🧮 Paper 1 non-calculator warm-up — Higher

Answer key

1. (c) 7/30 — Let x = 0.2333... . Because only the 3 recurs, use two multiples of x that line up the recurring part exactly: 10x = 2.333... and 100x = 23.333... . Subtracting removes the recurring tail completely: 100x − 10x = 23.333... − 2.333... = 21, so 90x = 21, giving x = 21/90 = 7/30. Treating the decimal as if it terminated after two places, writing 0.23 as 23/100, ignores that the 3 carries on forever. Misreading which digits recur — treating 0.2333... as if the block '23' repeated, giving 0.232323... — leads to x = 23/99, which is a different, larger recurring decimal from the one given. A numerator slip in the subtraction, computing 22 instead of 21, gives x = 22/90 = 11/45.
2. (c) x = 0 or x = 3 — Method: take out the common factor 5x: 5x(x − 3) = 0, so 5x = 0 or x − 3 = 0, giving x = 0 or x = 3. Distractor origins: x = 0 or x = 15 comes from forgetting to divide the second term by the common factor 5x correctly, leaving 15 instead of 3; x = 3 loses the solution x = 0 by dividing both sides by x; x = 5 or x = 3 mistakes the coefficient 5 itself for one of the solutions.
3. (a) x = 4 or x = −3 — Method: find two numbers that multiply to give −12 and add to give −1 — these are −4 and 3. So x² − x − 12 = (x − 4)(x + 3) = 0, giving x = 4 or x = −3. Distractor origins: x = −4 or x = 3 has the signs the wrong way round; x = 4 or x = 3 makes both roots positive, ignoring the sign of −12; x = 12 or x = −1 comes from reading off the coefficient and the constant directly instead of factorising.
4. (a) 0.1666... — Method: a fraction bar means divide, so the decimal is found by dividing the numerator by the denominator; when a remainder comes back unchanged the division never ends, the digit it produces repeats for ever, and the exact value has to be written with that recurring digit rather than a rounded one. Working: 1 ÷ 6 is set out as 1.000 ÷ 6; six does not go into 1, and six goes into 10 tenths once with 4 left over, so the first decimal digit is 1; the 4 left over makes 40 hundredths, and six goes into 40 six times with 4 left over again; that same remainder of 4 returns at every step, so the digit 6 repeats without end. Answer: 0.1666... The distractors: 0.16 comes from carrying the division out to two decimal places and stopping there, as though the decimal terminated; 0.17 comes from rounding the division to two decimal places, which gives a value close to one sixth but not equal to it; 0.6 comes from writing the digit of the denominator straight after the decimal point, as though 1/6 meant six tenths.
5. (c) 25 cm — Method: for a cube, the edge length is the cube root of the volume. Working: 25 × 25 × 25 = 15,625, so the edge length is 25 cm. 5 cm comes from cube-rooting 125 instead of 15,625, misreading the number of digits. 50 cm comes from working out 25 × 2 = 50, doubling the correct edge length. 125 cm comes from taking the square root of the volume instead of the cube root, since 125 × 125 = 15,625 — that would be the side of a SQUARE of area 15,625, not the edge of a cube of that volume. Answer: 25 cm.
6. (c) 1/2 — sin 45° = √2/2 and cos 45° = √2/2, so sin 45° × cos 45° = √2/2 × √2/2 = 2/4 = 1/2. √2/2 comes from writing down only one of the two factors and forgetting to multiply by the other. √2 comes from adding the two exact values instead of multiplying them: √2/2 + √2/2 = √2. 1 comes from wrongly treating sin 45° × cos 45° as sin(45° + 45°) = sin 90° = 1 — multiplying two ratios is not the same as adding their angles.
7. (d) 16π cm² — Method: for a circle, area = π × radius². Working: area = π × 4² = π × 16 = 16π cm². Answer: 16π cm². The student squared the radius but left out the π, which is why 16 cm² is not the exact area. 4π cm² comes from multiplying by the radius once instead of squaring it: π × 4 = 4π. 8π cm² comes from using the circumference formula 2 × π × radius instead of the area formula: 2 × π × 4 = 8π. 64π cm² comes from using the diameter (8 cm) as the radius in the area formula: π × 8² = 64π.
8. (a) t = 0 or t = 4 — The ball is at ground level exactly when h = 0. From the table, h = 0 at t = 0 and at t = 4, so those are the two times. Distractor origins: t = 1 or t = 3 picks the times with equal (but non-zero) height instead of ground level; t = 2 picks the time of maximum height instead of ground level; t = 0 finds only the starting time and misses the second one.
9. (b) 8π cm² — A diameter of 8 cm gives a radius of 4 cm. The area of a full circle would be π × r² = π × 4² = 16π cm², and a semicircle is exactly half of this, giving 16π ÷ 2 = 8π cm². Forgetting to halve the area for the semicircle gives 16π cm², the area of the whole circle. Halving the diameter twice, using a radius of 2 instead of 4, gives π × 2² = 4π cm². Using the diameter itself as the radius, so π × 8² = 64π, and then halving that for the semicircle gives 32π cm².
10. (b) 2⁵ — Method: a power outside brackets multiplies the index of every factor inside them, and dividing powers of the same base subtracts their indices. Working: (5² × 2³)³ = 5⁶ × 2⁹ and (5³ × 2²)² = 5⁶ × 2⁴. Dividing gives 5⁶⁻⁶ × 2⁹⁻⁴, and since 5⁰ = 1 the whole expression reduces to 2⁵. Answer: 2⁵. The distractors: 2² comes from adding the outside index to each inside index instead of multiplying, which gives 5⁵ × 2⁶ over 5⁵ × 2⁴; 2¹³ comes from adding the indices of 2 when dividing, 9 + 4, instead of subtracting them; 2 comes from applying the outside power to the first factor inside each bracket only, leaving 5⁶ × 2³ over 5⁶ × 2².
11. (a) 1/3 — Method: find the total fraction eaten, then subtract it from the whole pizza. Working: together they eat 5/12 + 3/12 = 8/12, so the fraction left is 12/12 − 8/12 = 4/12 = 1/3. Answer: 1/3. 2/3 comes from giving the fraction eaten instead of the fraction left. 7/12 comes from only subtracting Ben's slices and forgetting Mia's. 1/2 comes from comparing the 4 slices left with the 8 slices eaten, 4/8, a part-to-part comparison instead of comparing with the whole pizza of 12 slices.
12. (c) x = 0 or x = −7 — Factorising: x² + 7x = x(x + 7) = 0, so x = 0 or x + 7 = 0, giving x = 0 or x = −7. A candidate who divides both sides of the original equation by x, which loses the solution x = 0, gets only x = −7. A candidate who makes a sign error solving x + 7 = 0 gets x = 0 or x = 7. A candidate who misreads the coefficient and doubles it gets x = 0 or x = −14.
13. (c) 1/x⁶ — Method: raising a power to another power multiplies the two indices, and a negative index means one over the matching positive power. Working: −2 × 3 = −6, so (x⁻²)³ = x⁻⁶, and x⁻⁶ written as a fraction is 1/x⁶. Answer: 1/x⁶. The distractors: x⁶ comes from multiplying the indices correctly but dropping the minus sign; 1/x⁵ comes from adding the sizes of the indices, 2 + 3, instead of multiplying them; −x⁶ comes from reading the negative index as a minus sign in front of the whole term.
14. (b) x = 5 — Area = length × width, so x(x + 3) = 40, which rearranges to x² + 3x − 40 = 0. This factorises as (x + 8)(x − 5) = 0: the two numbers in the brackets must multiply to −40 and add to +3, and the pair 8 and −5 does both. This gives x = −8 or x = 5. Since x is a length, it cannot be negative, so x = 5. A candidate who gives both solutions without rejecting the negative one, which cannot be a length, answers x = 5 or x = −8. A candidate who picks the wrong factor pair of 40, such as 10 and −4 instead of 8 and −5, gets (x + 10)(x − 4) = 0 and answers x = 4. A candidate who rejects the wrong root, keeping the negative solution instead of the positive one, answers x = −8.
15. (c) 3⁻³ — Method: when dividing powers of the same base, subtract the index of the number you are dividing by from the index of the number being divided, keeping them in the order the question writes them. Working: 2 − 5 = −3, so 3² ÷ 3⁵ = 3⁻³. It is worth checking this against the numbers: 3² = 9 and 3⁵ = 243, and 9 ÷ 243 = 1/27, which is 3⁻³. 3³ comes from subtracting the other way round, 5 − 2 = 3, which reverses the sign of the index and gives 27 instead of 1/27. 3⁷ comes from working out 2 + 5 = 7, which is the rule for multiplying powers, not dividing them. 3¹⁰ comes from multiplying the indices, 2 × 5 = 10, instead of subtracting them. Answer: 3⁻³.
16. (a) x¹¹ — Method: when multiplying powers of the same base, add the indices. Working: 7 + 4 = 11, so x⁷ × x⁴ = x¹¹. x²⁸ comes from multiplying the indices, 7 × 4 = 28, instead of adding them. x³ comes from working out 7 − 4 = 3, which is the rule for dividing powers, not multiplying them. 11x comes from adding the indices to make 11 but then treating x as a coefficient instead of a power. Answer: x¹¹.
17. (d) 1/16 — Method: a negative index means the reciprocal of the power, so 2⁻⁴ is 1 divided by 2⁴. Working: 2⁴ = 2 × 2 × 2 × 2 = 16, so the value is 1/16. Answer: 1/16. The distractors: −16 comes from reading the negative index as a minus sign on the result; 16 comes from ignoring the minus sign and working out 2⁴; 1/8 comes from multiplying the base by the index, 2 × 4, and writing 1 over that product.
18. (b) 7 cm — The side opposite the 30° angle is found using sin 30° = opposite/hypotenuse, so opposite = 14 × sin 30° = 14 × 1/2 = 7 cm. 7√3 cm comes from using cos 30° = √3/2 instead of sin 30° (mixing up the opposite and adjacent sides). 14/√3 cm comes from using tan 30° = 1/√3 instead of sin 30°. 28 cm comes from dividing 14 by sin 30° instead of multiplying by it.
19. (b) 9/25 — Method: write the decimal over the matching power of ten, then divide the numerator and the denominator by their highest common factor. Working: 0.36 has two digits after the point, so 0.36 = 36/100; the highest common factor of 36 and 100 is 4, and 36 ÷ 4 = 9 with 100 ÷ 4 = 25; since 9 and 25 share no factor greater than 1, the fraction is fully cancelled. Answer: 9/25. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 9/50 comes from dividing the numerator by 4 but the denominator by only 2; 36/10 comes from counting one decimal place instead of two and writing the digits over 10.
20. (d) (5x − 1)/(x² − x − 2) — The common denominator is (x + 1)(x − 2) = x² − x − 2. The numerator becomes 2(x − 2) + 3(x + 1) = (2x − 4) + (3x + 3) = 5x − 1, so the sum is (5x − 1)/(x² − x − 2). Choosing 5/(2x − 1) adds the numerators (2 + 3 = 5) and the denominators ((x + 1) + (x − 2) = 2x − 1) directly, which is not how fractions add. Choosing (5x + 1)/(x² − x − 2) comes from expanding 2(x − 2) as 2x − 2 instead of 2x − 4, losing part of the constant term. Choosing (5x − 1)/(x² + x − 2) has the correct numerator but the wrong sign on the x-term when (x + 1)(x − 2) is expanded.