🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (a) t = 0 or t = 4 — The ball is at ground level exactly when h = 0. From the table, h = 0 at t = 0 and at t = 4, so those are the two times. Distractor origins: t = 1 or t = 3 picks the times with equal (but non-zero) height instead of ground level; t = 2 picks the time of maximum height instead of ground level; t = 0 finds only the starting time and misses the second one.
2. (a) 6 — Use √a × √b = √(ab): √3 × √12 = √(3 × 12) = √36 = 6. Adding the numbers under the roots instead of multiplying them, 3 + 12 = 15, gives √15 — that comes from applying the rule for adding surds to a multiplication question. Multiplying the two numbers under the roots but then forgetting to take the square root at the end leaves 36. Simplifying only √12 to 2√3 and then dropping the other √3 factor entirely gives 2√3.
3. (a) 5√2 cm — Method: the angles of a triangle add to 180°, so the third angle is 45° as well and the two shorter sides are equal. Take one of them as the side opposite a 45° angle and use sin 45° = opposite ÷ hypotenuse. Working: the exact value of sin 45° is √2/2, so the shorter side = 10 × √2 ÷ 2, and half of 10 is 5. Answer: 5√2 cm, which is about 7.07 cm. Remembering sin 45° as √2 rather than as √2 halved gives 10√2 cm, which is longer than the hypotenuse. Halving the hypotenuse because 45° is half of 90° gives 5 cm. Taking the value from the other special triangle, sin 60° = √3/2, gives 5√3 cm.
4. (c) 25 cm — Method: for a cube, the edge length is the cube root of the volume. Working: 25 × 25 × 25 = 15,625, so the edge length is 25 cm. 5 cm comes from cube-rooting 125 instead of 15,625, misreading the number of digits. 50 cm comes from working out 25 × 2 = 50, doubling the correct edge length. 125 cm comes from taking the square root of the volume instead of the cube root, since 125 × 125 = 15,625 — that would be the side of a SQUARE of area 15,625, not the edge of a cube of that volume. Answer: 25 cm.
5. (d) x = 2 or x = −5 — Method: find two numbers that multiply to give −10 and add to give 3 — these are 5 and −2. So x² + 3x − 10 = (x + 5)(x − 2) = 0, giving x = −5 or x = 2. Distractor origins: x = −2 or x = 5 swaps the signs of the two roots; x = 2 or x = 5 makes both roots positive, ignoring the sign of −10; x = −5 or x = −2 makes both roots negative.
6. (d) 27/80 — Method: write the total as a fraction of a litre, then divide by the number of glasses. Working: 1.35 = 27/20, so each glass holds 27/20 ÷ 4 = 27/80 of a litre. Answer: 27/80. 27/20 comes from converting the total correctly to a fraction but forgetting to divide by the number of glasses. 27/5 comes from multiplying the total by 4 instead of dividing. 17/50 comes from rounding 1.35 ÷ 4 to 0.34 before converting to a fraction.
7. (c) 0.001 — Method: a negative index means 'one over' the positive power, so $10^{-3}$ means one over $10^{3}$. Working: ten cubed is 1000, and one over 1000 is 0.001. 1000 comes from ignoring the negative sign and working out ten cubed instead of its reciprocal. −1000 comes from ignoring what the negative index does to the size, while still writing a negative sign on the large value. −0.001 comes from correctly finding the size, 0.001, but wrongly keeping a negative sign because the index was negative. Answer: 0.001.
8. (c) 5/11 — Let x = 0.45 recurring, so x = 0.454545... . Since two digits repeat, multiply by 100: 100x = 45.454545... . Subtracting the original x removes the recurring part exactly, because it lines up digit for digit: 100x − x = 45.454545... − 0.454545... = 45, so 99x = 45, giving x = 45/99 = 5/11. Treating the decimal as if it terminated at two places gives 45/100 = 9/20, which is only 0.45 and drops the repeating part entirely. Subtracting 10x instead of x — using 100x − 10x = 90x = 45 — is the wrong power of ten for a two-digit repeating block, and gives x = 45/90 = 1/2. Making an arithmetic slip in the numerator, 45 − 1 = 44 instead of 45, gives 44/99 = 4/9.
9. (c) x = 2 or x = 3 — Method: factorise into two brackets whose numbers multiply to the constant term and add to the coefficient of x, then set each bracket equal to zero. Working: two numbers that multiply to 6 and add to −5 are −2 and −3, so x² − 5x + 6 = (x − 2)(x − 3) = 0; then x − 2 = 0 gives x = 2 and x − 3 = 0 gives x = 3. Answer: x = 2 or x = 3. The distractors: x = −2 or x = −3 comes from reading the numbers inside the brackets as the solutions instead of changing their signs; x = 1 or x = 6 comes from taking the first factor pair of 6 without checking that the pair adds to −5; x = 5 or x = 6 comes from reading the solutions straight off the 5 and the 6 in the equation.
10. (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
11. (c) Exactly 1: the subtraction has no rounding at any step. — 10x − x removes the recurring part completely, because the digits after the decimal point in 10x and in x are identical from the tenths place onward, so they cancel exactly: 9.999... − 0.999... = 9.000... = 9. Nothing was rounded to reach 9x = 9, so x = 1 is an exact equality, not an approximation, and the statement that the value is exactly 1, with no rounding at any step, is the correct one. Calling it only approximately 1, on the ground that a recurring decimal can never reach a whole number, misunderstands what the subtraction has just shown: the recurring tail cancels completely, leaving no gap to approximate away. Claiming the method only works because the recurring digit is 9 is also wrong — the same subtraction cancels the recurring part for any repeating digit, not just 9; it is the choice of multiplier (10, matching the one-digit repeat) that makes the cancellation exact, not the digit itself. Saying 10x minus x gives 8.999... rather than 9 misreads the subtraction: 9.999... − 0.999... has no digit to borrow from, since every decimal digit in the two numbers matches, so the result is exactly 9, not 8.999... .
12. (c) 2 — First write 1 1/2 as an improper fraction, 3/2. To divide by 3/4, multiply by its reciprocal, 4/3: 3/2 × 4/3 = 12/6 = 2. Dropping the whole number and dividing only the fractional part, 1/2 ÷ 3/4 = 1/2 × 4/3, gives 2/3. Multiplying by 3/4 directly instead of using its reciprocal, 3/2 × 3/4, gives 9/8. Using the reciprocal of the first fraction instead of the second, 2/3 × 3/4, gives 1/2.
13. (b) 0.58333... — Divide 7 by 12 using long division. 70 ÷ 12 = 5 remainder 10, so the first decimal digit is 5. Bring down a 0 to make 100: 100 ÷ 12 = 8 remainder 4, so the second digit is 8. Bring down a 0 to make 40: 40 ÷ 12 = 3 remainder 4, so the third digit is 3. Bring down a 0 to make 40 again — the remainder 4 has reappeared, so the digit 3 repeats forever from here. This gives 7/12 = 0.58333... . Stopping the division after two digits and writing 0.58 treats it as if it terminated, when the remainder is not yet zero. Misreading the pattern as a two-digit repeating block, '58', gives 0.585858..., which wrongly makes the 5 recur as well as the 3. A slip in the long division that carries the wrong remainder forward can make the second digit itself appear to repeat instead of the third, giving 0.588888... .
14. (c) 1/4 — A negative index means the reciprocal of the positive power, so 2⁻² = 1 ÷ 2² = 1/4. Treating the negative sign as making the answer negative instead gives −(2²) = −4. Ignoring the negative sign altogether gives just 2² = 4. Finding the reciprocal correctly but then also applying a negative sign gives −1/4.
15. (d) 1/16 — Method: a negative index means the reciprocal of the power, so 2⁻⁴ is 1 divided by 2⁴. Working: 2⁴ = 2 × 2 × 2 × 2 = 16, so the value is 1/16. Answer: 1/16. The distractors: −16 comes from reading the negative index as a minus sign on the result; 16 comes from ignoring the minus sign and working out 2⁴; 1/8 comes from multiplying the base by the index, 2 × 4, and writing 1 over that product.
16. (d) x = 4 or x = −4 — Method: divide both sides by 2 to get x² = 16, then take the square root of both sides: x = 4 or x = −4. Distractor origins: x = 4 forgets the negative root; x = 8 comes from halving 16 instead of taking its square root; x = 16 stops at x² = 16 without ever taking the square root.
17. (d) 9√3 cm — DE is opposite the 60° angle at F, and EF is adjacent to it, so DE = EF × tan 60° = 9 × √3 = 9√3 cm. 9√3/2 cm comes from using sin 60° = √3/2 instead of tan 60°. 3√3 cm comes from using tan 30° = 1/√3 instead of tan 60° (9 × 1/√3 = 9/√3 = 3√3). 18 cm is the hypotenuse DF, not DE: it comes from using cos 60° = 1/2 and working out 9 ÷ 1/2 = 18, which finds the wrong side of the triangle.
18. (b) 5 and −6 — Method: turn the sentence into an equation in one letter, collect every term on one side so it reads as a quadratic equal to zero, then factorise. Working: if the number is x then x² + x = 30, which rearranges to x² + x − 30 = 0; two numbers that multiply to −30 and add to 1 are 6 and −5, so (x + 6)(x − 5) = 0 and x = −6 or x = 5. Both values work: 5 + 25 = 30 and −6 + 36 = 30. Answer: 5 and −6. The distractors: 6 and −5 comes from reading the numbers inside the brackets as the solutions without changing their signs; 5 only comes from discarding the negative solution, although nothing in the question rules out a negative number; 5 and 6 comes from hunting for a factor pair of 30 instead of forming and solving the quadratic.
19. (d) x² − 49 — Area = length × width = (x + 7)(x − 7). Expanding: x × x = x², x × (−7) = −7x, 7 × x = 7x, 7 × (−7) = −49. The two middle terms −7x and 7x cancel, leaving x² − 49. A candidate who misremembers the difference-of-two-squares result as a sum gets x² + 49. A candidate who makes a sign error and treats both middle terms as −7x instead of cancelling gets x² − 14x − 49. A candidate who confuses area with perimeter and simply adds the length and width gets 2x.
20. (d) (x − 8)(x + 8) — x² − 64 = x² − 8², a difference of two squares, which factorises as (x − 8)(x + 8). A candidate who treats it as a perfect square with a repeated negative factor gets (x − 8)(x − 8), which expands to x² − 16x + 64 — wrong on both the middle and constant terms. A candidate who uses a repeated positive factor gets (x + 8)(x + 8), which expands to x² + 16x + 64. A candidate who picks a different factor pair of 64, such as 4 and 16, without checking that the middle term cancels, gets (x − 4)(x + 16), which expands to x² + 12x − 64 — the wrong middle term.