🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
2. (b) 9/25 — Method: write the decimal over the matching power of ten, then divide the numerator and the denominator by their highest common factor. Working: 0.36 has two digits after the point, so 0.36 = 36/100; the highest common factor of 36 and 100 is 4, and 36 ÷ 4 = 9 with 100 ÷ 4 = 25; since 9 and 25 share no factor greater than 1, the fraction is fully cancelled. Answer: 9/25. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 9/50 comes from dividing the numerator by 4 but the denominator by only 2; 36/10 comes from counting one decimal place instead of two and writing the digits over 10.
3. (a) 0.1666... — Method: a fraction bar means divide, so the decimal is found by dividing the numerator by the denominator; when a remainder comes back unchanged the division never ends, the digit it produces repeats for ever, and the exact value has to be written with that recurring digit rather than a rounded one. Working: 1 ÷ 6 is set out as 1.000 ÷ 6; six does not go into 1, and six goes into 10 tenths once with 4 left over, so the first decimal digit is 1; the 4 left over makes 40 hundredths, and six goes into 40 six times with 4 left over again; that same remainder of 4 returns at every step, so the digit 6 repeats without end. Answer: 0.1666... The distractors: 0.16 comes from carrying the division out to two decimal places and stopping there, as though the decimal terminated; 0.17 comes from rounding the division to two decimal places, which gives a value close to one sixth but not equal to it; 0.6 comes from writing the digit of the denominator straight after the decimal point, as though 1/6 meant six tenths.
4. (b) 2⁵ — Method: a power outside brackets multiplies the index of every factor inside them, and dividing powers of the same base subtracts their indices. Working: (5² × 2³)³ = 5⁶ × 2⁹ and (5³ × 2²)² = 5⁶ × 2⁴. Dividing gives 5⁶⁻⁶ × 2⁹⁻⁴, and since 5⁰ = 1 the whole expression reduces to 2⁵. Answer: 2⁵. The distractors: 2² comes from adding the outside index to each inside index instead of multiplying, which gives 5⁵ × 2⁶ over 5⁵ × 2⁴; 2¹³ comes from adding the indices of 2 when dividing, 9 + 4, instead of subtracting them; 2 comes from applying the outside power to the first factor inside each bracket only, leaving 5⁶ × 2³ over 5⁶ × 2².
5. (a) −10 — Method: multiply each bracket out, treating the second bracket as being multiplied by −3 because it is subtracted, then collect like terms. Working: 4(2x − 1) = 8x − 4 and −3(x + 2) = −3x − 6, so the expression becomes 8x − 4 − 3x − 6 − 5x; the x terms give 8x − 3x − 5x = 0, so no term in x survives, and the numbers give −4 − 6 = −10. Answer: −10. The distractors: 2 comes from expanding −3(x + 2) as −3x + 6, leaving the numbers −4 + 6; 5x − 10 comes from forgetting the final −5x, so the x terms give 8x − 3x = 5x; −7 comes from multiplying the 4 over only the first term of its bracket, giving 8x − 1 and so the numbers −1 − 6.
6. (d) 6 m — The horizontal distance is adjacent to the 60° angle and the zip-wire is the hypotenuse, so horizontal distance = 12 × cos 60° = 12 × 1/2 = 6 m. 6√3 m comes from using sin 60° = √3/2 instead of cos 60°, which would give the vertical drop, not the horizontal distance. 4√3 m comes from treating 12 as the side adjacent to a tangent ratio and dividing by tan 60° = √3. 24 m comes from dividing 12 by cos 60° instead of multiplying by it.
7. (c) x = 0 or x = −7 — Factorising: x² + 7x = x(x + 7) = 0, so x = 0 or x + 7 = 0, giving x = 0 or x = −7. A candidate who divides both sides of the original equation by x, which loses the solution x = 0, gets only x = −7. A candidate who makes a sign error solving x + 7 = 0 gets x = 0 or x = 7. A candidate who misreads the coefficient and doubles it gets x = 0 or x = −14.
8. (a) x⁶ — Method: work through the powers in order — multiplying powers of the same base means adding indices, and dividing powers of the same base means subtracting indices. Working: first, x⁵ × x³ = x⁸ (adding 5 and 3); then x⁸ ÷ x² = x⁶ (subtracting 2 from 8). x⁴ comes from swapping the two rules — subtracting for the multiplication, 5 − 3 = 2, and then adding for the division, 2 + 2 = 4. x¹⁰ comes from adding all three indices, 5 + 3 + 2 = 10, treating the division the same as a multiplication. 6x comes from correctly reaching a total index of 6 but then writing it as a coefficient of x instead of as its power. Answer: x⁶.
9. (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.
10. (d) 26 — Method: expand both brackets, treating the second as multiplication by −2 so that both of its terms change sign, then collect like terms. Working: 2(a + 6) = 2a + 12 and −2(a − 7) = −2a + 14, so the expression becomes 2a + 12 − 2a + 14; the a terms give 2a − 2a = 0, so no term in a survives, and the numbers give 12 + 14 = 26. Answer: 26. The distractors: −2 comes from expanding the second bracket as −2a − 14, so that the numbers give 12 − 14; 4a − 2 comes from adding 2(a − 7) instead of subtracting it, giving 2a + 12 + 2a − 14; 13 comes from multiplying the 2 over only the first term of each bracket, giving 2a + 6 − 2a + 7.
11. (d) x = 0 or x = 6 — Method: factorise by taking out the common factor x: x(x − 6) = 0, so x = 0 or x − 6 = 0, giving x = 0 or x = 6. Distractor origins: x = 6 comes from dividing both sides by x, which loses the solution x = 0; x = 0 stops after finding only one factor; x = 3 comes from halving the coefficient of x instead of factorising.
12. (c) It has two different real solutions — Method: the discriminant is the quantity under the square root sign in the quadratic formula, so its sign decides how many real values the formula produces. Working: when the discriminant is positive its square root is a real number that is not zero, and the formula adds that root and subtracts it in turn, so the two results are different; a positive discriminant that is not a perfect square still gives two solutions, but they are not whole numbers. Answer: it has two different real solutions. The distractors: one repeated real solution is what a discriminant of zero gives, because adding and subtracting zero changes nothing; no real solutions is what a negative discriminant gives, because a negative number has no real square root; two whole-number solutions happens only when the discriminant is a perfect square and the division works out exactly, which a positive discriminant does not guarantee.
13. (d) 1/16 — Method: a negative index means the reciprocal of the power, so 2⁻⁴ is 1 divided by 2⁴. Working: 2⁴ = 2 × 2 × 2 × 2 = 16, so the value is 1/16. Answer: 1/16. The distractors: −16 comes from reading the negative index as a minus sign on the result; 16 comes from ignoring the minus sign and working out 2⁴; 1/8 comes from multiplying the base by the index, 2 × 4, and writing 1 over that product.
14. (d) x = 2 or x = −5 — Method: find two numbers that multiply to give −10 and add to give 3 — these are 5 and −2. So x² + 3x − 10 = (x + 5)(x − 2) = 0, giving x = −5 or x = 2. Distractor origins: x = −2 or x = 5 swaps the signs of the two roots; x = 2 or x = 5 makes both roots positive, ignoring the sign of −10; x = −5 or x = −2 makes both roots negative.
15. (a) 3 m — Height = sloping length × sin 45° = 3√2 × √2/2 = (3 × 2)/2 = 3 m, since √2 × √2 = 2. 3√2 m comes from forgetting to multiply by sin 45° at all. 3√2/2 m comes from using sin 30° = 1/2 instead of sin 45° = √2/2. 6 m comes from using √2 instead of √2/2 for sin 45°, dropping the denominator of the exact value: 3√2 × √2 = 6.
16. (d) x⁴ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided. Working: six factors of x on the top and two on the bottom cancel in pairs, leaving 6 − 2 = 4 factors of x. Answer: x⁴. The distractors: x³ comes from dividing the indices, 6 ÷ 2, instead of subtracting them; x⁸ comes from adding the indices, 6 + 2, as though the powers were being multiplied; x¹² comes from multiplying the indices, 6 × 2, as though a power were being raised to a power.
17. (a) 25 — Method: squaring a square root removes the root, so a square root raised to the power 4 can be squared in two stages. Working: (√5)⁴ = ((√5)²)² = 5² = 5 × 5 = 25. Answer: 25. The distractors: 5 comes from squaring once and stopping, treating the fourth power as a square; 625 comes from raising 5 to the power 4 and ignoring the root sign altogether; 20 comes from multiplying 5 by the index 4 instead of raising 5 to that power.
18. (c) 5/8 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.625 = 625/1000 = 5/8 (dividing both numerator and denominator by 125). Answer: 5/8. 25/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 31/50 comes from rounding 0.625 to 0.62 before converting. 8/5 comes from simplifying correctly to 5/8 and then writing the fraction upside down.
19. (c) (12 + 3π) cm — The perimeter of a quarter-circle is made up of two straight radii plus a quarter of the circumference. The two radii give 2 × 6 = 12 cm, and a quarter of the circumference is (1/4) × 2 × π × 6 = 3π cm, so the total perimeter is (12 + 3π) cm. Giving only the curved part, 3π cm, forgets the two straight edges entirely. Using the full circumference, 2 × π × 6 = 12π, instead of a quarter of it gives (12 + 12π) cm. Including only one radius instead of two gives (6 + 3π) cm.
20. (b) 8π cm² — A diameter of 8 cm gives a radius of 4 cm. The area of a full circle would be π × r² = π × 4² = 16π cm², and a semicircle is exactly half of this, giving 16π ÷ 2 = 8π cm². Forgetting to halve the area for the semicircle gives 16π cm², the area of the whole circle. Halving the diameter twice, using a radius of 2 instead of 4, gives π × 2² = 4π cm². Using the diameter itself as the radius, so π × 8² = 64π, and then halving that for the semicircle gives 32π cm².