⏱️ Ten-minute starters — Foundation

Answer key

1. (d) 50 g — Method: the milk is 4 parts of the ratio, so use the milk to find the value of one part, then read off the chocolate, which is 1 part. Working: one part = 200 ÷ 4 = 50, and the chocolate is one part. Answer: 50 g. The distractors: 40 g comes from treating the 200 g as the total mass of the mixture and splitting it into 1 + 4 = 5 parts; 250 g is the total mass of the finished mixture, the 200 g of milk plus the chocolate, rather than the chocolate on its own; 800 g comes from multiplying 200 by 4 instead of dividing, which scales the milk up rather than down to the chocolate.
2. (d) 0 — A vertex is a sharp corner point where edges meet. A cylinder has two curved, circular edges but no sharp corner points at all, so it has 0 vertices, making that the correct answer. '2' wrongly treats the two circular edges themselves as vertices, but an edge is not the same as a vertex. '4' overcounts by treating each circular edge as if it had two end-vertices, which does not apply to a continuous curved edge. '1' wrongly imagines the curved surface itself forming a single corner point, which it does not.
3. (a) 1,850 — Method: find the error interval, then check which value falls outside it. Working: half of 100 is 50, so the actual number of visitors, v, satisfies 1,750 ≤ v < 1,850. 1,850 sits exactly on the excluded upper boundary, since a value of 1,850 would round to 1,900, not 1,800. Answer: 1,850. (1,750 is a genuine possible value — it sits at the included lower boundary. 1,799 is a genuine possible value, just below the upper boundary. 1,760 is a genuine possible value, well inside the interval.)
4. (d) 25 — Gradient = (60 − 20) ÷ (15 − 5) = 40 ÷ 10 = 4 litres per minute. Since the butt is empty at t = 0, V = 4t. Setting V = 100 gives t = 100 ÷ 4 = 25 minutes.
5. (a) £20,000 — Method: add the parts of the ratio, divide the profit by the number of parts to find the value of one part, then multiply by the parts belonging to the partner asked about. Working: 3 + 5 + 4 = 12 parts, £48,000 ÷ 12 = £4,000 for one part, and that partner has 5 parts, so 5 × £4,000 = £20,000. Answer: £20,000. The distractors: £4,000 is the value of one part; £12,000 is the 3-part share; £16,000 is the 4-part share, which is what a candidate reaches by assuming the biggest share must go with the number written last in the ratio.
6. (d) 40 cm — Method: convert the real length to centimetres, then divide by the scale factor. Working: 10 m = 1000 cm. 1000 ÷ 25 = 40 cm. Wrong options: 0.4 cm comes from dividing 10 by 25 without converting metres to centimetres first; 25000 cm comes from multiplying instead of dividing (1000 × 25); 4 cm comes from converting 10 m to 100 cm (using ×10 instead of ×100) before dividing.
7. (a) 8.1 m — Multiply the length on the plan by the scale factor: 4.5 × 1.8 = 8.1, so the real length is 8.1 m. Choosing 6.3 m adds the two numbers instead of multiplying them (4.5 + 1.8 = 6.3). Choosing 2.5 m divides the plan length by the scale factor the wrong way round (4.5 ÷ 1.8 = 2.5) instead of multiplying. Choosing 9.0 m rounds the scale factor up to 2 before multiplying (4.5 × 2 = 9.0), losing the accuracy the 1.8 was giving.
8. (b) 10.5 — Method: multiply the drawing length by the scale factor to get the real length. Working: 7 cm × 1.5 = 10.5 m. A student who answers 8.5 has added the scale factor to the drawing length instead of multiplying (7 + 1.5). A student who answers 14 has rounded the scale factor up to 2 before multiplying. A student who answers 3.5 has divided the drawing length by 2 instead of multiplying it by 1.5. Answer: 10.5 m.
9. (b) 40 — The differences between consecutive terms are 3, 5, 7, 9, increasing by 2 each time, so the next difference is 11, giving 29 + 11 = 40. A candidate who reuses the last difference of 9 without increasing it gets 29 + 9 = 38. A candidate who increases the difference by only 1 instead of 2 gets 29 + 10 = 39. A candidate who reuses the first difference of 3 instead of the pattern gets 29 + 3 = 32.
10. (a) 0.8 — The gradient of a line through the origin is the y-coordinate of a point divided by its x-coordinate: 20 ÷ 25 = 0.8. Choosing 1.25 comes from dividing the wrong way round, 25 ÷ 20. Choosing 20 comes from reading off the cost at the point instead of dividing it by the number of miles. Choosing 5 comes from subtracting the two coordinates (25 − 20) instead of dividing them.
11. (a) 50 — Method: in ab², only the b is squared, so square b first, then multiply by a. Working: b² = 5² = 25, then a × b² = 2 × 25 = 50. Answer: 50. 100 comes from squaring the product ab instead of just b: (2 × 5)² = 100. 20 comes from squaring a instead of b: a² × b = 4 × 5 = 20. 10 comes from ignoring the square altogether and working out a × b = 2 × 5 = 10.
12. (a) (2, 7) — Midpoint = ((x1+x2)/2, (y1+y2)/2) = ((−3+7)/2, (5+9)/2) = (4/2, 14/2) = (2, 7). (4, 14) comes from adding the coordinates correctly but forgetting to divide by 2. (2, 9) comes from correctly averaging the x-coordinates but simply copying the y-coordinate of the second point instead of averaging the y-coordinates. (5, 2) comes from subtracting the coordinates instead of adding them before halving: ((7−(−3))/2, (9−5)/2) = (5, 2).