🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (a) x¹¹ — Method: when multiplying powers of the same base, add the indices. Working: 7 + 4 = 11, so x⁷ × x⁴ = x¹¹. x²⁸ comes from multiplying the indices, 7 × 4 = 28, instead of adding them. x³ comes from working out 7 − 4 = 3, which is the rule for dividing powers, not multiplying them. 11x comes from adding the indices to make 11 but then treating x as a coefficient instead of a power. Answer: x¹¹.
2. (c) 9π cm² — The area of a circle is π × r². With a radius of 3 cm this is π × 3² = 9π cm², and this is exact because π has not been replaced by any approximation. Writing 28.3 cm² replaces π with a rounded decimal value, 3.14, and then rounds the result again, so it is only an approximation. Writing 28.26 cm² uses π ≈ 3.14 without a final rounding step, but this is still only an approximation of 9π, not the exact value. Writing 27 cm² comes from replacing π with the rough approximation 3, which is even further from the true value.
3. (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
4. (b) 5² — Method: multiplying two powers of the same base adds their indices, and a negative index is added as a negative number. Working: −2 + 4 = 2, so 5⁻² × 5⁴ = 5². Answer: 5². The distractors: 5⁶ comes from adding the sizes of the indices, 2 + 4, and ignoring the minus sign; 5⁻⁸ comes from multiplying the indices, −2 × 4, instead of adding them; 5⁻⁶ comes from subtracting the indices, −2 − 4, as though the powers were being divided.
5. (d) x⁴ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided. Working: six factors of x on the top and two on the bottom cancel in pairs, leaving 6 − 2 = 4 factors of x. Answer: x⁴. The distractors: x³ comes from dividing the indices, 6 ÷ 2, instead of subtracting them; x⁸ comes from adding the indices, 6 + 2, as though the powers were being multiplied; x¹² comes from multiplying the indices, 6 × 2, as though a power were being raised to a power.
6. (c) 1/2 — sin 45° = √2/2 and cos 45° = √2/2, so sin 45° × cos 45° = √2/2 × √2/2 = 2/4 = 1/2. √2/2 comes from writing down only one of the two factors and forgetting to multiply by the other. √2 comes from adding the two exact values instead of multiplying them: √2/2 + √2/2 = √2. 1 comes from wrongly treating sin 45° × cos 45° as sin(45° + 45°) = sin 90° = 1 — multiplying two ratios is not the same as adding their angles.
7. (d) 1/4 — Method: deal with the fractional index first, then the negative sign. Working: $8^{2/3} = (\sqrt[3]{8})^2 = 2^2 = 4$. A negative index means take the reciprocal of that result, so $8^{-2/3} = \frac{1}{8^{2/3}} = \frac{1}{4}$. Answer: 1/4. A candidate who evaluates $8^{2/3}$ correctly but forgets the negative sign entirely gets 4 — they have dropped the instruction to take a reciprocal. A candidate who takes the reciprocal step but applies it as a sign change to the finished number instead of inverting it gets −4. A candidate who multiplies 8 by −2/3, treating the index as an ordinary factor rather than a power, gets −16/3.
8. (d) 6 — By Pythagoras' theorem, the square of the hypotenuse equals the sum of the squares of the other two sides: (√12)² + (√24)² = 12 + 24 = 36. The hypotenuse is √36 = 6 cm. Adding the two side lengths directly instead of squaring them first, treating the theorem as if it were a straight sum of the sides, gives √12 + √24 = 2√3 + 2√6. Multiplying the two squared values, 12 × 24 = 288, instead of adding them, then taking the root, gives √288 = 12√2. Adding the squares correctly to get 36 but forgetting to take the square root at the end leaves 36 as the answer instead of the hypotenuse itself.
9. (d) 636 g — Let x = 0.636363... . Since two digits repeat, multiply by 100: 100x = 63.636363... . Subtracting removes the recurring part exactly: 100x − x = 63.636363... − 0.636363... = 63, so 99x = 63, giving x = 63/99 = 7/11 kg. Converting to grams: 7/11 × 1000 = 7000/11 = 636.3636... g, which rounds to 636 g. Treating the decimal as if it terminated, writing 0.63 as 63/100 kg, gives 630 g when multiplied by 1000 — this drops the recurring part entirely. Subtracting 10x instead of x, using 100x − 10x = 90x = 63, is the wrong power of ten for a two-digit block, giving x = 63/90 = 7/10 kg, which is 700 g. A numerator slip in the subtraction, 63 − 1 = 62 instead of 63, gives x = 62/99 kg, which is 62000/99 = 626.26... g, rounding to 626 g.
10. (c) 3⁻³ — Method: when dividing powers of the same base, subtract the index of the number you are dividing by from the index of the number being divided, keeping them in the order the question writes them. Working: 2 − 5 = −3, so 3² ÷ 3⁵ = 3⁻³. It is worth checking this against the numbers: 3² = 9 and 3⁵ = 243, and 9 ÷ 243 = 1/27, which is 3⁻³. 3³ comes from subtracting the other way round, 5 − 2 = 3, which reverses the sign of the index and gives 27 instead of 1/27. 3⁷ comes from working out 2 + 5 = 7, which is the rule for multiplying powers, not dividing them. 3¹⁰ comes from multiplying the indices, 2 × 5 = 10, instead of subtracting them. Answer: 3⁻³.
11. (a) 3 m — Height = sloping length × sin 45° = 3√2 × √2/2 = (3 × 2)/2 = 3 m, since √2 × √2 = 2. 3√2 m comes from forgetting to multiply by sin 45° at all. 3√2/2 m comes from using sin 30° = 1/2 instead of sin 45° = √2/2. 6 m comes from using √2 instead of √2/2 for sin 45°, dropping the denominator of the exact value: 3√2 × √2 = 6.
12. (b) 3/50 — Method: write the decimal over the power of ten that matches the number of digits after the point, counting every digit including a zero, then divide the numerator and the denominator by their highest common factor. Working: 0.06 has two digits after the point, so it is 6 hundredths and can be written as 6/100; the highest common factor of 6 and 100 is 2, and 6 ÷ 2 = 3 with 100 ÷ 2 = 50. Answer: 3/50. The distractors: 3/5 comes from ignoring the zero straight after the point and converting 0.6 instead, giving 6/10, which cancels to 3/5; 3/500 comes from counting three decimal places instead of two and writing 6/1000, which cancels to 3/500; 1/6 comes from putting 1 over the digits after the point, as though 0.06 meant one sixth.
13. (d) 3√5 — Split 45 into a perfect square times a factor: 45 = 9 × 5. Take the square root of each part separately: √45 = √9 × √5 = 3√5, since √9 = 3. Writing the perfect-square factor itself (9) as the coefficient instead of its root would give 9√5 — that trap comes from forgetting the last step, rooting 9. Multiplying 3 and 5 together instead of keeping them as coefficient and radicand gives 15, which throws away the surd entirely. Doubling the correct coefficient by mistake gives 6√5.
14. (a) 10 — √49 = 7 and ∛27 = 3, so √49 + ∛27 = 7 + 3 = 10. Treating the cube root as dividing by 3 instead of finding the cube root gives 27 ÷ 3 = 9, then 7 + 9 = 16. Multiplying the two roots instead of adding them gives 7 × 3 = 21. Ignoring the cube root symbol and using 27 as it stands gives 7 + 27 = 34.
15. (d) 2x/(x − 2) — Factorise x² − 4 as (x − 2)(x + 2) first — it's a difference of two squares. The (x + 2) in the numerator then cancels with the (x + 2) in the factorised denominator, and 6x² ÷ 3x simplifies to 2x, leaving 2x/(x − 2). Writing 2/(x − 2) comes from over-cancelling 6x² ÷ 3x as 2 instead of 2x, dropping the x that should remain. Writing 2x/(x + 2) comes from factorising x² − 4 as (x + 2)² instead of (x − 2)(x + 2), a difference of two squares always has one plus and one minus bracket. Writing 2x²/(x − 2) comes from simplifying 6x² ÷ 3x as 2x² instead of 2x, dividing the coefficients but not reducing the power of x.
16. (d) x = 3 or x = −3 — Method: get x² on its own with a coefficient of 1, then take the square root of both sides and keep both the positive and the negative root. Working: dividing 2x² = 18 by 2 gives x² = 9, and the square root of 9 is 3, so x = 3 or x = −3; both check, because 2 × 9 = 18 either way. Answer: x = 3 or x = −3. The distractors: x = 9 or x = −9 comes from dividing by 2 and then forgetting to take the square root; x = 4 or x = −4 comes from subtracting 2 from 18 instead of dividing by it, giving x² = 16; x = 6 or x = −6 comes from multiplying by 2 instead of dividing, giving x² = 36.
17. (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
18. (b) 12 m — sin 30° = opposite ÷ hypotenuse, where the opposite side is the height (6 m) and the hypotenuse is the string. So string = height ÷ sin 30° = 6 ÷ (1/2) = 12 m. The distractor 3 m comes from multiplying by sin 30° instead of dividing (6 × 1/2 = 3). The distractor 6√3 m comes from using tan 30° = 1/√3 instead of sin 30° (6 ÷ (1/√3) = 6√3). The distractor 4√3 m comes from using cos 30° = √3/2 instead of sin 30° (6 ÷ (√3/2) = 12/√3 = 4√3).
19. (a) −10 — Method: multiply each bracket out, treating the second bracket as being multiplied by −3 because it is subtracted, then collect like terms. Working: 4(2x − 1) = 8x − 4 and −3(x + 2) = −3x − 6, so the expression becomes 8x − 4 − 3x − 6 − 5x; the x terms give 8x − 3x − 5x = 0, so no term in x survives, and the numbers give −4 − 6 = −10. Answer: −10. The distractors: 2 comes from expanding −3(x + 2) as −3x + 6, leaving the numbers −4 + 6; 5x − 10 comes from forgetting the final −5x, so the x terms give 8x − 3x = 5x; −7 comes from multiplying the 4 over only the first term of its bracket, giving 8x − 1 and so the numbers −1 − 6.
20. (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.