🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (d) 7/20 — Method: write the decimal over the power of ten that matches the number of digits after the point, then divide the numerator and the denominator by their highest common factor. Working: 0.35 has two digits after the point, so it is 35 hundredths and can be written as 35/100; the highest common factor of 35 and 100 is 5, and 35 ÷ 5 = 7 with 100 ÷ 5 = 20. Answer: 7/20. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 7/25 comes from dividing the numerator by 5 but the denominator by 4, using a different factor on the top and on the bottom; 35/10 comes from counting one decimal place instead of two and writing the digits over 10.
2. (d) x = 4 or x = −4 — Method: divide both sides by 2 to get x² = 16, then take the square root of both sides: x = 4 or x = −4. Distractor origins: x = 4 forgets the negative root; x = 8 comes from halving 16 instead of taking its square root; x = 16 stops at x² = 16 without ever taking the square root.
3. (c) 3/11 — Method: let a letter stand for the recurring decimal, multiply by the power of ten that shifts exactly one repeating block past the point, subtract the original equation so that the recurring tail cancels, then solve and cancel. Working: let x = 0.272727...; the repeating block is two digits long, so multiply by 100 to give 100x = 27.272727...; subtracting gives 99x = 27, so x = 27/99; the highest common factor of 27 and 99 is 9, and 27 ÷ 9 = 3 with 99 ÷ 9 = 11. Answer: 3/11. The distractors: 27/100 comes from writing the repeating block over 100 instead of over 99, forgetting that subtracting x leaves 99x rather than 100x; 3/10 comes from rounding the decimal to one place and converting 0.3; 2/9 comes from treating only the 2 as recurring and converting 0.222... instead.
4. (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
5. (b) x = 5 — Area = length × width, so x(x + 3) = 40, which rearranges to x² + 3x − 40 = 0. This factorises as (x + 8)(x − 5) = 0: the two numbers in the brackets must multiply to −40 and add to +3, and the pair 8 and −5 does both. This gives x = −8 or x = 5. Since x is a length, it cannot be negative, so x = 5. A candidate who gives both solutions without rejecting the negative one, which cannot be a length, answers x = 5 or x = −8. A candidate who picks the wrong factor pair of 40, such as 10 and −4 instead of 8 and −5, gets (x + 10)(x − 4) = 0 and answers x = 4. A candidate who rejects the wrong root, keeping the negative solution instead of the positive one, answers x = −8.
6. (b) 0.83333... — Divide 5 by 6 using long division. 5.000... ÷ 6: 50 ÷ 6 = 8 remainder 2, giving the first decimal digit 8. Bring down a 0 to make 20, and 20 ÷ 6 = 3 remainder 2 — the remainder 2 has reappeared, so from here the digit 3 repeats forever. This gives 5/6 = 0.83333... . Stopping after two decimal places and writing 0.83 treats the division as if it terminated, when the remainder never reaches zero. Shifting the decimal point one place too far to the left gives 0.083333..., the same digits divided by an extra power of ten. A slip in the long division itself, misreading a remainder, can produce the wrong repeating digit, 0.85555... .
7. (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.
8. (d) 9√3 cm — DE is opposite the 60° angle at F, and EF is adjacent to it, so DE = EF × tan 60° = 9 × √3 = 9√3 cm. 9√3/2 cm comes from using sin 60° = √3/2 instead of tan 60°. 3√3 cm comes from using tan 30° = 1/√3 instead of tan 60° (9 × 1/√3 = 9/√3 = 3√3). 18 cm is the hypotenuse DF, not DE: it comes from using cos 60° = 1/2 and working out 9 ÷ 1/2 = 18, which finds the wrong side of the triangle.
9. (a) x⁶ — Method: work through the powers in order — multiplying powers of the same base means adding indices, and dividing powers of the same base means subtracting indices. Working: first, x⁵ × x³ = x⁸ (adding 5 and 3); then x⁸ ÷ x² = x⁶ (subtracting 2 from 8). x⁴ comes from swapping the two rules — subtracting for the multiplication, 5 − 3 = 2, and then adding for the division, 2 + 2 = 4. x¹⁰ comes from adding all three indices, 5 + 3 + 2 = 10, treating the division the same as a multiplication. 6x comes from correctly reaching a total index of 6 but then writing it as a coefficient of x instead of as its power. Answer: x⁶.
10. (a) 13/40 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.325 = 325/1000 = 13/40 (dividing both numerator and denominator by 25). Answer: 13/40. 13/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 8/25 comes from rounding 0.325 down to 0.32 before converting. 3/8 comes from recalling the learned conversion 3/8 = 0.375 and matching it to 0.325 because both are three-place decimals beginning with 3, instead of converting the decimal given.
11. (d) 2⁷ — When multiplying powers of the same base, the indices add: 3 + 4 = 7, so 2³ × 2⁴ = 2⁷. Multiplying the indices instead of adding them gives 3 × 4 = 12, so 2¹². Subtracting the indices instead of adding them gives 4 − 3 = 1, so 2¹. Multiplying the bases together as well as adding the indices gives 2 × 2 = 4, so 4⁷.
12. (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
13. (c) 5/11 — Let x = 0.45 recurring, so x = 0.454545... . Since two digits repeat, multiply by 100: 100x = 45.454545... . Subtracting the original x removes the recurring part exactly, because it lines up digit for digit: 100x − x = 45.454545... − 0.454545... = 45, so 99x = 45, giving x = 45/99 = 5/11. Treating the decimal as if it terminated at two places gives 45/100 = 9/20, which is only 0.45 and drops the repeating part entirely. Subtracting 10x instead of x — using 100x − 10x = 90x = 45 — is the wrong power of ten for a two-digit repeating block, and gives x = 45/90 = 1/2. Making an arithmetic slip in the numerator, 45 − 1 = 44 instead of 45, gives 44/99 = 4/9.
14. (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.
15. (a) 1/2 — cos 0° = 1 and sin 30° = 1/2, so cos 0° − sin 30° = 1 − 1/2 = 1/2. 1 comes from writing down cos 0° alone and forgetting to subtract sin 30°. 3/2 comes from adding the two values instead of subtracting. −1/2 comes from working out sin 30° − cos 0°, the two terms the wrong way round.
16. (c) 3⁻³ — Method: when dividing powers of the same base, subtract the index of the number you are dividing by from the index of the number being divided, keeping them in the order the question writes them. Working: 2 − 5 = −3, so 3² ÷ 3⁵ = 3⁻³. It is worth checking this against the numbers: 3² = 9 and 3⁵ = 243, and 9 ÷ 243 = 1/27, which is 3⁻³. 3³ comes from subtracting the other way round, 5 − 2 = 3, which reverses the sign of the index and gives 27 instead of 1/27. 3⁷ comes from working out 2 + 5 = 7, which is the rule for multiplying powers, not dividing them. 3¹⁰ comes from multiplying the indices, 2 × 5 = 10, instead of subtracting them. Answer: 3⁻³.
17. (d) x² − 49 — Area = length × width = (x + 7)(x − 7). Expanding: x × x = x², x × (−7) = −7x, 7 × x = 7x, 7 × (−7) = −49. The two middle terms −7x and 7x cancel, leaving x² − 49. A candidate who misremembers the difference-of-two-squares result as a sum gets x² + 49. A candidate who makes a sign error and treats both middle terms as −7x instead of cancelling gets x² − 14x − 49. A candidate who confuses area with perimeter and simply adds the length and width gets 2x.
18. (a) 2/11 — Let x = 0.18 recurring, so x = 0.181818... . Since two digits repeat, multiply by 100: 100x = 18.181818... . Subtracting the original x removes the recurring part, because the digits line up exactly: 100x − x = 18.181818... − 0.181818... = 18, so 99x = 18, giving x = 18/99 = 2/11. Treating the decimal as if it terminated at two places gives 18/100 = 9/50, which is only 0.18 and drops the repeating part entirely. Subtracting 10x instead of x — using 100x − 10x = 90x = 18 — is the wrong power of ten for a two-digit repeating block, and gives x = 18/90 = 1/5. Making an arithmetic slip in the numerator, 18 − 1 = 17 instead of 18, gives 17/99.
19. (d) x⁽¹⁄²⁾ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided, and fractional indices are subtracted like any other fractions. Working: 3/4 − 1/4 = 2/4, which simplifies to 1/2, so the result is x⁽¹⁄²⁾. Answer: x⁽¹⁄²⁾. The distractors: x comes from adding the indices, 3/4 + 1/4 = 1, as though the powers were being multiplied; x³ comes from dividing the indices, so that 3/4 divided by 1/4 gives 3; x⁽³⁄¹⁶⁾ comes from multiplying the indices, 3/4 × 1/4.
20. (d) x = 2 or x = −5 — Method: find two numbers that multiply to give −10 and add to give 3 — these are 5 and −2. So x² + 3x − 10 = (x + 5)(x − 2) = 0, giving x = −5 or x = 2. Distractor origins: x = −2 or x = 5 swaps the signs of the two roots; x = 2 or x = 5 makes both roots positive, ignoring the sign of −10; x = −5 or x = −2 makes both roots negative.