🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (c) 6x(2x + 3) — The highest common factor of 12x² and 18x is 6x. Dividing each term by 6x gives 12x² ÷ 6x = 2x and 18x ÷ 6x = 3, so 12x² + 18x = 6x(2x + 3). A candidate who only takes out the number 6 (missing the x) gets 6(2x² + 3x), which is not fully factorised. A candidate who only takes out 2x (missing the extra factor of 3 in 6) gets 2x(6x + 9), also not fully factorised — the bracket still shares a common factor. A candidate who takes out 3x instead of the full 6x gets 3x(4x + 6), which again is not fully factorised since 4x + 6 shares a common factor of 2.
2. (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.
3. (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
4. (a) x¹¹ — Method: when multiplying powers of the same base, add the indices. Working: 7 + 4 = 11, so x⁷ × x⁴ = x¹¹. x²⁸ comes from multiplying the indices, 7 × 4 = 28, instead of adding them. x³ comes from working out 7 − 4 = 3, which is the rule for dividing powers, not multiplying them. 11x comes from adding the indices to make 11 but then treating x as a coefficient instead of a power. Answer: x¹¹.
5. (d) 6 + 2√3 — Multiply √3 by each term in the bracket separately. First term: √3 × 2 = 2√3. Second term: √3 × √12 = √(3 × 12) = √36 = 6. Adding the two results in the order they were found, and writing the whole-number term first, gives 6 + 2√3. Adding the numbers under the root for the second term instead of multiplying them (3 + 12 = 15) gives √15 in place of 6, leading to √15 + 2√3. Multiplying √3 by the 2 but never distributing to the √12 term at all leaves just 2√3. Treating √3 × 2 as if the 3 were multiplied by the 2 inside the root, √3 × 2 → √6, while still getting the second term correct, gives 6 + √6.
6. (b) 0.58333... — Divide 7 by 12 using long division. 70 ÷ 12 = 5 remainder 10, so the first decimal digit is 5. Bring down a 0 to make 100: 100 ÷ 12 = 8 remainder 4, so the second digit is 8. Bring down a 0 to make 40: 40 ÷ 12 = 3 remainder 4, so the third digit is 3. Bring down a 0 to make 40 again — the remainder 4 has reappeared, so the digit 3 repeats forever from here. This gives 7/12 = 0.58333... . Stopping the division after two digits and writing 0.58 treats it as if it terminated, when the remainder is not yet zero. Misreading the pattern as a two-digit repeating block, '58', gives 0.585858..., which wrongly makes the 5 recur as well as the 3. A slip in the long division that carries the wrong remainder forward can make the second digit itself appear to repeat instead of the third, giving 0.588888... .
7. (d) 6 — By Pythagoras' theorem, the square of the hypotenuse equals the sum of the squares of the other two sides: (√12)² + (√24)² = 12 + 24 = 36. The hypotenuse is √36 = 6 cm. Adding the two side lengths directly instead of squaring them first, treating the theorem as if it were a straight sum of the sides, gives √12 + √24 = 2√3 + 2√6. Multiplying the two squared values, 12 × 24 = 288, instead of adding them, then taking the root, gives √288 = 12√2. Adding the squares correctly to get 36 but forgetting to take the square root at the end leaves 36 as the answer instead of the hypotenuse itself.
8. (c) It has two different real solutions — Method: the discriminant is the quantity under the square root sign in the quadratic formula, so its sign decides how many real values the formula produces. Working: when the discriminant is positive its square root is a real number that is not zero, and the formula adds that root and subtracts it in turn, so the two results are different; a positive discriminant that is not a perfect square still gives two solutions, but they are not whole numbers. Answer: it has two different real solutions. The distractors: one repeated real solution is what a discriminant of zero gives, because adding and subtracting zero changes nothing; no real solutions is what a negative discriminant gives, because a negative number has no real square root; two whole-number solutions happens only when the discriminant is a perfect square and the division works out exactly, which a positive discriminant does not guarantee.
9. (c) 1/x⁶ — Method: raising a power to another power multiplies the two indices, and a negative index means one over the matching positive power. Working: −2 × 3 = −6, so (x⁻²)³ = x⁻⁶, and x⁻⁶ written as a fraction is 1/x⁶. Answer: 1/x⁶. The distractors: x⁶ comes from multiplying the indices correctly but dropping the minus sign; 1/x⁵ comes from adding the sizes of the indices, 2 + 3, instead of multiplying them; −x⁶ comes from reading the negative index as a minus sign in front of the whole term.
10. (c) cos 45° — cos 45° = √2/2, and √2 cannot be written as an exact fraction, so this value is irrational. tan 0° = 0, sin 90° = 1 and sin 30° = 1/2 are all rational, since each can be written as an exact whole number or fraction.
11. (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
12. (a) t = 0 or t = 4 — The ball is at ground level exactly when h = 0. From the table, h = 0 at t = 0 and at t = 4, so those are the two times. Distractor origins: t = 1 or t = 3 picks the times with equal (but non-zero) height instead of ground level; t = 2 picks the time of maximum height instead of ground level; t = 0 finds only the starting time and misses the second one.
13. (b) 1/9 — Method: let x stand for the recurring decimal, multiply by the power of ten that moves exactly one repeating block past the decimal point, subtract the original equation so that the recurring tail cancels, and solve the equation that is left. Working: let x = 0.111...; the repeating block is one digit long, so multiply by 10 to give 10x = 1.111...; subtracting the first equation from the second gives 10x − x = 1.111... − 0.111..., that is 9x = 1; dividing both sides by 9 gives x = 1/9. Answer: 1/9. The distractors: 1/10 comes from dividing by the multiplier 10 at the last step instead of by the 9 that is left in front of x; 1/11 comes from recalling the elevenths family instead of the ninths, although 1/11 = 0.0909... has a two-digit repeating block rather than a one-digit one; 11/100 comes from stopping the decimal after two digits and converting 0.11 into hundredths.
14. (b) 5/27 — Method: multiply the numerators together and the denominators together, then simplify. Working: (5 × 2)/(6 × 9) = 10/54 = 5/27. Answer: 5/27. 7/15 comes from adding the fractions instead of multiplying: (5+2)/(6+9) = 7/15. 15/4 comes from flipping the second fraction, as if dividing: (5 × 9)/(6 × 2) = 45/12 = 15/4. 5/3 comes from cancelling the two denominators against each other, dividing both 6 and 9 by 3 to leave 5/2 × 2/3 = 10/6 = 5/3; cancelling is only valid between a numerator and a denominator, never between two denominators.
15. (a) 13/40 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.325 = 325/1000 = 13/40 (dividing both numerator and denominator by 25). Answer: 13/40. 13/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 8/25 comes from rounding 0.325 down to 0.32 before converting. 3/8 comes from recalling the learned conversion 3/8 = 0.375 and matching it to 0.325 because both are three-place decimals beginning with 3, instead of converting the decimal given.
16. (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
17. (d) x² − 6x + 9 — Method: squaring a bracket means multiplying that bracket by itself, so expand (x − 3)(x − 3) term by term and then collect like terms. Working: x × x = x², x × (−3) = −3x, (−3) × x = −3x and (−3) × (−3) = 9, giving x² − 3x − 3x + 9, and the two middle terms collect to −6x. Answer: x² − 6x + 9. The distractors: x² − 3x + 9 comes from writing down only one of the two middle products instead of both; x² + 6x + 9 comes from treating (−3) × x as +3x, so the middle terms are added rather than subtracted; x² − 9 comes from treating the square as the difference of two squares (x − 3)(x + 3).
18. (b) 5 and −6 — Method: turn the sentence into an equation in one letter, collect every term on one side so it reads as a quadratic equal to zero, then factorise. Working: if the number is x then x² + x = 30, which rearranges to x² + x − 30 = 0; two numbers that multiply to −30 and add to 1 are 6 and −5, so (x + 6)(x − 5) = 0 and x = −6 or x = 5. Both values work: 5 + 25 = 30 and −6 + 36 = 30. Answer: 5 and −6. The distractors: 6 and −5 comes from reading the numbers inside the brackets as the solutions without changing their signs; 5 only comes from discarding the negative solution, although nothing in the question rules out a negative number; 5 and 6 comes from hunting for a factor pair of 30 instead of forming and solving the quadratic.
19. (a) 25 — Method: squaring a square root removes the root, so a square root raised to the power 4 can be squared in two stages. Working: (√5)⁴ = ((√5)²)² = 5² = 5 × 5 = 25. Answer: 25. The distractors: 5 comes from squaring once and stopping, treating the fourth power as a square; 625 comes from raising 5 to the power 4 and ignoring the root sign altogether; 20 comes from multiplying 5 by the index 4 instead of raising 5 to that power.
20. (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.