🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (a) x¹¹ — Method: when multiplying powers of the same base, add the indices. Working: 7 + 4 = 11, so x⁷ × x⁴ = x¹¹. x²⁸ comes from multiplying the indices, 7 × 4 = 28, instead of adding them. x³ comes from working out 7 − 4 = 3, which is the rule for dividing powers, not multiplying them. 11x comes from adding the indices to make 11 but then treating x as a coefficient instead of a power. Answer: x¹¹.
2. (d) 7/20 — Method: write the decimal over the power of ten that matches the number of digits after the point, then divide the numerator and the denominator by their highest common factor. Working: 0.35 has two digits after the point, so it is 35 hundredths and can be written as 35/100; the highest common factor of 35 and 100 is 5, and 35 ÷ 5 = 7 with 100 ÷ 5 = 20. Answer: 7/20. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 7/25 comes from dividing the numerator by 5 but the denominator by 4, using a different factor on the top and on the bottom; 35/10 comes from counting one decimal place instead of two and writing the digits over 10.
3. (c) 5(x + y − 1) — Method: take out the highest common factor of all three terms and divide every term by it, the number term included. Working: the highest common factor of 5x, 5y and −5 is 5; dividing gives 5x ÷ 5 = x, 5y ÷ 5 = y and −5 ÷ 5 = −1, so the bracket holds x + y − 1. Answer: 5(x + y − 1), which multiplies back out to 5x + 5y − 5. The distractors: 5(x + y + 1) comes from dividing −5 by 5 and losing the minus sign; 5(x + y − 5) comes from dividing only the terms containing a letter by 5 and carrying the −5 into the bracket unchanged; 5(xy − 1) comes from collecting the unlike terms 5x and 5y as 5xy before factorising.
4. (a) 2√3/3 — tan 30° = √3/3, so tan 30° + tan 30° = 2 × √3/3 = 2√3/3. √3 comes from wrongly treating tan 30° + tan 30° as tan(30° + 30°) = tan 60° = √3 — adding angles is not the same as adding ratios. √3/3 comes from forgetting to double the value and just writing down tan 30° on its own. 2√3 comes from doubling the numerator of √3/3 but forgetting to keep the denominator of 3.
5. (b) 3/50 — Method: write the decimal over the power of ten that matches the number of digits after the point, counting every digit including a zero, then divide the numerator and the denominator by their highest common factor. Working: 0.06 has two digits after the point, so it is 6 hundredths and can be written as 6/100; the highest common factor of 6 and 100 is 2, and 6 ÷ 2 = 3 with 100 ÷ 2 = 50. Answer: 3/50. The distractors: 3/5 comes from ignoring the zero straight after the point and converting 0.6 instead, giving 6/10, which cancels to 3/5; 3/500 comes from counting three decimal places instead of two and writing 6/1000, which cancels to 3/500; 1/6 comes from putting 1 over the digits after the point, as though 0.06 meant one sixth.
6. (a) 25 — Method: squaring a square root removes the root, so a square root raised to the power 4 can be squared in two stages. Working: (√5)⁴ = ((√5)²)² = 5² = 5 × 5 = 25. Answer: 25. The distractors: 5 comes from squaring once and stopping, treating the fourth power as a square; 625 comes from raising 5 to the power 4 and ignoring the root sign altogether; 20 comes from multiplying 5 by the index 4 instead of raising 5 to that power.
7. (a) 2/11 — Let x = 0.18 recurring, so x = 0.181818... . Since two digits repeat, multiply by 100: 100x = 18.181818... . Subtracting the original x removes the recurring part, because the digits line up exactly: 100x − x = 18.181818... − 0.181818... = 18, so 99x = 18, giving x = 18/99 = 2/11. Treating the decimal as if it terminated at two places gives 18/100 = 9/50, which is only 0.18 and drops the repeating part entirely. Subtracting 10x instead of x — using 100x − 10x = 90x = 18 — is the wrong power of ten for a two-digit repeating block, and gives x = 18/90 = 1/5. Making an arithmetic slip in the numerator, 18 − 1 = 17 instead of 18, gives 17/99.
8. (d) x = 2 or x = −5 — Method: find two numbers that multiply to give −10 and add to give 3 — these are 5 and −2. So x² + 3x − 10 = (x + 5)(x − 2) = 0, giving x = −5 or x = 2. Distractor origins: x = −2 or x = 5 swaps the signs of the two roots; x = 2 or x = 5 makes both roots positive, ignoring the sign of −10; x = −5 or x = −2 makes both roots negative.
9. (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
10. (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
11. (d) (x − 8)(x + 8) — x² − 64 = x² − 8², a difference of two squares, which factorises as (x − 8)(x + 8). A candidate who treats it as a perfect square with a repeated negative factor gets (x − 8)(x − 8), which expands to x² − 16x + 64 — wrong on both the middle and constant terms. A candidate who uses a repeated positive factor gets (x + 8)(x + 8), which expands to x² + 16x + 64. A candidate who picks a different factor pair of 64, such as 4 and 16, without checking that the middle term cancels, gets (x − 4)(x + 16), which expands to x² + 12x − 64 — the wrong middle term.
12. (d) x = 3 or x = −3 — Method: get x² on its own with a coefficient of 1, then take the square root of both sides and keep both the positive and the negative root. Working: dividing 2x² = 18 by 2 gives x² = 9, and the square root of 9 is 3, so x = 3 or x = −3; both check, because 2 × 9 = 18 either way. Answer: x = 3 or x = −3. The distractors: x = 9 or x = −9 comes from dividing by 2 and then forgetting to take the square root; x = 4 or x = −4 comes from subtracting 2 from 18 instead of dividing by it, giving x² = 16; x = 6 or x = −6 comes from multiplying by 2 instead of dividing, giving x² = 36.
13. (d) 8(7x − 3) — Method: find the highest common factor of the two terms, write it in front of a bracket and divide each term by it. Working: 56 = 8 × 7 and 24 = 8 × 3, so the highest common factor is 8; dividing gives 56x ÷ 8 = 7x and 24 ÷ 8 = 3, and the subtraction sign stays between them. Answer: 8(7x − 3), which multiplies back out to 56x − 24. The distractors: 8(7x + 3) comes from dropping the minus sign of −24 while dividing; 8(56x − 3) comes from dividing only the number term by 8 and leaving 56x untouched inside the bracket; 8(7x − 16) comes from subtracting 8 from 24 instead of dividing 24 by 8.
14. (c) It has two different real solutions — Method: the discriminant is the quantity under the square root sign in the quadratic formula, so its sign decides how many real values the formula produces. Working: when the discriminant is positive its square root is a real number that is not zero, and the formula adds that root and subtracts it in turn, so the two results are different; a positive discriminant that is not a perfect square still gives two solutions, but they are not whole numbers. Answer: it has two different real solutions. The distractors: one repeated real solution is what a discriminant of zero gives, because adding and subtracting zero changes nothing; no real solutions is what a negative discriminant gives, because a negative number has no real square root; two whole-number solutions happens only when the discriminant is a perfect square and the division works out exactly, which a positive discriminant does not guarantee.
15. (a) x = 10 or x = −10 — Rearranging, x² = 100. Taking the square root of both sides gives x = ±10, i.e. x = 10 or x = −10. A candidate who forgets the negative root gives only x = 10. A candidate who halves 100 instead of taking its square root gets x = 50. A candidate who applies the ± sign to 100 itself instead of to its square root gets x = 100 or x = −100.
16. (c) 100√3 cm — The height is opposite the 60° angle, so height = 2 × sin 60° = 2 × √3/2 = √3 m. Converting to centimetres: √3 m = 100√3 cm. '√3 cm' forgets to convert the answer from metres to centimetres. '200√3 cm' comes from mis-recalling sin 60° as √3 instead of √3/2, dropping the denominator of the exact value: 2 × √3 = 2√3 m = 200√3 cm. '50√3 cm' comes from halving the ladder's length before multiplying by sin 60°, instead of using the full 2 m.
17. (c) 3/11 — Method: let a letter stand for the recurring decimal, multiply by the power of ten that shifts exactly one repeating block past the point, subtract the original equation so that the recurring tail cancels, then solve and cancel. Working: let x = 0.272727...; the repeating block is two digits long, so multiply by 100 to give 100x = 27.272727...; subtracting gives 99x = 27, so x = 27/99; the highest common factor of 27 and 99 is 9, and 27 ÷ 9 = 3 with 99 ÷ 9 = 11. Answer: 3/11. The distractors: 27/100 comes from writing the repeating block over 100 instead of over 99, forgetting that subtracting x leaves 99x rather than 100x; 3/10 comes from rounding the decimal to one place and converting 0.3; 2/9 comes from treating only the 2 as recurring and converting 0.222... instead.
18. (b) 1/9 — Method: let x stand for the recurring decimal, multiply by the power of ten that moves exactly one repeating block past the decimal point, subtract the original equation so that the recurring tail cancels, and solve the equation that is left. Working: let x = 0.111...; the repeating block is one digit long, so multiply by 10 to give 10x = 1.111...; subtracting the first equation from the second gives 10x − x = 1.111... − 0.111..., that is 9x = 1; dividing both sides by 9 gives x = 1/9. Answer: 1/9. The distractors: 1/10 comes from dividing by the multiplier 10 at the last step instead of by the 9 that is left in front of x; 1/11 comes from recalling the elevenths family instead of the ninths, although 1/11 = 0.0909... has a two-digit repeating block rather than a one-digit one; 11/100 comes from stopping the decimal after two digits and converting 0.11 into hundredths.
19. (b) 5/27 — Method: multiply the numerators together and the denominators together, then simplify. Working: (5 × 2)/(6 × 9) = 10/54 = 5/27. Answer: 5/27. 7/15 comes from adding the fractions instead of multiplying: (5+2)/(6+9) = 7/15. 15/4 comes from flipping the second fraction, as if dividing: (5 × 9)/(6 × 2) = 45/12 = 15/4. 5/3 comes from cancelling the two denominators against each other, dividing both 6 and 9 by 3 to leave 5/2 × 2/3 = 10/6 = 5/3; cancelling is only valid between a numerator and a denominator, never between two denominators.
20. (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.