⏱️ Ten-minute starters — Foundation

Answer key

1. (d) 0.6 g/cm³ — Density = mass ÷ volume. 60 ÷ 100 = 0.6 g/cm³. 1.67 g/cm³ comes from dividing the volume by the mass instead of the mass by the volume (100 ÷ 60). 6000 g/cm³ comes from multiplying the mass by the volume instead of dividing (60 × 100). 40 g/cm³ comes from subtracting the mass from the volume (100 − 60) instead of dividing.
2. (a) unlikely — 3/8 = 3 ÷ 8 = 0.375, which is between 0 and 0.5, so the probability is best described as unlikely. Rounding 3/8 loosely to 'about a half' without converting it properly leads to evens, which is wrong since 0.375 is noticeably below 0.5. Reading 3/8 as the complement and using 1 − 3/8 = 5/8 = 0.625 instead gives likely, but the question asks about the probability of 3/8 itself, not its complement. Flipping the fraction to 8/3 ≈ 2.67, which is impossible for a probability, and rounding it towards the top of the scale gives certain.
3. (d) 24 — Method: split 60 into 3 + 7 = 10 equal parts, find the value of one part, then use the difference in ratio parts. Working: 60 ÷ 10 = 6, so the numbers are 3 × 6 = 18 and 7 × 6 = 42, and their difference is 42 − 18 = 24. Answer: 24. 4 comes from finding the difference between the ratio numbers, 7 − 3, but forgetting to multiply by the value of one part. 60 comes from adding the two numbers back together instead of subtracting, which just repeats the given sum. 80 comes from dividing 60 by the first ratio number, 3, instead of by the total number of parts, 10, giving a part value of 20 and a difference of 7 × 20 − 3 × 20 = 80.
4. (c) 6 — The units digit must be even, so it can be 2 or 8, giving 2 choices. The tens digit can then be any of the remaining 3 digits, since one digit has been used for the units. Multiply: 2 × 3 = 6. 12 comes from working out how many two-digit numbers can be made in total, 4 × 3 = 12, ignoring the requirement that the number is even. 8 comes from choosing the units digit from 2 options and then wrongly allowing any of the 4 digits again for the tens digit, 2 × 4 = 8, which lets a digit repeat. 2 comes from counting only the choices for the units digit and forgetting the tens digit.
5. (c) 0.07 — Each digit after the decimal point has a place value: the first digit is tenths, the second is hundredths, the third is thousandths. In 3.472, the 4 is in the tenths place and the 7 is in the hundredths place, so it is worth 0.07. Reading it as 7 ignores place value altogether, treating it as if it were a whole number. Reading it as 0.7 puts it one place too big, in the tenths place. Reading it as 0.007 puts it one place too small, in the thousandths place. The digit 7 in 3.472 is worth 0.07.
6. (b) 18.5 ≤ T < 18.7 — Method: the error interval reaches half the rounding unit either side of the recorded value. Working: half of 0.2 is 0.1, so the interval runs from 18.6 − 0.1 to 18.6 + 0.1. Answer: 18.5 ≤ T < 18.7. (18.4 ≤ T < 18.8 comes from using the full rounding unit, 0.2, either side instead of half of it. 18.5 ≤ T ≤ 18.7 comes from including the upper bound with ≤ instead of excluding it with <. 18.6 ≤ T < 18.8 comes from treating the recorded value as the start of the interval and adding the whole rounding unit, 0.2, above it.)
7. (d) 66 — 6 and (4x + 3) are correct factors of 24x + 18. — Substituting x=2 into 24x+18: 24×2+18=48+18=66. Checking the factorisation: 6×4x=24x and 6×3=18, so 6(4x+3)=24x+18, matching the original expression — 6 and (4x+3) are correctly identified as factors. A candidate who substitutes x=2 into (4x+3) but forgets to multiply by the factor 6 afterwards would compute just 4×2+3=11. A candidate who adds 24 and 18 together before multiplying by x, instead of multiplying 24 by x first, would compute (24+18)×2=84. A candidate who distributes the 6 over only the first term inside the brackets, forgetting the second, would check the factorisation as 6×4x=24x but leave the 3 unmultiplied, getting 24x+3 instead of 24x+18 — and would wrongly conclude that 6 and (4x+3) are not correct factors.
8. (a) 5.8 — The horizontal distance is 3 and the vertical distance is 5, so using Pythagoras' theorem the distance is √(3² + 5²) = √34 = 5.8 (1 d.p.). A candidate who adds the two differences instead of using Pythagoras gets 3 + 5 = 8.0. A candidate who works out 3² + 5² = 34 but forgets to take the square root gets 34.0. A candidate who subtracts the squares instead of adding them gets √(5² − 3²) = √16 = 4.0.
9. (d) 400 m — The distance travelled equals the area under the speed-time graph. The first 10 seconds form a triangle with base 10 and height 20, giving an area of 0.5 × 10 × 20 = 100 m. The next 15 seconds form a rectangle with base 15 and height 20, giving an area of 15 × 20 = 300 m. The total distance is 100 + 300 = 400 m. The option 500 m treats the whole 25 seconds as travelled at the constant 20 m/s, ignoring that the speed was building up during the first 10 seconds: 25 × 20 = 500. The option 300 m only counts the constant-speed section and forgets the triangle section entirely. The option 200 m comes from working out the triangle's area without halving it (10 × 20 = 200) and forgetting the rectangle altogether.
10. (c) 5 — Method: work out the volume of one box, divide the total volume by it, then round down since a partial box cannot fit. Working: volume of one box = 7³ = 343 cm³. 2000 ÷ 343 = 5.83 (2 d.p.). Since only whole boxes fit, the greatest number is 5. Answer: 5. (6 comes from rounding 5.83 up to the nearest whole number instead of rounding down to the number of boxes that actually fit. 343 comes from giving the volume of one box instead of the number of boxes. 5.8 comes from leaving the division as a decimal instead of rounding down to a whole number of boxes.)
11. (d) £4.80 — Method: find the error interval, then check which value falls outside it. Working: half of 20p is 10p, so the actual cost, c, satisfies £4.50 ≤ c < £4.70. £4.80 is above £4.70, so it could not be the actual cost. Answer: £4.80. (£4.50 is a genuine possible cost — it sits at the included lower boundary. £4.65 is a genuine possible cost, below the £4.70 upper boundary. £4.55 is a genuine possible cost, well inside the interval.)
12. (a) The relationship between two variables — Method: what a diagram shows is decided by what has to be known before a single mark can be plotted on it. Working: every point on a scatter graph is plotted from a pair of measurements taken from the same person or object, one read on the horizontal axis and one on the vertical axis; having two measurements for each point is what makes it possible to look for a pattern between them, and the pattern between two variables is what the graph displays. Answer: a scatter graph shows the relationship between two variables. The distractors: the frequency of each single value is what a bar chart or a vertical line chart shows, and it needs only one list of values; how a total is shared between categories is what a pie chart shows; how one quantity changes over time is what a time series line graph shows, in which one of the two axes is always time.