🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (d) 1/16 — Method: a negative index means the reciprocal of the power, so 2⁻⁴ is 1 divided by 2⁴. Working: 2⁴ = 2 × 2 × 2 × 2 = 16, so the value is 1/16. Answer: 1/16. The distractors: −16 comes from reading the negative index as a minus sign on the result; 16 comes from ignoring the minus sign and working out 2⁴; 1/8 comes from multiplying the base by the index, 2 × 4, and writing 1 over that product.
2. (c) 1/2 — sin 45° = √2/2 and cos 45° = √2/2, so sin 45° × cos 45° = √2/2 × √2/2 = 2/4 = 1/2. √2/2 comes from writing down only one of the two factors and forgetting to multiply by the other. √2 comes from adding the two exact values instead of multiplying them: √2/2 + √2/2 = √2. 1 comes from wrongly treating sin 45° × cos 45° as sin(45° + 45°) = sin 90° = 1 — multiplying two ratios is not the same as adding their angles.
3. (d) 6 m — The horizontal distance is adjacent to the 60° angle and the zip-wire is the hypotenuse, so horizontal distance = 12 × cos 60° = 12 × 1/2 = 6 m. 6√3 m comes from using sin 60° = √3/2 instead of cos 60°, which would give the vertical drop, not the horizontal distance. 4√3 m comes from treating 12 as the side adjacent to a tangent ratio and dividing by tan 60° = √3. 24 m comes from dividing 12 by cos 60° instead of multiplying by it.
4. (b) 5/27 — Method: multiply the numerators together and the denominators together, then simplify. Working: (5 × 2)/(6 × 9) = 10/54 = 5/27. Answer: 5/27. 7/15 comes from adding the fractions instead of multiplying: (5+2)/(6+9) = 7/15. 15/4 comes from flipping the second fraction, as if dividing: (5 × 9)/(6 × 2) = 45/12 = 15/4. 5/3 comes from cancelling the two denominators against each other, dividing both 6 and 9 by 3 to leave 5/2 × 2/3 = 10/6 = 5/3; cancelling is only valid between a numerator and a denominator, never between two denominators.
5. (b) x = 5 — Area = length × width, so x(x + 3) = 40, which rearranges to x² + 3x − 40 = 0. This factorises as (x + 8)(x − 5) = 0: the two numbers in the brackets must multiply to −40 and add to +3, and the pair 8 and −5 does both. This gives x = −8 or x = 5. Since x is a length, it cannot be negative, so x = 5. A candidate who gives both solutions without rejecting the negative one, which cannot be a length, answers x = 5 or x = −8. A candidate who picks the wrong factor pair of 40, such as 10 and −4 instead of 8 and −5, gets (x + 10)(x − 4) = 0 and answers x = 4. A candidate who rejects the wrong root, keeping the negative solution instead of the positive one, answers x = −8.
6. (c) (12 + 3π) cm — The perimeter of a quarter-circle is made up of two straight radii plus a quarter of the circumference. The two radii give 2 × 6 = 12 cm, and a quarter of the circumference is (1/4) × 2 × π × 6 = 3π cm, so the total perimeter is (12 + 3π) cm. Giving only the curved part, 3π cm, forgets the two straight edges entirely. Using the full circumference, 2 × π × 6 = 12π, instead of a quarter of it gives (12 + 12π) cm. Including only one radius instead of two gives (6 + 3π) cm.
7. (c) 25 cm — Method: for a cube, the edge length is the cube root of the volume. Working: 25 × 25 × 25 = 15,625, so the edge length is 25 cm. 5 cm comes from cube-rooting 125 instead of 15,625, misreading the number of digits. 50 cm comes from working out 25 × 2 = 50, doubling the correct edge length. 125 cm comes from taking the square root of the volume instead of the cube root, since 125 × 125 = 15,625 — that would be the side of a SQUARE of area 15,625, not the edge of a cube of that volume. Answer: 25 cm.
8. (c) 0.001 — Method: a negative index means 'one over' the positive power, so $10^{-3}$ means one over $10^{3}$. Working: ten cubed is 1000, and one over 1000 is 0.001. 1000 comes from ignoring the negative sign and working out ten cubed instead of its reciprocal. −1000 comes from ignoring what the negative index does to the size, while still writing a negative sign on the large value. −0.001 comes from correctly finding the size, 0.001, but wrongly keeping a negative sign because the index was negative. Answer: 0.001.
9. (b) 5 and −6 — Method: turn the sentence into an equation in one letter, collect every term on one side so it reads as a quadratic equal to zero, then factorise. Working: if the number is x then x² + x = 30, which rearranges to x² + x − 30 = 0; two numbers that multiply to −30 and add to 1 are 6 and −5, so (x + 6)(x − 5) = 0 and x = −6 or x = 5. Both values work: 5 + 25 = 30 and −6 + 36 = 30. Answer: 5 and −6. The distractors: 6 and −5 comes from reading the numbers inside the brackets as the solutions without changing their signs; 5 only comes from discarding the negative solution, although nothing in the question rules out a negative number; 5 and 6 comes from hunting for a factor pair of 30 instead of forming and solving the quadratic.
10. (a) 13/40 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.325 = 325/1000 = 13/40 (dividing both numerator and denominator by 25). Answer: 13/40. 13/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 8/25 comes from rounding 0.325 down to 0.32 before converting. 3/8 comes from recalling the learned conversion 3/8 = 0.375 and matching it to 0.325 because both are three-place decimals beginning with 3, instead of converting the decimal given.
11. (b) 24√2 — The side length of the tile is √72. Since 72 = 36 × 2, √72 = √36 × √2 = 6√2 cm. A square has four equal sides, so the perimeter is 4 × 6√2 = 24√2 cm. Simplifying √72 by writing the perfect-square factor itself as the coefficient instead of its root, 36√2 instead of 6√2, and then multiplying by 4 lands on 144√2. Working out the correct side length, 6√2 cm, but then giving that as the final answer without multiplying by 4 for the perimeter gives 6√2. Doubling the side length instead of quadrupling it, as if the perimeter were 2 × 6√2 rather than 4 × 6√2, gives 12√2.
12. (a) y¹² — Method: when a power is raised to another power, multiply the two indices. Working: (y³)⁴ means y³ × y³ × y³ × y³, which is four lots of three y's multiplied together, so the index is 3 × 4 = 12 and (y³)⁴ = y¹². y⁷ comes from adding the indices, 3 + 4 = 7, which is the rule for multiplying two separate powers, not for raising a power to a power. y⁸¹ comes from working out 3⁴ = 81 and using that as the index, raising the inner index to the outer power instead of multiplying the two indices. 12y comes from multiplying the indices to make 12 but then treating y as a coefficient instead of a power. Answer: y¹².
13. (b) 6x + 6 — Perimeter = 2[(2x + 5) + (x − 2)] = 2(3x + 3) = 6x + 6. A candidate who adds the length and width but forgets to double for the perimeter gets 3x + 3. A candidate who makes a sign error and adds 2 instead of subtracting it before doubling gets 2[(2x + 5) + (x + 2)] = 6x + 14. A candidate who multiplies the length and width instead of adding them, confusing the perimeter formula with the area formula, and then doubles that product, gets 2(2x + 5)(x − 2) = 4x² + 2x − 20.
14. (c) x = 0 or x = 3 — Method: take out the common factor 5x: 5x(x − 3) = 0, so 5x = 0 or x − 3 = 0, giving x = 0 or x = 3. Distractor origins: x = 0 or x = 15 comes from forgetting to divide the second term by the common factor 5x correctly, leaving 15 instead of 3; x = 3 loses the solution x = 0 by dividing both sides by x; x = 5 or x = 3 mistakes the coefficient 5 itself for one of the solutions.
15. (a) 25 — Method: squaring a square root removes the root, so a square root raised to the power 4 can be squared in two stages. Working: (√5)⁴ = ((√5)²)² = 5² = 5 × 5 = 25. Answer: 25. The distractors: 5 comes from squaring once and stopping, treating the fourth power as a square; 625 comes from raising 5 to the power 4 and ignoring the root sign altogether; 20 comes from multiplying 5 by the index 4 instead of raising 5 to that power.
16. (a) k = 3 — Method: a solution of an equation makes both sides balance, so substitute it in and solve the equation in k that is left. Working: putting x = 3 gives 3² − (k + 1) × 3 + k = 0, that is 9 − 3k − 3 + k = 0, so 6 − 2k = 0 and k = 3; the equation is then x² − 4x + 3 = 0, whose solutions are 3 and 1. Answer: k = 3. The distractors: k = −3 comes from solving 6 − 2k = 0 as though it gave 2k = −6; k = 4 comes from expanding −3(k + 1) as −3k − 1, multiplying only the k by 3; k = 1.5 comes from working 3² as 3 × 2 = 6, which leaves 3 − 2k = 0.
17. (a) 7/8 — Method: write the decimal over the power of ten that matches the number of digits after the point, then divide the numerator and the denominator by their highest common factor. Working: 0.875 has three digits after the point, so it is 875 thousandths and can be written as 875/1000; the highest common factor of 875 and 1000 is 125, and 875 ÷ 125 = 7 with 1000 ÷ 125 = 8. Answer: 7/8. The distractors: 8/7 comes from cancelling correctly but writing the two parts the wrong way round; 9/10 comes from rounding 0.875 to one decimal place as 0.9 before converting; 7/80 comes from counting four decimal places instead of three and using a denominator of 10000, giving 875/10000.
18. (d) 3√5 — Split 45 into a perfect square times a factor: 45 = 9 × 5. Take the square root of each part separately: √45 = √9 × √5 = 3√5, since √9 = 3. Writing the perfect-square factor itself (9) as the coefficient instead of its root would give 9√5 — that trap comes from forgetting the last step, rooting 9. Multiplying 3 and 5 together instead of keeping them as coefficient and radicand gives 15, which throws away the surd entirely. Doubling the correct coefficient by mistake gives 6√5.
19. (c) cos 45° — cos 45° = √2/2, and √2 cannot be written as an exact fraction, so this value is irrational. tan 0° = 0, sin 90° = 1 and sin 30° = 1/2 are all rational, since each can be written as an exact whole number or fraction.
20. (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.