🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (c) 3⁻³ — Method: when dividing powers of the same base, subtract the index of the number you are dividing by from the index of the number being divided, keeping them in the order the question writes them. Working: 2 − 5 = −3, so 3² ÷ 3⁵ = 3⁻³. It is worth checking this against the numbers: 3² = 9 and 3⁵ = 243, and 9 ÷ 243 = 1/27, which is 3⁻³. 3³ comes from subtracting the other way round, 5 − 2 = 3, which reverses the sign of the index and gives 27 instead of 1/27. 3⁷ comes from working out 2 + 5 = 7, which is the rule for multiplying powers, not dividing them. 3¹⁰ comes from multiplying the indices, 2 × 5 = 10, instead of subtracting them. Answer: 3⁻³.
2. (a) 6 — Use √a × √b = √(ab): √3 × √12 = √(3 × 12) = √36 = 6. Adding the numbers under the roots instead of multiplying them, 3 + 12 = 15, gives √15 — that comes from applying the rule for adding surds to a multiplication question. Multiplying the two numbers under the roots but then forgetting to take the square root at the end leaves 36. Simplifying only √12 to 2√3 and then dropping the other √3 factor entirely gives 2√3.
3. (d) x⁴ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided. Working: six factors of x on the top and two on the bottom cancel in pairs, leaving 6 − 2 = 4 factors of x. Answer: x⁴. The distractors: x³ comes from dividing the indices, 6 ÷ 2, instead of subtracting them; x⁸ comes from adding the indices, 6 + 2, as though the powers were being multiplied; x¹² comes from multiplying the indices, 6 × 2, as though a power were being raised to a power.
4. (d) 72a⁷ — Method: a power outside brackets applies to every factor inside them, and multiplying two powers of the same letter adds their indices. Working: (3a²)² = 3² × a⁴ = 9a⁴, and (2a)³ = 2³ × a³ = 8a³. Multiplying the two results gives 9 × 8 = 72 for the number and 4 + 3 = 7 for the index of a. Answer: 72a⁷. The distractors: 36a⁷ comes from squaring the 2 in (2a)³ instead of cubing it, giving 4a³ and then 9 × 4; 72a¹² comes from multiplying the indices 4 and 3 when the two terms are multiplied, instead of adding them; 17a⁷ comes from adding the coefficients 9 and 8 rather than multiplying them.
5. (c) tan 45° — Method: replace each ratio by its exact value, then compare. Working: a right-angled triangle with a 45° angle is isosceles, so its opposite and adjacent sides are equal and the tangent of 45° is exactly 1. The others are cos 30° = √3/2, about 0.87; sin 45° = √2/2, about 0.71; and cos 60° = 1/2. Answer: tan 45°, the only one of the four that reaches 1. Reading √3/2 as though it were √3, about 1.73, makes cos 30° look the largest, but the division by 2 is part of the value. Ranking by the size of the angle also fails here, because the cosine of an angle falls as the angle grows.
6. (c) 9/5 — Method: the area of a rectangle is its length multiplied by its width; the decimal product is then written over a power of ten and cancelled. Working: 24 × 75 = 1800, and 2.4 and 0.75 have three decimal places between them, so 2.4 × 0.75 = 1.8; the area of the panel is 1.8 square metres, which is eighteen tenths, so it can be written as 18/10, and dividing the numerator and the denominator by 2 gives 9 over 5. Answer: 9/5. The distractors: 4/5 comes from converting only the digits after the decimal point and losing the whole one, turning 1.8 into eight tenths; 63/20 comes from adding the two sides instead of multiplying them, giving 3.15; 9/50 comes from misplacing the decimal point in the product and writing 0.18, which cancels to 9 over 50.
7. (b) (x − 3)/(x + 2) — Factorise both: x² − 9 = (x − 3)(x + 3) (difference of two squares), and x² + 5x + 6 = (x + 2)(x + 3) (two numbers multiplying to 6 and adding to 5, namely 2 and 3). The factor (x + 3) is common to both, so it cancels, leaving (x − 3)/(x + 2). Choosing −9/(5x + 6) comes from cancelling the x² terms directly without factorising first — x² is not a common factor of the whole numerator or denominator. Choosing (x + 3)/(x + 2) cancels the (x − 3) factor instead of the shared (x + 3) factor, and (x − 3) does not appear in the denominator to cancel with. Choosing x − 3 cancels the whole denominator (x + 2) as though it were equal to 1.
8. (b) k = 9 — Method: complete the square, because a squared bracket is equal to zero for exactly one value of x. Working: x² − 6x = (x − 3)² − 9, so the equation becomes (x − 3)² − 9 + k = 0, that is (x − 3)² = 9 − k; there is exactly one solution when 9 − k = 0, so k = 9 and the equation reads x² − 6x + 9 = 0 with the repeated solution x = 3. Answer: k = 9. The distractors: k = 3 comes from halving the 6 and not squaring the result; k = 36 comes from squaring the whole of 6 instead of half of it; k = −9 comes from solving 9 − k = 0 with the sign of k the wrong way round.
9. (d) x² − 49 — Area = length × width = (x + 7)(x − 7). Expanding: x × x = x², x × (−7) = −7x, 7 × x = 7x, 7 × (−7) = −49. The two middle terms −7x and 7x cancel, leaving x² − 49. A candidate who misremembers the difference-of-two-squares result as a sum gets x² + 49. A candidate who makes a sign error and treats both middle terms as −7x instead of cancelling gets x² − 14x − 49. A candidate who confuses area with perimeter and simply adds the length and width gets 2x.
10. (c) 5/8 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.625 = 625/1000 = 5/8 (dividing both numerator and denominator by 125). Answer: 5/8. 25/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 31/50 comes from rounding 0.625 to 0.62 before converting. 8/5 comes from simplifying correctly to 5/8 and then writing the fraction upside down.
11. (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
12. (d) 6 + 2√3 — Multiply √3 by each term in the bracket separately. First term: √3 × 2 = 2√3. Second term: √3 × √12 = √(3 × 12) = √36 = 6. Adding the two results in the order they were found, and writing the whole-number term first, gives 6 + 2√3. Adding the numbers under the root for the second term instead of multiplying them (3 + 12 = 15) gives √15 in place of 6, leading to √15 + 2√3. Multiplying √3 by the 2 but never distributing to the √12 term at all leaves just 2√3. Treating √3 × 2 as if the 3 were multiplied by the 2 inside the root, √3 × 2 → √6, while still getting the second term correct, gives 6 + √6.
13. (d) 1/4 — Method: deal with the fractional index first, then the negative sign. Working: $8^{2/3} = (\sqrt[3]{8})^2 = 2^2 = 4$. A negative index means take the reciprocal of that result, so $8^{-2/3} = \frac{1}{8^{2/3}} = \frac{1}{4}$. Answer: 1/4. A candidate who evaluates $8^{2/3}$ correctly but forgets the negative sign entirely gets 4 — they have dropped the instruction to take a reciprocal. A candidate who takes the reciprocal step but applies it as a sign change to the finished number instead of inverting it gets −4. A candidate who multiplies 8 by −2/3, treating the index as an ordinary factor rather than a power, gets −16/3.
14. (d) 1/16 — Method: a negative index means the reciprocal of the power, so 2⁻⁴ is 1 divided by 2⁴. Working: 2⁴ = 2 × 2 × 2 × 2 = 16, so the value is 1/16. Answer: 1/16. The distractors: −16 comes from reading the negative index as a minus sign on the result; 16 comes from ignoring the minus sign and working out 2⁴; 1/8 comes from multiplying the base by the index, 2 × 4, and writing 1 over that product.
15. (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
16. (d) (x − 8)(x + 8) — x² − 64 = x² − 8², a difference of two squares, which factorises as (x − 8)(x + 8). A candidate who treats it as a perfect square with a repeated negative factor gets (x − 8)(x − 8), which expands to x² − 16x + 64 — wrong on both the middle and constant terms. A candidate who uses a repeated positive factor gets (x + 8)(x + 8), which expands to x² + 16x + 64. A candidate who picks a different factor pair of 64, such as 4 and 16, without checking that the middle term cancels, gets (x − 4)(x + 16), which expands to x² + 12x − 64 — the wrong middle term.
17. (d) x² − 6x + 9 — Method: squaring a bracket means multiplying that bracket by itself, so expand (x − 3)(x − 3) term by term and then collect like terms. Working: x × x = x², x × (−3) = −3x, (−3) × x = −3x and (−3) × (−3) = 9, giving x² − 3x − 3x + 9, and the two middle terms collect to −6x. Answer: x² − 6x + 9. The distractors: x² − 3x + 9 comes from writing down only one of the two middle products instead of both; x² + 6x + 9 comes from treating (−3) × x as +3x, so the middle terms are added rather than subtracted; x² − 9 comes from treating the square as the difference of two squares (x − 3)(x + 3).
18. (d) x = 0 or x = 6 — Method: factorise by taking out the common factor x: x(x − 6) = 0, so x = 0 or x − 6 = 0, giving x = 0 or x = 6. Distractor origins: x = 6 comes from dividing both sides by x, which loses the solution x = 0; x = 0 stops after finding only one factor; x = 3 comes from halving the coefficient of x instead of factorising.
19. (c) x = 0 or x = 3 — Method: take out the common factor 5x: 5x(x − 3) = 0, so 5x = 0 or x − 3 = 0, giving x = 0 or x = 3. Distractor origins: x = 0 or x = 15 comes from forgetting to divide the second term by the common factor 5x correctly, leaving 15 instead of 3; x = 3 loses the solution x = 0 by dividing both sides by x; x = 5 or x = 3 mistakes the coefficient 5 itself for one of the solutions.
20. (c) 1/2 — sin 45° = √2/2 and cos 45° = √2/2, so sin 45° × cos 45° = √2/2 × √2/2 = 2/4 = 1/2. √2/2 comes from writing down only one of the two factors and forgetting to multiply by the other. √2 comes from adding the two exact values instead of multiplying them: √2/2 + √2/2 = √2. 1 comes from wrongly treating sin 45° × cos 45° as sin(45° + 45°) = sin 90° = 1 — multiplying two ratios is not the same as adding their angles.