⏱️ Ten-minute starters — Foundation

Answer key

1. (d) £16.70 — The mileage charge is 2.20 × 6 = £13.20. Adding the fixed fee: £13.20 + £3.50 = £16.70. A candidate who forgets the fixed fee gives just the mileage charge, £13.20. A candidate who adds the fixed fee to the per-mile rate before multiplying by the number of miles, (3.50 + 2.20) × 6, gets £34.20. A candidate who rounds £2.20 down to £2 gets 2 × 6 + 3.50 = £15.50.
2. (c) −0.2, the car uses 0.2 litres of fuel for each mile — Method: the gradient is the change in the vertical value divided by the change in the horizontal value, which on this graph is a number of litres for each mile, and a negative gradient means the vertical quantity is going down. Working: from (0, 45) to (150, 15) the fuel changes by 15 − 45 = −30 litres while the distance changes by 150 − 0 = 150 miles, so the gradient is −30 ÷ 150 = −0.2, which says the tank loses 0.2 litres for every mile driven. Answer: −0.2, the car uses 0.2 litres of fuel for each mile. The distractors: '0.2, the car gains 0.2 litres of fuel for each mile' comes from subtracting the fuel values the other way round, 45 − 15 = 30, which drops the minus sign and reverses what the graph says; '−5, the car uses 5 litres of fuel for each mile' comes from dividing the change in distance by the change in fuel, 150 ÷ (−30), turning the gradient upside down; '−30, the car uses 30 litres of fuel for each mile' is the change in fuel on its own, never divided by the 150 miles travelled.
3. (b) 4 — Method: the cube root of a number is the value that multiplies by itself three times to give that number. Working: 4 × 4 × 4 = 64, so ∛64 = 4. Answer: 4. (8 comes from finding the square root of 64 instead of the cube root. 192 comes from multiplying 64 by 3 instead of finding the number that cubes to 64. 21.3 comes from dividing 64 by 3 instead of finding its cube root.)
4. (c) 2 — A cylinder has 3 faces in total: 1 curved surface and 2 flat circular faces, the base and the lid. The label covers only the curved surface, leaving the base and the lid uncovered — that is 2 faces. A candidate who forgets one of the two flat faces answers 1. A candidate who mistakenly splits the curved surface into two separate uncovered faces and then adds the 2 flat faces answers 4. A candidate who assumes the label covers the whole tin answers 0. The number of faces not covered by the label is 2.
5. (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
6. (b) k − 5 — Method: the width is 5 less than the length, so subtract 5 from the length. Working: length − 5 = k − 5. Answer: k − 5. 5 − k comes from subtracting in the wrong order, taking the length away from 5 instead of the other way round. k + 5 comes from adding instead of subtracting, missing that the width is smaller than the length. 5k comes from multiplying the length by 5 instead of subtracting 5 from it.
7. (b) 1215 — Method: generate the terms one at a time with the term-to-term rule and compare each with 1000 as you go, stopping at the first one that passes it. Working: the terms are 5, then 5 × 3 = 15, then 45, then 135, then 405, and 405 × 3 = 1215; 405 is still below 1000 while 1215 is above it. Answer: 1215. The distractors: 405 comes from stopping at the last term that is still below 1000 instead of giving the first one above it; 3645 comes from carrying on one term too far, past the first term that passes 1000; 2187 comes from using the multiplier 3 as the first term as well, generating 3, 9, 27, 81, 243, 729, 2187 instead of the sequence described.
8. (a) 3 — Method: subtract the constant term from both sides first, then divide by the coefficient of x. Working: 5x = 17 − 2 = 15; x = 15 ÷ 5 = 3. Answer: x = 3. 3.8 comes from adding 2 instead of subtracting it: (17 + 2) ÷ 5 = 3.8. 1.4 comes from dividing by 5 before subtracting the 2, the wrong order: 17 ÷ 5 = 3.4, then 3.4 − 2 = 1.4. 15 comes from correctly subtracting the 2 but then forgetting to divide by 5.
9. (a) A smaller circle — Since the cutting plane is parallel to the circular base, the cross-section is also a circle, but smaller than the base because the cone narrows as it rises towards the apex, so 'a smaller circle' is correct. 'A triangle' wrongly describes the outline seen from the side of the cone, not a horizontal cross-section. 'An ellipse' would only result from a cut made at an angle to the base, not one parallel to it. 'The same size circle as the base' wrongly ignores that the cone tapers, so any parallel cross-section above the base must be smaller.
10. (d) 2 : 3 — x is 2/3 of y means for every 3 parts of y, x is 2 parts, so x : y = 2 : 3. 3 : 2 comes from writing the ratio the wrong way round. 2 : 5 comes from comparing x with the total of x and y (2 parts out of 5), instead of with y alone. 3 : 5 comes from comparing y with the total of x and y (3 parts out of 5), instead of with x.
11. (d) 5 — Method: in an equation of inverse proportion the constant is divided by the value of x. Working: y = 20 ÷ x with x = 4 gives y = 20 ÷ 4 = 5. Answer: 5. The distractors: 80 comes from multiplying 20 by 4 instead of dividing, which is direct proportion applied to an inverse relationship; 16 comes from working out 20 − 4, treating the constant as something to subtract from; 0.2 comes from dividing the wrong way round, 4 ÷ 20.
12. (c) No — 8 from one class is too small to represent the school. — Method: judge reliability by asking whether the sample is both large enough, and spread across the population, relative to what it is meant to represent. Working: 8 pupils is a tiny fraction of the school's 1,000 pupils, and all 8 come from a single class rather than a range of year groups, so the sample is both too small and too narrow to represent the whole school reliably. She is not right. Saying any sample size gives an equally reliable estimate ignores that reliability generally improves with a larger, more representative sample. Saying the method is unreliable because it was not done online is not a reason connected to sample size or representativeness at all. Saying 8 is reliable because it is more than half her class compares the sample to the wrong population — the school has 1,000 pupils, not one class. Always judge a sample's size against the population it is meant to represent, not against a smaller group within it.