🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (a) t = 0 or t = 4 — The ball is at ground level exactly when h = 0. From the table, h = 0 at t = 0 and at t = 4, so those are the two times. Distractor origins: t = 1 or t = 3 picks the times with equal (but non-zero) height instead of ground level; t = 2 picks the time of maximum height instead of ground level; t = 0 finds only the starting time and misses the second one.
2. (b) 9/25 — Method: write the decimal over the matching power of ten, then divide the numerator and the denominator by their highest common factor. Working: 0.36 has two digits after the point, so 0.36 = 36/100; the highest common factor of 36 and 100 is 4, and 36 ÷ 4 = 9 with 100 ÷ 4 = 25; since 9 and 25 share no factor greater than 1, the fraction is fully cancelled. Answer: 9/25. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 9/50 comes from dividing the numerator by 4 but the denominator by only 2; 36/10 comes from counting one decimal place instead of two and writing the digits over 10.
3. (c) 1/4 — A negative index means the reciprocal of the positive power, so 2⁻² = 1 ÷ 2² = 1/4. Treating the negative sign as making the answer negative instead gives −(2²) = −4. Ignoring the negative sign altogether gives just 2² = 4. Finding the reciprocal correctly but then also applying a negative sign gives −1/4.
4. (d) 1/4 — Method: deal with the fractional index first, then the negative sign. Working: $8^{2/3} = (\sqrt[3]{8})^2 = 2^2 = 4$. A negative index means take the reciprocal of that result, so $8^{-2/3} = \frac{1}{8^{2/3}} = \frac{1}{4}$. Answer: 1/4. A candidate who evaluates $8^{2/3}$ correctly but forgets the negative sign entirely gets 4 — they have dropped the instruction to take a reciprocal. A candidate who takes the reciprocal step but applies it as a sign change to the finished number instead of inverting it gets −4. A candidate who multiplies 8 by −2/3, treating the index as an ordinary factor rather than a power, gets −16/3.
5. (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
6. (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
7. (d) 27/80 — Method: write the total as a fraction of a litre, then divide by the number of glasses. Working: 1.35 = 27/20, so each glass holds 27/20 ÷ 4 = 27/80 of a litre. Answer: 27/80. 27/20 comes from converting the total correctly to a fraction but forgetting to divide by the number of glasses. 27/5 comes from multiplying the total by 4 instead of dividing. 17/50 comes from rounding 1.35 ÷ 4 to 0.34 before converting to a fraction.
8. (c) x = 0 or x = 3 — Method: take out the common factor 5x: 5x(x − 3) = 0, so 5x = 0 or x − 3 = 0, giving x = 0 or x = 3. Distractor origins: x = 0 or x = 15 comes from forgetting to divide the second term by the common factor 5x correctly, leaving 15 instead of 3; x = 3 loses the solution x = 0 by dividing both sides by x; x = 5 or x = 3 mistakes the coefficient 5 itself for one of the solutions.
9. (a) 10 — √49 = 7 and ∛27 = 3, so √49 + ∛27 = 7 + 3 = 10. Treating the cube root as dividing by 3 instead of finding the cube root gives 27 ÷ 3 = 9, then 7 + 9 = 16. Multiplying the two roots instead of adding them gives 7 × 3 = 21. Ignoring the cube root symbol and using 27 as it stands gives 7 + 27 = 34.
10. (d) 3√5 — Split 45 into a perfect square times a factor: 45 = 9 × 5. Take the square root of each part separately: √45 = √9 × √5 = 3√5, since √9 = 3. Writing the perfect-square factor itself (9) as the coefficient instead of its root would give 9√5 — that trap comes from forgetting the last step, rooting 9. Multiplying 3 and 5 together instead of keeping them as coefficient and radicand gives 15, which throws away the surd entirely. Doubling the correct coefficient by mistake gives 6√5.
11. (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
12. (a) k = 3 — Method: a solution of an equation makes both sides balance, so substitute it in and solve the equation in k that is left. Working: putting x = 3 gives 3² − (k + 1) × 3 + k = 0, that is 9 − 3k − 3 + k = 0, so 6 − 2k = 0 and k = 3; the equation is then x² − 4x + 3 = 0, whose solutions are 3 and 1. Answer: k = 3. The distractors: k = −3 comes from solving 6 − 2k = 0 as though it gave 2k = −6; k = 4 comes from expanding −3(k + 1) as −3k − 1, multiplying only the k by 3; k = 1.5 comes from working 3² as 3 × 2 = 6, which leaves 3 − 2k = 0.
13. (a) x = 4 ± √13 — Method: halve the coefficient of x to form the bracket, subtract the square of that number to keep the expression equal to the original, then rearrange and take the square root of both sides. Working: half of −8 is −4, so x² − 8x + 3 = (x − 4)² − 16 + 3 = (x − 4)² − 13; setting this equal to zero gives (x − 4)² = 13, so x − 4 = ±√13 and x = 4 ± √13. Answer: x = 4 ± √13. The distractors: x = 8 ± √13 comes from putting the whole coefficient 8 inside the bracket instead of half of it; x = 4 ± √19 comes from adding 16 and 3 rather than subtracting 3 from 16; x = −4 ± √13 comes from writing the bracket as (x + 4)², which reverses the sign of the number that comes out of it.
14. (a) 13/40 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.325 = 325/1000 = 13/40 (dividing both numerator and denominator by 25). Answer: 13/40. 13/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 8/25 comes from rounding 0.325 down to 0.32 before converting. 3/8 comes from recalling the learned conversion 3/8 = 0.375 and matching it to 0.325 because both are three-place decimals beginning with 3, instead of converting the decimal given.
15. (b) (2x + 1)/(x − 3) — Factorise both the numerator and the denominator before you cancel anything. The numerator 2x² + 7x + 3 factorises to (2x + 1)(x + 3), and the denominator x² − 9 is a difference of two squares, factorising to (x − 3)(x + 3). The (x + 3) factor is common to both, so it cancels, leaving (2x + 1)/(x − 3). Writing (2x + 1)/(x + 3) comes from factorising x² − 9 as (x + 3)² instead of (x − 3)(x + 3) — a difference of two squares always has one plus and one minus bracket. Writing (2x + 3)/(x − 3) comes from mis-factorising the numerator as (2x + 3)(x + 1) and then wrongly cancelling the (x + 1) against the denominator's (x + 3) as though they were the same bracket. Writing 2x + 1 comes from cancelling the (x + 3) factor correctly but then dropping the remaining (x − 3) on the denominator altogether.
16. (b) 9 — Method: a negative index means take the reciprocal of the base first and then apply the positive power. Working: the reciprocal of 1/3 is 3, so (1/3)⁻² = 3² = 3 × 3 = 9. Answer: 9. The distractors: 1/9 comes from ignoring the minus sign and squaring 1/3 as it stands; −9 comes from reading the negative index as a minus sign on the result; 6 comes from multiplying the denominator by the index, 3 × 2, instead of squaring the reciprocal.
17. (c) x = −2 or x = 4 — The solutions of x² − 2x − 8 = 0 are the x-values where y = 0. From the table, y = 0 when x = −2 and when x = 4, so those are the two solutions. Distractor origins: x = −1 or x = 3 picks the pair of x-values that give equal (but non-zero) y-values instead of y = 0; x = 0 or x = −8 mixes up an x-value with its corresponding y-value; x = −2 only reads off one of the two roots and misses the other.
18. (b) (2x + 14)/((x − 1)(x + 3)) — To subtract these fractions, write them over the common denominator (x − 1)(x + 3): the numerator becomes 4(x + 3) − 2(x − 1). Expanding gives 4x + 12 − 2x + 2, which simplifies to 2x + 14, so the answer is (2x + 14)/((x − 1)(x + 3)). Writing (2x + 11)/((x − 1)(x + 3)) comes from not distributing the minus sign fully across the second bracket, treating −2(x − 1) as −2x − 1 instead of −2x + 2. Writing 2/((x − 1)(x + 3)) comes from subtracting the two original numerators directly, 4 − 2 = 2, the same mistake as subtracting fractions without a common denominator. Writing (2x − 10)/((x − 1)(x + 3)) comes from swapping which numerator multiplies which bracket, forming 4(x − 1) − 2(x + 3) instead of 4(x + 3) − 2(x − 1).
19. (a) 3 m — Height = sloping length × sin 45° = 3√2 × √2/2 = (3 × 2)/2 = 3 m, since √2 × √2 = 2. 3√2 m comes from forgetting to multiply by sin 45° at all. 3√2/2 m comes from using sin 30° = 1/2 instead of sin 45° = √2/2. 6 m comes from using √2 instead of √2/2 for sin 45°, dropping the denominator of the exact value: 3√2 × √2 = 6.
20. (d) 3x² + 4x − 7 — Method: the minus sign in front of the second bracket changes the sign of every term inside it; then collect like terms. Working: removing the brackets gives 5x² + 3x − 2 − 2x² + x − 5; the squared terms give 5x² − 2x² = 3x², the x terms give 3x + x = 4x, and the number terms give −2 − 5 = −7. Answer: 3x² + 4x − 7. The distractors: 7x² + 2x + 3 comes from adding the two brackets instead of subtracting, giving 5x² + 2x², 3x − x and −2 + 5; 3x² + 2x + 3 comes from applying the minus sign to 2x² only, leaving −x and +5 unchanged so that 3x − x = 2x and −2 + 5 = 3; 3x² + 4x + 3 comes from changing the signs of the terms with letters but leaving +5 as it stood, so the number terms give −2 + 5 = 3.