🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (c) 3/11 — Method: let a letter stand for the recurring decimal, multiply by the power of ten that shifts exactly one repeating block past the point, subtract the original equation so that the recurring tail cancels, then solve and cancel. Working: let x = 0.272727...; the repeating block is two digits long, so multiply by 100 to give 100x = 27.272727...; subtracting gives 99x = 27, so x = 27/99; the highest common factor of 27 and 99 is 9, and 27 ÷ 9 = 3 with 99 ÷ 9 = 11. Answer: 3/11. The distractors: 27/100 comes from writing the repeating block over 100 instead of over 99, forgetting that subtracting x leaves 99x rather than 100x; 3/10 comes from rounding the decimal to one place and converting 0.3; 2/9 comes from treating only the 2 as recurring and converting 0.222... instead.
2. (c) 100√3 cm — The height is opposite the 60° angle, so height = 2 × sin 60° = 2 × √3/2 = √3 m. Converting to centimetres: √3 m = 100√3 cm. '√3 cm' forgets to convert the answer from metres to centimetres. '200√3 cm' comes from mis-recalling sin 60° as √3 instead of √3/2, dropping the denominator of the exact value: 2 × √3 = 2√3 m = 200√3 cm. '50√3 cm' comes from halving the ladder's length before multiplying by sin 60°, instead of using the full 2 m.
3. (b) 1/9 — Method: let x stand for the recurring decimal, multiply by the power of ten that moves exactly one repeating block past the decimal point, subtract the original equation so that the recurring tail cancels, and solve the equation that is left. Working: let x = 0.111...; the repeating block is one digit long, so multiply by 10 to give 10x = 1.111...; subtracting the first equation from the second gives 10x − x = 1.111... − 0.111..., that is 9x = 1; dividing both sides by 9 gives x = 1/9. Answer: 1/9. The distractors: 1/10 comes from dividing by the multiplier 10 at the last step instead of by the 9 that is left in front of x; 1/11 comes from recalling the elevenths family instead of the ninths, although 1/11 = 0.0909... has a two-digit repeating block rather than a one-digit one; 11/100 comes from stopping the decimal after two digits and converting 0.11 into hundredths.
4. (c) tan 45° — Method: replace each ratio by its exact value, then compare. Working: a right-angled triangle with a 45° angle is isosceles, so its opposite and adjacent sides are equal and the tangent of 45° is exactly 1. The others are cos 30° = √3/2, about 0.87; sin 45° = √2/2, about 0.71; and cos 60° = 1/2. Answer: tan 45°, the only one of the four that reaches 1. Reading √3/2 as though it were √3, about 1.73, makes cos 30° look the largest, but the division by 2 is part of the value. Ranking by the size of the angle also fails here, because the cosine of an angle falls as the angle grows.
5. (a) 3 m — Height = sloping length × sin 45° = 3√2 × √2/2 = (3 × 2)/2 = 3 m, since √2 × √2 = 2. 3√2 m comes from forgetting to multiply by sin 45° at all. 3√2/2 m comes from using sin 30° = 1/2 instead of sin 45° = √2/2. 6 m comes from using √2 instead of √2/2 for sin 45°, dropping the denominator of the exact value: 3√2 × √2 = 6.
6. (d) x = 0 or x = 6 — Method: factorise by taking out the common factor x: x(x − 6) = 0, so x = 0 or x − 6 = 0, giving x = 0 or x = 6. Distractor origins: x = 6 comes from dividing both sides by x, which loses the solution x = 0; x = 0 stops after finding only one factor; x = 3 comes from halving the coefficient of x instead of factorising.
7. (d) 16π cm² — Method: for a circle, area = π × radius². Working: area = π × 4² = π × 16 = 16π cm². Answer: 16π cm². The student squared the radius but left out the π, which is why 16 cm² is not the exact area. 4π cm² comes from multiplying by the radius once instead of squaring it: π × 4 = 4π. 8π cm² comes from using the circumference formula 2 × π × radius instead of the area formula: 2 × π × 4 = 8π. 64π cm² comes from using the diameter (8 cm) as the radius in the area formula: π × 8² = 64π.
8. (a) x = 4 or x = −3 — Method: find two numbers that multiply to give −12 and add to give −1 — these are −4 and 3. So x² − x − 12 = (x − 4)(x + 3) = 0, giving x = 4 or x = −3. Distractor origins: x = −4 or x = 3 has the signs the wrong way round; x = 4 or x = 3 makes both roots positive, ignoring the sign of −12; x = 12 or x = −1 comes from reading off the coefficient and the constant directly instead of factorising.
9. (c) 0.7, 0.72, 3/4 — Method: numbers written in different forms cannot be compared as they stand, so every fraction is turned into a decimal by dividing the numerator by the denominator, and the decimals are then compared place by place from the left. Working: 3/4 means 3 ÷ 4 = 0.75, so the three values to compare are 0.7, 0.75 and 0.72; written to two decimal places they are 0.70, 0.75 and 0.72, and the hundredths digits 0, 5 and 2 put 0.70 first, 0.72 next and 0.75 last; written again in the forms the question used, the order from smallest is 0.7, then 0.72, then 3/4. Answer: 0.7, 0.72, 3/4. The distractors: 3/4, 0.7, 0.72 comes from turning 3/4 into 0.34 by writing the numerator and the denominator as the two digits after the point, which makes the fraction the smallest of the three; 0.72, 3/4, 0.7 comes from the belief that the more digits a decimal has the smaller it must be, which puts both 0.72 and 0.75 below 0.7 and 0.72 below 0.75; 3/4, 0.72, 0.7 comes from comparing the three values correctly but listing them largest first, against an instruction to start with the smallest.
10. (b) 6x + 6 — Perimeter = 2[(2x + 5) + (x − 2)] = 2(3x + 3) = 6x + 6. A candidate who adds the length and width but forgets to double for the perimeter gets 3x + 3. A candidate who makes a sign error and adds 2 instead of subtracting it before doubling gets 2[(2x + 5) + (x + 2)] = 6x + 14. A candidate who multiplies the length and width instead of adding them, confusing the perimeter formula with the area formula, and then doubles that product, gets 2(2x + 5)(x − 2) = 4x² + 2x − 20.
11. (b) 9 — Method: a negative index means take the reciprocal of the base first and then apply the positive power. Working: the reciprocal of 1/3 is 3, so (1/3)⁻² = 3² = 3 × 3 = 9. Answer: 9. The distractors: 1/9 comes from ignoring the minus sign and squaring 1/3 as it stands; −9 comes from reading the negative index as a minus sign on the result; 6 comes from multiplying the denominator by the index, 3 × 2, instead of squaring the reciprocal.
12. (c) 5(x + y − 1) — Method: take out the highest common factor of all three terms and divide every term by it, the number term included. Working: the highest common factor of 5x, 5y and −5 is 5; dividing gives 5x ÷ 5 = x, 5y ÷ 5 = y and −5 ÷ 5 = −1, so the bracket holds x + y − 1. Answer: 5(x + y − 1), which multiplies back out to 5x + 5y − 5. The distractors: 5(x + y + 1) comes from dividing −5 by 5 and losing the minus sign; 5(x + y − 5) comes from dividing only the terms containing a letter by 5 and carrying the −5 into the bracket unchanged; 5(xy − 1) comes from collecting the unlike terms 5x and 5y as 5xy before factorising.
13. (c) x = 0 or x = 3 — Method: take out the common factor 5x: 5x(x − 3) = 0, so 5x = 0 or x − 3 = 0, giving x = 0 or x = 3. Distractor origins: x = 0 or x = 15 comes from forgetting to divide the second term by the common factor 5x correctly, leaving 15 instead of 3; x = 3 loses the solution x = 0 by dividing both sides by x; x = 5 or x = 3 mistakes the coefficient 5 itself for one of the solutions.
14. (b) 5 and −6 — Method: turn the sentence into an equation in one letter, collect every term on one side so it reads as a quadratic equal to zero, then factorise. Working: if the number is x then x² + x = 30, which rearranges to x² + x − 30 = 0; two numbers that multiply to −30 and add to 1 are 6 and −5, so (x + 6)(x − 5) = 0 and x = −6 or x = 5. Both values work: 5 + 25 = 30 and −6 + 36 = 30. Answer: 5 and −6. The distractors: 6 and −5 comes from reading the numbers inside the brackets as the solutions without changing their signs; 5 only comes from discarding the negative solution, although nothing in the question rules out a negative number; 5 and 6 comes from hunting for a factor pair of 30 instead of forming and solving the quadratic.
15. (b) 7 cm — The side opposite the 30° angle is found using sin 30° = opposite/hypotenuse, so opposite = 14 × sin 30° = 14 × 1/2 = 7 cm. 7√3 cm comes from using cos 30° = √3/2 instead of sin 30° (mixing up the opposite and adjacent sides). 14/√3 cm comes from using tan 30° = 1/√3 instead of sin 30°. 28 cm comes from dividing 14 by sin 30° instead of multiplying by it.
16. (b) (60 + 4.5π) cm² — Method: find the area of the rectangle and the area of the semicircle separately, then add them. Working: the rectangle has area 10 × 6 = 60 cm². The semicircle has radius 3 cm, so its area is half of π × 3² = half of 9π = 4.5π cm². Total area = (60 + 4.5π) cm². Answer: (60 + 4.5π) cm². (60 + 18π) cm² comes from using the diameter (6 cm) as the radius in the semicircle area formula: half of π × 6² = 18π. (60 + 9π) cm² comes from forgetting to halve the full circle's area: π × 3² = 9π. (60 + 3π) cm² comes from finding the semicircle's arc length instead of its area: half of 2 × π × 3 = 3π.
17. (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
18. (d) x = 4 or x = −4 — Method: divide both sides by 2 to get x² = 16, then take the square root of both sides: x = 4 or x = −4. Distractor origins: x = 4 forgets the negative root; x = 8 comes from halving 16 instead of taking its square root; x = 16 stops at x² = 16 without ever taking the square root.
19. (a) 0.625 — Method: convert the fraction to a decimal so it can be compared properly with 0.6. Working: 5/8 = 0.625, and since 0.625 > 0.6, the larger value is 0.625. Answer: 0.625. 0.6 repeats Sam's incorrect claim, made by comparing single digits rather than full place value. 0.58 comes from converting 5/8 incorrectly, treating it as if it read 5 tenths and 8 hundredths. 0.85 comes from turning the fraction upside down and writing its digits straight after the decimal point, 8 then 5, instead of dividing.
20. (a) 6 — Use √a × √b = √(ab): √3 × √12 = √(3 × 12) = √36 = 6. Adding the numbers under the roots instead of multiplying them, 3 + 12 = 15, gives √15 — that comes from applying the rule for adding surds to a multiplication question. Multiplying the two numbers under the roots but then forgetting to take the square root at the end leaves 36. Simplifying only √12 to 2√3 and then dropping the other √3 factor entirely gives 2√3.