🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (b) 24√2 — The side length of the tile is √72. Since 72 = 36 × 2, √72 = √36 × √2 = 6√2 cm. A square has four equal sides, so the perimeter is 4 × 6√2 = 24√2 cm. Simplifying √72 by writing the perfect-square factor itself as the coefficient instead of its root, 36√2 instead of 6√2, and then multiplying by 4 lands on 144√2. Working out the correct side length, 6√2 cm, but then giving that as the final answer without multiplying by 4 for the perimeter gives 6√2. Doubling the side length instead of quadrupling it, as if the perimeter were 2 × 6√2 rather than 4 × 6√2, gives 12√2.
2. (d) 16π cm² — Method: for a circle, area = π × radius². Working: area = π × 4² = π × 16 = 16π cm². Answer: 16π cm². The student squared the radius but left out the π, which is why 16 cm² is not the exact area. 4π cm² comes from multiplying by the radius once instead of squaring it: π × 4 = 4π. 8π cm² comes from using the circumference formula 2 × π × radius instead of the area formula: 2 × π × 4 = 8π. 64π cm² comes from using the diameter (8 cm) as the radius in the area formula: π × 8² = 64π.
3. (d) x = 0 or x = 6 — Method: factorise by taking out the common factor x: x(x − 6) = 0, so x = 0 or x − 6 = 0, giving x = 0 or x = 6. Distractor origins: x = 6 comes from dividing both sides by x, which loses the solution x = 0; x = 0 stops after finding only one factor; x = 3 comes from halving the coefficient of x instead of factorising.
4. (c) 1 — cos 45° = √2/2 and sin 45° = √2/2. Squaring each gives (√2/2)² = 2/4 = 1/2, so (cos 45°)² + (sin 45°)² = 1/2 + 1/2 = 1. The distractor √2 comes from adding cos 45° + sin 45° directly without squaring first (√2/2 + √2/2 = √2). The distractor 2 comes from squaring the top of the fraction, (√2)² = 2, but then dividing by 2 instead of 4 for each term, giving 1 + 1 = 2. The distractor 1/2 comes from squaring only cos 45° and forgetting to add the sin 45° term.
5. (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
6. (d) 6 m — The horizontal distance is adjacent to the 60° angle and the zip-wire is the hypotenuse, so horizontal distance = 12 × cos 60° = 12 × 1/2 = 6 m. 6√3 m comes from using sin 60° = √3/2 instead of cos 60°, which would give the vertical drop, not the horizontal distance. 4√3 m comes from treating 12 as the side adjacent to a tangent ratio and dividing by tan 60° = √3. 24 m comes from dividing 12 by cos 60° instead of multiplying by it.
7. (d) 3/8 — Method: making half the recipe means dividing the quantity of sugar by 2. Working: 3/4 ÷ 2 = 3/8. Answer: 3/8. 3/2 comes from multiplying by 2 instead of dividing, as if doubling the recipe. 5/4 comes from adding 1/2 to 3/4 instead of halving it, confusing "half of" with "plus a half". 3/4 comes from leaving the amount unchanged, forgetting to halve it for the smaller recipe.
8. (a) 1/2 — cos 0° = 1 and sin 30° = 1/2, so cos 0° − sin 30° = 1 − 1/2 = 1/2. 1 comes from writing down cos 0° alone and forgetting to subtract sin 30°. 3/2 comes from adding the two values instead of subtracting. −1/2 comes from working out sin 30° − cos 0°, the two terms the wrong way round.
9. (c) 0.7, 0.72, 3/4 — Method: numbers written in different forms cannot be compared as they stand, so every fraction is turned into a decimal by dividing the numerator by the denominator, and the decimals are then compared place by place from the left. Working: 3/4 means 3 ÷ 4 = 0.75, so the three values to compare are 0.7, 0.75 and 0.72; written to two decimal places they are 0.70, 0.75 and 0.72, and the hundredths digits 0, 5 and 2 put 0.70 first, 0.72 next and 0.75 last; written again in the forms the question used, the order from smallest is 0.7, then 0.72, then 3/4. Answer: 0.7, 0.72, 3/4. The distractors: 3/4, 0.7, 0.72 comes from turning 3/4 into 0.34 by writing the numerator and the denominator as the two digits after the point, which makes the fraction the smallest of the three; 0.72, 3/4, 0.7 comes from the belief that the more digits a decimal has the smaller it must be, which puts both 0.72 and 0.75 below 0.7 and 0.72 below 0.75; 3/4, 0.72, 0.7 comes from comparing the three values correctly but listing them largest first, against an instruction to start with the smallest.
10. (c) 1/x⁶ — Method: raising a power to another power multiplies the two indices, and a negative index means one over the matching positive power. Working: −2 × 3 = −6, so (x⁻²)³ = x⁻⁶, and x⁻⁶ written as a fraction is 1/x⁶. Answer: 1/x⁶. The distractors: x⁶ comes from multiplying the indices correctly but dropping the minus sign; 1/x⁵ comes from adding the sizes of the indices, 2 + 3, instead of multiplying them; −x⁶ comes from reading the negative index as a minus sign in front of the whole term.
11. (a) 0.1666... — Method: a fraction bar means divide, so the decimal is found by dividing the numerator by the denominator; when a remainder comes back unchanged the division never ends, the digit it produces repeats for ever, and the exact value has to be written with that recurring digit rather than a rounded one. Working: 1 ÷ 6 is set out as 1.000 ÷ 6; six does not go into 1, and six goes into 10 tenths once with 4 left over, so the first decimal digit is 1; the 4 left over makes 40 hundredths, and six goes into 40 six times with 4 left over again; that same remainder of 4 returns at every step, so the digit 6 repeats without end. Answer: 0.1666... The distractors: 0.16 comes from carrying the division out to two decimal places and stopping there, as though the decimal terminated; 0.17 comes from rounding the division to two decimal places, which gives a value close to one sixth but not equal to it; 0.6 comes from writing the digit of the denominator straight after the decimal point, as though 1/6 meant six tenths.
12. (d) 27/80 — Method: write the total as a fraction of a litre, then divide by the number of glasses. Working: 1.35 = 27/20, so each glass holds 27/20 ÷ 4 = 27/80 of a litre. Answer: 27/80. 27/20 comes from converting the total correctly to a fraction but forgetting to divide by the number of glasses. 27/5 comes from multiplying the total by 4 instead of dividing. 17/50 comes from rounding 1.35 ÷ 4 to 0.34 before converting to a fraction.
13. (a) x = 4 or x = −3 — Method: find two numbers that multiply to give −12 and add to give −1 — these are −4 and 3. So x² − x − 12 = (x − 4)(x + 3) = 0, giving x = 4 or x = −3. Distractor origins: x = −4 or x = 3 has the signs the wrong way round; x = 4 or x = 3 makes both roots positive, ignoring the sign of −12; x = 12 or x = −1 comes from reading off the coefficient and the constant directly instead of factorising.
14. (d) x⁴ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided. Working: six factors of x on the top and two on the bottom cancel in pairs, leaving 6 − 2 = 4 factors of x. Answer: x⁴. The distractors: x³ comes from dividing the indices, 6 ÷ 2, instead of subtracting them; x⁸ comes from adding the indices, 6 + 2, as though the powers were being multiplied; x¹² comes from multiplying the indices, 6 × 2, as though a power were being raised to a power.
15. (c) x = −2 or x = 4 — The solutions of x² − 2x − 8 = 0 are the x-values where y = 0. From the table, y = 0 when x = −2 and when x = 4, so those are the two solutions. Distractor origins: x = −1 or x = 3 picks the pair of x-values that give equal (but non-zero) y-values instead of y = 0; x = 0 or x = −8 mixes up an x-value with its corresponding y-value; x = −2 only reads off one of the two roots and misses the other.
16. (a) 5√2 — Simplify each surd first: √8 = √4 × √2 = 2√2, and √18 = √9 × √2 = 3√2. Both terms are now multiples of √2, so they are like terms: 2√2 + 3√2 = 5√2. Adding the numbers under the two roots first, 8 + 18 = 26, and writing √26 treats unlike surds as if they combine under one root — they only combine once they share the same radicand, which is not how addition of surds works. Writing 9√2 for √18 instead of 3√2 (forgetting to root the 9) and then adding gives 2√2 + 9√2 = 11√2. Writing 4√2 for √8 instead of 2√2 (forgetting to root the 4) and adding gives 4√2 + 3√2 = 7√2.
17. (c) 2/5 — To find a fraction of a fraction, multiply them together: 3/5 × 2/3 = 6/15, which simplifies to 2/5. Multiplying only the numerators, 3 × 2 = 6, but adding the denominators, 5 + 3 = 8, instead of multiplying them gives 6/8, which simplifies to 3/4. Using only the fraction who study French, 3/5, and ignoring that a further fraction of them also study Spanish gives 3/5. Dividing by 2/3 instead of multiplying by it, using its reciprocal 3/2, gives 3/5 × 3/2 = 9/10.
18. (c) 6x(2x + 3) — The highest common factor of 12x² and 18x is 6x. Dividing each term by 6x gives 12x² ÷ 6x = 2x and 18x ÷ 6x = 3, so 12x² + 18x = 6x(2x + 3). A candidate who only takes out the number 6 (missing the x) gets 6(2x² + 3x), which is not fully factorised. A candidate who only takes out 2x (missing the extra factor of 3 in 6) gets 2x(6x + 9), also not fully factorised — the bracket still shares a common factor. A candidate who takes out 3x instead of the full 6x gets 3x(4x + 6), which again is not fully factorised since 4x + 6 shares a common factor of 2.
19. (b) 16π — Use the circumference formula C = 2πr to find the radius: 8π = 2πr, so r = 8π ÷ 2π = 4 cm. Then use the area formula A = πr²: A = π × 4² = 16π cm². Using C = πr instead of C = 2πr gives r = 8, and squaring that gives 64π. Finding r = 4 correctly but then substituting it back into the circumference formula instead of the area formula gives 2π × 4 = 8π. Finding r = 4 correctly but forgetting to square it in the area formula, using A = πr instead of A = πr², gives 4π.
20. (a) 17 — Method: work out each power separately, then combine them as the question asks. Working: $2^3 = 8$ and $3^2 = 9$, and 8 + 9 = 17. 72 comes from working out 8 × 9 = 72, multiplying the two powers instead of adding them. 12 comes from misreading the powers as repeated multiplication of the base by the index, 2 × 3 + 3 × 2 = 6 + 6 = 12. −1 comes from working out 8 − 9 = −1, subtracting the powers instead of adding them. Answer: 17.