🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (d) 3√5 — Split 45 into a perfect square times a factor: 45 = 9 × 5. Take the square root of each part separately: √45 = √9 × √5 = 3√5, since √9 = 3. Writing the perfect-square factor itself (9) as the coefficient instead of its root would give 9√5 — that trap comes from forgetting the last step, rooting 9. Multiplying 3 and 5 together instead of keeping them as coefficient and radicand gives 15, which throws away the surd entirely. Doubling the correct coefficient by mistake gives 6√5.
2. (d) 8(7x − 3) — Method: find the highest common factor of the two terms, write it in front of a bracket and divide each term by it. Working: 56 = 8 × 7 and 24 = 8 × 3, so the highest common factor is 8; dividing gives 56x ÷ 8 = 7x and 24 ÷ 8 = 3, and the subtraction sign stays between them. Answer: 8(7x − 3), which multiplies back out to 56x − 24. The distractors: 8(7x + 3) comes from dropping the minus sign of −24 while dividing; 8(56x − 3) comes from dividing only the number term by 8 and leaving 56x untouched inside the bracket; 8(7x − 16) comes from subtracting 8 from 24 instead of dividing 24 by 8.
3. (a) t = 0 or t = 4 — The ball is at ground level exactly when h = 0. From the table, h = 0 at t = 0 and at t = 4, so those are the two times. Distractor origins: t = 1 or t = 3 picks the times with equal (but non-zero) height instead of ground level; t = 2 picks the time of maximum height instead of ground level; t = 0 finds only the starting time and misses the second one.
4. (a) x¹¹ — Method: when multiplying powers of the same base, add the indices. Working: 7 + 4 = 11, so x⁷ × x⁴ = x¹¹. x²⁸ comes from multiplying the indices, 7 × 4 = 28, instead of adding them. x³ comes from working out 7 − 4 = 3, which is the rule for dividing powers, not multiplying them. 11x comes from adding the indices to make 11 but then treating x as a coefficient instead of a power. Answer: x¹¹.
5. (a) 5√2 cm — Method: the angles of a triangle add to 180°, so the third angle is 45° as well and the two shorter sides are equal. Take one of them as the side opposite a 45° angle and use sin 45° = opposite ÷ hypotenuse. Working: the exact value of sin 45° is √2/2, so the shorter side = 10 × √2 ÷ 2, and half of 10 is 5. Answer: 5√2 cm, which is about 7.07 cm. Remembering sin 45° as √2 rather than as √2 halved gives 10√2 cm, which is longer than the hypotenuse. Halving the hypotenuse because 45° is half of 90° gives 5 cm. Taking the value from the other special triangle, sin 60° = √3/2, gives 5√3 cm.
6. (c) 3⁻³ — Method: when dividing powers of the same base, subtract the index of the number you are dividing by from the index of the number being divided, keeping them in the order the question writes them. Working: 2 − 5 = −3, so 3² ÷ 3⁵ = 3⁻³. It is worth checking this against the numbers: 3² = 9 and 3⁵ = 243, and 9 ÷ 243 = 1/27, which is 3⁻³. 3³ comes from subtracting the other way round, 5 − 2 = 3, which reverses the sign of the index and gives 27 instead of 1/27. 3⁷ comes from working out 2 + 5 = 7, which is the rule for multiplying powers, not dividing them. 3¹⁰ comes from multiplying the indices, 2 × 5 = 10, instead of subtracting them. Answer: 3⁻³.
7. (a) 0.625 — Method: convert the fraction to a decimal so it can be compared properly with 0.6. Working: 5/8 = 0.625, and since 0.625 > 0.6, the larger value is 0.625. Answer: 0.625. 0.6 repeats Sam's incorrect claim, made by comparing single digits rather than full place value. 0.58 comes from converting 5/8 incorrectly, treating it as if it read 5 tenths and 8 hundredths. 0.85 comes from turning the fraction upside down and writing its digits straight after the decimal point, 8 then 5, instead of dividing.
8. (a) 0.1666... — Method: a fraction bar means divide, so the decimal is found by dividing the numerator by the denominator; when a remainder comes back unchanged the division never ends, the digit it produces repeats for ever, and the exact value has to be written with that recurring digit rather than a rounded one. Working: 1 ÷ 6 is set out as 1.000 ÷ 6; six does not go into 1, and six goes into 10 tenths once with 4 left over, so the first decimal digit is 1; the 4 left over makes 40 hundredths, and six goes into 40 six times with 4 left over again; that same remainder of 4 returns at every step, so the digit 6 repeats without end. Answer: 0.1666... The distractors: 0.16 comes from carrying the division out to two decimal places and stopping there, as though the decimal terminated; 0.17 comes from rounding the division to two decimal places, which gives a value close to one sixth but not equal to it; 0.6 comes from writing the digit of the denominator straight after the decimal point, as though 1/6 meant six tenths.
9. (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
10. (b) 5/27 — Method: multiply the numerators together and the denominators together, then simplify. Working: (5 × 2)/(6 × 9) = 10/54 = 5/27. Answer: 5/27. 7/15 comes from adding the fractions instead of multiplying: (5+2)/(6+9) = 7/15. 15/4 comes from flipping the second fraction, as if dividing: (5 × 9)/(6 × 2) = 45/12 = 15/4. 5/3 comes from cancelling the two denominators against each other, dividing both 6 and 9 by 3 to leave 5/2 × 2/3 = 10/6 = 5/3; cancelling is only valid between a numerator and a denominator, never between two denominators.
11. (a) 2√3/3 — tan 30° = √3/3, so tan 30° + tan 30° = 2 × √3/3 = 2√3/3. √3 comes from wrongly treating tan 30° + tan 30° as tan(30° + 30°) = tan 60° = √3 — adding angles is not the same as adding ratios. √3/3 comes from forgetting to double the value and just writing down tan 30° on its own. 2√3 comes from doubling the numerator of √3/3 but forgetting to keep the denominator of 3.
12. (a) 4 + √6 — Multiply top and bottom by the conjugate, 4 + √6. The denominator becomes (4 − √6)(4 + √6) = 4² − (√6)² = 16 − 6 = 10. The numerator becomes 10 × (4 + √6) = 40 + 10√6. So the fraction is (40 + 10√6)/10 = 4 + √6, since both terms in the numerator divide by 10. Distributing the conjugate to only the whole-number term of the numerator, and forgetting the surd term entirely, leaves just 4. Rationalising by multiplying the numerator by the conjugate but leaving the ORIGINAL denominator's sign unchanged instead of squaring it lands on 4 − √6, with the surd's sign never actually flipping to positive. Dividing only the whole-number part of the numerator by 10 and forgetting to divide the surd term too leaves 4 + 10√6.
13. (c) 5/11 — Let x = 0.45 recurring, so x = 0.454545... . Since two digits repeat, multiply by 100: 100x = 45.454545... . Subtracting the original x removes the recurring part exactly, because it lines up digit for digit: 100x − x = 45.454545... − 0.454545... = 45, so 99x = 45, giving x = 45/99 = 5/11. Treating the decimal as if it terminated at two places gives 45/100 = 9/20, which is only 0.45 and drops the repeating part entirely. Subtracting 10x instead of x — using 100x − 10x = 90x = 45 — is the wrong power of ten for a two-digit repeating block, and gives x = 45/90 = 1/2. Making an arithmetic slip in the numerator, 45 − 1 = 44 instead of 45, gives 44/99 = 4/9.
14. (a) 7/8 — Method: write the decimal over the power of ten that matches the number of digits after the point, then divide the numerator and the denominator by their highest common factor. Working: 0.875 has three digits after the point, so it is 875 thousandths and can be written as 875/1000; the highest common factor of 875 and 1000 is 125, and 875 ÷ 125 = 7 with 1000 ÷ 125 = 8. Answer: 7/8. The distractors: 8/7 comes from cancelling correctly but writing the two parts the wrong way round; 9/10 comes from rounding 0.875 to one decimal place as 0.9 before converting; 7/80 comes from counting four decimal places instead of three and using a denominator of 10000, giving 875/10000.
15. (b) x = 5 — Area = length × width, so x(x + 3) = 40, which rearranges to x² + 3x − 40 = 0. This factorises as (x + 8)(x − 5) = 0: the two numbers in the brackets must multiply to −40 and add to +3, and the pair 8 and −5 does both. This gives x = −8 or x = 5. Since x is a length, it cannot be negative, so x = 5. A candidate who gives both solutions without rejecting the negative one, which cannot be a length, answers x = 5 or x = −8. A candidate who picks the wrong factor pair of 40, such as 10 and −4 instead of 8 and −5, gets (x + 10)(x − 4) = 0 and answers x = 4. A candidate who rejects the wrong root, keeping the negative solution instead of the positive one, answers x = −8.
16. (d) 1/16 — Method: a negative index means the reciprocal of the power, so 2⁻⁴ is 1 divided by 2⁴. Working: 2⁴ = 2 × 2 × 2 × 2 = 16, so the value is 1/16. Answer: 1/16. The distractors: −16 comes from reading the negative index as a minus sign on the result; 16 comes from ignoring the minus sign and working out 2⁴; 1/8 comes from multiplying the base by the index, 2 × 4, and writing 1 over that product.
17. (c) 1/4 — A negative index means the reciprocal of the positive power, so 2⁻² = 1 ÷ 2² = 1/4. Treating the negative sign as making the answer negative instead gives −(2²) = −4. Ignoring the negative sign altogether gives just 2² = 4. Finding the reciprocal correctly but then also applying a negative sign gives −1/4.
18. (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
19. (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
20. (d) 9√3 cm — DE is opposite the 60° angle at F, and EF is adjacent to it, so DE = EF × tan 60° = 9 × √3 = 9√3 cm. 9√3/2 cm comes from using sin 60° = √3/2 instead of tan 60°. 3√3 cm comes from using tan 30° = 1/√3 instead of tan 60° (9 × 1/√3 = 9/√3 = 3√3). 18 cm is the hypotenuse DF, not DE: it comes from using cos 60° = 1/2 and working out 9 ÷ 1/2 = 18, which finds the wrong side of the triangle.