⏱️ Ten-minute starters — Foundation

Answer key

1. (c) 7800 kg/m³ — Method: build the conversion factor from the two unit changes separately — one for the mass, one for the volume. Working: 1 kg = 1000 g, so the mass figure is divided by 1000; 1 m = 100 cm, so 1 m³ = 100 × 100 × 100 = 1000000 cm³ and the volume figure is multiplied by 1000000. The density figure is therefore multiplied by 1000000 ÷ 1000 = 1000, giving 7.8 × 1000 = 7800. So the density of the metal is 7800 kg/m³. Distractor 780 kg/m³ comes from multiplying by 100 instead of 1000. Distractor 78000 kg/m³ comes from multiplying by 10000, an extra zero. Distractor 7.8 kg/m³ comes from not converting the units at all.
2. (a) segment — A chord cuts a circle into two regions, and each of these regions is called a segment. A sector is a different region, bounded by two radii and an arc, not by a chord. An arc is a curved part of the circumference, a length, not a region. A radius is a straight line from the centre to the edge, also a length, not a region.
3. (b) 12 — Method: substitute the total cost into the formula, then subtract the fixed cost and divide by the cost per person. Working: 92 = 6p + 20, so 6p = 92 − 20 = 72, p = 72 ÷ 6 = 12. Answer: 12 people. 15.33 comes from dividing the whole £92 by £6 without first subtracting the £20 fixed cost: 92 ÷ 6 ≈ 15.33. 4.3 comes from swapping the two amounts round, subtracting £6 and dividing by £20: (92 − 6) ÷ 20 = 4.3. 18.67 comes from adding the fixed cost instead of subtracting it: (92 + 20) ÷ 6 ≈ 18.67.
4. (b) 3/50 — Method: write the decimal over the power of ten that matches the number of digits after the point, counting every digit including a zero, then divide the numerator and the denominator by their highest common factor. Working: 0.06 has two digits after the point, so it is 6 hundredths and can be written as 6/100; the highest common factor of 6 and 100 is 2, and 6 ÷ 2 = 3 with 100 ÷ 2 = 50. Answer: 3/50. The distractors: 3/5 comes from ignoring the zero straight after the point and converting 0.6 instead, giving 6/10, which cancels to 3/5; 3/500 comes from counting three decimal places instead of two and writing 6/1000, which cancels to 3/500; 1/6 comes from putting 1 over the digits after the point, as though 0.06 meant one sixth.
5. (a) 7 — Method: multiply both sides by 3 to clear the fraction, then solve the resulting equation. Working: 2x + 1 = 5 × 3 = 15. Subtract 1: 2x = 14. Divide by 2: x = 7. Answer: 7. 2 comes from ignoring the denominator altogether, treating the equation as 2x + 1 = 5 without multiplying by 3 first. 8 comes from a sign error, adding 1 to 15 instead of subtracting it, giving 2x = 16. 14 comes from correctly reaching 2x = 14 but stopping there, without dividing by 2 to find x.
6. (b) 25 cm² — Method: a square has four equal sides, so divide the perimeter by 4 to recover the side length, then square that side to get the area. Working: 20 ÷ 4 = 5 cm, then 5 × 5 = 25. Answer: 25 cm². The distractors: 400 cm² comes from squaring the perimeter itself, 20 × 20, treating the 20 cm as though it were the side length; 100 cm² comes from dividing the perimeter by 2 rather than by 4, giving a side of 10 cm, and squaring that; 5 cm is the side length, from stopping as soon as the perimeter has been divided by 4 and never squaring it, which also leaves a length where an area was asked for.
7. (b) The arcs only meet exactly on AB, not above or below it. — With a radius of exactly half of AB, the arc centred at A and the arc centred at B each reach precisely to the midpoint of AB, so they meet only at that one point, on the line AB itself — there are no two intersection points above and below the line to join, so the perpendicular bisector cannot be drawn. (The claim that this radius is always too short to draw any arc is wrong, since a radius equal to half of AB is a perfectly valid, positive length for a compass arc; the claim that the radius must equal the full length of AB is wrong — a longer radius than half of AB would also work, it does not have to equal AB exactly; the claim that the arcs would not cross line AB at all is wrong, since they do cross it — that is exactly the problem, they meet only on it.)
8. (d) 1535 cm² — The wiper sweeps out a sector of radius 40 cm, the blade length, through an angle of 110°. Sector area is angle ÷ 360 × π × radius²: 110 ÷ 360 × 3.14 × 1600 = 1535.1 cm², which rounds to 1535 cm². Forgetting to square the radius, using radius instead of radius², gives 38 cm². Using 110 ÷ 180 instead of 110 ÷ 360 for the fraction gives 3070 cm². Treating the 40 cm blade length as a diameter, so using a radius of 20 cm, gives 384 cm².
9. (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
10. (a) 900 kg/m³ — Both parts of the compound unit change. There are 100 cm in a metre, so 1 m³ = 100³ = 1 000 000 cm³, and there are 1000 g in a kilogram. So 1 g/cm³ = 1 000 000 ÷ 1000 = 1000 kg/m³, and the plastic is 0.9 × 1000 = 900 kg/m³. 900 000 kg/m³ converts the volume but leaves the mass in grams, 0.0009 kg/m³ converts the mass but leaves the volume in cm³, and 0.09 kg/m³ uses the 100 cm in a metre without cubing it.
11. (a) (8, 2) — Method: translating a point by a column vector means adding the vector's top number to the x-coordinate and its bottom number to the y-coordinate. Working: x-coordinate 2 + 6 = 8; y-coordinate 5 + (−3) = 2. Answer: B = (8, 2). A candidate who ignores the negative sign and adds 3 instead of −3 gets (8, 8). A candidate who translates in the reverse direction, subtracting the vector from A instead of adding it, gets (−4, 8). A candidate who swaps the vector's top and bottom numbers before adding gets (−1, 11).
12. (a) 3.5 km/h — Average speed is total distance ÷ total time. Total distance = 5 + 9 = 14 km. Total time, including the rest, = 1 + 1 + 2 = 4 hours. So average speed = 14 ÷ 4 = 3.5 km/h. Leaving out the 1 hour rest and dividing by only the 3 hours of walking gives 14 ÷ 3 = 4.67 km/h. Averaging the two separate speeds, 5 km/h and 4.5 km/h, instead of using total distance over total time, gives (5 + 4.5) ÷ 2 = 4.75 km/h. Dividing only the second leg's distance by the total time, 9 ÷ 4 = 2.25 km/h, ignores the first leg's distance.