cm this is π × 3² = 9π cm², and this is exact because π has not been replaced by any approximation. Writing 28.3 cm² replaces π with a rounded decimal value, 3.14, and then rounds the result again, so it is only an approximation. Writing 28.26 cm² uses π ≈ 3.14 without a final rounding step, but this is still only an approximation of 9π, not the exact value. Writing 27 cm² comes from replacing π with the rough approximation 3, which is even further from the true value.
18. (c) 5/8 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.625 = 625/1000 = 5/8 (dividing both numerator and denominator by 125). Answer: 5/8. 25/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 31/50 comes from rounding 0.625 to 0.62 before converting. 8/5 comes from simplifying correctly to 5/8 and then writing the fraction upside down.
19. (b) 0.83333... — Divide 5 by 6 using long division. 5.000... ÷ 6: 50 ÷ 6 = 8 remainder 2, giving the first decimal digit 8. Bring down a 0 to make 20, and 20 ÷ 6 = 3 remainder 2 — the remainder 2 has reappeared, so from here the digit 3 repeats forever. This gives 5/6 = 0.83333... . Stopping after two decimal places and writing 0.83 treats the division as if it terminated, when the remainder never reaches zero. Shifting the decimal point one place too far to the left gives 0.083333..., the same digits divided by an extra power of ten. A slip in the long division itself, misreading a remainder, can produce the wrong repeating digit, 0.85555... .
20. (a) y¹² — Method: when a power is raised to another power, multiply the two indices. Working: (y³)⁴ means y³ × y³ × y³ × y³, which is four lots of three y's multiplied together, so the index is 3 × 4 = 12 and (y³)⁴ = y¹². y⁷ comes from adding the indices, 3 + 4 = 7, which is the rule for multiplying two separate powers, not for raising a power to a power. y⁸¹ comes from working out 3⁴ = 81 and using that as the index, raising the inner index to the outer power instead of multiplying the two indices. 12y comes from multiplying the indices to make 12 but then treating y as a coefficient instead of a power. Answer: y¹².