🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (c) 0.7, 0.72, 3/4 — Method: numbers written in different forms cannot be compared as they stand, so every fraction is turned into a decimal by dividing the numerator by the denominator, and the decimals are then compared place by place from the left. Working: 3/4 means 3 ÷ 4 = 0.75, so the three values to compare are 0.7, 0.75 and 0.72; written to two decimal places they are 0.70, 0.75 and 0.72, and the hundredths digits 0, 5 and 2 put 0.70 first, 0.72 next and 0.75 last; written again in the forms the question used, the order from smallest is 0.7, then 0.72, then 3/4. Answer: 0.7, 0.72, 3/4. The distractors: 3/4, 0.7, 0.72 comes from turning 3/4 into 0.34 by writing the numerator and the denominator as the two digits after the point, which makes the fraction the smallest of the three; 0.72, 3/4, 0.7 comes from the belief that the more digits a decimal has the smaller it must be, which puts both 0.72 and 0.75 below 0.7 and 0.72 below 0.75; 3/4, 0.72, 0.7 comes from comparing the three values correctly but listing them largest first, against an instruction to start with the smallest.
2. (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
3. (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
4. (d) (3x − 2)(x + 4) — For 3x² + 10x − 8, find two numbers multiplying to 3 × (−8) = −24 and adding to 10: these are 12 and −2. Rewrite: 3x² + 12x − 2x − 8 = 3x(x + 4) − 2(x + 4) = (3x − 2)(x + 4). Choosing (3x + 2)(x − 4) expands to 3x² − 10x − 8 — the correct factor pair but the wrong signs, giving the middle term the wrong sign. Choosing (x − 2)(3x + 4) expands to 3x² − 2x − 8 — the 3 is attached to the wrong bracket, changing which terms combine for the x-coefficient. Choosing (3x − 4)(x + 2) expands to 3x² + 2x − 8 — this uses 4 and 2 instead of the correct pair 12 and 2, so the middle term does not come to 10x.
5. (c) 1 — cos 45° = √2/2 and sin 45° = √2/2. Squaring each gives (√2/2)² = 2/4 = 1/2, so (cos 45°)² + (sin 45°)² = 1/2 + 1/2 = 1. The distractor √2 comes from adding cos 45° + sin 45° directly without squaring first (√2/2 + √2/2 = √2). The distractor 2 comes from squaring the top of the fraction, (√2)² = 2, but then dividing by 2 instead of 4 for each term, giving 1 + 1 = 2. The distractor 1/2 comes from squaring only cos 45° and forgetting to add the sin 45° term.
6. (b) 0.83333... — Divide 5 by 6 using long division. 5.000... ÷ 6: 50 ÷ 6 = 8 remainder 2, giving the first decimal digit 8. Bring down a 0 to make 20, and 20 ÷ 6 = 3 remainder 2 — the remainder 2 has reappeared, so from here the digit 3 repeats forever. This gives 5/6 = 0.83333... . Stopping after two decimal places and writing 0.83 treats the division as if it terminated, when the remainder never reaches zero. Shifting the decimal point one place too far to the left gives 0.083333..., the same digits divided by an extra power of ten. A slip in the long division itself, misreading a remainder, can produce the wrong repeating digit, 0.85555... .
7. (a) 5√2 — Simplify each surd first: √8 = √4 × √2 = 2√2, and √18 = √9 × √2 = 3√2. Both terms are now multiples of √2, so they are like terms: 2√2 + 3√2 = 5√2. Adding the numbers under the two roots first, 8 + 18 = 26, and writing √26 treats unlike surds as if they combine under one root — they only combine once they share the same radicand, which is not how addition of surds works. Writing 9√2 for √18 instead of 3√2 (forgetting to root the 9) and then adding gives 2√2 + 9√2 = 11√2. Writing 4√2 for √8 instead of 2√2 (forgetting to root the 4) and adding gives 4√2 + 3√2 = 7√2.
8. (d) x = 2 or x = −5 — Method: find two numbers that multiply to give −10 and add to give 3 — these are 5 and −2. So x² + 3x − 10 = (x + 5)(x − 2) = 0, giving x = −5 or x = 2. Distractor origins: x = −2 or x = 5 swaps the signs of the two roots; x = 2 or x = 5 makes both roots positive, ignoring the sign of −10; x = −5 or x = −2 makes both roots negative.
9. (a) 2√3 — Multiply the top and bottom of the fraction by √3, since √3 × √3 = 3: 6/√3 = (6 × √3)/(√3 × √3) = 6√3/3. Dividing 6 by 3 gives 2, so the fraction simplifies to 2√3. Multiplying only the numerator by √3 and then cancelling the surd in the denominator against it as if they were the same term, without properly squaring the denominator, leads to 6. Dividing 6 by 3 as 3 instead of 2 gives 3√3 — a slip in the final division. Simplifying 6√3/3 by cancelling the whole numerator's 3 with the denominator's 3, including the surd, gives 2, which loses the surd altogether.
10. (a) x = 4 or x = −3 — Method: find two numbers that multiply to give −12 and add to give −1 — these are −4 and 3. So x² − x − 12 = (x − 4)(x + 3) = 0, giving x = 4 or x = −3. Distractor origins: x = −4 or x = 3 has the signs the wrong way round; x = 4 or x = 3 makes both roots positive, ignoring the sign of −12; x = 12 or x = −1 comes from reading off the coefficient and the constant directly instead of factorising.
11. (d) 8(7x − 3) — Method: find the highest common factor of the two terms, write it in front of a bracket and divide each term by it. Working: 56 = 8 × 7 and 24 = 8 × 3, so the highest common factor is 8; dividing gives 56x ÷ 8 = 7x and 24 ÷ 8 = 3, and the subtraction sign stays between them. Answer: 8(7x − 3), which multiplies back out to 56x − 24. The distractors: 8(7x + 3) comes from dropping the minus sign of −24 while dividing; 8(56x − 3) comes from dividing only the number term by 8 and leaving 56x untouched inside the bracket; 8(7x − 16) comes from subtracting 8 from 24 instead of dividing 24 by 8.
12. (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.
13. (d) x⁴ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided. Working: six factors of x on the top and two on the bottom cancel in pairs, leaving 6 − 2 = 4 factors of x. Answer: x⁴. The distractors: x³ comes from dividing the indices, 6 ÷ 2, instead of subtracting them; x⁸ comes from adding the indices, 6 + 2, as though the powers were being multiplied; x¹² comes from multiplying the indices, 6 × 2, as though a power were being raised to a power.
14. (a) 2√3/3 — tan 30° = √3/3, so tan 30° + tan 30° = 2 × √3/3 = 2√3/3. √3 comes from wrongly treating tan 30° + tan 30° as tan(30° + 30°) = tan 60° = √3 — adding angles is not the same as adding ratios. √3/3 comes from forgetting to double the value and just writing down tan 30° on its own. 2√3 comes from doubling the numerator of √3/3 but forgetting to keep the denominator of 3.
15. (c) x = 0 or x = −7 — Factorising: x² + 7x = x(x + 7) = 0, so x = 0 or x + 7 = 0, giving x = 0 or x = −7. A candidate who divides both sides of the original equation by x, which loses the solution x = 0, gets only x = −7. A candidate who makes a sign error solving x + 7 = 0 gets x = 0 or x = 7. A candidate who misreads the coefficient and doubles it gets x = 0 or x = −14.
16. (d) x² − 49 — Area = length × width = (x + 7)(x − 7). Expanding: x × x = x², x × (−7) = −7x, 7 × x = 7x, 7 × (−7) = −49. The two middle terms −7x and 7x cancel, leaving x² − 49. A candidate who misremembers the difference-of-two-squares result as a sum gets x² + 49. A candidate who makes a sign error and treats both middle terms as −7x instead of cancelling gets x² − 14x − 49. A candidate who confuses area with perimeter and simply adds the length and width gets 2x.
17. (c) 0.001 — Method: a negative index means 'one over' the positive power, so $10^{-3}$ means one over $10^{3}$. Working: ten cubed is 1000, and one over 1000 is 0.001. 1000 comes from ignoring the negative sign and working out ten cubed instead of its reciprocal. −1000 comes from ignoring what the negative index does to the size, while still writing a negative sign on the large value. −0.001 comes from correctly finding the size, 0.001, but wrongly keeping a negative sign because the index was negative. Answer: 0.001.
18. (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
19. (c) 25 — Method: read off a, b and c with their signs and substitute them into b² − 4ac. Working: for 2x² + 3x − 2 = 0, a = 2, b = 3 and c = −2, so b² − 4ac = 3² − 4 × 2 × (−2) = 9 − (−16) = 9 + 16 = 25. Answer: 25. The distractors: −7 comes from taking c as +2, which gives 9 − 16; 22 comes from working b² as 2 × 3 = 6 and then 6 + 16; 13 comes from leaving the 4 out of 4ac and working 9 − 2 × (−2).
20. (a) 0.625 — Method: convert the fraction to a decimal so it can be compared properly with 0.6. Working: 5/8 = 0.625, and since 0.625 > 0.6, the larger value is 0.625. Answer: 0.625. 0.6 repeats Sam's incorrect claim, made by comparing single digits rather than full place value. 0.58 comes from converting 5/8 incorrectly, treating it as if it read 5 tenths and 8 hundredths. 0.85 comes from turning the fraction upside down and writing its digits straight after the decimal point, 8 then 5, instead of dividing.