🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (a) x = 3/2 or x = −3/2 — Method: the equation has an x² term and a number but no x term, so make x² the subject and then take the square root of both sides, keeping the negative root as well as the positive one. Working: adding 9 to both sides of 4x² − 9 = 0 gives 4x² = 9, and dividing both sides by 4 gives x² = 9/4. Square-rooting the top and the bottom of 9/4 gives 3/2, so x = 3/2 or x = −3/2, and each value checks out because 4 × 9/4 − 9 = 0. Answer: x = 3/2 or x = −3/2. The distractors: x = 3 or x = −3 comes from square-rooting both sides of 4x² = 9 without first dividing by the 4, so the coefficient of x² is ignored; x = 9/4 or x = −9/4 comes from stopping at x² = 9/4 and writing that value down as x, leaving the square root undone; x = 3/2 only comes from taking the positive square root of 9/4 and losing the negative solution.
2. (d) 6 — By Pythagoras' theorem, the square of the hypotenuse equals the sum of the squares of the other two sides: (√12)² + (√24)² = 12 + 24 = 36. The hypotenuse is √36 = 6 cm. Adding the two side lengths directly instead of squaring them first, treating the theorem as if it were a straight sum of the sides, gives √12 + √24 = 2√3 + 2√6. Multiplying the two squared values, 12 × 24 = 288, instead of adding them, then taking the root, gives √288 = 12√2. Adding the squares correctly to get 36 but forgetting to take the square root at the end leaves 36 as the answer instead of the hypotenuse itself.
3. (d) x = 4 or x = −4 — Method: divide both sides by 2 to get x² = 16, then take the square root of both sides: x = 4 or x = −4. Distractor origins: x = 4 forgets the negative root; x = 8 comes from halving 16 instead of taking its square root; x = 16 stops at x² = 16 without ever taking the square root.
4. (a) t = 0 or t = 4 — The ball is at ground level exactly when h = 0. From the table, h = 0 at t = 0 and at t = 4, so those are the two times. Distractor origins: t = 1 or t = 3 picks the times with equal (but non-zero) height instead of ground level; t = 2 picks the time of maximum height instead of ground level; t = 0 finds only the starting time and misses the second one.
5. (b) 3/50 — Method: write the decimal over the power of ten that matches the number of digits after the point, counting every digit including a zero, then divide the numerator and the denominator by their highest common factor. Working: 0.06 has two digits after the point, so it is 6 hundredths and can be written as 6/100; the highest common factor of 6 and 100 is 2, and 6 ÷ 2 = 3 with 100 ÷ 2 = 50. Answer: 3/50. The distractors: 3/5 comes from ignoring the zero straight after the point and converting 0.6 instead, giving 6/10, which cancels to 3/5; 3/500 comes from counting three decimal places instead of two and writing 6/1000, which cancels to 3/500; 1/6 comes from putting 1 over the digits after the point, as though 0.06 meant one sixth.
6. (c) 9/5 — Method: the area of a rectangle is its length multiplied by its width; the decimal product is then written over a power of ten and cancelled. Working: 24 × 75 = 1800, and 2.4 and 0.75 have three decimal places between them, so 2.4 × 0.75 = 1.8; the area of the panel is 1.8 square metres, which is eighteen tenths, so it can be written as 18/10, and dividing the numerator and the denominator by 2 gives 9 over 5. Answer: 9/5. The distractors: 4/5 comes from converting only the digits after the decimal point and losing the whole one, turning 1.8 into eight tenths; 63/20 comes from adding the two sides instead of multiplying them, giving 3.15; 9/50 comes from misplacing the decimal point in the product and writing 0.18, which cancels to 9 over 50.
7. (a) 2/11 — Let x = 0.18 recurring, so x = 0.181818... . Since two digits repeat, multiply by 100: 100x = 18.181818... . Subtracting the original x removes the recurring part, because the digits line up exactly: 100x − x = 18.181818... − 0.181818... = 18, so 99x = 18, giving x = 18/99 = 2/11. Treating the decimal as if it terminated at two places gives 18/100 = 9/50, which is only 0.18 and drops the repeating part entirely. Subtracting 10x instead of x — using 100x − 10x = 90x = 18 — is the wrong power of ten for a two-digit repeating block, and gives x = 18/90 = 1/5. Making an arithmetic slip in the numerator, 18 − 1 = 17 instead of 18, gives 17/99.
8. (a) 17 — Method: work out each power separately, then combine them as the question asks. Working: $2^3 = 8$ and $3^2 = 9$, and 8 + 9 = 17. 72 comes from working out 8 × 9 = 72, multiplying the two powers instead of adding them. 12 comes from misreading the powers as repeated multiplication of the base by the index, 2 × 3 + 3 × 2 = 6 + 6 = 12. −1 comes from working out 8 − 9 = −1, subtracting the powers instead of adding them. Answer: 17.
9. (b) 0.83333... — Divide 5 by 6 using long division. 5.000... ÷ 6: 50 ÷ 6 = 8 remainder 2, giving the first decimal digit 8. Bring down a 0 to make 20, and 20 ÷ 6 = 3 remainder 2 — the remainder 2 has reappeared, so from here the digit 3 repeats forever. This gives 5/6 = 0.83333... . Stopping after two decimal places and writing 0.83 treats the division as if it terminated, when the remainder never reaches zero. Shifting the decimal point one place too far to the left gives 0.083333..., the same digits divided by an extra power of ten. A slip in the long division itself, misreading a remainder, can produce the wrong repeating digit, 0.85555... .
10. (c) x = 0 or x = 3 — Method: take out the common factor 5x: 5x(x − 3) = 0, so 5x = 0 or x − 3 = 0, giving x = 0 or x = 3. Distractor origins: x = 0 or x = 15 comes from forgetting to divide the second term by the common factor 5x correctly, leaving 15 instead of 3; x = 3 loses the solution x = 0 by dividing both sides by x; x = 5 or x = 3 mistakes the coefficient 5 itself for one of the solutions.
11. (d) x² − 49 — Area = length × width = (x + 7)(x − 7). Expanding: x × x = x², x × (−7) = −7x, 7 × x = 7x, 7 × (−7) = −49. The two middle terms −7x and 7x cancel, leaving x² − 49. A candidate who misremembers the difference-of-two-squares result as a sum gets x² + 49. A candidate who makes a sign error and treats both middle terms as −7x instead of cancelling gets x² − 14x − 49. A candidate who confuses area with perimeter and simply adds the length and width gets 2x.
12. (d) 2⁷ — When multiplying powers of the same base, the indices add: 3 + 4 = 7, so 2³ × 2⁴ = 2⁷. Multiplying the indices instead of adding them gives 3 × 4 = 12, so 2¹². Subtracting the indices instead of adding them gives 4 − 3 = 1, so 2¹. Multiplying the bases together as well as adding the indices gives 2 × 2 = 4, so 4⁷.
13. (b) 16π — Use the circumference formula C = 2πr to find the radius: 8π = 2πr, so r = 8π ÷ 2π = 4 cm. Then use the area formula A = πr²: A = π × 4² = 16π cm². Using C = πr instead of C = 2πr gives r = 8, and squaring that gives 64π. Finding r = 4 correctly but then substituting it back into the circumference formula instead of the area formula gives 2π × 4 = 8π. Finding r = 4 correctly but forgetting to square it in the area formula, using A = πr instead of A = πr², gives 4π.
14. (a) 1/2 — cos 0° = 1 and sin 30° = 1/2, so cos 0° − sin 30° = 1 − 1/2 = 1/2. 1 comes from writing down cos 0° alone and forgetting to subtract sin 30°. 3/2 comes from adding the two values instead of subtracting. −1/2 comes from working out sin 30° − cos 0°, the two terms the wrong way round.
15. (c) (12 + 3π) cm — The perimeter of a quarter-circle is made up of two straight radii plus a quarter of the circumference. The two radii give 2 × 6 = 12 cm, and a quarter of the circumference is (1/4) × 2 × π × 6 = 3π cm, so the total perimeter is (12 + 3π) cm. Giving only the curved part, 3π cm, forgets the two straight edges entirely. Using the full circumference, 2 × π × 6 = 12π, instead of a quarter of it gives (12 + 12π) cm. Including only one radius instead of two gives (6 + 3π) cm.
16. (a) 2√3 — Multiply the top and bottom of the fraction by √3, since √3 × √3 = 3: 6/√3 = (6 × √3)/(√3 × √3) = 6√3/3. Dividing 6 by 3 gives 2, so the fraction simplifies to 2√3. Multiplying only the numerator by √3 and then cancelling the surd in the denominator against it as if they were the same term, without properly squaring the denominator, leads to 6. Dividing 6 by 3 as 3 instead of 2 gives 3√3 — a slip in the final division. Simplifying 6√3/3 by cancelling the whole numerator's 3 with the denominator's 3, including the surd, gives 2, which loses the surd altogether.
17. (a) x = 10 or x = −10 — Rearranging, x² = 100. Taking the square root of both sides gives x = ±10, i.e. x = 10 or x = −10. A candidate who forgets the negative root gives only x = 10. A candidate who halves 100 instead of taking its square root gets x = 50. A candidate who applies the ± sign to 100 itself instead of to its square root gets x = 100 or x = −100.
18. (a) x = 3 — Method: factorise x² + 2x − 15 as (x + 5)(x − 3), since 5 × (−3) = −15 and 5 + (−3) = 2. Setting each bracket equal to zero gives x + 5 = 0 or x − 3 = 0, so x = −5 or x = 3. Only x = 3 is offered here. Distractor origins: x = −3 reverses the sign of the factor pair, treating the bracket (x − 3) as giving x = −3 instead of x = 3; x = 5 takes the number from the other factor, (x + 5), but with the wrong sign, giving x = 5 instead of x = −5; x = 15 takes the constant term of the original expression as if it were a root, without factorising at all.
19. (d) 8(7x − 3) — Method: find the highest common factor of the two terms, write it in front of a bracket and divide each term by it. Working: 56 = 8 × 7 and 24 = 8 × 3, so the highest common factor is 8; dividing gives 56x ÷ 8 = 7x and 24 ÷ 8 = 3, and the subtraction sign stays between them. Answer: 8(7x − 3), which multiplies back out to 56x − 24. The distractors: 8(7x + 3) comes from dropping the minus sign of −24 while dividing; 8(56x − 3) comes from dividing only the number term by 8 and leaving 56x untouched inside the bracket; 8(7x − 16) comes from subtracting 8 from 24 instead of dividing 24 by 8.
20. (b) 24√2 — The side length of the tile is √72. Since 72 = 36 × 2, √72 = √36 × √2 = 6√2 cm. A square has four equal sides, so the perimeter is 4 × 6√2 = 24√2 cm. Simplifying √72 by writing the perfect-square factor itself as the coefficient instead of its root, 36√2 instead of 6√2, and then multiplying by 4 lands on 144√2. Working out the correct side length, 6√2 cm, but then giving that as the final answer without multiplying by 4 for the perimeter gives 6√2. Doubling the side length instead of quadrupling it, as if the perimeter were 2 × 6√2 rather than 4 × 6√2, gives 12√2.