⏱️ Ten-minute starters — Foundation

Answer key

1. (c) 45% — Method: adding water changes the total volume but not the amount of fruit juice, so find the juice, find the new total volume, and write the first as a percentage of the second. Working: 3 × 0.6 = 1.8 litres of fruit juice; the new volume is 3 + 1 = 4 litres; 1.8 ÷ 4 = 0.45, which is 45%. Answer: 45%. The distractors: 60% is the strength before the water goes in, and assumes that adding water leaves the strength unchanged; 15% comes from dividing the 60% by the 4 litres of mixture instead of dividing the 1.8 litres of juice by the 4 litres; 75% is the fraction of the new mixture that came out of the original jug, 3 litres out of 4, which ignores that only 60% of that 3 litres was juice.
2. (b) 3 — Method: solving an index equation like this means finding how many factors of the base multiply together to give the number on the right. Working: 4¹ = 4, 4² = 16 and 4³ = 64, so three factors of 4 are needed. Answer: 3. The distractors: 4 comes from listing 4, 16 and 64 and counting the base itself as a step, which gives one more than the index; 6 comes from solving the equation with 2 as the base instead of 4, since 2⁶ = 64; 16 comes from dividing 64 by 4, treating the index as an instruction to divide.
3. (d) 0 — Method: the range is the largest value minus the smallest value, whatever those two values turn out to be. Working: every value is 10, so the largest value is 10 and the smallest value is 10 as well, and the range is 10 − 10 = 0. Answer: 0 — a range of nothing says the data do not vary at all. The distractors: 10 comes from writing down the repeated value itself instead of the difference between the extremes; 20 comes from adding the largest and the smallest, 10 + 10, instead of subtracting; 40 comes from adding all four values, which gives the total sold and not a measure of spread.
4. (c) 100.5 m — The curved part of a semicircular bend is half of a full circle's circumference. The full circumference would be 2 × 3.14 × 32 = 200.96 m, and half of that is 200.96 ÷ 2 = 100.48 m, which rounds to 100.5 m. Choosing 201.0 m uses the FULL circumference, forgetting to halve it for a semicircle. Choosing 50.2 m halves the radius as well as taking a semicircle, using 3.14 × 16 = 50.24 m instead of the correct radius of 32 m. Choosing 64.0 m uses the diameter, 2 × 32 = 64, as if it were the curved length, ignoring π and the semicircle shape entirely.
5. (b) 3 — The real width is 0.6 × 500 = 300 cm, which converts to 3 m by dividing by 100. A candidate who uses the wrong side of the rectangle, 1.2 cm, instead of the 0.6 cm width, gets 1.2 × 500 = 600 cm = 6 m. A candidate who multiplies correctly but converts the 300 cm to metres by dividing by 1000 instead of 100 gets 0.3 m. A candidate who converts by dividing by 10 instead of 100 gets 30 m. The real width of the bay is 3 m.
6. (a) s/f — Sharing s sweets equally between f friends means dividing the total by the number of friends, written as a fraction: s/f. Writing f/s divides the wrong way round, sharing the number of friends between the sweets instead of the sweets between the friends. Writing s − f mistakes sharing for taking away, subtracting the number of friends from the number of sweets. Writing sf multiplies the two quantities together, which would make the total larger rather than splitting it into smaller equal parts. The number of sweets each friend receives is s/f.
7. (a) 8,350 — Rounding to the nearest 100 means the true number can be up to half of 100, which is 50, below the recorded figure before it would round down to a lower hundred. The smallest possible number is therefore 8,400 − 50 = 8,350. Adding 50 instead of subtracting it gives 8,450, which is the upper end of the interval rather than the smallest value, and 8,450 is not itself possible because it would round up to 8,500. Subtracting a whole 100 instead of half of it gives 8,300, going too far below the recorded value. Subtracting 10 instead of half of the rounding unit gives 8,390, treating the rounding unit as 100 but the tolerance as only 10.
8. (b) Acute — An acute angle is any angle less than 90°. Since 47° is less than 90°, it is acute. An obtuse angle is between 90° and 180°, which 47° is not. A reflex angle is greater than 180°, which is far too big for 47°. A right angle is exactly 90°, not 47°. The angle is acute.
9. (c) 40 minutes — Method: for grouped data, estimate the mean using the midpoint of each class — multiply each midpoint by its frequency, add the results, then divide by the total frequency. Working: the midpoints are 10, 30, 50 and 70 minutes. 10 × 5 = 50. 30 × 10 = 300. 50 × 10 = 500. 70 × 5 = 350. Σfx = 50 + 300 + 500 + 350 = 1200. Σf = 5 + 10 + 10 + 5 = 30. Estimated mean = 1200 ÷ 30 = 40 minutes. Using the upper boundary of each class instead of the midpoint — 20 × 5 = 100, 40 × 10 = 400, 60 × 10 = 600, 80 × 5 = 400 — gives a total of 1500 and an estimate of 1500 ÷ 30 = 50 minutes, too high because a boundary is not the middle of the class. Averaging the frequencies themselves, 5, 10, 10 and 5, ignores the times altogether and gives 7.5. Stopping after Σfx = 1200 without dividing by the total frequency gives a number far too large to be a time in minutes. Always find the midpoint of each class before multiplying by the frequency, and always divide by Σf at the end.
10. (d) positive — Moving from A to B, the x-coordinate increases from 1 to 4 and the y-coordinate also increases from 1 to 7, so the line rises as it goes from left to right, which means the gradient is positive. "negative" would need y to decrease as x increases, which is not the case here. "zero" would need the y-coordinate to stay the same, but it changes from 1 to 7. "cannot be determined" is wrong because the coordinates of both points are known, so the direction of the line can always be found.
11. (c) 3 — Method: find the height scale factor, cube it to find the volume (and coverage) scale factor, use it to find one large sack's coverage, then divide the total lawn area by this and round up to a whole number of sacks. Working: height scale factor = 40 ÷ 20 = 2, so coverage scale factor = 2³ = 8, and each large sack covers 30 × 8 = 240 m². 500 ÷ 240 = 2.08…, which rounds UP to 3 whole sacks. Answer: 3. 2 comes from correctly finding that each large sack covers 240 m², but then rounding 500 ÷ 240 down instead of up, which would leave part of the lawn untreated. 5 comes from squaring the height scale factor (2² = 4) instead of cubing it, giving a coverage of only 30 × 4 = 120 m² per sack. 17 comes from forgetting to scale the coverage at all and dividing 500 by the smaller sack's coverage of 30 m².
12. (d) (−5, −4) — Method: every vertex of a translated shape moves by the same vector, so find that vector from the one vertex whose image is given, then apply it to A. Working: C(4, 5) moves to (0, −1), so across 0 − 4 = −4 and up −1 − 5 = −6, giving the vector $\binom{-4}{-6}$. Applying it to A(−1, 2): −1 − 4 = −5 and 2 − 6 = −4. Answer: the image of A is (−5, −4). Working the vector out as object minus image gives 4 to the right and 6 up, which applied to A gives (3, 8). Getting the horizontal movement right but reversing the vertical one gives (−5, 8). Treating (0, −1) as the image of every vertex ignores that a translation carries each vertex to a different place.