🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (b) 0.58333... — Divide 7 by 12 using long division. 70 ÷ 12 = 5 remainder 10, so the first decimal digit is 5. Bring down a 0 to make 100: 100 ÷ 12 = 8 remainder 4, so the second digit is 8. Bring down a 0 to make 40: 40 ÷ 12 = 3 remainder 4, so the third digit is 3. Bring down a 0 to make 40 again — the remainder 4 has reappeared, so the digit 3 repeats forever from here. This gives 7/12 = 0.58333... . Stopping the division after two digits and writing 0.58 treats it as if it terminated, when the remainder is not yet zero. Misreading the pattern as a two-digit repeating block, '58', gives 0.585858..., which wrongly makes the 5 recur as well as the 3. A slip in the long division that carries the wrong remainder forward can make the second digit itself appear to repeat instead of the third, giving 0.588888... .
2. (b) (x − 5)(x + 2) — We need two numbers that multiply to −10 and add to −3: these are −5 and 2, since −5 × 2 = −10 and −5 + 2 = −3. So x² − 3x − 10 = (x − 5)(x + 2). A candidate who swaps the signs, using +5 and −2, gets (x + 5)(x − 2), which expands to x² + 3x − 10 — the wrong middle term. A candidate who picks the factor pair 1 and 10 instead of 2 and 5 gets (x − 10)(x + 1), which expands to x² − 9x − 10. A candidate who makes both factors negative gets (x − 5)(x − 2), which expands to x² − 7x + 10 — the wrong sign on the constant term.
3. (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.
4. (d) 1/16 — Method: a negative index means the reciprocal of the power, so 2⁻⁴ is 1 divided by 2⁴. Working: 2⁴ = 2 × 2 × 2 × 2 = 16, so the value is 1/16. Answer: 1/16. The distractors: −16 comes from reading the negative index as a minus sign on the result; 16 comes from ignoring the minus sign and working out 2⁴; 1/8 comes from multiplying the base by the index, 2 × 4, and writing 1 over that product.
5. (c) 0.001 — Method: a negative index means 'one over' the positive power, so $10^{-3}$ means one over $10^{3}$. Working: ten cubed is 1000, and one over 1000 is 0.001. 1000 comes from ignoring the negative sign and working out ten cubed instead of its reciprocal. −1000 comes from ignoring what the negative index does to the size, while still writing a negative sign on the large value. −0.001 comes from correctly finding the size, 0.001, but wrongly keeping a negative sign because the index was negative. Answer: 0.001.
6. (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
7. (c) x = 3 or x = 1/2 — Method: factorise into two brackets whose x terms multiply to 2x² and whose numbers multiply to 3, checking that they produce the middle term −7x, then set each bracket equal to zero. Working: (2x − 1)(x − 3) expands to 2x² − 6x − x + 3 = 2x² − 7x + 3, so (2x − 1)(x − 3) = 0; then 2x − 1 = 0 gives x = 1/2 and x − 3 = 0 gives x = 3. Answer: x = 3 or x = 1/2. The distractors: x = 3/2 or x = 1 comes from factorising as (2x − 3)(x − 1), whose middle term is −5x and not −7x; x = −3 or x = −1/2 comes from reading the roots straight out of (2x − 1)(x − 3) without changing the signs; x = 6 or x = 1 comes from using the quadratic formula with the denominator written as a instead of 2a, dividing 7 ± 5 by 2.
8. (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
9. (b) 8π cm² — A diameter of 8 cm gives a radius of 4 cm. The area of a full circle would be π × r² = π × 4² = 16π cm², and a semicircle is exactly half of this, giving 16π ÷ 2 = 8π cm². Forgetting to halve the area for the semicircle gives 16π cm², the area of the whole circle. Halving the diameter twice, using a radius of 2 instead of 4, gives π × 2² = 4π cm². Using the diameter itself as the radius, so π × 8² = 64π, and then halving that for the semicircle gives 32π cm².
10. (c) x = 0 or x = −7 — Factorising: x² + 7x = x(x + 7) = 0, so x = 0 or x + 7 = 0, giving x = 0 or x = −7. A candidate who divides both sides of the original equation by x, which loses the solution x = 0, gets only x = −7. A candidate who makes a sign error solving x + 7 = 0 gets x = 0 or x = 7. A candidate who misreads the coefficient and doubles it gets x = 0 or x = −14.
11. (d) 6 m — The horizontal distance is adjacent to the 60° angle and the zip-wire is the hypotenuse, so horizontal distance = 12 × cos 60° = 12 × 1/2 = 6 m. 6√3 m comes from using sin 60° = √3/2 instead of cos 60°, which would give the vertical drop, not the horizontal distance. 4√3 m comes from treating 12 as the side adjacent to a tangent ratio and dividing by tan 60° = √3. 24 m comes from dividing 12 by cos 60° instead of multiplying by it.
12. (a) x = 10 or x = −10 — Rearranging, x² = 100. Taking the square root of both sides gives x = ±10, i.e. x = 10 or x = −10. A candidate who forgets the negative root gives only x = 10. A candidate who halves 100 instead of taking its square root gets x = 50. A candidate who applies the ± sign to 100 itself instead of to its square root gets x = 100 or x = −100.
13. (d) 26 — Method: expand both brackets, treating the second as multiplication by −2 so that both of its terms change sign, then collect like terms. Working: 2(a + 6) = 2a + 12 and −2(a − 7) = −2a + 14, so the expression becomes 2a + 12 − 2a + 14; the a terms give 2a − 2a = 0, so no term in a survives, and the numbers give 12 + 14 = 26. Answer: 26. The distractors: −2 comes from expanding the second bracket as −2a − 14, so that the numbers give 12 − 14; 4a − 2 comes from adding 2(a − 7) instead of subtracting it, giving 2a + 12 + 2a − 14; 13 comes from multiplying the 2 over only the first term of each bracket, giving 2a + 6 − 2a + 7.
14. (a) 0.1666... — Method: a fraction bar means divide, so the decimal is found by dividing the numerator by the denominator; when a remainder comes back unchanged the division never ends, the digit it produces repeats for ever, and the exact value has to be written with that recurring digit rather than a rounded one. Working: 1 ÷ 6 is set out as 1.000 ÷ 6; six does not go into 1, and six goes into 10 tenths once with 4 left over, so the first decimal digit is 1; the 4 left over makes 40 hundredths, and six goes into 40 six times with 4 left over again; that same remainder of 4 returns at every step, so the digit 6 repeats without end. Answer: 0.1666... The distractors: 0.16 comes from carrying the division out to two decimal places and stopping there, as though the decimal terminated; 0.17 comes from rounding the division to two decimal places, which gives a value close to one sixth but not equal to it; 0.6 comes from writing the digit of the denominator straight after the decimal point, as though 1/6 meant six tenths.
15. (d) a/2 — Method: write both terms over the same denominator, subtract the numerators, then cancel the fraction down. Working: 6 is a multiple of 3, so a/3 is rewritten as 2a/6; the calculation becomes 5a/6 − 2a/6 = 3a/6, and dividing numerator and denominator by 3 gives a/2. Answer: a/2. The distractors: 4a/3 comes from subtracting the denominators as well as the numerators, giving (5 − 1)a over (6 − 3); 2a/3 comes from subtracting 1 from 5 without first rewriting a/3 as 2a/6, giving 4a/6; 7a/6 comes from adding the two fractions instead of subtracting them, giving 5a/6 + 2a/6.
16. (a) 1/2 — To find a fraction of an amount, multiply the fractions together: 3/5 × 5/6 = 15/30, which simplifies to 1/2 litre. Adding the fractions instead of multiplying them, using a common denominator of 30, gives 18/30 + 25/30 = 43/30, a value greater than the whole bottle. Dividing by 5/6 instead of multiplying by it, using its reciprocal 6/5, gives 3/5 × 6/5 = 18/25. Multiplying 5/6 by itself instead of by 3/5 gives 25/36.
17. (a) 2/11 — Let x = 0.18 recurring, so x = 0.181818... . Since two digits repeat, multiply by 100: 100x = 18.181818... . Subtracting the original x removes the recurring part, because the digits line up exactly: 100x − x = 18.181818... − 0.181818... = 18, so 99x = 18, giving x = 18/99 = 2/11. Treating the decimal as if it terminated at two places gives 18/100 = 9/50, which is only 0.18 and drops the repeating part entirely. Subtracting 10x instead of x — using 100x − 10x = 90x = 18 — is the wrong power of ten for a two-digit repeating block, and gives x = 18/90 = 1/5. Making an arithmetic slip in the numerator, 18 − 1 = 17 instead of 18, gives 17/99.
18. (b) 5/27 — Method: multiply the numerators together and the denominators together, then simplify. Working: (5 × 2)/(6 × 9) = 10/54 = 5/27. Answer: 5/27. 7/15 comes from adding the fractions instead of multiplying: (5+2)/(6+9) = 7/15. 15/4 comes from flipping the second fraction, as if dividing: (5 × 9)/(6 × 2) = 45/12 = 15/4. 5/3 comes from cancelling the two denominators against each other, dividing both 6 and 9 by 3 to leave 5/2 × 2/3 = 10/6 = 5/3; cancelling is only valid between a numerator and a denominator, never between two denominators.
19. (c) cos 45° — cos 45° = √2/2, and √2 cannot be written as an exact fraction, so this value is irrational. tan 0° = 0, sin 90° = 1 and sin 30° = 1/2 are all rational, since each can be written as an exact whole number or fraction.
20. (b) 9 — Method: a negative index means take the reciprocal of the base first and then apply the positive power. Working: the reciprocal of 1/3 is 3, so (1/3)⁻² = 3² = 3 × 3 = 9. Answer: 9. The distractors: 1/9 comes from ignoring the minus sign and squaring 1/3 as it stands; −9 comes from reading the negative index as a minus sign on the result; 6 comes from multiplying the denominator by the index, 3 × 2, instead of squaring the reciprocal.